• Tunnel and Underground Space
• /
• v.23 no.6
• /
• pp.561-571
• /
• 2013

Various experiences on enhanced geothermal system (EGS) has been accumulated from the Soultz project through various scientific experiments and research activities for more than 20 years since it started in the year of 1984 until the 1.5 MW Organic Rankine Cycle (ORC) binary power plant has been built up in Soultz-sous-$\hat{e}$ area, France. They have been applied to Cooper basin in Australia, Landau and Insheim in Germany and so forth. This report summaries the experiences from Soultz in the aspect of artificial reservoir creation, expecting to be helpful for reducing any trial and errors or unnecessary expenses in ongoing Korean EGS project in Pohang area, where the geological features are similar to Soultz area.

• Tunnel and Underground Space
• /
• v.16 no.5 s.64
• /
• pp.413-421
• /
• 2006

In order to explain entirely dynamic fracture process induced by blasting in rock mass, it needs to consider detonation pressure and gas pressure acting on blasthole wall simultaneously. In this study, prior to simulating the coupling between gas flow and rock mass, we analyzed effects of gas pressure-time history, length of cracks and equation of state adopted to calculate the gas pressure on the gas flow within a radial fracture created by single-hole blasting. The effects were investigated on two assumptions: (a) the radial fracture was composed of 5 cracks which were 0.01 m in length and 0.001 m in asperity each and (b) the PETN explosive which diameter was 36 mm was charged in a blasthole of 45 mm diameter. It was concluded that the maximum gas pressure and its travel time were dependent on characteristics of charged explosives and geometrical properties of radial fracture.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.41 no.8
• /
• pp.1-8
• /
• 2004

Experimental results are presented for gate oxide degradation, such as SILC and soft breakdown, and its effect on device parameters under negative and positive bias stress conditions using n-MOSFET's with 3 nm gate oxide. The degradation mechanisms are highly dependent on stress conditions. For negative gate voltage, both interface and oxide bulk traps are found to dominate the reliability of gate oxide. However, for positive gate voltage, the degradation becomes dominated mainly by interface trap. It was also found the trap generation in the gate oxide film is related to the breakage of Si-H bonds through the deuterium anneal and additional hydrogen anneal experiments. Statistical parameter variations as well as the “OFF” leakage current depend on both electron- and hole-trapping. Our results therefore show that Si or O bond breakage by tunneling electron and hole can be another origin of the investigated gate oxide degradation. This plausible physical explanation is based on both Anode-Hole Injection and Hydrogen-Released model.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2001.02a
• /
• pp.29-48
• /
• 2001

일반적인 폐수처리 시 여러 광물들이 사용되는 데 예를 들면, 수산화칼슘 및 탄산나트륨은 중화제, 점토는 응집제, 알룸(alum) 및 염화철은 인 제거제로 사용되고 있다. 산성광산배수인 경우에는 알칼리성의 중화제로 석회 (CaO), 석회석 (CaCO$_3$), 가성소다 (NaOH), 탄산나트륨 (NaCO$_3$) 등이 사용된다. 그러나, 설비비 및 유지비가 많이 들어 몇 십년 동안 계속해서 침출되는 산성광산배수를 처리하기에는 문제가 있다. 산성광산배수 (Acid Mine Drainage, AMD)는 pH가 6.0 미만이고 총산도 (totalacidity)가 총알카리도 (total alkalinity)를 초과하는 물로서 노천광이 가행되었던 지역, 가행중이거나 휴광 또는 폐광된 광산에서 유출된다. 또한 도로사면 절개부나 지하철 터널에서도 황철석(pyrite)이나 백철석 (marcasite)을 함유하는 층이 공기 중에 노출되면 산성수가 침출되어 나오기도 한다. 산성광산배수에 의한 하천수의 오염이 매우 극심하여 때로는 미생물마저도 그 속에 살 수 없게 된다. 산성광산배수에 의해 오염된 하천수의 오염범위는 산성수의 양, 농도, 하천에 유입되는 산성수의 분포, 상류에서 흘러드는 오염되지 않은 물의 양, 지류에서 유입되는 물의 양에 따라 좌우된다. 산성광산배수 오염이 문제시되고 있는 나라는 미국을 포함하여 호주, 일본, 한국, 러시아, 남아연방 등이다. 산성광산배수는 환원환경에서 생성된 석탄층 및 접촉교대 또는 열수에 의해 생성된 금속광이 공기 및 물에 노출되어 생성되는 자연적인 현상이다. 그러나 국지적인 지역에서 인간이 이 광상들을 환경영향을 고려하지 않고 대규모로 개발할 때 인간 생활에 심각한 영향을 미치는 것이다. 광산산성배수를 처리하기 위해 상기와 같이 여러 기술이 도입 적용되었으며 일부 기술들은 현재도 사용되고 있다. 각 기술마다 일장일단이 있으므로 경비의 과다, 유지 및 관리에 대한 지속성 여부, 공간의 확보 여부, 지역적 특수성에 맞춰 가장 적합한 방법을 채택하여야 하며 꾸준히 채택한 기술의 개량 및 새로운 기술의 첨가가 요구되고 있다. 따라서, 산성광산배수 오염지대에 대해 획일적으로 같은 처리방법을 채택하여 사용하는 것보다 각 지역 또는 광산산성폐수가 유출되어 나오는 광산폐기물의 특성 등을 고려하여 거기에 맞는 기술들을 복합적으로 또는 단독으로 사용하되 처리방법 채택 시 신중을 기할 것이 요망된다.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.14 no.7
• /
• pp.1647-1652
• /
• 2010

