• The Sea:JOURNAL OF THE KOREAN SOCIETY OF OCEANOGRAPHY
• /
• v.8 no.4
• /
• pp.392-400
• /
• 2003

We used an oxygen microelectrode to measure the vertical profiles of oxygen concentration in sediments located near point sources of organic matter. The measurements were carried out between 13th and 17th May, 2003, in semi-closed bay and coastal sediments in the central part of the South Sea. The measured oxygen penetration depths were extremely shallow and ranged from 1.30 to 3.80 mm. This suggested that the oxidation and reduction reactions in the early diagenesis should be studied at the mm depth scale. In order to estimate the oxygen consumption rate, we applied the one-dimension diffusion-reaction model to vertical profiles of oxygen near the sediment/water interface. Oxygen consumption rates were estimated to be between 10.8 and 27.6 mmol O$_2$ m$\^$-2/ day$\^$-1/(average: 19.1 mmol O$_2$ m$\^$-2/ day$\^$-1/). These rates showed a positive correlation with the organic carbon of the sediments. The corresponding benthic organic carbon oxidation rates calculated using an modified Redfield ratio (170/110) at the sediment/water interface were in the range of 89.5-228.1 mg C m$\^$-2/ day$\^$-1/(average: 158.0 mg C m$\^$-2/ day$\^$-1/). We suggest that these results are maximum values at the presents situation in the bay because the sampling sites were located near point sources of organic materials. This study will need to be carried out at many coastal sites and throughout the seasons to allow an understanding of the mechanisms of eutrophication e.g. the spatial distribution of oxygen consumption within the oxic zone and hypoxic conditions in the coastal sea.

• Journal of Korean Tunnelling and Underground Space Association
• /
• v.17 no.3
• /
• pp.295-303
• /
• 2015

This paper presents the study of leakage effect due to multi-cell inflater of rapid protection system to protect the possibilities of tunnel damages by flooding threats and unusual leakage to be occurred during and after subsea tunnel construction. Particularly, this protect system should be necessary in subsea tunnel. This research concentrates the physical model tests due to several multi-cell inflater to study protection capacity of leakage between the inflater and tunnel liner. A 27:1 small scale model are used in the model tests. The leakage rate, water pressure and axial displacement of inflater are measured during the model tests. According to the results, the minium leakage rate clearly shows in the case of two-cell inflater compared with in other cases. It is concluded that the results of this research will be very useful to understand the fundamental information of inflater structure design and development the technology of tunnel protection structures in the future.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.24 no.2
• /
• pp.97-108
• /
• 2012

A Lagrangian particle tracking model coupled with the ECOM3D were used to study on the behavior of fresh water released from the Namgang Dam in terms of residence time in Kangjin Bay, South Sea, Korea. Model was calibrated until skill cores for elevation, velocity, temperature and salinity are satisfied over 85%. In the numerical simulation, particles were released in 1 hour time interval from the northern boundary. The different patterns of particle trajectory are identified under the varying dynamics from tidal to density-driven current. The average residence time of total particles are approximately 65.9 hours in the entire Kangjin Bay. The average residence time were increased from 55~65 to 70~80 hours during maximum discharge period. Discharge rate of fresh water and average residence time in the Kangjin Bay is high correlated with correlation coefficient over 0.81.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.23 no.7
• /
• pp.113-119
• /
• 2019

