• Journal of the Korean Institute of Navigation
• /
• v.22 no.2
• /
• pp.39-45
• /
• 1998

CATV(Cable Television) 및 MATV(Master Antenna TV) 시스템용 신호분기기(Tap-Off)의 광대역설계법을 새로운 방법으로 제안한다. 먼저 결합선로형 방향성결합기의 이론을 도입하여 변성기형 방향성결합기에 적용하여 해석하였다. 제안한 해석방법의 타당성을 입증하기 위하여 시뮬레이션한 결과와 실험결과를 비교 검토하였고 전송선로의 임피던스를 매칭시켜 반사계수 20dB, isolation 25dB(5∼1600MHz)을 만족하는 신호분기기(14dB)의 광대역화(5∼2150MHz)를 실현하였다.

• Journal of electromagnetic engineering and science
• /
• v.18 no.2
• /
• pp.73-77
• /
• 2018

This paper proposes a dual-band bandpass filter using stepped-impedance resonators (SIRs) with parallel coupled structures. The proposed filter adopts U-shaped SIRs with parallel coupled lines (PCLs) that have interdigital and comb-line shorted ends. The central PCLs build an upper passband and a transmission zero, and the two U-shaped SIRs build a lower passband. Four resonators and coupling structures are theoretically analyzed to derive its scattering parameters. A novel dual-band bandpass filter is designed and fabricated using the induced scattering characteristics. The measured results show that the fabricated dual-band bandpass filter has an insertion loss of less than 1.02 dB in the lower band of 2.45 GHz and of 3.01 dB in the upper band of 3.42 GHz, and a band-to-band isolation of more than 40 dB, from 3.14 to 3.2 GHz.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.24 no.1
• /
• pp.10-14
• /
• 1987

Considering transition gating of the input unipolar NRZ signal, the equivalent linear time-invariant model has been derived for the PLL in the timing clock recovery circuits. The magnitude of the alignment and accumulated jitter has been found along a chain of repeaters. For the timing recovery circuit of 90 Mbps optical communication system, the computer simulation shows that, for the first stage of the chain, the alignment jiter and the accumulated jitter are of -5.1766 dB and for the 7-th stage, the alignment jitter and accumulated jitter have the value of -1.0193dB, 4.9053 dB respectively.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.24 no.3
• /
• pp.324-330
• /
• 2013

This paper presented measurement results of scattering characteristics of dielectric barrier discharge (DBD) plasma at atmospheric pressure. In this paper, plasma actuator is fabricated by parallel connecting of basic configuration of DBD plasma actuator, then plasma could be generated by applying 14 kV, 4 kHz of high voltage generator. In order to measure the scattering characteristics of DBD plasma, in this paper, two horn antennas and vector network analyzer are used to compare the S-parameter. Because of the structure of fabricated plasma generator, different result is obtained as antenna polarization changes. When antenna polarization is parallel to electrodes of plasma generator, the scattered field is reduced by 2 dB in maximum. In addition, for parallel polarization case, PEC is set up behind the plasma generator to measure backward scattered field. When the observation angles are $40^{\circ}C$ and $60^{\circ}C$, the amount of reduced scattered field is 2 dB in maximum at 5 GHz.

• Proceedings of the IEEK Conference
• /
• 2005.11a
• /
• pp.1273-1278
• /
• 2005

In this thesis, a 2 stage 6-pole bandpass filter(BPF) is designed and implemented by using triple-mode cavity for satellite payload system. The BPF has a 100MHz bandwidth at the center frequency of 14.5GHz(Ku-band) and the response of the filter is the Chebyshev function. The cavity filter uses two orthogonal $TE_{113}$ modes and one $TM_{012}$ mode. The coupling between the adjacent cavityes(intercavity coupling) results in a Chebyshev response and is accomplished by only H-filed component of TE modes. The size and location of intercavity slot is determined by the coupling equation from E- and H-field of TE and TM resonant modes in circular cavity. The 2-stage 6-pole triple-mode cavity BPF has the insertion loss of 2.4dB and the reflection loss of 15dB in the passband. The triple-mode BPF proposed in this thesis can be used as channel filters for satellite payload system and can minimize filter assembly in general wireless communication system.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.12 no.2
• /
• pp.308-315
• /
• 2001

