• Proceedings of the Korea Concrete Institute Conference
• /
• 2008.11a
• /
• pp.645-648
• /
• 2008

The expansion joint is an important part of the bridge, but the failure is occurred on the non-shrinkage concrete which is connected to the slab of the bridge and the expansion joint, and the other problem is the release of anchors in expansion joint due to the impact and vibration during the driven car on the bridge, especially an overloaded car. In this study, to overcome the failure of non-shrinkage of concrete, high impact resisting mortar is developed. The high impact resisting mortar shall be a polyurethane material compounded with an aggregate system to develop excellent flexibility characteristics, high load bearing capacity.

• Journal of the Korean Society for Railway
• /
• v.13 no.4
• /
• pp.371-375
• /
• 2010

In order to decide the strength requirement of the window glass for the high-speed train, the pressure change during the passage of the EMU type high-speed train has been numerically simulated. Based on the calculation results, the pressure difference between the inner and outer pressure of the cabin has been calculated to yield the amount of load acting on the window glass of the cabin. To simulate the pressure field generated by the high-speed train passing through the tunnel, computational fluid dynamics based on the axi-symmetric Navier-Stokes equation has been employed. The pressure change inside a train has been calculated using first order difference approximation based on a linear equation between the pressure change ratio inside a train and the pressure difference of inside and outside of the train.

• Proceedings of the KAIS Fall Conference
• /
• 2008.05a
• /
• pp.245-247
• /
• 2008

Traffic intersection conrol is implemented by the data which is acquired to vechile Loop detector. Traffic intersection control equation is Webster equation, which use passing and delayed vechile number. But webster equation is applied to the spot traffic intersection, it is not used to related traffic intersection network system. There is not the approprate remote traffic intersection control, even if there is, it is high cost local network system. Therefore low cost and expert traffic intersection control is realized by internet referencing next and distant intersection traffic information.

• Journal of Korean Society of Transportation
• /
• v.31 no.3
• /
• pp.45-54
• /
• 2013

Korea Expressway Corporation has been utilizing vehicles equipped with dedicated short range communication (DSRC) based on-board equipment (OBE) for collecting path travel times. A path based method (PBM) estimates the path travel time using probe vehicles traveling whole links on the path, so it is not always possible to obtain sufficient samples for calculating path travel time in the DSRC system. Having this problem in utilizing DSRC for travel time information, this study attempted to estimate path travel time with the help of a link based method (LBM) and examined whether the LBM can be used for obtaining reliable path travel times. Some comparisons were made and identified that the MAPE difference between the LBM and the PBM estimates are less than 3%, signaling that LBM can be used as a proxy for PBM in case of sparse sample conditions. Some limitations and a future research agenda have also been proposed.

• Annual Conference of KIPS
• /
• 2007.05a
• /
• pp.568-571
• /
• 2007

본 연구에서는 차량검지시스템을 이용하여 메타데이터의 검지시스템의 하드웨어와 소프트웨어가 도로에 적합한 시스템이 되도록 실험을 통하여 이를 검증하고, 표준화를 위해 제안하였다. 첫째, 교통정보를 메타데이터하고자 할 때 그 구축범위가 너무 광범위한 점을 보완하여 시내 교통정보의 범위를 줄이고자 적용범위로 VDS(차량검지시스템 : Vehicle Detection System)의 메타데이터 구성요소에 대한 표준을 마련하였다. 둘째, 본 표준에서는 차량의 속도, 단위 시간당 차량의 통과수 및 점유시간 등을 조사할 수 있는 VDS의 메타데이터 구성요소를 추출하고 데이터 요소에 대한 정의 및 기술형식을 정의하였다. 셋째, VDS의 메타데이터 표준지정은 교통정보의 데이터 요소 및 형식을 동일하게 사용하도록 함으로써 상이한 개발업체에 의해 개발된 시스템의 교통정보를 일관성 있게 표현할 수 있다. 넷째, 본 표준은 VDS 메타데이터의 데이터 요소명을 표준화하기 위해서 Data Dictionary를 구축하여 실제 데이터 요소에서 data dictionary에서 정의된 약어들의 조합으로 표시하여 데이터 모델링시 유용하게 쓰일 수 있도록 하였다.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.19 no.2
• /
• pp.48-61
• /
• 2020

