• Journal of the Mineralogical Society of Korea
• /
• v.22 no.1
• /
• pp.13-22
• /
• 2009

The study area is a tunnelling section passing through the Yangsan Fault zone. Kyungbu express highway and national road 35 are located above the tunnel. Previous study showed that fault gouge and fault breccia were widely distributed in the tunnelling section with a maximum width of 100 m. From the present study, it is found that sedimentary rocks consisting mainly of shale are distributed at the eastern block of the Yangsan Fault and these rocks are not subject to mechanical fracturing and hydrothermal alteration. On the other hand, dacitic tuff distributed at the western block of the Yangsan Fault is largely affected by mechanical fracturing and hydrothermal alteration. The large fault zone of $50{\sim}130m$ width was formed by complex processes of mechanical fracturing and hydrothermal alterations such as chloritization, sericitization, and kaolinization. Based on the characteristics of mechanical fracturing and hydrothermal alterations, the Yangsan fault zone in the study area is geotechnically classified as four zones: unaltered zone, altered zone, altered fractured zone, and fault gouge zone. These zones show different degrees and aspects in mechanical fracturing and hydrothermal alterations, resulting in different engineering properties.

• The Proceeding of the Korean Institute of Electromagnetic Engineering and Science
• /
• v.14 no.3
• /
• pp.20-40
• /
• 2003

Since unloaded Q-value of a high-temperature superconductor(HTS) filter is very high, a bandpass filter(BPF) and a lowpass filter(LPF) with an increase of pole numbers can be fabricated without an increase of an insertion loss(IL) ; recently a 70-pole BPF is developed in USA. They have an abrupt skirt property and an excellent attenuation level for out-of band. Moreover, they can be miniaturized when lumped element resonators or the slow-wave characteristic are used. Technology of fabricating a HTS epitaxial film as well as a film of a 4 inch area also makes the planar type filter with a various structure and an enhanced power handling capability possible. Recently, the HTS filter subsystems composed of a planar-type HTS filters, a GaAs-based LNA and a mini-cryocooler are developed. The extended receiver front- end subsystems for mobile radio communications decrease the noise-figure level of the communication system and the frequency interference interacted adjacent bands, and increase the efficiency of frequency and the capacity of communication system. In this paper, theory for developing the HTS filter, its kinds, its design rules, its characteristics are reviewed. The feature of the research and market trends related to the HTS filter systems for the receiver front-end subsystem of mobile base station are surveyed.

• Journal of Korea Port Economic Association
• /
• v.35 no.2
• /
• pp.109-126
• /
• 2019

The Panmunjom Declaration adopted by the leaders of South and North Korea on April 27, 2018, has created an environment conducive for peace and cooperation in the Korean Peninsula. In the June of last year, South Korea has joined the Organization for Cooperation between Railways (OSJD). The membership of OSJD has established a solid foundation for restoring a multimodal logistics system that connects the Korean peninsula to Eurasia countries, including China and Russia. In this paper, a questionnaire survey targeting working-level experts was conducted to find the barriers in constructing multimodal logistics that efficiently connect the port-continental railways of the Korean peninsula and the Eurasian nations. Survey items were divided into five categories-border crossing procedures, technology, facilities, operation, and government support. As a result, among the most important problems of international multimodal logistics in Eurasia that need to be solved on priority include improving transshipment facilities, eliminating inspection carried out at every country for transit, simplifying documents for customs clearance, and minimizing the changes in freight rates. In conclusion, for vitalizing the connection between the Korean peninsula and the continental railways, it is necessary to develop a transshipment system to facilitate the changes in tracks at the borders by making a joint effort with the international community. Second, railway and operational systems in South Korea, North Korea, China, and Russia should be standardized. Third, international cooperation among South Korea, North Korea, China, and Russia is essential for simplifying customs clearance at borders, priority departure of domestic cargo, sharing information about the changes in freight rates, and so on. Finally, the government should come up with measures to secure the quantity of cargo required to form block trains, while developing new business models.

