• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.35 no.2
• /
• pp.275-285
• /
• 2015

This experimental study presents the fatigue evaluation of a precast deck connected using Ultra-High Performance, Fiber Reinforced Concrete (UHPFRC). Four types of two identical large-scale specimens were fabricated with simplified splice rebar details which had a short splice length of ten times rebar diameter. The flexural behavior of each type of specimens until failure was investigated and fatigue behavior of the same type of specimens was then evaluated using two-million cyclic loading. In the flexural tests, tensile rebars exhibited the deformation exceeding yielding strain but failure mode related to the splice details was not observed in spite of such a short splice length. In the fatigue tests, damage was not appreciably accumulated by the cyclic loading except initial flexural cracks and the stress variations in tensile rebars was less than the allowable stress range. These experimental results demonstrate that all types of specimens exhibited acceptable fatigue performance and indicate that enhanced mechanical properties of ultra-high performance material permits to use a simplified splice details along with short joint width.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.31 no.5D
• /
• pp.739-747
• /
• 2011

The paper presents implementation & evaluation of survey method with tilted transducer of Multi Beam Echo Sounder (MBES) to increase horizontal & vertical coverage over obstructed port environments with limited physical properties of MBES. Proposed method ($25^{\circ}$ titled transducer) have some discrepancy of bathymetric profiles between normal and tilting method, but we proved average difference is less than IHO Special Order requirements with survey data at port of Dong Ho Port, Masan, Korea. For horizontal mapping coverage of total survey area ($114,961m^2$), normal method covered 53%, $60,895m^2$ of total area but tilting method covered 75%, $5.933m^2$. It is 22% efficient than normal method with similar environments. For vertical mapping coverage of total vertical structure face ($7,421m^2$), normal method covered 14%, $1,046m^2$, proposed methods covered 60%, $4,450m^2$. And we adapt longitudal steel bar to validate MBES results, and provide calibration method with titled transducer of MBES.

• Progress in Medical Physics
• /
• v.9 no.4
• /
• pp.201-206
• /
• 1998

IMRT optimization method on multiple slice has been developed by using gradient based algorithm. On about 10-30 CT slices including treatment region of a patient, dose optimization has been performed slice by slice to meet the condition that each organ should be exposed below maximum tolerable doses and that the tumor dose within the range of 100$\pm$5 %. Field size was limited to 8$\times$8 cm$^2$ and in this condition, beam divergence was not taken into account to calculate dose distribution. Total dose distribution was calculated by superposing each beamlet whose dose distribution had been precalculated. In order to investigate beam number dependency, dose optimization was performed for one, three, five, seven, and nine coplanar beams and then each optimization index was evaluated. It is found that optimization time was proportional to number of slices to be optimized, and the most efficient plan was obtained from the case of three-to-seven incident beams with respect to calculation time and optimization index. In conclusion, dose optimization of multiple slice was able to be obtained by repeating dose optimization of single slice under condition that the beam size is not too large to ignore beam divergence. And it turns out that result of dose optimization was so sensitive to the position of isocenter that some method to optimize isocenter position is needed to improve it.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.21 no.1
• /
• pp.768-773
• /
• 2020

In large-scale land development for the rational use and management of national land resources, the use of geospatial information is essential for the efficient management of projects. Recently, drone LiDAR (Light Detection And Ranging) has attracted attention as an effective geospatial information construction technique for large-scale development areas, such as housing site construction and open-pit mines. Drone LiDAR can be classified into a method using SLAM (Simultaneous Localization And Mapping) technology and a GNSS (Global Navigation Satellite System)/IMU (Inertial Measurement Unit) method. On the other hand, there is a lack of analytical research on the application of drone LiDAR or the characteristics of each method. Therefore, in this study, data acquisition, processing, and analysis using SLAM and GNSS/IMU type drone LiDAR were performed, and the characteristics and utilization of each were evaluated. As a result, the height direction accuracy of drone LiDAR was -0.052~0.044m, which satisfies the allowable accuracy of geospatial information for mapping. In addition, the characteristics of each method were presented through a comparison of data acquisition and processing. Geospatial information constructed through drone LiDAR can be used in several ways, such as measuring the distance, area, and inclination. Based on such information, it is possible to evaluate the safety of large-scale development areas, and this method is expected to be utilized in the future.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.44 no.12
• /
• pp.1793-1798
• /
• 2015

Antioxidant activities of various solvent extracts from Coriolus versicolor were investigated for their total polyphenol content, total flavonoid content, 1,1-diphenyl-2-picrylhydrazyl (DPPH) radical scavenging activity, and 2,2'-azino-bis(3-ethylbenzothiazoline-6-sulfonic acid) (ABTS) cation radical scavenging activity. C. versicolor extracts were produced by organic solvents such as ethanol, ethyl acetate, and methanol. Total polyphenol and flavonoid contents in the ethanol and ethyl acetate extracts were higher than those in the methanol extract. DPPH radical scavenging activity of methanol extract showed the highest value of 80.3%, which was similar to that of ascorbic acid (85.5%). All extracts showed good (>90.0%) ABTS cation radical scavenging activity. The antimicrobial activities of these extracts from C. versicolor were evaluated against six strains of bacteria using the disc diffusion method. All extracts showed antimicrobial activities against all tested bacteria except Staphylococcus aureus. These results indicate that various extracts from C. versicolor could be useful as natural antioxidant and antimicrobial agents.