The objective of this study is to estimate traffic capacity based on the heavy-vehicle ratio in a two-lane freeway work zone where one lane is blocked by construction. For this, closed circuit television (CCTV) video data of the freeway work zone was collected, and the congestion at an upstream point was observed. The traffic volume at a downstream point was analyzed after a bottleneck was created by the blockage due to the upstream congestion. A distribution model was estimated using observed-time headway, and the road capacity was analyzed using a goodness-of-fit test. Through this process, the general capacity and an equation for capacity based on the heavy-vehicle ratio passing through the work zone were presented. Capacity was estimated to be 1,181~1,422 passenger cars per hour per lane (pcphpl) at Yeongdong, and 1,475~1,589pcphpl at Jungbu Naeryuk. As the ratio of heavy vehicles increased, capacity gradually decreased. These findings can contribute to the proper capacity estimation and efficient traffic operation and management for two-lane freeway work zones that block one lane due to a work zone.

• International Journal of Highway Engineering
• /
• v.12 no.2
• /
• pp.63-69
• /
• 2010

Since speed limit enforcement in school zones is the most important to reduce the occurrence of severe child related accidents, school zones typically have a speed limit of 30km/h. However, it is found that the majority of vehicles passing school zones are traveling over 30km/h. This indicates that school zones are not being effectively operated to achieve the main objective which is the reduction of child related accidents. This study aims to identify the factors affecting the violation of speed limits in school zones through the results of field survey from 8 elementary schools. The results showed that time period, the number of lanes, the width of sidewalks, and the status of colored pavement were found to be highly associated with the violation of speed limits in school zones at the 95% significance level. The results of this study may provide some insights for making safe environments around schools.

• International Journal of Highway Engineering
• /
• v.11 no.2
• /
• pp.45-54
• /
• 2009

Despite vehicle instability problems caused by gusts of wind on freeways located in mountain or seaside areas, current national highway design standards overlook their detrimental effects, and if higher design speed freeways being proposed now by the government are in operation, the strong effect of the gust of wind becomes a highway alignment design issue. This paper presents the vehicle movements and their resulting safety effects by checking vehicle sliding and overturn based on vehicle dynamic analysis for the case when a gust of wind blows to vehicles negotiating curves on higher speed freeways. In this analysis, vehicle types, curve radii, motorist responsive time to vehicle driving path changes, and vehicle speeds are systematically arranged to get vehicle sliding and overturn values in each different conditions. The results showed that there were little overturn possibilities when wind speed would stay in 50m/sec with higher than 600 meter curve radii. Interestingly it was also found in sliding checks that, although being safe at less than 15.0m/sec wind speed levels, there appeared the need of vehicle travel prohibitions when the wind speed could exceed 25.0m/sec level. The findings in this research is of information in future higher speed freeway designs, and particularly useful when designing freeways passing frequent gust wind areas.

• 한국공간정보시스템학회:학술대회논문집
• /
• 2005.05a
• /
• pp.413-417
• /
• 2005

본 연구에서는 설계속도별 연속류 흐름을 가진 대상도로를 선택하여, 대상도로의 비첨두 시간을 정하여, 동영상에 의한 촬영을 실시하여 구간 주행속도를 추출하는 연구를 수행하였다. 각 대상구간의 거리는 수치지도 및 측량, 주행기록계 등을 이용하여 측정하였고, 영상의 분석을 통하여 차량의 구간통과시간을 산정하여 설계속도별 주행속도를 추출하였다. 그에 대한 검증으로 차량의 DGPS를 장착하여 대상도로를 주행하면서 동영상에 의한 주행속도와 비교 검증을 실시하였다.

• Journal of the KSME
• /
• v.53 no.2
• /
• pp.49-53
• /
• 2013

철도차량은 중요한 친환경 대중교통 수단으로서 운행 구간이 확장되고 있다. 그러나 철도선로가 거주지역을 통과하여 설치되면서 환경 소음 문제가 야기되고 있으며 이의 저감이 중요한 이슈 중 하나이다. 철도차량 및 궤도에서 발생하는 전동음은 저감해야 할 주요 소음원 중 하나이다. 따라서 철도의 진동 및 소음 관련된 연구현황들에 대해 알아보고 궤도 지지단을 고려한 레일의 진동과 방사 소음 특성을 예측하고 궤도 모니터링 시스템 개발에까지 적용이 가능한 방법들에 대한 연구가 필요하다.