• Journal of the Korea Institute of Building Construction
• /
• v.21 no.6
• /
• pp.583-591
• /
• 2021

In this study, the applicability and reproducibility of LIBS in the analysis of chloride penetration in the mortar section were investigated. Standard analysis (IC, potentiometric titration) and LIBS analysis were simultaneously performed on the accelerated and immersed mortar by chloride concentration. Through LIBS analysis after making an eluate at the same depth for each concentration, the signal intensity of chloride ions was confirmed according to the depth and concentration at the wavelength of 837.59 nm, and a correlation between the LIBS signal intensity and the chloride concentration was confirmed. Although it is an aqueous solution-based LIBS analysis, the applicability and reproducibility of LIBS were confirmed not only for the incorporation of chloride but also for the amount of permeated chloride.

• Journal of the Korean Geotechnical Society
• /
• v.29 no.9
• /
• pp.5-15
• /
• 2013

In this paper, the unsaturated slope stability analysis considering suction stress (Lu and Godt, 2008) was introduced and the results applied for a certain sand slope were analyzed. The unsaturated slope stability analysis considering suction stress can analyze both conditions of steady infiltration and no infiltration, and it can estimate the safety factor of slope as a function of soil depth. Also, the influence of weathering phenomenon at a certain depth from the ground surface can be considered. The stability analysis considering suction stress was applied to the unsaturated infinite slope composed of sand with the relative density of 60%. The suction stress under no infiltration condition was affected by ground water table until a certain influencing depth. However, the suction stress under steady infiltration condition was affected by seepage throughout the soils. Especially, the maximum suction stress was displayed around ground surface. The factor of safety in the infinite slope under no infiltration condition rapidly increased and decreased within the influence zone of ground water table. As a result of slope stability analysis, the factor of safety is less than 1 at the depth of 2.4 m below the ground surface. It means that the probability of slope failure is too high within the range of depths. The factor of safety under steady infiltration condition is greater than that under no infiltration condition due to the change of suction stress induced by seepage. As the steady infiltration rate of precipitation was getting closer to the saturated hydraulic conductivity, the factor of safety decreased. In case of the steady infiltration rate of precipitation with $-1.8{\times}10^{-3}cm/s$, the factor of safety is less than 1 at the depths between 0.2 m and 3 m below the ground surface. It means that the probability of slope failure is too high within the range of depths, and type of slope failure is likely to be shallow landslides.

• Journal of Power System Engineering
• /
• v.15 no.3
• /
• pp.65-69
• /
• 2011

This paper introduces the multi-coil eddy current sensor and its characteristic in magnetic material gas turbine rotor. In the past, magnetic particle inspection method was used for qualitative defect evaluation in magnetic material gas turbine rotor. And the ultrasonic inspection method was used for quantitative defect evaluation. Nowadays, eddy current method is used in magnetic gas turbine rotor inspection due to advanced sensor design technology. We developed multi-coil eddy current sensor for the rotor dovetail inspection. At first, rotor stress is analyzed for the determination of sensor position and number. The sensor coils are designed to cover the stress concentration area of rotor dovetail. We select optimum frequency according to material standard penetration data and experiment results. The rotor mock-up and artificial defects were made for the signal detection and resolution analysis of multi-coil eddy current sensor. The results show that signal detection and resolution capabilities are enhanced in comparison to the commercialized sensor enough for the gas turbine rotor inspection. So, this developed multi-coil eddy current sensor substituted for commercialized one and it applied in real gas turbine rotor inspection.

