• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.9B
• /
• pp.1518-1526
• /
• 2000

This paper proposes an optical transmission link design method based on an optimum compensation scheme using dispersion compensating fiber (DCF), so that high-speed long-distance optical transmission would be possible over the conventional standard single mode fiber (SMF) link. The proposed design method provides the maximized transmission distances according to the signal speeds, where the amplifier spacing and repeater spacing are optimized wit respect to self-phase modulation(SPM) due to fiber nonlinearity and amplified spontaneous emission (ASE) noises caused by optical amplifies. It is also shown that there exists an optimum input signal power range balancing the effects of ASE noise and SPM for the given amplifier spacing and repeater spacing.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.43 no.5 s.347
• /
• pp.35-44
• /
• 2006

Reflective semiconductor optical amplifiers(R-SOAs) were designed with high gain, wide optical bandwidth, high thermal reliability and wide modulation bandwidth in TO-can package for the transmitter of wavelength division multiplexed-passive optical network(WDM-PON) application. Double trench structure and current block layer were introduced in designing the active layer of R-SOA to enable high speed modulation. The injection power requirement and the viable temperature range of WDM-PON system are experimentally analysed in based on Amplified Spontaneous Emission(ASE)-injected R-SOAs. The effect of the different injection spectrum in the gain-saturated R-SOA was experimentally characterized based on the measurements of excessive intensity noise, Q factor, and BER. The proposed spectral pre-composition method reduces the bandwidth of injection source below the AWG bandwidth and thereby avoids spectrum distortion impeding the intensity noise reduction originated from the amplitude squeezing.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.37 no.5
• /
• pp.23-30
• /
• 2000

To compensate the nonlinearity of electroabsorption modulator(EAM) resulting from its near exponential transfer function, a semiconductor optical amplifier(SOA) that has a log transfer function is used. Since the transfer function of SOA is inverse to that of EAM, the intermodulation distortion(IMD) of EAM can be reduced by cascading SOA to EAM. Also, the RF gain can be increased by the optical gain of SOA. For these reasons, spurious free dynamic range(SFDR) of EAM is enhanced by connecting SOA to EAM in series and operating in gain salutation region. To improve the nonlinearity compensation of EAM, the increased gain of SOA is required and the slope of gain saturation, the ratio of gain to input SOA power, needs to be steep. However, signal spontaneous beat noise that is the dominant system noise increases in proportion to the gain such that the SFDR of EAM is reduced. The higher the gain of SOA is, the more ASE is increased. Thus the noise level of system is increased and the following SFDR of EAM is decreased. The slope of gain saturation region and ASE of have trade-off relation and the optimization is achieved at 8㏈ optical gain. 9㏈ enhancement of SFDR of EAM is obtained. This scheme is easy to embody the linear EAM and the integration with three components (DFB-LD, EAM and SOA) offers many merits, such as low insertion loss, low chirping and low polarization sensitivity.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.3A
• /
• pp.153-159
• /
• 2005

In this paper, we propose All-Optical WDM Buffer System for resolving the contention of Packets in Optical Packet Switching System. The proposed system consists of tunable wavelength converters based on SOA, N×N AWG, and fiber delay lines. This structure can reduce ASE and cross-talk noise because the contending packets are sent and buffered through each different path determined by a wavelength routing. We also performed buffering experiment for two contending WDM optical pulses with each 50ns width, and found that the contending problem is resolved well.

• Journal of the Optical Society of Korea
• /
• v.14 no.1
• /
• pp.49-54
• /
• 2010

In this study, the use of a continuous-wave (CW) supercontinuum (SC) seeded by an erbium-doped fiber's amplified spontaneous emission (ASE) for optical-coherence tomography imaging is experimentally demonstrated. It was shown, by taking an in-depth image of a human tooth sample, that due to the smooth, flat spectrum and long-term stability of the proposed CW SC, it can be readily applied to the spectral-domain optical-coherence tomography system. The relative-intensity noise level and spectral bandwidth of the CW SC are also experimentally analyzed as a function of the ASE beam power.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.21 no.2
• /
• pp.25-31
• /
• 2020

