• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.22 no.8
• /
• pp.1173-1182
• /
• 1998

A throughflow analysis program for axial flow turbines is constructed, which can handle not only the two-dimensional multi-streamline (streamline curvature) method but also the one-dimensional mean line method. Calculations are performed for single stage and multi-stage axial flowturbines. For a wide operating range, the performance and flow field calculated by the present streamline curvature method are close enough to the test data. It is also revealed for the single stage turbine that the present analysis leads to far better correspondence with the experiment than other researchers" throughflow analyses. A special focus is put on the comparison of the results between the streamline curvature analysis and the mean line analysis. It is found that the mean line analysis can not predict the performance for highly off-designed conditions as accurately as the streamline curvature method, which shows the importance of considering the spanwise variation of loss and flow.

• The KSFM Journal of Fluid Machinery
• /
• v.5 no.1 s.14
• /
• pp.33-41
• /
• 2002

Low NPSH and high pressure pumps we widely used for turbopump systems, which have an inducer and operate at high rotating speeds. In this paper, a meanline method has been established for the preliminary design and performance prediction of pumps having an inducer for cavitating or non-cavitating conditions at design or off-design points. The method was applied for the performance prediction of a fuel pump. Predicted performances by the method are shown to be in good agreement with experimental results for cavitating and non-cavitating conditions. The established meanline method can be used for the performance prediction and preliminary design of high speed pumps which have a inducer, impeller and volute.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.12 no.4
• /
• pp.56-62
• /
• 2008

This study presents the aerodynamic design and numerical analysis results on a transonic centrifugal compressor which is used for gas turbine systems. Mean-line analysis and quasi-3D analysis are used for the aerodynamic design, and Reynolds-averaged Navier-Stokes analysis is applied to flow analysis of the compressor. The aerodynamic parameters for a transonic compressor, such as pressure coefficient, swirl parameter, blade loading, are discussed, and flow characteristics in the impeller and diffuser are discussed.

• 유체기계공업학회:학술대회논문집
• /
• 2003.12a
• /
• pp.457-463
• /
• 2003

A general program of meanline design and/or performance prediction for centrifugal/mixed-flow compressors is successfully commercialized using various empirical loss models. 4 types of diffusers, 3 types of exit elements, shrouded/unshrouded impellers and real gas option are included in the program capabilities. Total 16 cases of benchmark test results proved its reliability to be effectively utilized in the development processes.

• 유체기계공업학회:학술대회논문집
• /
• 2001.11a
• /
• pp.250-257
• /
• 2001

Low NPSH and high pressure pumps are widely used for turbopump systems, which have an inducer and operate at high rotating speeds In this paper, a meanline method has been established for the preliminary design and performance prediction of pumps having an inducer for cavitating or non-cavitating conditions and at design or off-design points. The method was applied for the performance prediction of a fuel pump, which had been developed by Hyundai Mobis in collaboration with KeRC for a liquid rocket engine. The engine uses liquid methane and liquid oxygen as working fluids and rotates at 50,000 rpm KeRC carried out a model testing of the fuel pump with water as a working fluid at the reduced speed (10,000 ${\~}$ 15,000 rpm). Predicted performances by the method are shown to be in good agreement with experimental results for cavitating and non-cavitating conditions. The established meanline method can be used for the performance prediction and preliminary design of high speed pumps which have a inducer, impeller and volute.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2012.05a
• /
• pp.566-570
• /
• 2012

