• Journal of Korean Tunnelling and Underground Space Association
• /
• v.15 no.4
• /
• pp.375-385
• /
• 2013

This study evaluates correlation between petrographic characteristics and weathering grade of low-graded metasedimentary rocks mainly consisting of phyllite. Weathering grade of rock material was determined based on the results of geological survey. The Schmidt hammer test was carried out to obtain estimates of strength of rock materials. Point counting and microscopic observation were also conducted to analyze mineral composition and to measure spacing of foliation for 9 rock specimens. As a result of microscopic analysis, as the weathering grade was lower, the quartz was found more in quantity, consequently making rock stronger against weathering process. On the other side, lower weathering grade of rock resulted in less content of mica which is weak against weathering process. In addition, the rock materials with closer foliation spacing are found to be weaker in strength and have higher weathering grade.

• Journal of the Korean Geosynthetics Society
• /
• v.12 no.1
• /
• pp.1-10
• /
• 2013

In this study, the characteristics of particle crash of decomposed granite soil sampled at Pocheon area were presented. The degree of weathering was artificially achieved by means of hydrofluoric acid. Weathering index was firstly determined by the analysis of mineral composition. Then, particle distribution, permeability tests were conducted. The results showed that weathering effects on particle crash over entire particle sizes. Comparative analysis on specific surface between $D_{10}$ and $D_{50}$ indicated that the smaller the particle size, the more the particle crash. In addition, the most particle crashing due to compaction appeared around the optimum moisture content. The incremental ratio of specific surface appeared to decrease as weathering proceeds, which means that the higher the weathering index the less the particle crash.

• 한국지구물리탐사학회:학술대회논문집
• /
• 2008.10a
• /
• pp.201-206
• /
• 2008

Determining the coefficient of weathering(CW) for stone heritage plays very important role in investigation and conservation plan. In most case, CW is obtained from the empirical relation, which use the difference between sonic velocities of fresh and weathered rocks. In this paper, we measured sonic velocities for the samples from Iksan, Geochang, Wonju, Goesan and Chungju of which our stone heritages are made. We first investigate the uncertainty of velocity by portable measurement by comparing it to lab measurement. There were small difference, but we conclude that the difference is not major. However, the velocity of fresh rock differs significantly among samples: ranging from 3200 to 4400m/s. This cause a lot of error in CW estimation if we use typical fresh rock velocity as of 5000m/s. Thus accurate measurement of the velocity of fresh rock is crucial to CW estimation.

• Journal of the Korean GEO-environmental Society
• /
• v.14 no.10
• /
• pp.59-64
• /
• 2013

Effects of weathering intensity on the adsorption of heavy metals such as lead(Pb) and copper(Cu) onto decomposed granite soils were investigated by a series of batch tests. The chemical components such as $SiO_2$, $K_2O$ and $Na_2O$ having relatively high solubility were reduced and the oxidized $Fe_2O_3$ content was increased with the increase of weathering intensity. Weathering of granite soils increased the ignition loss and specific surface area, while it decreased the permeability. The lead and copper adsorptions onto the decomposed granites were enhanced with the increase of weathering intensity, mainly due to the increase of specific surface area and clayed contents. Adsorption of lead and copper onto the weathered granites could be more adequately described by the pseudo-second-order kinetic model than the pseudo-first-order model.

• Journal of The Geomorphological Association of Korea
• /
• v.20 no.4
• /
• pp.37-50
• /
• 2013

This study analyzes results of published studies of weathering pits in Korea focusing on tafoni and gnamma and it suggests new types of weathering pits and next subjects through the analysis. 34 papers, published between 1978 and February 2012, have been analyzed and the following are details of the analysis. In terms of the study results, weathering pits are commonly developed on coarse-grained rocks such as granite, but also found on various rocks. Multiple reasons including mechanical, chemical and salt weathering create weathering pits and they are closely related to the geological structure. Weathering pits are classified as tafoni and gnamma but the forms have not been verified. In the future, quantitative analysis must be conducted find the factors influencing creation, forms and development of weathering pits.

