• Journal of the Korea institute for structural maintenance and inspection
• /
• v.10 no.4
• /
• pp.108-118
• /
• 2006

The purpose of this study is to investigate the effectiveness of a LQG Hybrid controller to suppress the earthquake disturbance for the building structure. The ground acceleration of N-S component of El-Centro earthquake was scaled to confirm that the building behaved within the elastic range. The tuned mass damper(TMD) on the top floor regulated by LQG algorithm was designed to control the floor displacements. The displacement responses of the hybrid control were compared with those obtained from an active control along with a passive control. The results showed that the LQG hybrid control used approximately 50% less input forces than an active control to satisfy the performance criteria.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.14 no.5
• /
• pp.416-423
• /
• 2004

In this paper, an experimental verification of system identification technique for constructing finite element model is conducted for a three-story test structure equipped with an active mass driver (AMD). Twenty Gaussian white noises were used as the input for AMD, and the corresponding accelerations of each floor are measured. Then, the complex frequency response function (FRF) for the input, the force induced by the AMD, was obtained and subsequently, the Markov parameters and system matrices were estimated. The magnitudes as well as phase of experimentally obtained FRFs match well with those of analytically obtained FRFs.

• Journal of the Korean Geotechnical Society
• /
• v.17 no.1
• /
• pp.57-65
• /
• 2001

역사적 지진 발생 기록이 풍부하고 양산 단층 영향권 내에 있어 지진 발생 가능성이 높은 경주 지역을 대상으로 지진민감도 분석을 수행하였다. 지형적 특성을 고려한 지반조사와 현장 및 실내 시험을 통하여 대상 지역 지반의 지층 구성과 각 지층의 동적 특성을 분석 평가하고, 이를 토대로 한 지반 응답 해석을 수행하였다. 9개의 시험공을 시추하여 2개소의 크로스홀 시험과 7개소의 다운홀 시험을 실시하였고, 시추부지 포함 13개소에서 SASW 시험도 수행하였다. X선 회절 및 풍화도 분석과 공진주 시험 등의 실내시험도 병행하였다. 이러한 시험 결과를 바탕으로 El Centro 지진에 의한 지표면 최대 가속도를 등가 선형 부지응답해석을 통해 평가한 결과 붕괴방지 수준에서 0.158g~0.286g, 기능수행 수준에서 0.067g~0.116g의 분포를 보였고 퇴적층에 의하여 형성된 경주 시가지 분지 지형에서 증폭정도가 심하다는 것을 알 수 있었다. 해석 결과로 볼 때, 현행 건교부 기준 설계응답스펙트럼은 경우에 따라 지반 운동을 과소평가하고 지반 고유의 공진 현상을 고려하지 못하였다. 이러한 문제를 해결하기 위하여 개선된 지반 분류방법을 소개하였고 부지고유의 지반응답평가의 중요성에 대해 제시하였다.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2004.09a
• /
• pp.281-285
• /
• 2004

폐기물 매립시설물은 지진에 의해 파괴될 경우 시설물 파괴로부터 인명 및 경제적인 피해와 더불어 복구하기 어려운 환경적인 문제가 발생한다. 따라서 지진시 지반 및 구조물의 거동을 정확히 예측하기 위한 신뢰성 있는 지반 가속도의 증폭현상 평가가 필요하다. 본 연구에서는 1차원 지반응답특성 평가 프로그램인 SHAKE91과 유한차분 프로그램인 FLAC을 이용 하여 폐기물 매립지에서의 지진거동 특성을 분석하였다. 1차원 해석결과 연약층이 존재하는 곳에서 지반변형이 많이 이루어졌고, FLAC 해석결과 폐기물층 사면부에서 뚜렷한 변위벡터가 발생하였으나 내진 2등급 매립지의 허용변위 30cm 이내이므로 해석 대상 구조물은 안전함을 알 수 있었다.

• Journal of the Earthquake Engineering Society of Korea
• /
• v.1 no.1
• /
• pp.57-67
• /
• 1997

The objective of present paper is to investigate elasto-plastic behaviour and estimate the resistance capacity of a beam-shear wall structural system against earthquake ground accleration exciations. Pushover analysis is adopted to estimate inttiate and post stiffnesses and yielding point for inelastic response analysis in LPM (Lumped Parameter Mass) model, and modified Clough model is used as the hysteresis rule of each story. Three earthquake waves are used in the analysis but their peak ground accelerations are changed to be 0.12g, 0.24g. It is assumed that the earthquakes act in the longigtudianl direction of a 25 Story apartment building which consists of two some unit plan. The distribution of story ratio and ductility ratio are estimated and discussed within Korean, Japanese code and UBC.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.20 no.6
• /
• pp.113-119
• /
• 2016

In this study, the method to predict the lateral response by using strain data is presented on the steel moment frame. For this, the reliability of the proposed method by applying the example of five-story frame structure were verified. Using the strain value of columns, it predicted the lateral response of structure. It is assumed that all of four strain sensors for one column set up and the strain responses of both end of the column are utilized. The lateral response of member is calculated by using the slope deflection method. Also, using the acceleration response of the one layer, the stiffness of the rotation spring located in the supporting point is predicted. As a result, it was effective to understand the lateral displacement and acceleration responses and to predict local damage and location.

