• Journal of Energy Engineering
• /
• v.10 no.2
• /
• pp.114-119
• /
• 2001

TRIGA Mark-II&III 연구로서의 운영과정에서 발생된 방사성 슬러리 함유 폐액에 대하여 음이온, 앙이온, 그리고 비이온 응집제를 첨가하였을 때의 여과 효과를 실험실 규모의 진공여과 장치로 연구하였다. 여과 실험 자료를 이용하여 Darcy’s Law에서 유도된 여과 케익 저항 값을 산출하였다. 응집제 사용으로 응집제를 사용하지 않은 경우롸 비교하여 케익 저항값의 개선은 있었지만, 수분함량은 증가하였다. 각각의 응집제 사용에 따른 침전율, 여과 케익의 수분함량, 그리고 여과 케익 저항 값을 비교한 결과 음이온 응집제 12~16ppm/$\ell$ waste를 사용하였을 경우가 가장 효과적인 것으로 나타났다.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.18 no.2
• /
• pp.62-70
• /
• 2010

A feasibility test for accelerating composting of sewage sludge irradiated with electron beam(3kGy) was investigated. Dried wood chip and leaves were used as a bulking agent and carbon source, respectively. The test variables included changes in temperature, organics and nutrients, and bioactivities from experimental and control composters. Results indicates that the temperature rose up to $60^{\circ}C$ within 1 day and maintained high temperature above $50^{\circ}C$ for more than 5 days in the irradiated sludge cake composter. It resulted in the fast degradation of organics during the initial 5 days, showing that approximately 70% of total amount of carbon degraded within 20 days was destroyed. It is likely that the composting of electron beam irradiated sludge cake is able to reduce it's maturing period significantly.

• Journal of the Korean Geosynthetics Society
• /
• v.5 no.2
• /
• pp.31-37
• /
• 2006

The purposes of this paper are to study the use possibility of geotextile tubes for dewatering of high water content sludges and sediments and to evaluate affecting factors on dewatering. To do this, pressure filtration tests are conducted on four high water content materials with two geotextiles under two filtration pressures. Based on the test results, although woven geotextile tubes are not satisfied the soil retention criteria used in filter design commonly, a great portion of fines are retained by filter cake formation on geotextile tube's upstream side, but also after formation of filter cake, the permeability drops sharply. Higher filtration pressure tends to increase dewatering rate, but has very little effect on filtration efficiency. Dewatering capacity is affected by several factors which are related to the geotextile, but the property of sludge appears to be the dominant control factor for dewatering efficiency.

• Journal of the Korean Geotechnical Society
• /
• v.18 no.5
• /
• pp.261-269
• /
• 2002

The objectives of this paper are to study the use of geotextile tribes for dewatering high water content sludges and sediments and to evaluate their feasibility and affecting fsctors. To accomplish these objectives, pressure filtration tests were conducted on woven geotextile (Geotex$\circledR$ 46T and 1212T) fir high water content materials with a modified experimental apparatus. Test results indicate that 1) the filter cake formed on the inside of the geotextile tube is the major contributor to the retention of fine particles, but also causes a decrease in permeability, 2) controlling the formation of the filter cake and thus achieving a balance between soil retention and permeability is vital to a successful project, and 3) geotextiles, sludge properties, and filtration pressures have some effects on the dewatering efficiency and dewatering rate.

• Resources Recycling
• /
• v.13 no.3
• /
• pp.12-18
• /
• 2004

A study on the enhancement of the dewaterability of sewage sludge was carried out by using the sea waste materials as a dewatering aid. It was made from a starfish and a shell by heating at $105∼700 ^{\circ}C$ and centrifuge and belt press were used as a mechanical dewatering process. The moisture content of sludge cake was reduced by 15∼22% (w/w) after addition of the dewatering aid at the dose of 1∼8 g/100mL of digested sludge. CST (capillary suction time) was measured to evaluate the effect of dewatering aid on sludge dewatering properties. CST was reduced after addition of a shell while increased after addition of a starfish. Enhancement of dewaterability after addition of a shell was better than that of a starfish. The heating temperature effect of the dewatering aid on dewaterability was not clear.