In an optical system that serves as the backbone of an information transmission system, it is essential to evaluate the statistical characteristics of the signal and noise for a performance evaluation and optimization of the system. The optical receiver system improves the reception sensitivity by adopting an optical amplifier in front of the optical detector to improve the reception sensitivity, but some problems change the bandwidth of the electronic signal to the optical signal in the optical receiver due to the ASE noise added to the output of the optical detector. The problem of changing the ratio of the bandwidth of these signals varies according to the passband characteristics of the filter present at the output stage. The frequency response effect can be solved by constructing an infinite order filter, but it is almost impossible to implement it. In this paper, the Butterworth filter was implemented to evaluate the frequency response characteristics of an optical receiver system according to the filter order. The simulation results showed that the receiver sensitivity increases as the order of Butter-Worth filters increases. In addition, as a result of simulation of the change of various values, it was confirmed that the reception sensitivity increased with increasing. That is, the average photocurrent increases, and the dispersion decreases with increasing.

• Journal of the Optical Society of Korea
• /
• v.7 no.2
• /
• pp.64-66
• /
• 2003

The optical gain and noise figure improved double-pass two-stage EDFA using a mirror, circulator, and gain-flattening filters is proposed. By double passing the pump light and removing the ASE propagating into the input part, the signal gain of 5 ㏈ and noise figure of 2.1 ㏈ are improved compared to the conventional single- and double-pass EDFA With gain-fattening filters in the second stage of EDFA, we obtain an improved flat gain with a gain flatness less than 1 ㏈ over 33-nm wavelength range at the 980-nm pump power of 86 ㎽.

• Journal of the Optical Society of Korea
• /
• v.19 no.5
• /
• pp.437-443
• /
• 2015

In this paper, we analyze the performance of the all-optical multihop radio over a free space optical (RoFSO) communication system with amplify-and-forward (AF) relays under varying weather conditions. The proposed channel model considers the propagation loss, attenuation and atmospheric fading modeled by the Gamma-Gamma (GG) distribution. Both the amplified spontaneous emission (ASE) noise in the all-optical relays and the background noise projected onto receiver apertures have been considered in the analysis. The lower bound analytical expressions for the end-to-end bit error rate (BER) and outage probability are derived for the multihop system employing the all-optical relays with the full channel state information (CSI). Meanwhile, the exact results for BER and outage probability are obtained via Monte Carlo simulation. Results indicate the performance of the proposed system will be improved by the multihop transmission technology. For a fixed number of relays, the BER and outage probability will be increased with the deterioration of the weather conditions.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.7A
• /
• pp.951-958
• /
• 2000

In wavelength-routed all-optical networks, signals are transmitted on a direct optical path, or a lightpath, in a single-hop manner without opto-electronic/electro-optic(OE/EO) conversion at intermediate nodes. However, due to the physical constraints of optical elements such as ASE noise and crosstalk signals can be degraded un a long path. To establish a connection under such impairments, the optical signal may need to be regenerated at intermediate nodes, dividing a lightpath into two or more fragments. However, since signal regeneration at intermediate nodes requires additional network resources, the selection of these nodes should be made carefully to minimize blocking of other lightpaths. In this paper, we deal with the problem of establishing a lightpath in a multihop manner under physical constraints. We provide both minimal-cost and heuristic algorithms for locating signal regeneration nodes(SRNs). For a minimal-cost algorithm, we formulate the problem using dynamic programming(DP) such that blocking of other lightpaths due to the lack of transmitters/receivers(TXs/RXs) and wavelengths is minimized throughout the network.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.12 no.10
• /
• pp.1860-1865
• /
• 2008

40Gbps WDMSystems have been studied by numerical simulation to optimize their performance. Standard single mode fiber is assumed, and the most popular modulation format, NRZ, is used for the study. These assumptions are valid when existing WDM systems are required to upgrade their performance to 40Gbps. It is shown that the standard single mode fiber can transmit optical signals over 4800 (BER < 10-15) by optimizing optical and electrical filter characteristics at the receiver and by compensation of dispersion. In addition, when the system performance is mainly limited by ASE noise of EDFAs, it is found that flattop-shaped optical filter at the receiver gives a better result than Gaussian-shaped filter unless the insertion loss of the optical filter is larger than 5dB.