• Journal of Korean Association for Spatial Structures
• /
• v.10 no.3
• /
• pp.65-74
• /
• 2010

In this study, the vibration control effect according to the installation location of the sky-bridge and the difference of natural periods of the connected buildings has been investigated. To this end, 40-story and 50-story building structures connected by a sky-bridge were used as example structures and the equivalent modeling method was used. Boundary nonlinear time history analyses were performed using El Centro and Taft earthquakes to investigate the dynamic behavior of the example structures and vibration control effect of the sky-bridge. Based on numerical results, it has been shown that displacement responses can be effectively controlled as the installation floor of the sky-bridge increases and acceleration responses can be effectively reduced when the sky-bridge is installed on the mid-stories of the example building.

• Journal of the Korean GEO-environmental Society
• /
• v.10 no.1
• /
• pp.49-54
• /
• 2009

The seismic slope stability is most often evaluated by the pseudo-static limit analysis, in which the earthquake loading is simplified as static inertial loads acting in horizontal and/or vertical directions. The transient loading is represented by constant acceleration via the pseudostatic coefficients. The result of a pseudostatic analysis is governed by the selection of the value of the pseudostatic coefficient. However, selection of the value is very difficult and often done in an ad hoc manner without a sound physical reasoning. In addition, the maximum acceleration is commonly estimated from the design guideline, which cannot accurately estimate the dynamic response of a slope. There is a need to perform a 2D dynamic analysis to properly define the dynamic response characteristics. This paper develops a new hybrid pseudostatic method that links the modified one-dimensional seismic site response analysis and the pseudostatic algorithm. The modified site response analysis adjusts the density of the layers to simulate the change in mass and weight of the layers of the slope with depth. Multiple analyses were performed at various locations within the slope to estimate the change in seismic response of the slope. The calculated peak acceleration profiles with depth from the developed procedure were compared to those by the two-dimensional analyses. Comparisons show that the two methods result in remarkable match. The calculated profiles are used to perform pseudostatic analysis. The results show that use of peak or a fraction of acceleration at the surface can seriously underestimate or overestimate the factor of safety, and that the proposed procedure significantly enhances the reliability of a standard procedure.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.32 no.6
• /
• pp.425-434
• /
• 2019

It is important to ensure the seismic safety of pile-bent bridges constructed in areas with thick soft ground consisting of various soil layers against seismic motion in these layers. In this study, several synthetic seismic waves that are compatible with the seismic design spectrum for rock sites were generated, and the ground acceleration history of each soil layer was obtained based on ground analyses. Using these acceleration histories, each soil layer was modeled using equivalent linear springs, and multi-support excitation analyses were performed using the input motion obtained at each soil layer. Due to the nonlinear behavior of the soft soil layers, the intensity of the input ground motion was not amplified, which resulted in the elastic behavior of the bridge. In addition, inputting the acceleration history obtained from a particular layer simultaneously into all the ground springs reduced the response. Therefore, the seismic performance of this type of bridge might be overestimated if multi-excitation analysis is not performed.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.29 no.1
• /
• pp.95-103
• /
• 2016

In this paper, aeroelastic instability and aerodynamic damping ratio of a helical $180^{\circ}$ model which shows better aerodynamic behavior in both along-wind and crosswind responses on a super tall building was investigated by an aeroelastic model test, and the aerodynamic damping ratio was evaluated from the wind-induced responses of the model by using Random Decrement Technique. Aerodynamic damping ratios evaluated in this study were verified through comparison with previous results obtained by quasi-steady theory. As a result, the aeroelastic instability of the helical $180^{\circ}$ model in crosswind direction were not occurred for any conditions with increasing the reduced wind velocity while the square model generally encounters aeroinstability due to the vortex shedding. The aerodynamic damping in along-wind direction for the helical $180^{\circ}$ and the square model increased monotonically both with reduced wind velocity, i.e., there is no relation with modifications of building shapes. On the other hand, in crosswind direction, the characteristics of aerodynamic damping ratio with reduced wind velocity for helical $180^{\circ}$ model were quit different from those of the square model.