• Journal of Korean Society of Environmental Engineers
• /
• v.27 no.1
• /
• pp.93-100
• /
• 2005

Comparative thickening and dewatering characteristics of municipal wastewater sludge were investigated in terms of separated and combined treatment of primary and secondary BNR sludge. Also, various conditioning methods such as cation polymer addition, steam and ultrasonication treatment were examined to improve dewaterability of sludge. The dewaterability was measured by using specific resistant test, wedge zone simulator and centrifuge. The result of the sludge thickening test revealed that separated thickening was better in terms of solids recovery and supernatant quality. Particularly, the thickening of primary sludge with high solids (about 3.5% TS) showed very poor solid separation. The addition of cation polymer showed better conditioning characteristic for dewatering and the optimal polymer dosage was 0.26% for primary sludge, 0.43% for secondary sludge and 0.38% for combined sludge. Contrary to the result of the thickening, the dewatering test revealed that dewatering of the combined sludge is better than that of separated sludge, representing better solids separation and filtrate quality. The polymer addition was essential to improve dewaterability in filter (belt) press type dewatering but it was inefficient for the dewatering of secondary sludge only. The centrifuge type dewatering showed better performance and the dewaterability was slightly improved when the polymer was added. Based on the results of this research a sustainable sludge treatment process, particularly in terms of the recycle water quality and solids recovery, was proposed.

• The Korean Journal of Soil Zoology
• /
• v.7 no.1_2
• /
• pp.17-21
• /
• 2002

Food waste which had been mixed with night soil sludge and composted for 21 days (mixing ratio = food waste/paper mill sludge : 1, w/w) was supplied to the 5 g of Eisenia fetida popualtion at various temperatures (5, 6, 7, 8, 9, 10, 15, 20, 25, 30, 31, 32, 33, 34, 35$^{\circ}C$). The biomass of earthworms one month after feeding at 20-32$^{\circ}C$ was about two times more than that of the introduced earthworms, increasing rate of which was much higher than them at the other tested temperatures . There were decreases at temperatures below 7$^{\circ}C$, and less increases at temperatures of 8-10$^{\circ}C$ in biomass. Earthworms could not survive at temperatures at 34$^{\circ}C$ and 35$^{\circ}C$. Feeding rates of earthworms were much higher at 20-32$^{\circ}C$ than them at the other tested temperatures, and there were no differences among them at temperatures of 20-32$^{\circ}C$. But at 3 months after feeding, the biomass and feeding rate of earthworms decreased severely even at 20$^{\circ}C$ and 30$^{\circ}C$, which was supposed to be due to the long term effect of salts, especially sodium chloride (NaCl) in the food wastes.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2021.06a
• /
• pp.425-425
• /
• 2021

