• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.10 no.6
• /
• pp.1292-1297
• /
• 2009

This study was performed to investigate solubility, dissolution rate and ash content of solid type fuel additive in gasoline and diesel in order to set up manufacturing standards. From the results, the unfiltered impurities were increased when the fuel additive was added on gasoline and diesel. Also, the unfiltered fuel additive was decreased with respect to increasing the pore size of the filter paper. When one gram of the fuel additive was dissolved in one liter of gasoline at room temperature, the best dissolution rate was about 2 hours. But, almost nothing was dissolved in diesel during 72 hours at $20^{\circ}C$ below zero. At the experiment of ash content, the gasoline which the fuel additive was melted in was showing 28 times more ash content than that was not including the fuel additive. Therefore, it seemed that almost all of ash content was caused by the fuel additive.

• Journal of Energy Engineering
• /
• v.8 no.1
• /
• pp.119-126
• /
• 1999

본 연구는 polysulfone 막을 표면처리 하여 오일 폐수를 한외여과 처리하였고 이때 fouling의 감소효과를 실험하였다. 고분자나 계면활성제를 polysulfone막에 흡착시켜 표면처리를 하였다. 다양하게 표면처리된 막으로 dodecane(0.1 v%)/물 에멀젼과 dodecane-계면활성제/물 에멀젼을 회분식 실험방법으로 수행하였다. SDS로 개질한 막으로 dodecane-계면활성제/물 에멀젼을 환외여과 처리하였을 때 fouling이 가장 작게 나타났고, 재사용에 좋은 방법으로 나타났다.

• Proceedings of the Korea Society for Energy Engineering kosee Conference
• /
• 1998.10a
• /
• pp.134-137
• /
• 1998

표면처리 한 UF 막으로 오일/물 에멀젼과 오일-SDS/물 어멜젼을 한외여과 시험하였다. 고분자와 계면활성제를 polysulfon막에 흡착시켜 표면을 처리하였다. 오일-SDS/물 에멀젼의 한외여과는 SDS양을 변화시키면서 수행하였다. 다양한 표면처리 한 막으로 한외여과 실험을 회분식 실험방법으로 수행하였다. 표면처리 안한 막에 대한 오일 에멀젼 한외여과시 fouling의 주요 원인이 오일 에멀젼의 흡착이며, 막의 표면처리와 오일 에멀젼에 계면활성제의 주입으로 뚜렷한 fouling의 저감효과가 있었다.

• Journal of Industrial Technology
• /
• v.27 no.A
• /
• pp.203-209
• /
• 2007

본 연구는 목재로서 활용가치가 적은 수피(bark)를 활용하여 수질오염물질을 제거할 수 있는 여과 시스템에 대한 기초연구로서 소나무의 일종인 loblolly pine(Pinus taeda L.) 수피의 인 ($PO_4-P$) 흡착특성을 연구하였다. 실험에 사용된 수피는 입상형태로서 polyallylamine hydrochloride로 전처리하여 회분식 등온 흡착실험을 수행하였다. 회분식 등온흡착실험은 수용액 pH 3~pH 8범위에서, 인의 농도별(10, 20, 30, 40 mg/L)로 수행하였다. pH 5에서 가장 높은 인 제거 효율을 나타냈으며, 수용액의 pH는 실험 후 pH 3으로 감소하였다. 이러한 감소는 수피에 의한 phosphate의 흡착이 Lewis acid-base 반응으로서 이 과정에서 $H^+$의 방출로 인하여 나타난 현상인 것으로 여겨지며, 주된 반응 메카니즘은 더 연구할 필요성이 있다. 인 흡착은 초기에 빠른 속도로 진행되었으며 대략 200분 이후에 평형에 도달하였고, 시간이 지날수록 흡착양이 증가하는 경향을 보였다. 인의 흡착특성 결과는 Langmuir 등온흡착식과 Freundlich 등온흡착식으로 설명될 수 있으며, 등온흡착식 적용결과, 흡착제에 대한 최대 흡착능은 7.14 mg/g 이며 다른 흡착제와 비교하여 더 높았다. 실험결과와 모델에 의한 흡착능을 비교하고자 pseudo second-order model을 적용하여 흡착 동역학 상수를 구하였다. 또한 EDXA분석으로 회분식 흡착실험 후 수피와 인이 결합되어있는 것을 확인할 수 있었다.

• Proceedings of the Membrane Society of Korea Conference
• /
• 1997.04b
• /
• pp.45-47
• /
• 1997

정밀여과 및 한외여과에 의해 단백질 등과 같은 거대분자 물질을 분리정제할 경우 피할 수 없는 문제점은 막에 의해 분리된 거대부자들이 막표면에 쌓이는 농도분극(concentration polarization)현상과 이 누적된 거대분자가 막과의 상호작용에 의해 막표면 또는 막세공 내에 비가역적으로 침적되는 막오염(membrane fouling)현상이 일어난다는 점이다. 특히 막표면 또는 막세공 내에 분리대상 물질이 비가역적으로 침적되어 발생되는 막오염은 상대적으로 가역적 침적 과정인 농도분극보다 제어 또는 억제가 어려워 최근의 막분리 분야 연구의 상당 부분이 막오염 유발요인의 해석, 막오염을 효율적으로 제어 또는 억제하기 위한 방법의 연구에 집중되고 있다. 본 연구에서는 단백질 용액의 정밀여과시 단백질 변성이 막오염에 미치는 영향을 체계적으로 규명하기 위한 연구의 일환으로서 BSA를 분리대상 물질로하여, BSA용액을 미리 기계적 Shear(펌프 및 sonification), 열, 화학적 방법(pH 및 변성제)으로 변성시킨 후, 이 용액을 대상으로 회분식 정밀여과 실험을 수행하여 단백질 응집체 형성이 막투과량 감소에 미치는 영향을 실험적으로 검토하였으며, 각각의 막투과량 감소 특성을 아래의 4가지 blocking filtration law로서 해석하였다: complete blocking law, intermediate blocking law, standard blocking law, cake filtration law.