A CdS film has been used as a window layer in CdTe and Cu(In,Ga)$Se_2$ thin films solar cell. Partial substitution of Zn for Cd increases the photocurrent and the open-circuit voltage by providing a match in the electron affinities of the two materials and the higher band gap. In this paper, CdZnS/CdTe and CdS/CdTe heterojunctions were fabricated and the electrical characteristics were investigated. Current-voltage-temperature measurements showed that the current transport for CdS/CdTe heterojunction was controlled by both tunneling and interface recombination. However, CdZnS/CdTe heterojunction displayed different current transport mechanism with the operating temperature. For above room temperature, the current transport of device was generation/recombination in the depletion region and was the leakage current and/or tunneling in the range below room temperature.

• Journal of the Korea Society of Computer and Information
• /
• v.17 no.11
• /
• pp.73-81
• /
• 2012

This paper proposes an ETWAD(Encapsulation and Tunneling Wormhole Attack Detection) design based on positional information and hop count on Ad-Hoc Network. The ETWAD technique is designed for generating GAK(Group Authentication Key) to ascertain the node ID and group key within Ad-hoc Network and authenticating a member of Ad-hoc Network by appending it to RREQ and RREP. In addition, A GeoWAD algorithm detecting Encapsulation and Tunneling Wormhole Attack by using a hop count about the number of Hops within RREP message and a critical value about the distance between a source node S and a destination node D is also presented in ETWAD technique. Therefore, as this paper is estimated as the average probability of Wormhole Attack detection 91%and average FPR 4.4%, it improves the reliability and probability of Wormhole Attack Detection.

• Journal of Korean Tunnelling and Underground Space Association
• /
• v.2 no.2
• /
• pp.72-85
• /
• 2000

Rock is a very complex and heterogeneous material, containing structural flaws due to geologic generation process. Because of those structural flaws, deformation and failure of rock when subjected to differential compressive stresses is non-linear. To simulate the non-linear behavior of rock, mechanical crack models, that is, sliding and shear crack models have been used in several studies. In those studies, non-linear stress-strain curves and various behaviors of rock including the changes of effective elastic moduli ($E_1$, $E_2$, ${\nu}_1$, ${\nu}_2$, $G_2$) due to crack growth were simulated (Kemeny, 1993; Jeon, 1996, 1998). Most of the studies have mainly focused on the verification of the mechanical crack model with relatively less attempt to apply it to practical purposes such as numerical analysis for underground and/or slope design. In this study, the validity of mechanical crack model was checked out by simulating the non-linear behavior of rock and consequently it was applied to a practical numerical analysis, finite element analysis commonly used.

• Tunnel and Underground Space
• /
• v.11 no.3
• /
• pp.217-224
• /
• 2001

Rock masses are usually discontinuous in nature due to various geological processes and contain rock joints and bridges. Crack propagation and coalescence processes in rock bridge mainly cause rock failures in slopes, foundations, and tunnels. In this study, we focused on the crack initiation, propagation and coalescence process of rock materials containing two pre-existing open cracks arranged in different geometries. Specimens of 120${\times}$60${\times}$25 mm in size, which were made of Yeoman Marble, were prepared. In the specimens, two artificial cracks were cut with pre-existing crack angle ${\alpha}$, bridge angle ${\beta}$, pre-existing crack length 2c and bridge length 2b. Wing crack initiation stress, wing crack propagation angle, and crack coalescence stress were measured and crack initiation, propagation and coalescence processes were observed during uniaxial compression. Crack coalescence types were classified and analytical study using Ashby and Hallam model (1986) was performed to be compared with the experimental results.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.8 no.4
• /
• pp.781-787
• /
• 2007

Network Mobility (NEMO) basic support protocol doesn't execute the process of route optimization and has not presented the particular security mechanism in other blocks except hi-directional tunnel between Mobile Router (MR) and its Home Agent (HA). Therefore in this paper we process secure route optimization courses through authenticated binding update protocol between MR and its Correspondent Node (CN) and the protocol of the competency of mandate between MR and its Mobile Network Node (MNN); its block also uses an bi-directional tunnel as the block between MR and its HA. The address of each node are generated by the way of Cryptographically Generated Address (CGA) for proving the ownership of address. Finally we analyze the robustness of proposed protocol using security requirements of MIPv6 and existing attacks and the efficiency of this protocol using the connectivity recovery and end-to-end packet transmission delay time.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.32 no.2
• /
• pp.109-115
• /
• 2014

The aim of the study is to present a method to build an octree and to query from it for huge 3D point clouds of which volumes correspond or surpass the main memory, based on the memory-efficient octree developed by Han(2013). To the end, the method directly refers to 3D point cloud stored in a file on a hard disk drive instead of referring to that duplicated in the main memory. In addition, the method can save time to rebuild octree by storing and restoring it from a file. The memory-referring method and the present file-referring one are analyzed using a dataset composed of 18 million points surveyed in a tunnel. In results, the memory-referring method enormously exceeded the speed of the file-referring one when generating octree and querying points. Meanwhile, it is remarkable that a still bigger dataset composed of over 300 million points could be queried by the file-referring method, which would not be possible by the memory-referring one, though an optimal octree destination level could not be reached. Furthermore, the octree rebuilding method proved itself to be very efficient by diminishing the restoration time to about 3% of the generation time.