• 한국가시화정보학회지
• /
• 제13권1호
• /
• pp.9-14
• /
• 2015

There have been many attempts to reduce the cost of transportation. Especially, drag reduction of heavy vehicles has enormous influence on energy saving by reducing the driving power of the vehicles. In this study, the effects of drag-reducing additive devices such as side skirt, boat tail and cab-roof fairing on the drag reduction of a 5 ton truck model were experimentally investigated. The aerodynamic performance of these flow-control devices attached to heavy vehicle was evaluated through wind tunnel test. In addition, flow patterns around the truck model were visualized by using smoke tube method. The drag coefficient is reduced by up to 5.7%, 7.16% and 22.2% by the side skirt, boat tail and cab-roof fairing, respectively. The interactive effect of the side skirt and boat tail was also investigated.

• 한국가스학회지
• /
• 제23권1호
• /
• pp.19-26
• /
• 2019

본 연구에서는 친환경적 냉매로 주목받고 있는 이산화탄소 자연 냉매를 이용하여 1톤 크기의 냉동 탑차에 들어가는 냉방 시스템을 개발하고, COP를 올리기 위해 열교환기 및 Unit cooler를 설계하였다. 또한 LNG의 기존 CNG 5톤 냉동탑차를 LNG 차량으로 개조하여 냉방시스템의 효율을 높임과 동시에 CNG 대비 안전성을 확보하였다. 결과적으로 1톤 및 5톤 크기에서 자연 냉매를 사용한 친환경적인 냉동탑차를 개발하였다.

• 한국산학기술학회논문지
• /
• 제20권5호
• /
• pp.73-80
• /
• 2019

본 논문은 기존 5ton 카고 트럭의 적재함을 개조하여 농기계의 상, 하차를 손쉽게 할 수 있도록 하는 전동 유압 슬라이딩 데크를 개발하기 위하여 전동 유압 슬라이딩 데크 시스템의 기본 설계를 수행하였고, 기구학적 해석을 통하여 슬라이딩 데크의 길이와 구조를 고안 하였으며, 구조해석을 통하여 안전성과 경제성을 고려한 재질을 선정하였다. 먼저 슬라이딩 데크 시스템의 기본 설계를 위하여 운송 대상 농기계를 조사하였고, 필요한 요소들을 선정하였다. 선정한 요소들을 충족시킬 수 있는 유압실린더를 이용한 시스템을 고안하였다. 단순화 모델링과 기구학적 다이어그램을 통하여 슬라이딩 데크 시스템의 작동 구조를 파악하였으며, 기구학 해석을 통해 슬라이딩 데크의 최소길이와 그 구조를 고안하였다. 안전성과 경제성을 모두 만족하는 재질을 선정하기 위하여, 자동차 구조물에 사용되는 대표적인 4가지 재질을 선정하였다. 해석이 필요한 부분을 선정하고, 단순화 모델링을 통해 최대하중을 받는 조건에서 재질에 따른 응력과 변형량을 비교하였다. 그 결과 SS41P 재질사용하면 단가를 줄이고 안전성을 만족하는 결과를 얻을 수 있었다. 작동이 불가능한 농기계의 상, 하차를 위하여 윈치 시스템을 설계하고 적용하였다.

• 산업경영시스템학회지
• /
• 제32권1호
• /
• pp.34-43
• /
• 2009

In this thesis, we explain developing processes of the power transmission system for lift truck. Conventional power transmission system had some problems such as spatial constraints or low speed and high torque problem. Because conventional power transmission system was mainly designed for high speed vehicles. In this paper we developed power shift drive axle specialized for $2.0{\sim}3.5$ ton lift truck. Innovative structure of transmission which is built in inside axle, enables to reduce system weight and size by 40% compared to the conventional power transmission system. Also, it is possible to do additional functions such as auto parking system and anti-roll back system.

• 한국환경과학회지
• /
• 제5권2호
• /
• pp.229-241
• /
• 1996

This study was performed to find the most desirable emission reduction for each mobile source pollutant and the optimal control strategy at a given level of expenditures in Pusan City in 2000 by using the interactive s-constraint method developed by Chang-Hyo Lee and Hyung-Wook Kim, which isone of the mathematical programming models. The most desirable emission reduction is 7093 ton/year for particulate (TSP), 4871 ton/year for NOx, 5148 ton/year for HC and 36779 ton/year for CO. The optimal control strategy is as follows; 1. As to passenger car and taxi, limiting VKT (vehicle kilometers travelled) in congested areas will be necessary. In addition to this, improving vehicie inspection Program should be enforced. 2. As to small-gasoline bus, traffic adaptive control system will be necessary. 3. As to small-diesel bus, non-adjustable engine parameters will have to be applied. .4. As to heal bus and heart truck, catalytic trap oxidizer and limiting VKT in congested areas will do necessary. 5. As to motorcycle, 2-cycle motorcycles should be converted to 4-cycle motorcycles.