• Journal of Power System Engineering
• /
• v.15 no.4
• /
• pp.37-41
• /
• 2011

This paper introduces the special eddy current sensor and its characteristic for bolt hole defect evaluation in gas turbine rotor. In the past, Fluorescent penetration inspection method was used for qualitative defect evaluation in gas turbine rotor bolt hole. This method can defect the bolt hole defect but can not evaluate the defect size. Nowadays, eddy current method is used quantitative defect evaluation due to advanced sensor design technology. And eddy current method is more time and cost saving than the old method. We developed bolt shape eddy current sensor for the rotor bolt hole defect detection and evaluation. The eddy current sensor moves to the bolt hole guided by screw nut and detects the defect on the bolt hole. The bolt hole mock-up and artificial defects were made and used for the signal detection & resolution analysis of eddy current sensor. The results show that signal detection capability is enough to detect 0.2 mm depth defect. And the resolution capability is enough to differentiate 02, 0.5, 1.0 and 2.0 mm depth defect.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.4 no.2
• /
• pp.7-14
• /
• 1985

An experiment to investigate the rate of change of phase angle of eddy current output signal caused by outer surface defect of nonferromagnetic tube by variation of standard depth of penetration and variation of percent of tube wall penetration was carried out. The results of the experiment show that the phase angle of defect signal is increased with decreasing the standard depth of penetration or the depth of defect. The results also show that the phase angle is decreased with increasing the skin effect of eddy current, and that the resolution is decreased with decreasing the depth of defect.

• Journal of Power System Engineering
• /
• v.14 no.4
• /
• pp.63-67
• /
• 2010

This paper introduces the eddy current signal characteristic of magnetic and non-magnetic gas turbine rotor. In the past, Magnetic particle inspection method was used in magnetic material for qualitative defect evaluation and the ultrasonic test method was used for quantitative evaluation. Nowadays, eddy current method is used in magnetic gas turbine rotor inspection due to advanced sensor design technology. We are studying on the magnetic gas turbine rotor by using eddy current method. We prepared diverse depth specimens made by magnetic and non-magnetic materials. We select optimum frequency according to material standard penetration data and experiment results. We got the signal on magnetic and non-magnetic material about 0.2 mm, 05 mm, 1.0 mm, 1.5 mm 2.0 mm and 2.5 mm depth defects and compare the signal amplitude and signal trend according to defect depth and frequency. The results show that signal amplitudes of magnetic are bigger than non-magnetic material and the trends are similar on every defect depth and frequency. The detection and resolution capabilities of eddy current are more effective in magnetic material than in non-magnetic materials. So, the eddy current method is effective inspection method on magnetic gas turbine rotor. And it has the merits of time saving and simple procedure by elimination of the ultrasonic inspection in traditional inspection method.

• The Journal of Engineering Geology
• /
• v.25 no.3
• /
• pp.377-385
• /
• 2015

We constructed a model test apparatus to evaluate the dependence of the saturation velocity (V_s) in soils on rainfall intensity (I_R). The apparatus comprises a soil box, a rainfall simulator, and measuring sensors. The model grounds (60 cm × 50 cm × 15 cm) were formed by Joomunjin standard sand with a relative density of 75%. The rainfall simulator can control the rainfall intensity to reenact the actual rainfall in a soil box. Time Domain Reflectometer (TDR) sensors and tensiometers were installed in the soils to measure changes in the volumetric water content and matric suction due to rainfall infiltration. During the tests, the soil saturation was determined by raising the groundwater table, which was formed at the bottom of the soil box. [Please check that the correct meaning has been maintained.] The wetting front did not form at the ground surface during rainfall because the soil particles were uniform and the coefficient of permeability was relatively high. Our results show that the suction stress of the soils decreased with increasing volumetric water content, and this effect was most pronounced for volumetric water contents of 20%-30%. Based on a regression analysis of the relationship between rainfall intensity and the average saturation velocity, we suggest the following equation for estimating the saturation velocity in soils: V_savg (cm/sec) = 0.068I_R (mm/hr).

• Proceedings of the Korea Contents Association Conference
• /
• 2006.11a
• /
• pp.322-326
• /
• 2006

Though human being has ability to percept a full colored vision, the technology of early photography only can produce black and white images. For cinema filming imagery also captured mono tone with black and white, until developed a color film technology. The desire for presenting color imagery and the technique for producing film and color ink, photography and print utilize color on it with noticeable color impact to viewers. It, however, abusing fun colors image each and every printed and filmed imagery, the freshness of eye catching power diminished now. On contrast, color becomes black and white or partially used for making discrepancy among full colored images. This image detected commercial and music video, and it spread to film. To use those bleached color images is for evoking a nostalgia and a visual differentiation. Especially, it can be provocative images brought to audience with that. such as "Anycall", "Dimchae" for CF, and "Schindler's list," and "Sin city" for movie. It is hard to investigate on the color studies for partially used images. Therefore, this study is to research that through CF and film, base on it, to investigate the application for this image. To collect data from survey, it will be established a basic concept for understanding the partial color applying.

