• Journal of the Korean Wood Science and Technology
• /
• v.46 no.1
• /
• pp.85-92
• /
• 2018

In order to use glued built up timber beam as a structural member for post and beam construction, it must be possible to manufacture long-span lumber. In this study, the researchers conducted a performance evaluation for longitudinal bonding of lumber (cross-section $89{\times}120mm$) made from larch. The specimens were prepared in six different forms using the longitudinal bonding method. The bonding strength of these specimens was tested through tensile strength tests and bending strength tests. The tensile strength test result of the longitudinally bonded parts was better than that of the double lap specimens. And, the tensile strength value of the scarf specimen was better than that of the hooked scarf specimen. The tensile strength of the GFRP (Glass Fiber Reinforced Plastic) rod insertion bonding specimen was 3.6 MPa, which was the highest. As for the bending strength test result of the longitudinally bonded part, the average MOR (modulus of rupture) of the specimen where a GFRP rod was inserted and bonded measured 29 MPa, while the specimens of other bonded parts showed a MOR no more than 11 MPa. Toughness destruction was observed in specimens where a GFRP rod was insertion-bonded. The rest of the specimens showed brittle destruction. The average MOR strength of the Rod + Lap specimen was 30.5 MPa, which was the highest among all longitudinally bonded specimens. The bending strength of the Rod + Lap specimens showed an effective strength that was 66% of that of the control group which were not longitudinally bonded.

• Applied Chemistry for Engineering
• /
• v.29 no.4
• /
• pp.413-418
• /
• 2018

Cypress woods treated individually with boric acid (BA4), ammonium pentaborate (APB4), or BA4/APB4 additives were examined for combustion gases. Each of the specimens was painted with a 4 wt% solution of boron compounds three times. Dried at room temperature, the combustion gas was analyzed using a cone calorimeter (ISO 5660-1). Consequently, the second maximum oxygen consumption rate of the specimen treated with boron compounds was 0.1067 to 0.1246 g/s, which was 5.3 to 18.9%, respectively lower than that of the blank specimen. The specific extinction area of specimens treated with BA4 and APB4 was also 2.0 to 19.0% lower, respectively. However, treated with BA4/APB4 showed 21.2% higher than that of the blank specimen. The maximum carbon monoxide concentration of the specimens with boron compounds was reduced by 0 to 25%. It was estimated to be 1.6 to 2.2 times higher than the permissible exposure limits by Occupational Safety and Health Administration (OSHA), indicating a fatal toxicity. The boron compounds were effective in reducing carbon monoxide, but didn't meet the OSHA limit. The boron compound inhibited the burning behavior of the cypress wood, which suppressed the second maximum oxygen consumption rate by 5.3 to 18.9% and the maximum carbon monoxide generation by 0 to 25%.

• Journal of Chest Surgery
• /
• v.37 no.8
• /
• pp.623-631
• /
• 2004

Background: Using the neovascularizing properties of the omentum, we studied the viability and vascularity of the cryopreserved rat tracheal allografts with omental implantation. Material and Method: The cryopreserved tracheal allografts of eight-week old male Sprague Dawley rats were implanted into the omentum. The rats were divided into the four groups according to the duration of cryopreservation and of omental implantation. We examined the tracheal allografts histologically for viability of cartilages, inflammation and fibrosis of smooth muscle and connective tissue, and degree of vascularity. Result: The degree of inflammation in the smooth muscle and the connective tissue of the tracheal allografts was not statistically related to neither the duration of cryopreservation or of omental implantation. The tracheal cartilages of the tracheal allografts were found to be severely calcified in all cases. Significant difference in vascularity was found between the groups I and II (p < 0.05). And a sufficient vascularity in the intercartilaginous space was observed in the mid portion of the tracheal allografts as well as both ends. Conclusion: In conclusion, the omental implantation for 2 weeks could establish a sufficient vascularity in the intercartilaginous spaces for maintaining the viability of the tracheal allografts. This study might provide a possibility of the sequential tracheal allotransplantation after omental implantation.

• Korea journal of population studies
• /
• v.21 no.1
• /
• pp.162-183
• /
• 1998

This study examines the sampling bias that may have resulted from the large number of missing observations. Despite well-designed and reliable sampling procedures, the observed sample values in DSFH(Demographic Survey on Changes in Family and Household Structure, Japan) included many missing observations. The head administerd survey method of DSFH resulted in a large number of missing observations regarding characteristics of elderly non-head parents and their children. In addition, the response probability of a particular item in DSFH significantly differs by characteristics of elderly parents and their children. Furthermore, missing observations of many items occurred simultaneously. This complex pattern of missing observations critically limits the ability to produce an unbiased analysis. First, the large number of missing observations is likely to cause a misleading estimate of the standard error. Even worse, the possible dependency of missing observations on their latent values is likely to produce biased estimates of covariates. Two models are employed to solve the possible inference biases. First, EM algorithm is used to infer the missing values based on the knowledge of the association between the observed values and other covariates. Second, a selection model was employed given the suspicion that the probability of missing observations of proximity depends on its unobserved outcome.