• 한국해양학회지
• /
• v.30 no.6
• /
• pp.550-564
• /
• 1995

The temporal and spatial characteristics of wind fields over the neighbouring seas of the Korean peninsula are investigated using 10-years daily wind data during 1978${\sim}$1987 which have been spatially smoothed and low-pass filtered. Long term annual and monthly means are examined for synoptic patterns and spectral analyses are made for temporal variability and spatial coherence. Spatial patterns of the annual mean wind stress and curl have a strong resemblance with those of monthly means during the winter season. Two outstanding periodicities are observed at 1 and 2 cycles per year. The synoptic winds over the study area are highly coherent at both the annual and semi-annual periodicities. However, each basin has its own characteristic spatial pattern. For instance, the prevailing wind during the winter season is northerIy over the northern East Sea (ES), Yellow Sea (YS), and northern East China Sea (ECS), while it is northwesterly over the southern ES and northesterly over the northern ES and southern ECS. At the same time, the wind stress curl is positive over the northern ES and southern ECS, while it is negative over the southern ES, YS and northern ECS. On the other hand, the wind field during the summer season, with its strength being much reduced, is completely different from that during the winter season, and frequent passage of tropical storms provokes large temporal variability over ECS. One remarkable point is that the annual cycle, dominated by the Siberian High, tends to propagate from northeast to southwest, i.e., from northern 25 toward southern ES, YS and ECS, while the semi-annual cycle propagates in the opposite direction, from southwest to northeast. The semi-annual periodicity may reflect development of extratropical cyclones in spring and fall which frequently cross the Korean peninsula. In higher frequencies, there are no dominant periodicities, but local winds over YS and ES are highly correlated for frequencies larger than 0.1 cycles per day and phase difference increases linearly with frequency. This linear increase of phase corresponds to phase speed of 550 and 730 km/d at 0.1 and 0.3 cpd, respectively, The phase speed is apparently coincident with moving speed of extratropical cyclones across the Korean peninsula in the west-east direction.

• Proceedings of the KIEE Conference
• /
• 1999.07d
• /
• pp.1852-1854
• /
• 1999

In order to enhance satellite communication system performance, filters are required with the characteristics of sharp skirt, low insertion loss, and high power handling capability. But the performance of microwave passive filters is significantly declined by the conduction losses, especially in case of planar structures using film conductors. By using high temperature superconducting(HTS) film material as the conductor, higher performance could be expected. We have designed and developed narrow bandpass filters using haripin-type superconducting microstrip line for satellite communication. High quality superconducting YBCO thin films have been grown on MgO substrates by pulsed laser deposition(PLD) The deposited YBCO films were patterned by conventional wet-etching process. The transition temperatures of these films had shown 86 - 89 K. The film thicknesses were about 500 nm. Experimental results are presented for the insertion loss and return loss of the filter at 60 K.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.13 no.3
• /
• pp.111-118
• /
• 2013

The connection based TCP protocol provides reliable packet delivery, but it takes certain overhead compare to the connection-less UDP protocol. Thus, 3GPP devise the upper-layer RLC protocol which provides reliability based upon the UDP protocol. Consequently, each implement of a base station and/or mobile terminal require the development of the RLC protocol, and it must qualify various interoperable tests. In this paper, we implement a testbed which verifies the RLC protocol under various packet losses/inversion circumstances of networks. Finally, we propose our testbed as the RLC protocol tester for the developments.

• Explosives and Blasting
• /
• v.31 no.2
• /
• pp.25-31
• /
• 2013

In this case of "Seongnam~Yeoju double-lanes railroad construction", there were resident houses and gas pipe which were concerned about damages from vibration and noise. Especially, gas pipe which is a diameter of ${\varphi}500mm$ was located under the ground along upside road. The limit of vibration was 1.0cm/sec to protect gas pipe. The electronic blasting systems have been used to control vibration & noise not only gas pipe but also resident houses. The results of tunnelling were successfully conducted with effective vibration control and quick excavation by electronic blasting without any damages to adjacent facilities.

