• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2004년도 하계학술대회 논문집 B
• /
• pp.1220-1222
• /
• 2004

In this paper, we propose a new discrete-time predictive current controller for a PM-LSM(permanent magnet linear synchronous motor). The main objectives of the current controllers are to ensure that the measured stator currents tract the command values accurately and to shorten the transient interval as much as possible, in order to obtain high-performance of ac drive system. A new control strategy is seen the scheme that gets the fast adaptation of transient current change, the fast transient response tracking and is proposed simplified calculation. Moreover, the simulation results will be verified the improvements of predictive controller and accuracy of the current controller.

• 전력전자학회논문지
• /
• 제7권3호
• /
• pp.237-243
• /
• 2002

단상 위상각제어시스템의 경우 제어기의 구조상의 단순함과 저가격화로 인해 많은 노이즈가 발생함에도 불구하고 트라이액 교류 위상각제어기를 속도제어기로 사용하고 있다. 시판되는 진공청소기의 경우 트라이액의 위상각을 조절하여 속도를 제어하고 있는데 고조파전류의 발생을 최소화로 하기 위해서 속도의 선형성을 고려하지는 않고 제작하고 있는 경우가 대부분이다. 본 논문에서는 진공청소기용 위상각 제어기에 파라미터 추정에 의한 실제작 시스템으로 고조파가 많이 발생되는 특정 트라이액 트리거 위상각에서도 고조파전류가 효과적으로 감소되고 부수적으로 지연각이 없어지는 고조파전류 감쇠용 위상제어기의 설계 및 제작하여 실험을 통해 입증하였다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2009년도 제40회 하계학술대회
• /
• pp.776_777
• /
• 2009

Optimal efficiency control of synchronous reluctance motor(SynRM) is very important in the sense of energy saving and conservation of natural environment because the efficiency of the SynRM is generally lower than that of other types of AC motors. This paper is proposed a novel efficiency optimization control of SynRM considering iron loss using neural network(NN). The optimal current ratio between torque current and exciting current is analytically derived to drive SynRM at maximum efficiency. This paper is proposed an efficiency optimization control for the SynRM which minimizes the copper and iron losses. The design of the speed controller based on adaptive learning mechanism fuzzy-neural networks(ALM-FNN) controller that is implemented using fuzzy control and neural networks. The objective of the efficiency optimization control is to seek a combination of d and q-axis current components, which provides minimum losses at a certain operating point in steady state. The control performance of the proposed controller is evaluated by analysis for various operating conditions. Analysis results are presented to show the validity of the proposed algorithm.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2004년도 전력전자학술대회 논문집(2)
• /
• pp.992-996
• /
• 2004

Small electric motors in an automobile perform various tasks such as engine cooling, pumping, and in heating, ventilating, and air-conditioning (HVAC) system. At present, most of dc motors are supplied by 12V or 24V batteries. However, DC motors surfer from lack of efficiency, low life cycles and unreliability. Therefore, there is a growing interest in substituting DC motors for advanced AC motors including switched reluctance motors. Although there are several other forms SRM converters, they are either unsatisfactory to the control performance or unsuitable for the 12V-battery powered 3-phase SRM drives. Taking into account the requirement for effective operation and simplicity structure of converter in the limited internal environment of automobiles, the author inclines toward selecting the modified C-dump converter as well as the energy efficient C-dump converter. This is so that more economical and efficient converter topology in automobile industries can be utilized. This paper describes the foundation for the design and development of a 12V-250W-3000rpm SRM drives for automobiles. Furthermore, complete circuit, computer simulation and experiment results are presented to verify the performance of the C-dump converters.

• Journal of Power Electronics
• /
• 제18권3호
• /
• pp.923-930
• /
• 2018

Based on the application of an integrated dynamic brake (IDB) system that uses a PWM inverter fed-AC motor drive to operate the piston, a new active zero state PWM (AZSPWM) is proposed to improve the stability and reliability of the IDB system by suppressing the conducted electro-magnetic interference (EMI) noise under a wide range of load torque. The new AZSPWM reduces common-mode voltage (CMV) by one-third when compared to that of the conventional space vector PWM (CSVPWM). Although this method slightly increases the output current ripple by reducing the CMV, like the CSVPWM, it can be used within the full range of the load torque. Further, unlike other reduced common-mode voltage (RCMV) PWMs, it does not increase the switching power loss. A theoretical analysis is presented and experiments are performed to demonstrate the effectiveness of this method.

