• Journal of the Korean Society for Marine Environment & Energy
• /
• v.12 no.3
• /
• pp.188-196
• /
• 2009

This study conducted numerical simulations to analyze the wave characteristics(distribution) depending on the directional changes of waves in the Nakdong river estuary by using SWAN(Simulating WAves Nearshore) model. The results from the tests are summarized as below. The wave height rates are generally highly distributed with the incident waves from the S, SSE, SSW, SE, SW in sequence. When the waves from the S, SSW, SSE directions are predominant, the bigger waves were observed in front of sandbars. According to the results of the wave steepness against the wave direction, at the east coast of Gadeok island(northwest of Nakdong estuary), where has mild seabed slopes, the wave height rates distribute in the range of 0.4~0.6; the wave height rates over the west coastal region of Dadeapo(southeast of Nakdong estuary) are 0.5~0.6. The wave height rate tends to be rapidly decreased over the east region of Nakdong river estuary rather than its west region.

• The Journal of the Acoustical Society of Korea
• /
• v.29 no.5
• /
• pp.303-313
• /
• 2010

This paper describes an acoustic communication receiver structure, which is designed for QPSK (Quadrature Phase Shift Keying) signal with 25 kHz carrier frequency and 5 kHz symbol rate, and takes samples from received signal at 100 kHz sampling rate. Based on the described receiver structure, optimum design parameters, such as number of taps of FF (Feed-Forward) and FB (Feed-Back) filters and forgetting factor of RLS (Recursive Least-Square) algorithm, of joint equalizer are determined to minimize the BER (Bit Error Rate) performance of the joint equalizer output symbols when the acquisition data in shallow water using implemented acoustic transducers is decimated at a rate of 2:1 and then enforced to the input of receiver. The transmission distances are 1.4 km, 2.9 km, and 4.7 km. Analysis results show that the optimum number of taps of FF and FB filters are different according to the distance between source and destination, but the optimum or near optimum value of forgetting factor is 0.997. Therefore, we can reach a conclusion that the proper receiver structure could change the number of taps of FF and FB filters with the fixed forgetting factor 0.997 according to the transmission distance. Another analysis result is that there are an acceptable performance degradation when the 16-tap-length simple filter is used as a low-pass filter of receiver instead of 161-tap-length matched filter.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.10 no.4
• /
• pp.204-210
• /
• 1998

This paper presents the development of the probability density function applicable for wave heights (peak-to-trough excursions) in finite water depth including shallow water depth. The probability distribution applicable to wave heights of a non-Gaussian random process is derived based on the concept of the maximum entropy method. When wave heights are limited by breaking wave heights (or water depth) and only first and second moments of wave heights are given, the probability density function developed is closed form and expressed in terms of wave parameters such as $H_m$(mean wave height), $H_{rms}$(root-mean-square wave height), $H_b$(breaking wave height). When higher than third moment of wave heights are given, it is necessary to solve the system of nonlinear integral equations numerically using Newton-Raphson method to obtain the parameters of probability density function which is maximizing the entropy function. The probability density function thusly derived agrees very well with the histogram of wave heights in finite water depth obtained during storm. The probability density function of wave heights developed using maximum entropy method appears to be useful in estimating extreme values and statistical properties of wave heights for the design of coastal structures.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.32 no.2
• /
• pp.106-121
• /
• 2020

In order to make harbor outskirt facilities robust using the reliability-based design, probabilistic models of wave heights at varying stage of shoaling process optimized for Korean sea waves are prerequisite. In this rationale, we numerically simulate the nonlinear shoaling process of random waves over the beach with a sandbar at its foreshore. In doing so, comprehensive numerical models made of spatially filtered Navier-Stokes Eq., LES [Large Eddy Simulation], dynamic Smagorinsky turbulence closure were used. Considering the characteristics of swells observed at the east coast of Korean Peninsula, random waves were simulated using JONSWAP wave spectrum of various peak enhancement coefficients and random phase method. The coefficients of probabilistic models proposed in this study are estimated from the results of frequency analysis of wave crests and its associated trough detected by Wave by Wave Analysis of the time series of numerically simulated free surface displacements based on the threshold crossing method. Numerical results show that Modified Glukhovskiy wave height distribution, the most referred probabilistic models at finite water depth in the literature, over-predicts the occurring probability of relatively large and small wave heights, and under predicts the occurrence rate of waves of moderate heights. On the other hand, probabilistic models developed in this study show vary encouraging agreements. In addition, the discrepancy of the Modified Glukhovskiy distribution from the measured one are most visible over the surf zone, and as a result, the Modified Glukhovskiy distribution should be applied with caution for the reliability-based design of harbor outskirt facilities deployed near the surf-zone.

• Geophysics and Geophysical Exploration
• /
• v.26 no.4
• /
• pp.185-198
• /
• 2023

In marine seismic surveys, the inevitable occurrence of trace gaps in the near offset resulting from geometrical differences between sources and receivers adversely affects subsequent seismic data processing and imaging. The absence of data in the near-offset region hinders accurate seismic imaging. Therefore, reconstructing the missing near-offset information is crucial for mitigating the influence of seismic multiples, particularly in the case of offshore surveys where the impact of multiple reflections is relatively more pronounced. Conventionally, various interpolation methods based on the Radon transform have been proposed to address the issue of the nearoffset data gap. However, these methods have several limitations, leading to the recent emergence of deep-learning (DL)-based approaches as alternatives. In this study, we conducted an in-depth analysis of two representative DL-based studies to scrutinize the challenges that future studies on near-offset interpolation must address. Furthermore, through field data experiments, we precisely analyze the limitations encountered when applying previous DL-based trace interpolation techniques to near-offset situations. Consequently, we suggest that near-offset data gaps must be approached by extrapolation rather than interpolation.

