• Journal of the Institute of Electronics and Information Engineers
• /
• v.53 no.2
• /
• pp.36-44
• /
• 2016

In this paper, an Impulse Radio-Ultra Wide band RF Transceiver for WBAN applications is implemented in $0.18{\mu}m$ CMOS technology. The designed RF transceiver support 3-5GHz UWB low band and employs OOK(On-Off Keying) modulation. The receiver employs non-coherent energy detection architecture to reduce complexity and power consumption. For the rejection of the undesired interferers and improvement of the receiver sensitivity, RF active notch filter is integrated. The VCO based transmitter employs the switch mechanism. As adapt the switch mechanism, power consumption and VCO leakage can be reduced. Also, the spectrum mask is always same at each center frequency. The measured sensitivity of the receiver is -84.1 dBm at 3.5 GHz with 1.579 Mbps. The power consumption of the transmitter and receiver are 0.3nJ/bit and 41 mW respectively.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2002.11a
• /
• pp.219-222
• /
• 2002

본 논문에서는 이중 대역 소형 평면 패치 안테나를 이용하여 5.6GHz 대역과 5.8GHz 대역에서 동작하는 이중 대역 안테나를 제안하였다. 안테나의 격리도 특성을 최소화하기 위해 서로 다른 급전선 구조를 이용하였고, 급전부에 개방스터브를 사용하여 VSWR $\leq$2를 기준으로 5.48 GHz 대역과 5.87 GHz대역에서 각각 3.1%와 2.73% 이상의 대역폭을 얻었으며, 격리도 특성은 두 대역에서 평균적으로 -27㏈를 얻었다

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.14 no.3
• /
• pp.304-311
• /
• 2003

In this paper, we present the 2.4 ㎓ and 5 ㎓ dual band antenna fur access point of WLAN(Wireless Local Area Network). The proposed antenna must have equal gains in both frequency bands to accept two services. We proposed using collinear array to compensate gain difference for two different frequency bands. Simulation results using 3D simulation program, CST MWS(Microwave Studio), for dual band antenna with collinear away show that the maximum gain is about 4.7 dBi at 2.4 ㎓, 5.2 dBi at 5.7 ㎓. We got additional gain of about 2.1 ㏈ with collinear array for 2.4 ㎓ in measurement. Measured results for the dual band antenna with collinear array show applicable performances for access point of wireless LAN.

• The Journal of Information Technology
• /
• v.5 no.2
• /
• pp.47-54
• /
• 2002

OFDM ambient noise and entrain error that this research proposes in IEEE 802.11g, use 256-State 2/3 binary scale Convoulutional 8-PSK Modulations, FEC coding, PBCC and did speed of 12 Mbpses that belong on category of 5 GHzs Band FHSS way so that can be applied in 20 Mbpses DSSS'S generalization that is establishing Pyojunan in current IEEE embodying transmission device model who operate with the equal speed from 2.4 GHzs ISM Band important duty to DSSS way.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.42 no.7 s.337
• /
• pp.41-48
• /
• 2005

We design and fabricate 3-dB tandem directional coupler using the coplanar waveguide structure which is applicable to balanced amplifiers and mixers for 60 GHz wireless local area network system. The coupler comprises the multiple-sectional parallel-coupled lines to facilitate the fabrication process, and enable smaller device size and higher directivity than those of the conventional 3-dB coupler employing the edge-coupled line. In this study, we adopt the structure of two-sectional parallel-coupled lines of which each single-coupled line has a coupling coefficient of -8.34 dB and airbridge structure to monolithically materialize the uniplanar coupler structure instead of using the conventional multilayer or bonded structure. The airbridge structure also supports to minimize the parasitic components and maintain desirable device performance in V-band (50$\~$75 GHz). The measured results from the fabricated couplers show couplings of 3.S$\~$4 dB and phase differences of 87.5$^{\circ}{\pm}1^{\circ}$ in V-band range and show directivities higher than 30 dB at a frequency of 60 GHz.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.29 no.1
• /
• pp.42-49
• /
• 2018