Concrete structures built on reclaimed land are combined with chemical erosion such as chlorine and sulfate ions from seawater. Chloride attack deteriorates the performance of the structure by corroding reinforcing bars. In addition, the waste water treatment structure has a problem that the concrete is deteriorated by the sulfate generated inside. Therefore, in this study, the characteristics and chemical resistance of low heat cement concrete used in wastewater treatment structures constructed on reclaimed land were evaluated. As a result of the experiment, the target slump and air content were satisfied under all the mixing conditions. The slump of low heat cement (LHC) concrete was higher than that of ordinary portland cement (OPC) concrete, while the air content of LHC concrete was smaller than that of OPC concrete with the same mix proportion. As a result of compressive strength test, OPC concrete showed higher strength at younger age compared to 28 days. In contrast, LHC concrete exhibited higher strength than OPC concrete at the age of 56 days. As a result of chlorine ion penetration tests, LHC-B concrete showed chlorine ion penetration resistance performance of the "very low" level at the age of 56 days. As a result of chemical resistance evaluation, when the LHC concrete is applied without epoxy treatment, chemical resistance is improved by about 18% compared to OPC concrete. In testing chemical resistance, the epoxy coated concrete exhibited less than 5% strength reduction when compared to sound concrete.

• Korean Journal of Remote Sensing
• /
• v.28 no.1
• /
• pp.121-128
• /
• 2012

High resolution intertidal DEM is a basic material for science research like sedimentation/erosion by ocean current, and is invaluable in a monitoring of environmental changes and practical management of coastal wetland. Since the intertidal zone changes rapidly by the inflow of fluvial debris and tide condition, remote sensing is an effective tool for observing large areas in short time. Although radar interferometry is one of the well-known techniques for generating high resolution DEM, conventional repeat-pass interferometry has difficulty on acquiring enough coherence over tidal flat due to the limited exposure time and the rapid changes in surface condition. In order to overcome these constraints, we tested the feasibility of radar interferometry using Cosmo-SkyMed tandem-like one-day data and ERS-ENVISAT cross tandem data with very short revisit period compared to the conventional repeat pass data. Small temporal baseline combined with long perpendicular baseline allowed high coherence over most of the exposed tidal flat surface in both observations. However the interferometric phases acquired from Cosmo-SkyMed data suffer from atmospheric delay and changes in soil moisture contents. The ERS-ENVISAT pair, on the other hand, provides nice phase which agree well with the real topography, because the atmospheric effect in 30-minute gap is almost same to both images so that they are cancelled out in the interferometric process. Thus, the cross interferometry with very small temporal baseline and large perpendicular baseline is one of the most reliable solutions for the intertidal DEM construction which requires very accurate mapping of the elevation.

• Journal of Korean Society of Environmental Engineers
• /
• v.28 no.6
• /
• pp.620-625
• /
• 2006

In this investigation, an ICP-DRC/MS method to measure arsenic with ultra-trace concentration without any interference by the compounds such as $^{40}Ar^{35}Cl^+\;and\;^{40}Ca^{35}Cl^+$, which disturb the precise measurement of arsonic was described. Thus, the oxgen was introduced into the dynamic reaction cell as reaction gas and reacted with arsenic ion created in plasma gas, $AsO^+$ was formed and detected with m/z of 91 by ICP-MS. It resulted in better detection limit than the old method with m/z of 75($As^+$). The optimum condition for oxygen supply as the reaction gas was 0.5 mL/min. The analytical features of the method are as follows: detection limit of $0.02{\mu}g/L$, precision(RSD) of 3.4%, and recovery of 96%. Arsenic in the water samples from the tributary streams to the Han River and the main stream of Paldang were analyzed with this method to identify the characteristics in its distribution. The concentration of As ranged from 0.53 to $1.26{\mu}g/L$. We could measure As with very low concentration, less than $1.0{\mu}g/L$, with excellent reproducibility. The method developed is expected to be applied to analyze As of the samples from sea water, food, and domestic and industrial waste water which have high concentration of Cl and/or Ca.

• Journal of the Korean Applied Science and Technology
• /
• v.32 no.4
• /
• pp.740-747
• /
• 2015

This research was performed to evaluate the feasibility of in situ soil flushing for TPH-contaminated soil remediation. It was conducted in batch test as fundamental research for in situ soil flushing. The 30% of initial TPH concentration was removed by shaking only in batch test. The removal efficiency of TPH in case of groundwater as surfactant dilution solution was approximate 2~6% lower than that of distilled water. Mixing ratio of soil to surfactant solution did not practically effect on the TPH removal efficiency. In the experiment of using single or mixed surfactant solution with 0.1~4.0 wt%, Tween-80, SWA-1503, SWA-1503+SDS showed averagely over 80%. It was determined that the optimum surfactant concentration was 0.1 wt% because there was no significant difference between concentrations of 0.1~4.0 wt%.