• Journal of Advanced Marine Engineering and Technology
• /
• 제32권3호
• /
• pp.379-386
• /
• 2008

The 36 liter LNG tank is designed to fit in the limited installation space of a small truck. Two LNG tanks allow one ton truck to run about 432 km per fueling. which is about 1.8 times longer than CNG mileage for the same truck. The variation of BOG with car acceleration for the different fuel liquid/vapor ratios in a tank is analysed by the modified Fortran program "Pro-Heatleak". Computational analyses show that the relationship between the BOG and liquid/vapor ratio is linearly proportional at a given acceleration. Fuel consumption decreases the volume of liquid fuel in the tank but increases the specific BOG. BOG increases with increasing of car acceleration when fuel liquid/vapor ratio is greater than 0.5 and decreases with increasing of car acceleration when fuel liquid/vapor ratio is less than 0.5. The difference between maximum and minimum BOG for full tank is about 12 percents. For the fuel liquid/vapor ratio equal to 0.5 BOG does not depend on car acceleration.

• 한국기후변화학회지
• /
• 제7권2호
• /
• pp.177-184
• /
• 2016

Recently, the need for technology development of commercial vehicle fuel consumption has emerged. Fuel economy improvement of transport equipment and transportation efficiency, and increasing attention to the logistics cost reduction measures. Increasing attention to the logistics cost reduction measures by fuel economy improvement of transport equipment and transportation efficiency. In this study, we have installed aerodynamic reduction device (side skirt, boat tail) to 14.5 ton cargo trucks and 45 ft tractor-trailers. And the fuel consumption was compared installed before and after. Fuel economy assessment for the aerodynamic reduction value device was tested by modifying the SAE J1321 Joint TMC/SAE Fuel Consumption Test Procedure - Type II test in according domestic situation. Greenhouse gas reductions were calculated in accordance with the scenario, including fuel consumption test results. When the 14.5 ton cargo trucks has been equipped with side skirts and boat tail, it confirmed the improvement in fuel efficiency of 4.72%. One Heavy-duty truck's the annual greenhouse gas reductions value are $6.86ton\;CO_2\;eq$. And if applying the technology to more than 50% of registered 15 ton trucks, greenhouse gas reductions are calculated as $686,826ton\;CO_2\;eq./yr$.

• 대한교통학회지
• /
• 제35권5호
• /
• pp.458-467
• /
• 2017

2014년 기준 국내 약 76% 이상의 화물이 도로를 이용하여 수송되고 있는 만큼 고속도로는 화물수송의 중추적 역할을 수행하고 있다. 그러나 고속도로에서 수송되는 화물자동차 및 화물의 규모를 가늠할 수 있는 지표의 산정방안에 관한 연구는 부족한 실정이다. 본 연구에서는 한국도로공사에서 관리하는 스마트 제한차량 분석시스템(TCS, HS-WIM) 자료를 활용하여 산출 가능한 화물자동차통행실적(대${\cdot}$km/년), 화물수송실적(톤${\cdot}$km/년), 화물자동차 통행효율(대${\cdot}$km/km), 화물수송효율(톤${\cdot}$km/km) 총 4가지 지표를 선정하였다. 본 연구는 도로교통 통계를 활용한 구간교통량 기반 지표 산정방안과 고속도로 영업소 간 기종점교통량을 활용한 기종점교통량 기반 지표 산정방안의 장 단점 및 한계점을 제시하고 평가 및 검증하였다. 또한 고속도로 관리자 입장에서 스마트 제한차량분석시스템을 활용하여 실시간(1일, 1개월)으로 산출가능한 방법론을 제시한 것에 의의를 가진다.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2006년도 추계학술대회논문집
• /
• pp.836-839
• /
• 2006

This paper presented comparison of vibration characteristics of a 5-ton truck at the two kinds of rear axle suspension, a conventional leaf spring suspension and an air spring suspension. Vibration at the selected location in the freight compartment and the rear axle were measured while the vehicle was running on various kinds of road at the specified speed. At all kinds of the driving conditions used in the test the air spring suspension showed good performance of vibration attenuation, especailly at the frequency range of under 5 Hz.

• 한국분무공학회지
• /
• 제20권2호
• /
• pp.121-129
• /
• 2015

This study was designed to investigate the emission characteristics of unregulated pollutants (Aldehyde, VOCs, PAHs) as well as regulated pollutants (CO, HC, NOx and PM) from diesel medium-duty trucks. The emission characteristics of unregulated and regulated pollutants were assessed based on regulation standards (EURO 4 and EURO 5) and intake weight (2.5 ton and 5 ton). The results show that unregulated and regulated pollutants remained almost unchanged at higher speeds but decreased at below 23.5 km/h. Reduction in unregulated and regulated pollutants was noticeable in vehicles of recent regulation standards and light intake weight. The analysis of aldehyde using UPLC showed that formaldehyde and acetaldehyde of aldehyde were most dominant. The GC/MS analysis showed that benzene, toluene, ethylbenzene and xylene of VOCs was over 80% followed by toluene, xylene, ethylbenzene and benzene. In addition, the analysis of PAHs using GC/TOF-MS indicated that bi- and tricyclic aromatic ring of aromatic compounds was 73% and 53% at 2.5 ton and 5 ton vehicles, respectively. The results of this study will be contributed to establish HAPs inventory.