• Journal of Advanced Navigation Technology
• /
• v.28 no.1
• /
• pp.136-141
• /
• 2024

In this paper, a broadband inset-fed microstrip patch antenna operating at 10.525 GHz band was proposed. The proposed broadband inset-fed microstrip patch antenna consists of three narrow rectangular patches. At the center of the center patch, two symmetrical side patches were connected by a strip conductor and were arranged with their centers shifted in a perpendicular direction with respect to the center patch. For performance comparison, a conventional inset-fed square microstrip patch antenna was designed. Experiment results show that the frequency band of the measured input reflection coefficient with a voltage standing wave ratio less than 2 for the broadband inset-fed microstrip patch antenna was 10.036-11.051 GHz (9.63%), whereas that for the conventional inset-fed rectangular microstrip patch antenna was 10.306-10.772 GHz (4.42%). Therefore, the input reflection coefficient frequency bandwidth of the fabricated broadband inset-fed microstrip patch antenna was increased by 2.18 times, compared to the conventional inset-fed square microstrip patch antenna.

• The Journal of Korean Institute of Information Technology
• /
• v.16 no.11
• /
• pp.61-68
• /
• 2018

This paper describes design of a 10.525 GHz self oscillating mixer semiconductor IC chip combining voltage controlled oscillator and frequency mixer using silicon CMOS technology for Doppler radar applications. The p-core type VCO included in the self oscillating mixer minimizes the noise contained in the transmitted signal. This noise minimization increases the sensing distance and acts in a direction favorable to the reaching distance and the sensitivity of the motion detection sensor. Simulation results for phase noise show that a VCO designed as a P-core has a noise characteristic of -106.008 dBc / Hz at 1 MHz offset and -140.735 dBc / Hz at 25 MHz offset compared to a VCO designed with N-core and NP-core showed excellent noise characteristics. If a self-oscillating mixer is implemented using a p-core designed VCO in this study, a motion sensor with excellent range and reach sensitivity will be produced.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.5 no.7
• /
• pp.1210-1218
• /
• 2001

In this paper, A X-band voltage-controlled hair-pin resonator oscillator(VCHRO) is able to a local oscillator or a signal source in transmitter/receiver of a microwave communication system for mobile radar, is designed and fabricated In order to apply mobile radar system is used the hair-pin resonator stronger on shock or vibration than the dielectric resonator, and also, in order to improvement the phase noise and output power is used a system of serial feedback format A hair-pin resonator was simulated by momentum method of HP ADS and then a oscillator circuit was designed that operates at 10.525 GHz by nonlinear method in harmonic balance simulation. The HRO generated output power of 6.93 dBm at 10.525 GHz, phase noise of -57.74 dBc at 100 kHz offset from carrier and the 2'nd harmonic was suppressed -23.90 dBc.

• Journal of Navigation and Port Research
• /
• v.26 no.5
• /
• pp.525-528
• /
• 2002

The proposed EMC filter composed with feed-through capacitors and ferrite beads of high permeability was prepared which satisfy the EMC standard for a wide-band noise signal in the frequence of 10 MHz to 1.5 GHz in power supply line. The optimum structure of ferrite bead was found by calculating the load effect of ferrite beads. As a result, the filter showed excellent differential- and common-mode noises filtering characteristics above 30dB in the frequency band from 10 MHz to 1.5 GHz. The immunity characteristics are improved more than 10 to 30 dB over the frequency band from DC to 1.8GHz.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.15 no.1
• /
• pp.31-38
• /
• 2020

In this paper, we propose a quadruple band antenna for GPS/WLAN/WiMAX application. The proposed antenna has quadruple band characteristics by considering the interconnection of four strip lines and DGS on the ground place. The total substrate size is 20.0 mm (W1) ⨯27.0 mm (L1), thickness (h) 1.0 mm, and the dielectric constant is 4.4, which is made of 20.0 mm (W2)⨯ 27.0 mm (L8 + L6+ L10) antenna size on the FR-4 substrate. From the fabrication and measurement results, bandwidths of 60 MHz (1.525 to 1.585 GHz) bandwidth for GPS band, 825 MHz (3.31 to 4.135 GHz) bandwidth for WiMAX band and 480 MHz (2.395 to 2.975 GHz) and 385 MHz (5.10 to 5.485 GHz) bandwidth for WLAN band were obtained on the basis of -10 dB. Also, gain and radiation pattern characteristics are measured and shown in the frequency of triple band as required.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.7 no.6
• /
• pp.1287-1292
• /
• 2012

In this paper, a dual polarization patch antenna operates at the wide bandwidth of 1.525GHz~1.665GHz was designed and fabricated. To obtain the wide bandwidth and high gain, increased height of air floor from GND was applied, and to get wide band axial ratio and high gain, parasitic patch was applied. The simulation and measurement showed good agreements, the VSWR was less than 1.9 at the frequency bandwidth, the return loss was less than -10dB, and the LHCP(Left Hand Circular Polarization) and RHCP(Right Hand Circular Polarization) isolation was less than -13dB at the frequency bandwidth.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.4 no.2
• /
• pp.75-81
• /
• 2009

In this paper, Microwave doppler radar sensor operated in 10.525GHz is designed by dielectric resonant oscillator. According to doppler effects, a characteristic of Microwave sensor with FMCW was analyzed. The qualities of objects velocity and distance between object and microwave sensor by sensor output frequency difference was measured. As a result of Microwave doppler radar sensor, the prototype sensor is available for indoor burglar alarms and other application through FMCW signal.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.21 no.2
• /
• pp.514-525
• /
• 1996

In this paper, Push-push Osciplier(Oscillator + Multiplier) has been analyzed by even-odd mode analysis method. A 10GHz DRO, an Osciplier using 10GHz DRO design method and an Osciplier using even-odd mode analysis method were designed, fabricated and tested to verify this method. The measured results verified the validity of the analysis method using even-odd mode analysis.

• Proceedings of the Korea Information Processing Society Conference
• /
• 2019.10a
• /
• pp.34-37
• /
• 2019

The drone uses a Microwave Doppler Radar Sensor which operates at 10.525GHz to recognize harmful animal which intruded into the arable land. Moreover provide user with notification services on risk factors. Subsequently, the user the drone's camera and a camera-only app to watch the farmland in real-time, steer the drone directly, and use the NeoPixel LED ring and the speaker to stimulate the harmful animal's sight and hearing to induce escape.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.6 no.4
• /
• pp.519-526
• /
• 2002

In this paper, a microstrip patch array antenna for a Doppler radar at 10.525GHz is desinged and fabricated. To be used for mobile radar system, the antenna is fabricated on a single layer laminate to resist a fire impact and is covered with the Teflon foam. To obtain the desired characteristics, the array antenna is designed 4$\times$8 array using a corporate 3-dB amplitude taper. Also, using square patch elements, the antenna can be converted to a circular polarized antenna later. The designed and fabricated array antenna has the reflection coefficient$({S_11})$ -53.498dB, the horizontal beam width of $10^{\circ}$, the vertical beam width of $18.8^{\circ}$, the gain of 21dBi, the bandwidth of 220MHz for VSWR<1.5 and a side lobe level of less than -17.5dB.