• Economic and Environmental Geology
• /
• v.43 no.2
• /
• pp.85-100
• /
• 2010

Devonian Cairn Formation is one of the important hydrocarbon reservoirs in Alberta, Canada. However, the Cairn Formation, outcropped in the study area, is not prospective reservoir with poor porosity and permeability by some late diagenetic processes. In this study, geochemical characteristics of the Cairn Formation were studied to use these preliminary results for advanced geological and geophysical petroleum explorations in the near future. Rock-Eval pyrolysis showed that total organic carbon content is less than 0.3 wt.%, indicating a minor amount of bitumen and/or other hydrocarbons. The carbonates in the Cairn Formation are mainly composed of subhedral and anhedral dolomites. Pore sizes in the carbonate are various, ranging from nanometer to micrometer. Clastic sediments increase in the upper and lower parts of the Cairn Formation, probably due to changing its depositional conditions. The Cairn Formation can also be divided into several intervals based on Ca/Mg ratio in dolomite and degree of amount of calcite. These could be formed by different sedimentary environment, degree of cementation and recrystallization, different saline/fresh water, etc.

• Journal of Wetlands Research
• /
• v.6 no.1
• /
• pp.133-147
• /
• 2004

Environmental quality(water and sediment) was analyzed in the tidal flat of Saemangum of Jeonbuk Province, the west coast of Korea, using the 101 sediment samples and 69 water samples collected in September 4~13, 2001. Major water quality parameters with the means of 69 surface water samples are as follows; $25.51{\pm}0.68^{\circ}C$ for water temperature, $29.88{\pm}5.01$ for salinity, $1.40{\pm}0.78mg/L$ for COD, $0.352{\pm}0.417mg/L$ for DIN, and $0.027{\pm}0.023mg/L$ for phosphate, respectively. Higher values were found at the subestuary of Dongjin and Mangyung River, and lower values at the Saemangum embayment and Gomso Bay. There was a significant negative correlation between salinity and the other water quality parameters(p<0.0001) such as COD, nutrients, SS and N/P. This correlation suggested that the major pollution sources be from terrestrial inputs through tributaries in this area. Principal component analysis clearly revealed a spatial variation of water quality; stations with higher values of nutrients and COD located subestuary of tributaries. 14 sediment quality parameters including 8 trace metals were measured using the 101 surface sediment samples. Average values for the parameters are as follows; Al $2.28{\pm}0.92%$, Cd $0.61{\pm}0.27ppm$, Cu $8.95{\pm}4.06ppm$, Fe $1.19{\pm}0.37%$, Mn $182.31{\pm}77.45ppm$, Ni $10.83{\pm}4.97ppm$, Pb $15.20{\pm}4.35ppm$, Zn $41.34{\pm}34.62ppm$, COD $2.68{\pm}1.85mg/g\;dry$, AVS $0.04{\pm}0.08mg/g\;dry$, IL $1.29{\pm}1.08%$, water content $24.11{\pm}4.49%$, TN $0.02{\pm}0.02%$, TC $0.22{\pm}0.30%$. Spatial variations of sediment quality were not clear as water quality. Some higher values were found at the subestuary of Gum River and lower values at the other area. There was a significant positive correlation between the heavy metal concentrations and organic materials within the sediment(p<0.05). Enrichment factors showed the ranges of 1~2 for most of the metals in the sediment except zinc(1~6), indicating no serious exogenous input of heavy metals in the study area. Also, the heavy metal concentrations in the sediment were within the ranges found at the natural marine environments.