• Journal of Korea Water Resources Association
• /
• v.48 no.3
• /
• pp.149-158
• /
• 2015

It is well known that emergency outlet works have to be provided for the safety of dams. However, concept of emergency outlet works did not applied for the design of the most dams in Korea. Korean design standard for low-level outlet works does not provide enough design criteria which could be used in design of emergency outlet works. In this research, as-built status and hydraulic design criteria of outlet works, such as drawdown rate or hydraulic pressure due to the impounded water depth, were examined. Another relationship between drawdown rate and the dam slope stability was also examined with SEEP model. It was found that 25% reduction of impounded water depth decreases the pressure forces about 50%. Therefore, outlet works should be designed to drawdown properly at the beginning of the emergency. Seepage analysis of dam bodies showed that most of Korean dams could safely stand for 1m/day drawdown rate. Higher drawdown rate could result high discharge so the drawdown rate must be related with the flood risk of downstream. Finally, multi-stage design was recommended that faster discharge for the initial 25% of water depth in 7-10 days than the rest of it in 1-2 months.

• Journal of the Korean Geosynthetics Society
• /
• v.19 no.3
• /
• pp.9-21
• /
• 2020

In this study, the design method of the combined sheet pile was considered in the coastal landfill where sandy and clayey soils are mixed, and the behavior in excavation was analyzed. It was confirmed from the elasto-plastic analysis that the predicted behavior of the temporary facilities of earth retaining differs according to the type of the combined sheet pile method (Built up, Interlocking, Welding) and the analysis method (soldier pile method, continuous wall method). In the case of sheet pile member force, the results of the continuous wall analysis method predicted the most conservative results. When the stress ratio (calculation/allowance) of each member was analyzed based on the maximum member force of the combined sheet pile method, the maximum value was obtained for bending moment in the side pile and combined stress in the case of the strut. As a result of finite element analysis, the member force of the side pile was the largest in the short-term effective stress analysis condition, while the compressive force of the strut was large in the consolidation analysis. When comparing the results of the elasto-plastic analysis and the finite element analysis, the shear force of the side pile and the axial force of the strut were greatly evaluated in the elasto-plastic analysis, and the bending moment of the side pile was the largest in the short-term effective stress condition of the finite element analysis. In addition, the displacement of the side pile was predicted to be greater in the finite element analysis than in the elasto-plastic analysis.

• The Korean Journal of Pesticide Science
• /
• v.2 no.1
• /
• pp.65-69
• /
• 1998

To determine the amount of total bromide as 2-bromoethanol, the domestic agricultural products such as rice, barley, carrot, cucumber, apple, tomato, squash, green pepper, melon, strawberry, grape, peach, potato and celery were analyzed by GC/MSD as well as GC/ECD. The bromide was detected in most of the domestic samples and the highest bromide residue determined was 13.2 ppm in barley. The imported agricultural products including melon, kiwi, lemon, pineapple, banana, orange and grape were also analyzed for the bromide. The bromide was also detected in most of the imported ones and the highest bromide residue determined was 12.3 ppm in pineapple. In addition, the bromide residue in instant noodle spices was monitored for 4 years, recently. As results, in 1994, the bromide content was in the range of non-detection to 2.4 ppm (average 1.1 ppm) from 22 out of 24 samples; in 1995, the bromide content was 1.0 and 2.2 ppm from 2 out of 37 samples; in 1996, the bromide content was in the range of 0.7 to 37 ppm (average 12.4 ppm) from all 11 samples; and in 1997, the bromide content was in the range of 0.2 to 4.6 ppm (average 1.2 ppm) from all 59 samples. However, none of sample analyzed for the bromide was exceeded Maximum Residue Limit(s) of Korea and Codex in these survey.

• Journal of Korean Society of Transportation
• /
• v.35 no.1
• /
• pp.79-89
• /
• 2017

The purpose of this study is to analyze the current right-turn operation at signalized intersections and suggest appropriate right-turn operation strategy. From field investigation, right-turn signals have not only operated various type and shape, lacking of consistency, but also there was no clear regulations or standards. It could increase drivers' confusion and cause vehicle-to-pedestrian accidents. In order to improve pedestrian safety, there is urgent need to study the regulations and standards regarding to right-turn traffic control. This study suggests appropriate right-turn signal operation strategy. In case of permissive right-turn operation, it should be stated on regulations that red light means right-turn vehicles must stop temporarily at the stop line and then turn right. Necessary conditions for installing right-turn signal for protected operation are that there should have one or more exclusive right-turn lanes and right-turn signal face should contain the lenses with three-color arrow indication. In addition, we assort right-turn operation types as permissive, protected and protected/permissive right-turn and suggest specific signal operation strategy by the types.

• Journal of the Korean Society for Library and Information Science
• /
• v.46 no.4
• /
• pp.169-188
• /
• 2012

This study aimed to analyze the characteristics of the bibliographic description of ISBD Consolidated edition published in 2011 and to grasp the considerations in applying the rules of ISBD consolidated edition to KCR4. For achieving this, the four aspects were analyzed such as the description area and data elements, the resource types, the punctuation, and the order of the elements of ISBD Consolidated edition(2011). The characteristics of ISBD Consolidated edition are as follows. First, the content form and the media type area are added in new 0 area and elements are designated by mandatory to confirm to FRBR. Second, content form, content qualification and media type replaced GMD in title and statement of responsibility area. Third, the prescribed punctuations were retained even when this results in double punctuation, and individual square brackets were preferred than entire square brackets when using square brackets to all elements in same area. Fourth, the order of elements in description was set out by patterns of data elements in areas, therefore could reduce the confusion of the order of elements. ISBD Consolidated edition as an international standard would make various rules to maintain the uniformity, but also respects the bibliographic practices of individual countries. Therefore, each country must revise its own rule to conform the ISBD Consolidated edition as well as reflect its unique situation. In Korea, since KCR4 was developed based on the previous edition of ISBD, it should be revised to confirm to the ISBD Consolidated edition. Therefore, this study is expected to contribute to the revision of KCR4.