• Journal of Korea Technology Innovation Society
• /
• v.14 no.1
• /
• pp.22-39
• /
• 2011

This study examines the wage level from a viewpoint of major-job match as part of an analysis on the skill mismatch problem in 4-year college graduates. The empirical analysis explicitly incorporate the sample selection bias as an econometric problem not only suggested but merely introduced in the earlier studies. This study also set up a major-job match variable, which was usually handled as a binary variable for analytical convenience, as a polychotomous choice variable in selection equation as provided by the survey. In particular, it considered multi-cohort survey on graduates of the years 1982, 1992, and 2002 for the empirical analysis. As a result of empirical analysis, the wage premium of a major-job match was identified. This result was consistent after the consideration of a sample selection bias and also after modeling the major-job match variable as polychotomously selective. Through an analysis classified by the major, this study identified a relatively high wage premium among Social Science, Engineering, and Science majors. However, there was a difference in the effect of selection among these majors. Also, by assessing cohort effects this study found that the skill mismatch had rapidly progressed in 1992, while difference between 1992 and 2002 cohorts are insignificant. The analysis suggests that wage level is better understood within the context of both sample selection and major-job match, and regardless of model specification the major-job match affects wage strongly.

• Journal of Digital Convergence
• /
• v.18 no.8
• /
• pp.201-215
• /
• 2020

We conducted the analysis using the data of the '2019 Korean Middle and Elderly Technology Acceptance Survey' to verify the comprehensive senior technology acceptance model. In this study, we examined the significant effect the relationship between behavioral intention to use the diital health devices and perceived usefulness, perceived ease of use, gerontechnology self-efficacy, gerontechnology anxiety, facilitating conditions, attitude to life and satisfaction through the structural equation. The results of the research model are as follows. First, the usefulness and ease of use had significant effects on intention to use. Second, the self-efficacy had significant effects on the intention to use. But they had negative effect. Third, perceived usefulness, self-efficacy and anxiety had significant effects on ease of use. Lastly, self-efficacy, facilitating conditions, attitude to life and satisfaction had significant effects on perceived usefulness. These findings highlight that verified the comprehensive senior technology acceptance model in Korea.

• Maxillofacial Plastic and Reconstructive Surgery
• /
• v.13 no.1
• /
• pp.117-127
• /
• 1991

When open reduction of maxilla fractures is postponed due to concurrent life-threatening injuries, delayed union may result with malunion or nonunion. If delayed malunion is occurred, significant facial deformity may result, including a dished-out face, irregular retromaxillism with Angle's class III malocclusion, open anterior bite, nasal collapse, telecanthus and malar flattening. The treatment planning for this problem includes cephalometric evaluation anterior and lateral tomograms, dental casts, orthodontic planning, dental planning and use of impression tray to rupture the fibrous tissue casts, orthodontic planning, dental planning and use of impression tray to rupture the fibrous tissue attachment at the fracture site. In this paper, one case presented a 58-year-old female patient with maxilla retrusion after comminuted fracture, who was treated with orthodontic methods of maxillary protraction headgear and Plaster headcap, whereas the other two cases were about male patients who were treated principally with surgically open reduction or Le Fort I-controlled transverse osteotomy with iliac bone graft.

• Management & Information Systems Review
• /
• v.30 no.4
• /
• pp.117-146
• /
• 2011

The objective of this study is to investigate factors influencing user's intention to use by expanding TAM(Technology Acceptance Model). Based on this model, this study developed a comprehensive model and user's motivation factors such as extrinsic and intrinsic motivation to describe their intention to accept WCDMA service. For this purpose those who have subscribed to and use the current mobile communication service - all of whom were 13 to 49 years old living in Seoul or other large cities - were surveyed. Structural equation model was conducted to identify and validate the relationship of overall variables relating to mobile service acceptance. The analysis results indicate that intrinsic motivations in mobile service acceptance process have significant impacts on perceived usefulness and perceived ease to use. The results of this study also proposed the way to boost mobile service user's extrinsic and intrinsic motivation for coming up with strategies on how to improve effectiveness of communication and marketing. Future directions and limitations are also discussed.

• Journal of Korea Water Resources Association
• /
• v.53 no.3
• /
• pp.201-214
• /
• 2020

This study proposes a bias correction method of dual-pol radar rain rate in real time using the dual Kalman filter. Unlike the conventional Kalman filter, the dual Kalman filter predicts state variables with two systems (state estimation system and model estimation system) at the same time. Bias of rain rate is corrected by applying the bias correction ratio to the rain rate estimate. The bias correction ratio is predicted from the state-space model of the dual Kalman filter. This method is applied to a storm event with long duration occurred in July 2016. Most of the bias correction ratios are estimated between 1 and 2, which indicates that the radar rain rate is underestimated than the ground rain rate. The AR (1) model is found to be appropriate for explaining the time series of the bias correction ratio. The time series of the bias correction ratio predicted by the dual Kalman filter shows a similar tendency to that of observation data. As the variability of the bias correction increases, the dual Kalman filter has better prediction performance than the Kalman filter. This study shows that the dual Kalman filter can be applied to the bias correction of radar rain rate, especially for long and heavy storm events.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.32 no.4_1
• /
• pp.363-371
• /
• 2014

Most space-borne optical scanning systems adopt linear arrayconfigurations. The well-knownthree different types of space-borne sensors arealong-track line scanner, across-track linescanner, and three line scanner. To acquire accurate location information of an object on the ground withthose sensors, the exterior and interior orientation parameters are critical factors for both of space-borne and airborne missions. Since the imaging geometry of sensors mightchange time to time due to thermal influence, vibration, and wind, it is very important to analyze the Interior Orientation Parameters (IOP) effects on the ground. The experiments based on synthetic datasets arecarried out while the focal length biases are changing. Also, both high and low altitudes of the imagingsensor were applied. In case with the along-track line scanner, the focal length bias caused errors along the scanline direction. In the other case with the across-track one, the focal length bias caused errors alongthe scan line and vertical directions. Lastly, vertical errors were observed in the case ofthree-line scanner. Those results from this study will be able to provide the guideline for developing new linearsensors, so as for improving the accuracy of laboratory or in-flight sensor calibrations.