• Applied Chemistry for Engineering
• /
• v.9 no.3
• /
• pp.445-450
• /
• 1998

Interpenetrating polymer networks(IPNs) were prepared from castor oil-type polyurethanes(PUs) and epoxy resin. Two types of PU were prepared by using polypropylene ether glycol(PPG) as a chain extending agent and caster oil(CO) as a crosslinking agent. COPU/epoxy simultaneous interpenetrating polymer networks(SINs) based on CO had a better compatibility over the all composition than PPGPU/epoxy SINs based on PPG. The flexural strength of all PPGPU/epoxy SINs was decreased with decreasing entanglement of networks. COPU/epoxy SINs showed the higher fracture toughness and mechanial properties than the PPGPU/epoxy SINs. Fracture surfaces of all of the SINs showed the localized shear deformation and crack deflection rather than generation of stress whitening associated with the cavitation.

• Proceedings of the Computational Structural Engineering Institute Conference
• /
• 2011.04a
• /
• pp.10-13
• /
• 2011

내진설계의 기본 개념은 보를 기둥보다 약하게 설계하여 보에 소성힌지를 발생시켜 구조물 전체의 큰 변형을 방지하는 것이다. ACI 352R-02에서는 지역의 지진특성에 따라서 접합부의 상세 설계법을 구분하여 적용한다. 하지만 보와 접합부의 내력 차이가 상대적으로 작게 설계된 구조물의 경우 탄성 범위를 유지해야 하는 경우의 접합부에도 파괴가 발생할 가능성이 있다. 횡하중이 작용할 때 접합부 내부는 전단력의 지배를 받게 되고, 전단내력과 부착내력에 따라서 파괴모드가 결정된다. 본 논문에서는 양방향 반복하중이 작용하는 10개의 보-기둥 접합부를 통해서 접합부와 인접보의 전단내력 차이에 따라서 발생하는 파괴모드를 관찰하고 접합부 내의 전단내력 및 부착내력의 감소로 인해 발생하는 부재의 연성에 대해서 관찰하였다.

• Korean Journal of Materials Research
• /
• v.10 no.5
• /
• pp.321-327
• /
• 2000

Two kinds of $Al_2O_3/TZP$ composites were prepared using the liquid infiltration of 3Y-TZP and 12Ce-TZP precursors into hte sintered porous $Al_2O_3$. Small TZP additions(~11.0wt%) had increased the strength(19~59%) and fracture toughness(14~157%) of the sintered Al2O3 material($1600^{\circ}C$, 2h). The addition of 3Y-TZP was effective on case of the strength. By the way, in case of the fracture toughness that of 12Ce-TZP was effective. Infiltrated TZP was concentrated on the surface where its grain growth was enhanced and $Al_2O_3$ grain growth was effectively inhibit-ed, when compared to the inner region of the composite. The indentation crack was propagated through both intergranular modes and transgranular and the proportion if intergranular fracture was the larger in $Al_2O_3/12Ce-TZP$.

• Journal of the Korean Geotechnical Society
• /
• v.28 no.4
• /
• pp.35-42
• /
• 2012

This paper evaluates the effect of anisotropic conductivity on the seepage face and reliability index of an homogeneous dam with and without toe drain. The analysis are conducted under steady state saturated-unsaturated seepage condition using finite element method. Various anisotropic conductivity ratios were interpreted under such conditions as the vertical conductivity is reduced while the horizon conductivity is fixed. The shear strength of soil is defined by the modified Mohr-Coulomb failure criterion. The analysis results demonstrate that the length of seepage face and reliability index at the downstream and upstream of the dam increase with an increasing anisotropic ratio. These results of the seepage face and reliability index, however, depend on the total head difference between the upstream slope and downstream toe. The difference in seepage face and reliability index is attributed to the different equipotential head with different anisotropic ratios of the dam material.

• Journal of the Korean Geotechnical Society
• /
• v.37 no.10
• /
• pp.41-54
• /
• 2021

In this study, probabilistic steady seepage behavior of soil foundation beneath water retaining structures according to the location of cutoffs was studied. A Monte Carlo Simulation based on the random finite element method that considers the uncertainty and spatial variability of soil permeability was performed to evaluate the probabilistic seepage behavior. Fragility curves were developed by calculating the failure probability conditional on the occurrence of a given water level from the probability distribution obtained from Monte Carlo simulations. The fragility curve was prepared for the flow quantities such as flow rate through foundation soil, uplift force on the base of structure, and exit gradient in downstream to examine the reliability of the water retaining structure and the foundation soil. From the fragility curves, the effect of the location of cutoff wall on the reliability of water retaining structure and foundation soil according to the rise in water level was studied.