• Proceedings of the Korea Contents Association Conference
• /
• 2006.11a
• /
• pp.145-148
• /
• 2006

This study aimed at preventing women from suffering from health problems and stress due to excessive lookism and encouraging them to participate in sports activities to form desirable body image and eventually to live a healthy and sound life. To achieve this goal, this study formed a population with members of sports centers located in Seoul and Daejeon areas as of 2006 and made a sample of 450 participants in physical exercise at a sports center through stratified cluster random sampling and that of 450 non-participants through a survey with mothers and sisters of those students from elementary and secondary schools within the areas for sampling the participants' group, thereby analyzing the data on a total of 900 persons. A questionnaire was used as a tool to collect data; a reliability test presented weight-, health-, and figure-related factors as a=.807, a=.819, and a=.784, respectively. This study used such statistical analysis methods as t-test, One-way ANOVA, and the Analysis of Covariance to analyze data. This study produced the following conclusions through these research methods and procedure. Pticipation in physical exercise has a positive effect on body image. Pticipation in physical exercise at a sports center show higher satisfaction with body image than non-participats.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.13 no.3
• /
• pp.2322-2341
• /
• 1971

The studies were conducted to determine the methods of irrigation control which is not only able to save the irrigation water as a adaptable measures for the insufficient irrigation water and the drought but also increase the yields of rice, in the paddy field which shows over percolating tendency through the couple years of 1968 and 1969 at Suwon. These experiments were carried with late maturing rice variety, Norim No. 6 and the major treatments in this experiments were filling the clay under surface soil, periodic irrigation and lining the Vinyl under the surface soil and three replicated completely randomized design was employed. Results obtained will be summarzed as follows. 1. Through the couple years, the plots tilled the clay under 15cm of the surface soil saved the irrigation water by 364% to 45% and 78% to 88% respectively. Particulary, the plot of filling the clay with 9cm thick under 15cm of the surface soil, saved the amount of irrigation water by 45% to 88% and also increased yields by 12% to 20% through the couple years. 2. The plots in which amount of 40mm of irrigation water is irrigated periodically from 5 to 8 days at the stages of tillering and ripening, saved theamount of irrigation water by 41% to 55% and also increased yields by 10% to 16% respectively through the couple years. 3. The plot lined the Vinyl under 15cm of the surface soil, saved the amount of irrigation water by 75% to 88% in accordance with the size of hole. The plot of lining the Vinyl with $3cm/m^2$ hole yielded almost same as the check plot, but in the case of lesser hole than above yielded less. 4. The plots inserted the Vinyl paper in 57cm depth and with 6cm height from the soil surface around the plot to prevent the ridge percolation reduced the amount of percolation by 25% to 33%. 5. The plot filled the wheat straw with 6cm thick under 15cm of the surface soil increased yields by 30% in former year but opposite results were gained in later year. 6. Generally, yields and yield components such as number of spikes of spikes per hill and number of grains per spike were decreased in 1969. These faots are considered to depend upon the rainy and cold weather in the stages of vigorous tillering and less sunshine in the stages of ripening. 7. The variation of characters among the plots will be summarized as follows. (1) Tallerplant height was found in the plots of clay filling and irrigation control. (2) longer culm length and higher yields were founds in the plots filled the clay with 9cm thick and controled the irrigation periodically froir 7 to 8 days. (3) Length of spike increased generally with yields but opposite tendency was found also. (4) Number of spikes per hill increased with yields in the plots of irrigation control. (5) Number of grains per spike increased with yields in the plots filled the clay with 9cm thick and controled irrigation periodically from 5 to 8 days. (6) Tendency of variation of 1000 grain weight is similar to Number of grains per spike. (7) Percentage of complete grains increased in the plot of clay filling and irrigation control.