• Korean Chemical Engineering Research
• /
• v.43 no.6
• /
• pp.696-703
• /
• 2005

The definition of cake is not established for cake filtration, and especially the definition was impossible for the filtration of the floc already sedimented. The definition is proposed with the experimental method named 'filtration-permeation'. The limit of water content which can be achieved with cake filtration of floc was established with the definition of cake. The expression operation of which the purpose is to reduce the water content of pre-formed filter cake is calculated with our 'unified theory on solid-liquid separation' and compared with the experimental results. The importance of expression is analyzed by the calculated whole procedure of cake filtration and expression. The method determining the most effective operational conditions of filter press including the cake discharge and washing time is proposed.

• Journal of Korean Society of Environmental Engineers
• /
• v.34 no.6
• /
• pp.406-413
• /
• 2012

Effect of three additives, chitosan, ferric chloride, and MPE50 on membrane fouling reduction was studied. They were introduced with various dosing rate into activated sludge, and changes in filtration resistance measured by the batch cell filtration test were evaluated. Both the filtration resistance and the specific cake resistance were minimized at 20 mg/g-MLSS with chitosan, 70 mg/g-MLSS with ferric chloride, and 20 mg/g-MLSS with MPE50 addition, respectively. Introduction of the additives into the activated sludge resulted in reduction of not only cake resistance, but also fouling resistance. However, the chitosan addition to three different activated sludge resulted in three different optimal dose of 10, 20, 30 mg/g-MLSS, respectively. This implies that the optimal dose is dependent on sludge characteristics rather than a constant value. Overdose above the optimal dosage always aggravated filterability in all cases. Zeta potential of sludge flocs, relative hydrophobicity, floc size distribution, soluble EPS concentration and supernatant turbidity were measured in order to analyze fouling reduction mechanism. Nearly neutral surface charge along with the largest particle size was observed at the optimal dose. This could be explained by particle destabilization and restabilization mechanism as positively charged additives were injected into sludge flocs of negative surface charge. Both soluble EPS concentration and supernatant turbidity also showed the lowest value at the optimal dose. These foulants are believed to be coagulated and entrapped in sludge flocs during flocculation. Chitosan and MPE50 which are cationic polymeric substances showed higher reduction in both soluble EPS and fine particles comparing with ferric chloride.

• Journal of Korean Society of Environmental Engineers
• /
• v.37 no.3
• /
• pp.182-190
• /
• 2015

This study was conducted to evaluate the removal efficiencies of organic matter and pharmaceuticals and to identify the removal mechanism of pharmaceuticals using sand obtained from Hwangryong River in Jangsung. Batch and column studies were used to simulate managed aquifer recharge (MAR) systems. All experiments were performed using field effluent containing pharmaceuticals from Damyang Wastewater Treatment Plant as an influent. Based on the removal results of organic matter and pharmaceuticals from the batch and column experiments, soil organic matter (SOM) and microbial activity were found to effectively remove target contaminants. The removal of organic matter was found to increase under biotic conditions. Neutral and cation pharmaceuticals (iopromide, estrone, and trimethoprim) exhibited removal efficiencies higher than 70% from natural sand and baked sand media in batch and column studies. Carbamazepine persisted in the sand batch and column studies. Anion pharmaceuticals (ketoprofen, ibuprofen, and diclofenac) can be removed under conditions featuring high SOM and adenosine triphosphate (ATP) concentrations in the sand surface. Based on the experimental Batch and column results, biodegradation and sorption were found to be important mechanisms for the removal of pharmaceuticals within the simulated MAR systems.

• Journal of Navigation and Port Research
• /
• v.30 no.3 s.109
• /
• pp.241-245
• /
• 2006

Displayed result that handle particle contaminant and hydrospace organism included a number of ballast that is happened in ship using automatic back washing filter. Reason that removes first contaminant that is included in number of ballast is that heighten processing effectof after processing processof the filter. Another advantage is to drop off the solids with controlling revolution of drum screen in pretreatment filtration process. The fact that it is easy to attach and detach a several type of screen for getting the expected water quality is another advantage. Filter rotation speed of filtration filter could be expose by 35mmHg more than 60 rpm and filter consecutively filtration pressure is 40.5mmHg in 20 rpm and 40 rpm are 36.6mmHg. Filtration system removal aquatic organism over $70{\mu}min$ ballast water. This study shows that the filtration treatment system has a potential for the treatment of ballast water.

• Journal of Aquaculture
• /
• v.16 no.2
• /
• pp.76-83
• /
• 2003

To improve the efficiency of removal of bacteria and virus with DynaSand Filters used for treatment of recycling wastewater from aquaculture, effect of biofilm formation on bacterial transport through coated sand was estimated. At the neutral pH (pH 7.0), the coated sand was positive of zeta potential (surface charge). Column experiments were also carried out to test the effect of uncoated sand as well as coated sand with Al and Fe. The coated sand influenced more significantly the surface properties, adsorption and transport than the uncoated sand. The leaching batch system investigated for synthetic water showed concentrations of 7.47, 4.80, 20.89 and 7.23 mg/L for the uncoated sand, coated sand with Al, Fe and Al+Fe, respectively. Hence there are significant differences among the tested coatings with reference to bacterial transport and surface properties.