• Journal of the Korean earth science society
• /
• v.28 no.1
• /
• pp.64-74
• /
• 2007

The marine seismic prospecting using a research vessel in the shallow sea near the coastal area has certain limits according to the water depth and survey environment. Also, for the electrical resistivity survey at seashore area, one may need a specially designed high-voltage source to penetrate the very conductive surface layer. Therefore, we have conducted a feasibility study on the application of magnetotelluric method (MT), a passive geophysical method, on investigating of shallow marine environment geology. Our study involves both theoretical modeling and field survey at the tidal flat area which represent the very shallow marine environment. We have applied the audio-frequency magnetotelluric (AMT) method to the intertidal deposits of Gunhung Bay, west coast of Korea, and analysed the field data both qualitatively and quantitatively to investigate the morphology and sedimentary stratigraphy of the tidal flat. The inversion of AMT data well reveals the upper sedimentary layer of Holocene intertidal sediments having a range of 13-20 m thickness and the erosional patterns at the unconformable contact boundary. However, the AMT inversion results tend to overestimate the depth of basement (30-50 m) when compared with the seismic section (27-33 m). Since MT responses are not significantly sensitive to the resistivity of middle layer or the depth of basement, the AMT inversion result for basement may have to be adjusted using the comparison with other geophysical information like seismic section or logging data if possible. But, the AMT method can be an effective alternative choice for investigating the seashore area to get important basic informations such as the depositional environment of the tidal flat, sea-water intrusion and the basement structure near the sea shore.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.14 no.4
• /
• pp.308-318
• /
• 2002

The requirements to the numerical model of wind-generated waves in shallow water are discussed in the framework of the Korteweg-de Vries equation. The weakness of nonlinearity and dispersion required for the Korteweg-de Vries equation applicability is considered for fully developed sea, non-stationary wind waves and swell, including some experimental data. We note for sufficient evaluation of the freak wave statistics it is necessary to consider more than about 10,000 waves in the wave record, and this leads to the limitation of the numerical domain and number of realizations. The numerical modelling of irregular water waves is made to demonstrate the possibility of effective evaluation of the statistical properties of freak waves with heights equal to 2-2.3 significant wave height.

• Journal of the Korean earth science society
• /
• v.33 no.1
• /
• pp.1-10
• /
• 2012

Analysis on high-resolution seismic and core data reveals that the sedimentary strata in Gyeonggi Bay consists of four sedimentary units (Unit I-IV, from top to bottom) formed during the late Quaternary period. Unit I is interpreted as sediments of tidal flat and channel-fill deposits, formed during the Holocene transgression. Unit II is divided into shallow-marine facies unit in offshore area and channelized fluvial to estuarine facies unit in nearshore sand ridge and tidal flat. Unit III is considered as tidal flat deposits with the uppermost severely weathered and oxydized layers. This unit is composed of shallow marine sedimentary successions formed during the MIS-5 highstand. The lowermost Unit IV rests on Mesozoic basement rocks, considered as the shallow marine and shelf deposits formed before the MIS-5 lowstand.

• The Journal of the Acoustical Society of Korea
• /
• v.32 no.6
• /
• pp.455-471
• /
• 2013

Active sonar has been commonly used to detect targets existing in the shallow water. When a signal is transmitted and returned back from a target, it has been distorted by various properties of acoustic channel such as multipath arrivals, scattering from rough sea surface and ocean bottom, and refraction by sound speed structure, which makes target detection difficult. It is therefore necessary to consider these channel properties in the target signal simulation in operational performance system of active sonar. In this paper, a monostatic active sonar system is considered, and the target echo, reverberation, and ambient noise are individually simulated as a function of time, and finally summed to simulate a total received signal. A 3-dimensional highlight model, which can reflect the target features including the shape, position, and azimuthal and elevation angles, has been applied to each multipath pair between source and target to simulate the target echo signal. The results are finally compared to those obtained by the algorithm in which only direct path is considered in target signal simulation.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.1 no.1
• /
• pp.22-30
• /
• 1989

Wave propagation is changed by the effect of shoaling, current-depth refraction and shelter-ing etc. To solve these problems. numerous models have been developed. In the present study, a coordinate system is proposed based on the wave ray equation with the wave number equation including diffraction effects . The governing equation for the study was derived from the mild slope wave equation in non-steady state, including current effects (Kirby, 1986a) and trans-formed into an orthogonal curvilinear coordinate system on the basis of the wave ray equation. To obtain a numerical solution, an explicit finite difference scheme was used, and solved by the relaxation method. This model was tested for various cases: Firstly a submersed circular shoal and a constant unit depth. Secondly a submerged elliptic shoal on a slope, and finally a breakwater harbour with obliquely incident waves on a slope. The model was found to simulate the experimental results and other theoretical results in wave height and wave angle fairy well, and the applicability of the model around an arbitrary shaped coastal structure was also verified. To demonstrate the general usefullness of the present approach , the model is to be applied to a field situation with a complex bed topography.