In this paper, a new power amplifier is proposed for reduction of amplified RX band noise signals as well as intermodulation distortion signals using feedforward technique. This power amplifier is implemented for IMT-2000 basestation TX frequency band. Both TX band intermodulation distortion signals and RX band noise signals are reduced by controlling variable attenuator, phase shifter and error amplifier. The proposed power amplifier, which contains two loops-intermodulation distortion signals cancellation loop and RX band noise signals cancellation loop, can provide duplexer with low TX path insertion loss for various wireless communication systems due to choice of loose RX attenuation characteristic. The principle of the proposed amplifier is described graphically based on the conceptual schematic diagram. A two-tone test for power amplifier is done at 2.14GHz with frequency spacing of 5MHz, and RX band rejection test is done over RX full band of 60MHz with 1.95GHz center frequency. Experimental results represent that the cancellation performance of intermodulation distortion signals and RX band noise signals are more than 3 1dB and 21dB, respectively.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.16 no.5 s.96
• /
• pp.488-493
• /
• 2005

In this study, waveguide-to-CPW transitions were developed for integrating waveguide and MMIC at V-band. The finite element method for numerical analysis and repeated experiments were performed to propose two types of waveguide-to-CPW transition. Using quartz substrate, proposed structures were designed for low loss as well as broadband characteristics. These waveguide-to-CPW transitions showed a good reliability and insensitivity to matching precision, and they could be fabricated with lower cost than that of the conventional connectors. Proposed two types of the structure showed insertion loss less than 1.9 dB and return loss better than 14 dB from 53 GHz to 60 GHz except unwanted resonance region, respectively.

• Korean journal of applied entomology
• /
• v.32 no.1
• /
• pp.76-82
• /
• 1993

Phonotaxis of the African mole cricket, Gryllotalpa africana palisot de Beauvois, was investigated in 1990 and 1992 at the agronomy Experiment Station of Korea Ginseng & Tobacco Research Institute in Hwaseong-gun, Kyonggi-do, Male adults produced calling sounds (calling songs) through the openings of subsurface burrows. Intensities of the sound were 77-80 dB at 15 cm above the openings. When tape recordings of male calling songs were broadcasted outdoors at 105-110 dB by two horn speakers installed at the center of a 1.4 m diameter-funnel, flying adults were attracted for 1.5 hours from about 30 minutes after sunset. Among attracted adults, 14.3-16.9% landed in the funnel, and 65.7-74.7% landed on the ground within 2m form the sound source. Females were 66.7-74.3%, which seemed to be due to the sex ratio of the population in the field. Adults landing in the funnel and at the distance of within 2m from the center of the funnel were tend to be a little more than those attracted to a blacklight trap.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.15 no.12
• /
• pp.2527-2533
• /
• 2011

In this paper we propose a new pre-processing algorithm applied to multi-view video coding using color compensation algorithm based on image features. Multi-view images have a difference between neighboring frames according to illumination and different camera characteristics. To compensate this color difference, first we model the characteristics of cameras based on frame's feature from each camera and then correct the color difference. To extract corresponding features from each frame, we use Harris corner detection algorithm and characteristic coefficients used in the model is estimated by using Gauss-Newton algorithm. In this algorithm, we compensate RGB components of target images, separately from the reference image. The experimental results with many test images show that the proposed algorithm peformed better than the histogram based algorithm as much as 14 % of bit reduction and 0.5 dB ~ 0.8dB of PSNR enhancement.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.14 no.11
• /
• pp.2391-2396
• /
• 2010

The power-controlled six-port element that can control the local oscillator signal power and receiving RF signal power was designed and implemented in this paper. The direct conversion six-port element configuration was proposed, which provides the constant six-port output power by controlling the six-port input power with various signal strength. The direct conversion six-port element protects the power detector element of six-port receiver from the saturation status and compensates the transmission performance degradation. For implementation of power-controlled six-port element, the power-controlled six-port element including the power controller was analyzed. The implemented power-controlled six-port element shows the power control capability of 36 dB and gain imbalance of about 1.6 dB, phase imbalance of about $4^{\circ}$ in the frequency range of 1.69 GHz. The measured results show the good performance as direct conversion front-end element.