• Journal of Electrical Engineering and Technology
• /
• 제1권4호
• /
• pp.528-533
• /
• 2006

Electrical discharges may occur in gas, liquid as well as solid insulating materials. This paper describes the investigation results on the discharges in air, silicone oil and low density polyethylene (LDPE) using needle plane electrode system under AC voltage of 50 Hz. The experimental results showed that for discharge in air (corona), discharge pulses were concentrated around the peak of applied voltage at negative half cycle. For silicone oil positive as well as negative discharges were observed which concentrated around the peak of applied voltage. The positive pulse number was smaller but the magnitude was higher than that of negative discharge. Discharges in void took place at wider range of phase of applied voltage. The unbalance in pulse number and magnitude similar to that of oil discharges were observed. For electrical treeing in LDPE, the discharges were spread before the zero cross of the applied voltage up to the peak at both positive and negative half cycles. The discharge pulse sequence analysis indicated that the PD occurrence in air, oil and void were strongly affected by the magnitude of applied voltage. However, for electrical treeing it was observed that the discharge occurrence was strongly affected by the time derivative of the applied voltage (dv/dt).

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2001년도 춘계학술대회 논문집 전기기기 및 에너지변환시스템부문
• /
• pp.240-243
• /
• 2001

This paper presents the digital controller using variable gain for single-phase power factor correction (PFC) converter. Generally, the gain of inner current control loop in single-stage PFC converter has a constant magnitude. This is why input current is distorted under low input voltage. In particular, a digital controller has more time delay than an analog controller which degrades characteristics of control loop. So, it causes the problem that the gain of current control loop isn't increased enough. In addition, the oscillation happens in the peak value of the input voltage open loop PFC system gain changes according to ac input voltage. These aspects make the design of the digital PFC controller difficult. In this paper, the improved digital control method for single-phase power factor converter is presented. The variable gain according to input voltage and input current help to improve current shape. The 800W converter is manufactured to verify the proposed control method.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1998년도 하계학술대회 논문집 E
• /
• pp.1761-1763
• /
• 1998

ITO(Iridium-Tin Oxide) thin film, as discharge electrodes in AC PDP, should have low resistivity and high transparency. Regarded as a high deposition rate method, the ITO thin film fabricated by the facing target sputtering system has been studied in this paper. The electrical property of the ITO film deposited below $150^{\circ}C$ is not satisfied. The SEM pictures show that the ITO films deposited below $150^{\circ}C$ are amorphous. After being annealed the amorphous ITO films become crystalline, and for this reason, the electrical property of amorphous ITO films can be effectively improved by annealing process. An ITO film with the resistivity as low as $1.99{\times}10^{-4}$ and transparency above 85% has be gotten after vacuum annealing at $300^{\circ}C$ for 2 hours while deposited at $75^{\circ}C$. The corresponding deposition rate is $220{\AA}/min$.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1998년도 하계학술대회 논문집 E
• /
• pp.1705-1707
• /
• 1998

In this paper, a superposed discharge type ozonizer was designed and manufactured. The ozonizer is equipped with three electrodes : central electrode, internal electrode and external electrode, and it consists of two gaps. The ozone is generated by superposing silent discharge, which are respectively generated betweens two gaps. This paper describes the following two characteristics : (1) 'the characteristics of discharge with variation with output voltage of AC High Voltage source, quantity of the supplied gas and discharge voltage (2) the characteristics of ozone discharge power, temperature of the supplied gas.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2003년도 제5회 영호남 학술대회 논문집
• /
• pp.15-18
• /
• 2003

Fault current limiters (FCL) are extensively needed to suppress fault currents, especially for trunk power systems heavily connected to high voltage/large current transmission lines. Due to its ideal electrical behavior, high-temperature superconductor fault current limiter (HTSFCL) becomes one of the most important developing trends of limiters in power system. This paper describes the result of an investigation of the dielectric characteristics of turn-to-turn insulation for pancake and solenoid type reactor coil in liquid nitrogen. The influence of thickness in a variety length, on AC, DC and impulse surface flashover has been investigated. Also, the relationships between the number of turn and breakdown characteristics were clarified. The information gathered in this test series should be helpful in the design of liquid nitrogen filled DC reactor type HTSFCL.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2006년도 제37회 하계학술대회 논문집 B
• /
• pp.1145-1146
• /
• 2006