In this paper, a dual-band microstrip-fed monopole antenna with a DGS(defected ground structure) for WLAN(wireless local area network) applications is presented. The antenna consists of a monopole and a defected ground, which were etched on both sides of the FR-4 substrate. The defected ground structure was used to obtain the dual band, while the step-by-step reduction in the monopole width was used to improve the impedance matching of the antenna. The antenna has an overall compact size of $44{\times}51{\times}1.6mm^3$, which was optimized by varying the size of the monopole and the ground plane such that it may resonate at the 2.4 GHz and 5 GHz bands of the WLAN. The measurement results showed that the antenna operates in the frequency band of 210 MHz(2.29~2.50 GHz) and 900 MHz(5.05~5.95 GHz) for a VSWR under 2, and showed omnidirectional radiation pattern at all desired frequencies.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.27 no.3C
• /
• pp.234-240
• /
• 2002

A power amplifier with AlGaAs/InGaAs/GaAs HBT's has been developed for customer premise equipments of the quasi millimeter-wave frequency-band broadband wireless local loop(BWLL) system. Parameters of the linear and nonlinear equivalent circuits for a common base HBT have been extracted by a fitting method. The amplifier has been designed through the linear and nonlinear circuit simulations and fabricated on a ceramic substrate for a hybrid IC. The amplifier has produced a 25.5-dBm output power with 35% power-added efficiency(PAE) at 24.4 GHz and achieved a 7.5-dB linear power gain at 24.8 GHz. In 24.25 ∼24.75 GHz band, the amplifier has exhibited a saturated output over larger than 22 dBm and PAE higher than 25%.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.25 no.6
• /
• pp.619-627
• /
• 2014

In this paper, we designed a blade antenna for VHF-UHF band(500 MHz~3 GHz) to be used as aircraft antennas. Unlike previously reported researches that use high-dielectric materials and insert rectangular extended grounds, the antenna structure was designed by optimizing the curvature of both a radiator and an extended ground whose shape is varied by changing the exponent of an n-th polynomial. Based on the optimized structure, we measured impedance matching and gain performances to evaluate the antenna in the VHF-UHF band(500 MHz~3 GHz). As a result, we confirmed that the antenna shows matching characteristics of less than -6 dB and has average gains of greater than -5 dBi in the entire VHF-UHF band.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.15 no.2
• /
• pp.273-278
• /
• 2011

This paper has proposed a dual-band transmitter RF Front-end for IMT-Advanced systems which has been implemented in a 0.13-${\mu}m$ CMOS technology. The proposed dual-band transmitter RF Front-End covers 2300~2700 MHz, 3300~3800 MHz frequency ranges which support 802.11, Mobile WiMAX, and IMT-Advanced system. The proposed dual-band transmitter RF Front-End consumes 45 mA from a 1.2 V supply voltage. The performances of the transmitter RF Front-End are verified through post-layout simulations. The simulation results show a +0 dBm output power at 2 GHz band, and +1.3 dBm output power at 3 GHz band.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.2
• /
• pp.147-153
• /
• 2009

In this paper, FSS(Frequency Selective Surface) using defect mode characteristic is proposed. The unit cell using defect mode characteristic of the proposed FSS is offered lower resonant frequency in the same cell size. The number of suitable array is optimized 13 by 13. Also, the patch antennas operated in WCDMA(Wideband Code Division Multiple Access) Tx band and Rx band are designed for the comparison. The gain value of proposed FSS-1 complex structure (the patch antenna of Tx band and FSS) is improved 3.3 dB from 9.98 dBi to 13.28 dBi in Tx band. The gain value of proposed FSS-2 complex structure(the patch antenna of Rx band and FSS) is improved 5.53 dB from 9.81 dBi to 15.34 dBi in Rx band. Also the measured impedance bandwidth($VSWR{\leq}2$) of manufactured $13{\times}13$ array antenna is from 337 MHz(1.87 to 2.21 GHz). The measured radiation gain is 11.39 dBi(1.94 GHz), 13.11 dBi(2.05 GHz), 11.09 dBi(2.14 GHz). The measured radiation efficiency is 81 %. Because the proposed FSS structure has more higher gain, it will be applied to antenna of WCDMA repeater system.