북평산업단지내 공공폐수처리시설(6,500톤/일)의 가동률은 30% 이하로 매우 저조하며, 폐수배출업체는 29개소로 그 수가 적어 배출오염부하량 비율에 따른 처리비용이 일부 업체의 경우 과도하게 부과되고 있는 실정이다. 입주업체 운영비용 부담을 저감하기 위해 해당 지자체에서는 운영비용의 65% 이내에서 일정금액을 지원하고 있으나, 동일업종에 대한 원인자비용부담금 비율의 경우, 동해시 A업체는 30.18%로 타 지역 B업체의 4.83% 보다 높은 것으로 나타났으며, 지자체 지원금을 제외한 순수 처리부과금의 경우 A업체가 2배 이상 큰 것으로 나타났다. 이에 북평산업단지 공공폐수처리시설의 전체 운영비 절감을 위한 효율적인 운영방안 마련이 필요하다. 따라서 본 연구에서는 북평산업단지내 공공폐수처리시설의 운영 및 관리현황을 검토하여 효율적인 운영방안을 제시하고자 하였다. 현재 운영시설에 대한 현황을 파악하고 관련 법률 및 계획등을 검토한 결과, 북평산단 지역은 하수처리 구역이 아닌 공공폐수처리구역으로 산업폐수의 공공하수도처리시설 연계처리 지침에 따라 인근 공공하수처리시설과의 연계처리가 불가한 것으로 나타났다. 또한, 환경부에서는 가동률이 저조한 처리시설에 대해서는 시설개선을 통한 방안을 제시하고 있어 현 처리시설의 공정개선을 통한 운영비 절감방안이 가장 효율적인 것으로 판단되었다. 이에, 현재 생물 반응조 후단에서 운영 중인 가압 부상조에 새로운 배관을 설치하여, 최초 침전지 유출수를 가압부상조 처리 후, 생물 반응조로 유입하고, 최종 침전 후 총인을 제어 할 수 있는 약품투입 시설을 설치하는 공정 개선 방안을 제시하였다. 이처럼 생물 반응조 이전에 가압부상조를 설치하고, 후단 가압 부상조 미운영시 공정개선 전·후에 따른 총 슬러지 발생량은 24.2%, 탈수케익 처리비용은 27.6% 절감할 수 있는 것으로 산정되었으며, 전체 처리시설에 대한 총 운영비 감소율은 13.4%로 분석되었다.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.16 no.3
• /
• pp.29-37
• /
• 2008

The objective of this research is to evaluate the optimum treatment methods for disposal sludge cake at different temperatures and periods of time. The disposal dehydrated sewage cake used in this study was obtained from N wastewater treatment plant in the P City. This system consists of continuous conveyer thermal dryer and pyrolysis. The continual conveyer thermal dryer was operated to evaluate the optimum conditions with temperature settings, ranges from 130 to $180^{\circ}C$, loading rates of 650~750 kg/hr and operating times of 110~120 minutes. The continual pyrolysis was also operated to evaluate the optimum conditions with temperature settings, ranges from 650 to $750^{\circ}C$, loading rates of 100~158 kg/hr and operating times of 20~40 minutes. The sewage sludge cake has a moisture content of 78~80% (wt) which decreased up to 1~3%(wt) resulted in breaking of cell wall after operating the continuous conveyer thermal dryer and pyrolysis. Important parameters which were operating times, moisture contents, loading rates, conveyer velocities and rotary velocities effects on the thermal kinetics and dynamics were investigated to evaluate the optimum conditions for the continual thermal dryer and pyrolysis.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.16 no.2
• /
• pp.47-56
• /
• 2008

The objective of this research is to evaluate the optimum recycling methods for the sewage sludge cakes at different microwave power-settings and for different periods of time. The dehydrated sewage sludge cakes used in this study was obtained from N wastewater treatment plan in the P City. The beginning drying processes were carried out in a microwave oven with 2,450 MHz frequency and power ranges of 1kW to 4 kW. The continuous conveyer drying system was also operated with 2,450 MHz frequency and power setting, ranging from of 1 kW to 6 kW. Initial moisture content of the sewage cake is 78~80%, and the moisture content decreased rapidly up to 0.2~2(wt%) within short periods due to breaking the cell walls. This study is also conducted to evaluate the characteristics of sewage sludge cakes with respect to important physical parameters effect on the thermal kinetics for evaporation water in the sludge which are operation times, moisture contents, drying rates, input amounts, flow rates and calorific values. It takes 60 minutes and 120 minutes to reach the critical moisture contents with power setting of 4 kW for 3kg/min and 6kg/min of the flow rates respectively. It takes 120 minutes and 110 minutes to reach the critical moisture contents with flow rates of 2.5 cm/min and sludge input of 6kg/min for the power settings of 4 kW and 6 kW respectively. The most effective value of the power for drying the sludge is 4 kW. Operation with 6kg/min and 4kW on 2cm of the sludge thickness can be effectively and inexpensively to reach the critical moisture contents, when you compare 2cm of the sludge thickness with 1cm and 3cm of the sludge thickness.