분산 형 전원 및 석탄 가스화와 연계한 복합 발전이 가능한 용융탄산염 연료전지(MCFC : Molten Carbonate Fuel Cell)는 천연가스, 석탄가스 등 다양한 연료를 사용할 수 있고, 공해요인이 적고, 높은 에너지 변환효율을 가지고 있어 전력사업 분야에 적용 가능성이 가장 큰 새로운 발전방식이다. 국내에서도 1993년부터 선도기술개발 사업의 하나로 시작하여 현재 250 kW급 발전시스템 개발 연구가 진행되고 있다. 250 kW개발 전 수행한 100 kW급 MCFC 발전 시스템 개발 연구에서는 6,000cm2 급 단위전지 90장으로 구성된 50 kW급 MCFC 스택 2기 로 구성된 100 kW MCFC 스택과 이를 운전 평가를 위한 시스템을 완성하였다. 2005년부터 스택운전에 필요한 시스템 내 단위기기들에 대한 시운전을 진행 한 후 장착된 100 kW MCFC 스택 운전에서는 시스템 단위 기기의 고장으로 전 부하운전을 실시하지 못했지만 상압 상태에서 AC 50 kW 전력을 계통과 연계 운전 시험을 진행하였다. 향후 100 kW MCFC 시스템 보완후 재 운전 시험을 진행할 예정이다. 한편 병행하여 진행되는 250 kW 열병합 발전 시스템 개발에서는 시스템 상세설계 및 신형 분리판을 이용한 새로운 형태의 스택을 개발 운전시험을 진행하고 있다. 여기에서는 MCFC 발전 시스템의 개요와 시스템의 운전을 위한 운전 모드 그리고 스택 운전 내용을 요약하여 소개하고자 한다.

• 유체기계공업학회:학술대회논문집
• /
• 유체기계공업학회 2004년도 유체기계 연구개발 발표회 논문집
• /
• pp.697-702
• /
• 2004

LG Electronics developed linear compressors for a household refrigerator which can reduce energy consumption up to $24\%$ by only Drop-ln instead of a conventional reciprocating compressor. The linear compressor is composed of a linear oscillating motor, a piston directly coupled with the linear motor, a cylinder and the specific discharge system of LG. Because of this free-piston structure, the position of the piston can be changeable according to the voltage variation, load variation and so on. By this reason, LG linear compressor has been in need of an additional unit to control the position of the free-piston stably. In this paper we will introduce the innovative technology which is able to operate the linear compressor without controlling the piston position like a conventional reciprocating compressor.

• 한국유체기계학회 논문집
• /
• 제18권3호
• /
• pp.33-37
• /
• 2015

A numerical study on the IPM/Bridge Diode cooling and coil cooling has been performed. Results are presented as plots of thermal resistance, temperature drop and RPM-ratio. CFD analysis for conventional cooling system has been performed as a reference case. As the RPM-Ratio was increased, heatsink thermal resistance and coil temperature were decreased. IPM/Bridge Diode thermal resistance and temperature of the coil is tended to be trade-off. The temperature of coil closest to the AC-motor fan showed the most significant change in accordance with duct design. The temperature of coil located at the top of DC-motor fan showed the most significant variation as the cooling air passes the heatsink fin area.

• 한국세라믹학회지
• /
• 제33권1호
• /
• pp.119-125
• /
• 1996

Magnetic properties through controlled nucleation and crystallization wer studied for ferrimagnetic 40Fe2O3-20CaO-40SiO2 glass useful as thermoseeds for hyperthermia of tumor therapy. The maximum nucleation and crystal growth temperature are $700^{\circ}C$ and 100$0^{\circ}C$ respectively. The glass showed the maximum saturation magnetization of 168.4 emu/cm3 when nucleated $700^{\circ}C$ for 60 min and crystal grown at 100$0^{\circ}C$ for 4hrs. The maximum coercive force was 390 Oe when uncleated $700^{\circ}C$ for 60 min and crystal grown at 975$^{\circ}C$ for 2 hrs. The variation of the saturation magnetization could be well quantitatively interpreted in terms of the volume fraction of the magnetite whereas that of the coercive forces could be explained only qual.itatively in terms of the particle size of the magnetite. Hysteresis losses showed the maximum value of 0.18W/cm3 when heat treated at 100$0^{\circ}C$ for 4 hrs pre-necleated at $700^{\circ}C$ for 60 min and temperature increase of 7K under AC magnetic field of 10 kOe and 10kHz.

• 한국세라믹학회지
• /
• 제34권6호
• /
• pp.620-628
• /
• 1997

The possibility of the existence of a field-induced micro-macrodomain switching was proposed and examined using 9 mol % PbZrO3-doped 0.6Pb(Ni1/3Nb2/3)O3-PbTiO3 (PNN-PT) systems having rhombohedral symmetry at room temperature. the thermally depoled (freshly prepard) specimens prepared from the rhombohedral side of the system exhibited a relaxor behavior for the whole range of temperature examined (for T