• Proceedings of the Materials Research Society of Korea Conference
• /
• 2003.03a
• /
• pp.56-56
• /
• 2003

최근 정보통신 분야의 급격한 발달로 인하여 무선통신에 사용되는 주파수 영역 또한 계속 높아짐에 따라 대역통과 필터 소자의 삽입 손실, 소비 전력, 크기, MMIC화에 대한 많은 연구가 진행되고 있다 압전 현상을 이용한 박막형 공진기가 이러한 요구를 충족시키고, 현재의 SAW filter를 대체할 소자로 떠오르고 있다. 본 실험에서는 단결정 미세 구조를 만들 수 있고, 압전 효과 또한 우수하며, Surface Micromachining보다 비교적 제조 공정이 간단하고 선택적 에칭이 가능한 Bulk Micromachining을 이용하여 Si$_3$N$_4$ Membrane을 이용한 중심주파수 5.2GHz인 두께 진동모드 Film Bulk Acoustic Wave Resonator(FBAR)를 제작하고 공진기의 고주파 특성을 평가하였다. Membrane구조 형성을 위해 Backside면인 Si$_3$N$_4$, Si은 RIE(Reactive Ion Etching)와 선택적 에칭용액인 KOH로 각각 에칭하여 Membrane을 갖는 구조로 중심주파수 5.2GHz인 두께 진동모드 FBAR를 설계 및 제조하였다. 체적 탄성파 공진 현상은 r.f Magnetron Sputtering법으로 증착한 AIN 압전박막과 Mo전극으로부터 발생 가능하였다. 본 연구에서는 0.9$\mu\textrm{m}$-Si$_3$N$_4$ Membrane을 이용해 FBAR를 제작/평가하고, RIE을 통해 Membrane을 제거해 가면서 공진기의 특성 즉, Quality factor와 유효전기기계결합계수(K$_{eff}$) 및 S parameter특성을 비교 측정해 보았다. 측정해본 결과 Membrane Free일때가 훨씬더 공진 특성이 우수함을 볼 수 있다

• Clinical and Experimental Pediatrics
• /
• v.45 no.9
• /
• pp.1165-1169
• /
• 2002

Satoyoshi syndrome(generalized Komuragaeri disease) is a rare disorder of unknown cause, characterized by progressive, painful, intermittent muscle spasms and alopecia. Endocrinopathy with amenorrhea, secondary skeletal abnormalities, and diarrhea or unusual malabsorption are frequently seen. It seems that autoimmunity may play a role in its pathogenesis. We report a 13-year-old girl with characteristic manifestations of the syndrome. She was treated with intravenous gammaglobulin and Prednisolone. Painful muscle cramps were gradually improved, but the scalp condition did not change. Satoyoshi syndrome should be considered in children with unexplained muscle spasms and alopecia.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2011.05a
• /
• pp.250-250
• /
• 2011

지정학적으로 3면이 바다로 접하고 있는 우리나라 해안가 주변의 원자력발전소는 관류형 냉각 방식(Once-through cooling System)을 채택하고 있기에, 이 계통을 통과한 냉각수는 주변해역으로 흘러들어가 주변 환경에 영향을 줄 수 있다. 또한 동해 주변 인접국들의 활발한 원자력 이용과 방사능 물질의 수송 등으로 인해 방사능 사고 위험이 증대됨에 따라 동해 원전 주변의 해양방사성물질 거동에 대한 필요성이 제기되고 있다. 이에 따라 동해의 해양환경을 조사 분석하여 해역에서의 오염 물질의 거동 파악이 중요하고, 산업시설 주변 연안의 오염물 이동 및 해석을 위해 오염물의 시 공간적으로 농도를 추정하는 것이 중요한 사항이다. 따라서 본 연구에서 수직 수평적으로 2차원 및 3차원화가 용이한 EFDC 모델을 사용하였다. 국립해양조사원에서 발간하는 DC103의 수치해도를 이용하여 모델영역은 동서방향으로 171km, 남북방향으로 235km로 설정하고, 격자간격은 $1km{\times}1km$의 정방향 격자를 사용하여 동해 월성 주변의 조위 시계열 검증 및 조화분석을 통한 검증을 실시한 결과 관측한 결과와 양호한 재현성을 나타내었다. 또한 국립수산과학원에서 제공되고 있는 년별 수온, 염분 자료 등의 해양환경과 지형적 특성을 고려하여 오염 물질의 이동 경로를 파악함으로써 사고시 피해를 줄이고자 한다.