• Journal of the Korean Geotechnical Society
• /
• v.29 no.9
• /
• pp.5-15
• /
• 2013

In this paper, the unsaturated slope stability analysis considering suction stress (Lu and Godt, 2008) was introduced and the results applied for a certain sand slope were analyzed. The unsaturated slope stability analysis considering suction stress can analyze both conditions of steady infiltration and no infiltration, and it can estimate the safety factor of slope as a function of soil depth. Also, the influence of weathering phenomenon at a certain depth from the ground surface can be considered. The stability analysis considering suction stress was applied to the unsaturated infinite slope composed of sand with the relative density of 60%. The suction stress under no infiltration condition was affected by ground water table until a certain influencing depth. However, the suction stress under steady infiltration condition was affected by seepage throughout the soils. Especially, the maximum suction stress was displayed around ground surface. The factor of safety in the infinite slope under no infiltration condition rapidly increased and decreased within the influence zone of ground water table. As a result of slope stability analysis, the factor of safety is less than 1 at the depth of 2.4 m below the ground surface. It means that the probability of slope failure is too high within the range of depths. The factor of safety under steady infiltration condition is greater than that under no infiltration condition due to the change of suction stress induced by seepage. As the steady infiltration rate of precipitation was getting closer to the saturated hydraulic conductivity, the factor of safety decreased. In case of the steady infiltration rate of precipitation with $-1.8{\times}10^{-3}cm/s$, the factor of safety is less than 1 at the depths between 0.2 m and 3 m below the ground surface. It means that the probability of slope failure is too high within the range of depths, and type of slope failure is likely to be shallow landslides.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2009.05a
• /
• pp.417-418
• /
• 2009

As iron corrosion by means of penetration of chlorides resulted in a serious deterioration of seaside and landfill concrete construction, it is urgently necessary for seaside construction to acquire watertightness and resistance for chloride-attack. Hence in this study, Si/Al liquor type hybrid-inorganic salt which was very effective compound for improving resistance for chloride-attack applied to mortar and then evaluated resistance for chloride-attack with curing(7, 14, 28, 56 days).

• Journal of the Korean Vacuum Society
• /
• v.2 no.3
• /
• pp.374-383
• /
• 1993

필라멘트와 Si 기판 사이의 기전력을 20, 80, 140, 200V로 증가시키면서 EACVD에 의하여 성장된 다이아몬드 박막에 대하여 다이아몬드/Si 계면분석 및 계면강도를 측정하였다. 주사형전자현미경(SEM), 고분해능투과형전자현미경(HRTEM), 오제이전자분석기(AES)에 의해 계면상태를 분석한 결과, 기전력 증가에 따라 활성탄화수소 이온(CmHn-)에너지가 증가되어져 CmHn-이 Siso로 침투(Impringement)가 증가되고 침투된 높은 에너지의 CmHn-이 Si과 화학결합하여 생성되는 SiC층 깊이 및 농도 분포도 증가된다. 풀 시험(Pull test)에 의한 계면강도 측정 결과, SiC층 깊이 및 농도분포가 증가할수록 계면강도가 증가하였다. 관찰된 파면과 파면의 X-선 메핑 결과 및 HRTEM과 AES에 의한 분석 결과, 기전력 증가에 따라 공극율이 적고 치밀한 다이아몬드 박막이 성장된다. 그리고 생성되는 SiC층 농도 및 깊이 분포가 증가함에 따라 다이아몬드/Si 계면이 강화되고, 상대적으로 파괴는 다이아몬드/Si 계면이 아닌 SiC층이나 Si 내부에서 발생된다. 결국, 기전력을 증가하여 활성탄화수소이온의 에너지를 증가함으로써 계면강도가 우수하며 공극율이 매우 적고 치밀한 다이아몬드 박막을 성장할 수 있다.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2002.03a
• /
• pp.773-778
• /
• 2002

강우시 불포화 자연사면의 파괴메커니즘을 규명하기 위하여 사면내 모관흡수력의 변화를 고려한 안정해석을 수행하였다. 사면에는 강우계, Tensiometer, Pizometer, Water mock, 경사계 등이 설치되었으며 강우시 사면내 부간극수압과 임시지하수위의 거동을 관찰하였다. 실내실험으로부터 불포화 사면의 안정해석을 위하여 입력 값으로 사용되는 불포화투수계수, 불포화강도정수를 시료의 No.200체 통과량과 건조밀도를 기준으로 경험계수를 이용하여 추정 사용하였다. 강우의 침투로 인한 사면내 부간극수압의 분포는 계측값과 수치해석결과가 차이를 보였으며 이는 불포화 흐름시 흙속의 공기의 영향, 강우의 나무와 수풀에 의한 중간차단효과 및 증발의 영향을 해석에 고려하지 못했기 때문으로 사료된다. 사면안정해석결과 강우초기 모관흡수력을 고려하는 경우 약 10%의 안전율의 증가를 나타냈으며, 침투가 진행되면서 그 차이는 좁아져 임시지하수위가 표층까지 도달했을 때 흡수력을 고려하지 않는 해석과 안전율은 일치하였다.

• 한국해양학회지
• /
• v.26 no.4
• /
• pp.324-331
• /
• 1991

Laboratory experiments were undertaken in mixing chamber to study the water-in-oil emulsion formation tendency, stability and formation rate of 16 crude oils. Arabian, Iran, Dubai, Isthmus and Daekyung crudes showed high emulsion formation tendency and had water contents of 80-90%. Emulsions of crude oils of middle East were very stable, while Isthmus and Daekyung sudes formed unstable emulsion. Emulsion formation tendency rate, and stability showed significant correlations with asphaltene content of crude oil. To evaluate the possibility of preventing mousse formation, inhibition ability of several dispersants and demulsifier was tested. They inhibited mousse formation at 0.1-0.2% concentrations (v/v). Emulsion inhibition by chemical treatment delayed the time of formation, but did not decrease water content. Demulsifying ability of dispersants and demulsifier was tested because biscous emulsion causes formidable problems in skimming, pumping and recovery operation. British demulsifier Alcohol 0 showed excellent emulsion breaking efficiency at 0.1% of emulsion Vol..