• Journal of Power Electronics
• /
• 제16권6호
• /
• pp.2173-2181
• /
• 2016

Permanent magnet synchronous motors (PMSMs) have higher torque and superior output power per volume than other types of AC motors. They are commonly used for applications that require a large output power and a wide range of speed. For precise control of PMSMs, knowing the accurate position of the rotor is essential, and normally position sensors such as a resolver or an encoder are employed. On the other hand, the position sensors make the driving system expensive and unstable if the attached sensor malfunctions. Therefore, sensorless algorithms are widely researched nowadays, to reduce the cost and cope with sensor failure. This paper proposes a sensorless algorithm that can be applied to a wide range of speed. The proposed method features a robust operation at low-speed as well as high-speed ranges by employing a gain adjustment scheme and intermittent voltage pulse injection method. In the proposed scheme the position estimation gain is tuned by a closed loop manner to have stable operation in tough driving environment. The proposed algorithm is fully verified by various experiments done with a 1 kW outer rotor-type PMSM.

• 전력전자학회논문지
• /
• 제10권6호
• /
• pp.569-577
• /
• 2005

본 논문에서는 일반적으로 교류 전동기 구동을 위해 널리 사용되고 있는 6-switch IGBT module을 3상 SRM에 적용한 새로운 구동 방법을 제안한다 비대칭 브리지 컨버터의 경우 사용되는 소자수가 많고 복잡한 제어 및 구동회로를 요구하며 이로 인하여 전체적인 시스템 가격은 상승하게 된다. SRM구동을 위한 비대칭 브리지 컨버터의 구동 방법과 비교하여 본 논문에서 제안한 구동방법은 전체적인 시스템의 크기와 파격을 줄일 수 있다. 따라서 유도기, BLDC 모터, 그 외의 모터등과 비교할 수 있는 SRM 구동을 위한 새로운 토폴로지가 될 수 있다. 제안된 회로의 타당성을 검증하기 위해 비대칭 브리지 컨버터를 적응한 시스템과의 비교 실험을 진행하였다.

• Journal of Power Electronics
• /
• 제3권4호
• /
• pp.230-238
• /
• 2003

Electric vehicles (EV) demands for greater acceleration, performance and vehicle range in pure electric vehicles plus mandated requirements to further reduce emissions in hybrid electric vehicles (HEV) increase the appeal for combined on-board energy storage systems and generators. And the power electronics plays an important role in providing an interface between fuel cells (FC) and loads. This paper deals with a multiple input DC-DC power converter devoted to combine the power flowing of multi-source on energy systems. The multi-source is composed of (i) FC system as a prime power demands, (ii) super capacitor banks as energy storage devices for high and intense power demands, (iii) superconducting magnetic energy storage system (SMES), (iv) multiple input DC-DC power converter and (v) a three phase inverter-fed permanent magnet synchronous motor as a drive. In this system, It is used super capacitor banks and superconducting magnetic energy replaces from the battery system. The modeling and transient performance simulation is effective for reducing transient influence caused by sudden charge of effective load. The main purpose of power electronic converters is to convert the DC power output from the fuel cell and other to a suitable AC voltage, which can be connected to electric loads directly (PMSM). The fuel cell and other output is connected to the DC-DC converter, which regulates the DC link voltage.

• 조명전기설비학회논문지
• /
• 제16권2호
• /
• pp.71-80
• /
• 2002

영구자석형 선형동기전동기(PMLSM)는 고속, 고추력의 직선추진이 가능하므로 산업현장에서 위치결정장치나 물류반송시스템 및 공작기계 등의 선형 서보 시스템에 이용이 되고 있다. 본 논문에서는 PMLSM의 AC 서보화를 위해 동기 프레임상에서 제어구조가 미리 설정된 스위칭 함수에 따라 불연속적으로 변화되는 가변구조 전류제어방식 및 간접 벡터제어이론을 기본으로하여 도달시간을 제거하고, 구동시스템의 추력 이용도를 높이기 위해 파라미터 변동과 한정된 외란에 거의 영향을 받지 않으며 오버슈트가 없는 고속응답을 실현하기 위해 슬라이딩 모드제어 알고리즘을 제안하여 PMLSM의 위치제어에 적용하고자 한다.

• 전력전자학회논문지
• /
• 제12권1호
• /
• pp.65-73
• /
• 2007

본 논문은 1-Hz의 낮은 고정자 전류 주파수에서도 동작하는 순수적분 기반의 자속추정을 위한 온라인 전류측정 오차 보상방법을 제안한다. 오프셋 전류와 변환이득오차에 의한 역상분 전류 성분은 상태관측기를 이용하여 제거하고, 동시에 변환이득오차에 의한 역상분 전류는 동기좌표계에서 영구자석에 의하여 발생된 q축 자속을 기준모델에 의한 값과 추정된 자속에 의한 값 사이의 차이에 의하여 보상한다. 이 보상기는 PI제어기를 이용하여 두 값 사이의 오차가 0이 되도록 제어한다. 또한 적분기 초기값 오차 및 관측기의 전동기 상수 오차에 의한 잔여오차 보상방법도 제안하였다. 타당성을 입증하기 위하여 1.1-kW 영구자석형 동기전동기(PMSM)에 제안된 보상 방법을 구현하여 다양한 실험을 수행하였다.