• Journal of the Korean Geotechnical Society
• /
• v.39 no.4
• /
• pp.19-29
• /
• 2023

This research proposes a direct shear test method to evaluate the behavior of the soil-grout interface. The proposed test method was employed to conduct direct shear tests on two types of specimens: residual soil and residual soil-grout. The evaluation of the shear stress-slip curve indicated that the residual shear strength of residual soil-grout was similar to that of residual soil. It was further confirmed that residual soil determines the behavior of the critical state of the residual soil-grout interface. However, a remarkable increase in the maximum shear strength at the residual soil-grout interface was observed. The increase rate of the maximum shear strength was higher in loose soil due to the increased thickness of the interface layer where residual soil particles and grout particles are mixed.

• Journal of the Korean Geotechnical Society
• /
• v.23 no.12
• /
• pp.13-23
• /
• 2007

Weathered soils appear from the rock and its weathering result. In accordance with the degree of weathering the roch may become soft rock, weathered rock and residual soil. In general, classification method for determining the degree of weathering are performed by chemical method and N-value. But these method have some problems. So, this research is to suggest an appropriate physical method to determine the degree of weathering of weathered soils. A new classification method for determining the degree of weathering is suggested, based upon the results from fall cone test. According to the proposed physical method using fall cone apparatus, the measured values of the samples from the same area show distinctive difference of weathering. For the checking, we selected two areas. As a result, the relationship between CWI and water content according to penetration is expressed as an equation in Ilsan and Incheon area. And it proved to be a good method to determine the degree of weathering.

• The Journal of Engineering Geology
• /
• v.34 no.1
• /
• pp.25-38
• /
• 2024

Laboratory tests of accelerated artificial weathering compared the effects of seawater and acidified distilled water on rock weathering. The experiments simulated chemical and physical weathering of five different types of volcanic rock by applying 45 freeze-thaw cycles using seawater and acidified distilled water (pH 3), both at 70℃. The physical properties and uniaxial compressive strength (UCS) of the rocks were measured after 15 and 45 cycles of artificial weathering. Most of degradation of physical properties appeared within the first 15 cycles, and acidified distilled water had a greater effect than seawater. Analysis of variance (ANOVA) statistically evaluated the differences in UCS of the different rock types during the tests. The rate of UCS reduction after 45 cycles was similar across the samples, being independent of the rock type and the trend of changes in physical properties. In contrast to the changes in the physical properties, the UCS was more affected by seawater than by acidified distilled water.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2004.04a
• /
• pp.114-118
• /
• 2004

울산지역의 대수층 분포특성과 지하수 유동특성에 관해 연구하기 위해 크리깅 기법을 이용하였다. 울산지역의 시추자료 1,783개 지점과 지하수위자료 총 1,171개 지점에 대하여 2년간(2002년～2003) 자료를 획득하여 분석하였다. 본 연구지역의 표고 충적층 하부경계 심도, 충적층, 하부경계 심도, 충적층 층후, 풍화대 층후, 충적층-풍화대 층후, 대수층 단면, 지하수위 그리고 지하수유동 분석을 하기 위해 베리오그램 분석한 결과 풍화대 하부경계 심도에 지수형모델(exponential model), 나머지 지하수위를 포함한 성분들은 모두 구상형모델(shperical model)이 가장 적합하게 나타났다. 울산지역 대수층의 경우 산악지역은 얕은 충적층과 풍화대 분포가 나타나는 반면, 남구는 충적층, 북구는 풍화대 발달이 우세하게 나타났다. 그리고 울산지역의 충적층과 풍화대 층후 분포특성이 울산단층을 따라 층후가 두껍게 나타났다. 지하수 유동은 고지형의 북구와 동구 산악지역에서 바다에 인접한 내륙지역으로 지하수 유동특성을 보였으며, 울산의 4개구는 산악지역, 태화강, 동천강, 울산단층 그리고 충적층과 풍화대가 잘 발달된 대수층을 따라 지하수유동 특성이 잘 나타났다.

• Journal of the Korean Geotechnical Society
• /
• v.20 no.1
• /
• pp.75-82
• /
• 2004

To evaluate the characteristics of permeability in weathered residual soil, flexible wall permeameter tests are performed using undisturbed samples. The Influence of hydraulic gradient and confining pressure on the permeability of weathered residual soil is analyzed. To compare the characteristics of permeability between weathered soil and sand, similar tests are performed using Jumoonjin sand. Also, piping model tests are performed to investigate the piping resistance of weathered residual soil. As a result, weathered residual soil shows very dependable permeability on hydraulic gradient and very large resisting ability against piping compared with sand.