본 연구에서는 비선형 k-$\varepsilon$ 모형을 이용하여 직사각형 개수로에서 평균흐름과 난류구조를 모의하였다. 표준 k-$\varepsilon$ 난류모형은 난류의 등방성을 가정하여 국부적 평형상태에서 계산하기 때문에 유선에 따른 레이놀즈 응력의 변형이 큰 경우나 이방성이 강한 경우 이를 계산하지 못한다. 이를 보완하기 위하여 제시된 것이 비선형 k-$\varepsilon$ 난류모형이다. 본 연구에서는 표준 k-$\varepsilon$ 모형과 비선형 k-$\varepsilon$ 모형에 의한 모의결과를 비교하였다. 난류모형을 검증하기 위하여 직사각형 개수로에 흐름을 완전 발달된 등류로 가정하여 해석하였다. 지배방정식을 해석하기 위해 Patankar와 Spalding (1972)이 제시한 SIMPLER 알고리즘을 사용하였고 유한체적법을 이용하여 이산화하고 엇갈린 격자체계를 사용하여 계산에서 발생하는 과도한 진동을 줄였다. 또한 차분기법은 Patankar (1980)가 제시한 Power-law 기법을 채택하였으며 경계조건으로 2층 벽법칙 모형과 Hossain과 Rodi (1993)의 모형을 이용하였다. 두 모형의 적용성을 검증하기 위하여 실측자료를 이용하여 비교하였고 그 결과 비선형 k-$\varepsilon$ 모형이 표준 k-$\varepsilon$ 모형에 비해 좀 더 실측지에 가깝게 모의하는 것을 볼 수 있었다.

• Proceedings of the KSME Conference
• /
• 2001.06e
• /
• pp.649-654
• /
• 2001

This paper describes aerodynamic preliminary design performance prediction and flow analysis for centrifugal compressor of the marine middle engine turbocharger. The performance characteristics of turbocharger compressor are investigated at various operating conditions using mass flow rate and revolution speed, and computational flow analysis for impeller and diffuser at design point are performed. Preliminary design results correspond to actual compressor geometric values comparatively by applying modified slip factor. Performance prediction and flow analysis results show good agreement with experiments. Therefore, this will provide the performance prediction in preliminary design, and help to increase the design capability for optimized impeller.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.2 no.2
• /
• pp.112-117
• /
• 1990

Boussinesq-type equations should be employed in which the water surface profile is considerably steep or the bottom topography is abruptly changed. The primary reason is that the pressure deviates significantly from the hydrostatic pressure distribution due to the large curvature of the stream lines. It is shown that such a Boussinesq type equation can be also derived by making use of the concept of the averaged flow description for specifying the turbulence effects. In addition, a numerical scheme is developed to solve the equations and the effects of the Boussinesq term is briefly investigated.

• The Journal of the Korea Contents Association
• /
• v.8 no.6
• /
• pp.43-53
• /
• 2008

Hyper text transfer protocol (HTTP) over transmission control protocol (TCP) is currently used to transfer objects in the Internet. Stream control transmission protocol (SCTP), an alternative to TCP, which allows for independent delivery among streams, and can thus reduce the mean response delay of web object. We present an analytical model to find the mean response delay for HTTP over SCTP, therefore, estimate the effectiveness of SCTP over TCP. Typical TCP delay models assume the wired environment. On the contrary, the proposed model in this paper assumes the multiple packet losses and wireless environment where fast retransmission is not possible due to small window. The estimated mean response time can be used the benchmark to meet quality of service (QoS) at end-user. We validate the accuracy of our model using experiments. It is shown that the differences between the results from model and those from experimental are very small below 6 % on average. We also find that the mean response delay for HTTP over SCTP is less than that for HTTP over TCP.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.22 no.1
• /
• pp.70-78
• /
• 1998

The present study has tested semi-empirical loss models for a reliable performance prediction of mixed-flow pumps with four different specific speeds. In order to improve the predictive capabilities, this paper recommends a new internal loss model and a modified parasitic loss model. The prediction method presented here is also compared with that based on two-dimensional cascade theory. Predicted performance curves by the proposed set of loss models agree fairly well with experimental data for a variety of mixed-flow pumps in the normal operating range, but further studies considering 'droop-like' head performance characteristic due to flow reversal in mixed-flow impellers at low flow range near shut-off head are needed.