• The Sea:JOURNAL OF THE KOREAN SOCIETY OF OCEANOGRAPHY
• /
• v.7 no.3
• /
• pp.95-99
• /
• 2002

3.5KHz subbottom profiling systems are useful for delineating of shallow (up to 10~100m below the sea bottom) geological structure. These systems are generally used to image geological structures with less than 1m of vertical resolution. However swell in the sea is quite often higher than 1m, causing degradation in the quality of the 3.5KHz subbottom profiles. In this paper, we show the quality of digitally recorded data can be enhanced by the suppression of swell effect. Prior to suppression of swell effect, sea bottom detection procedure was applied using the characteristics that the amplitude of sea bottom reflection is high. To suppress the swell effect, we applied moving average method and high-cut filtering method using the extracted water depth of adjacent traces. Acceptable results were obtained from both methods. In the case of bad quality data or shallow data interfered with direct wave, the suppression of swell effect is difficult due to incorrect sea bottom detection.

• Geophysics and Geophysical Exploration
• /
• v.26 no.3
• /
• pp.138-149
• /
• 2023

In geoscience and engineering the geological characteristics of sediment strata is crucial and possible if reliable borehole logging and seismic data are available. To investigate the characteristics of the shallow strata in the Korea Strait, laboratory sonic logs were obtained from deep borehole data and seismic section. In this study, we integrated and analyzed the sonic log data obtained from the drilling core (down to a depth of 200 m below the seabed) and multichannel seismic section. The correlation value was increased from 15% to 45% through time-depth conversion. An initial model of P-wave impedance was set, and the results were compared by performing model-based, band-limited, and sparse-spike inversions. The derived P-impedance distributions exhibited differences between sediment-dominant and unconsolidated layers. The P-impedance inversion process can be used as a framework for an integrated analysis of additional core logs and seismic data in the future. Furthermore, the derived P-impedance can be used to detect shallow gas-saturated regions or faults in the shallow sediment. As domestic deep drilling is being performed continuously for identifying the characteristics of carbon dioxide storage candidates and evaluating resources, the applicability of the integrated inversion will increase in the future.

• Journal of the Korean Geophysical Society
• /
• v.9 no.4
• /
• pp.427-441
• /
• 2006

Sub-bottom profiler and deep tow imaging system were performed in the KODOS (Korea Deep Ocean Study) area in order to find out controlling factor in nodule formation from the relationship between distribution of Mn nodules and micro-scale topographic change. Although abundance of r- and t- types nodules increase on the seafloor of thin upper transparent layer, no significant correlation was found between the thickness of upper transparent layer and total nodule abundance in the study area. Our results show that distribution pattern of nodule, including abundance, continuity, and facies, can vary with small scale in similar abyssal plain.

• Geophysics and Geophysical Exploration
• /
• v.25 no.1
• /
• pp.1-13
• /
• 2022

For surveying shallow gas reservoirs in the Pohang basin, we proposed a seismic exploration method applicable to the transition zone in which land and marine areas are connected. We designed the seismic acquisition geometry considering both environments. We installed land nodal receivers on the ground and employed vibroseis and airgun sources in both land and marine areas. For seismic exploration in the transition zone, specific acquisition and processing techniques are required to ensure precise matching of reflectors at the boundary between the onshore and offshore regions. To enhance the continuity of reflection events on the seismic section, we performed amplitude and phase corrections with respect to the source types and applied a static correction. Following these processing steps, we obtained a seismic section showing connected reflectors around the boundary in the transition zone. We anticipate that our proposed seismic exploration method can also be used for fault detection in the transition zone.

• Journal of Advanced Marine Engineering and Technology
• /
• v.34 no.8
• /
• pp.1222-1229
• /
• 2010

Compared to conventional high resolution acoustic profiling, ultra high resolution shallow acoustic profiling using parametric echo sounder is limited in penetration, yet it provides resolution suitable for detailed seabed investigation in the shallow waters. The parametric sub-bottom profiler system provides not only the exact determination of water depth, but also the detailed information about sediment layers and sub-bottom structures. Possible applications include dredging project, search of buried pipeline, ship wrecks, and other artificial objects through the detailed mapping of thickness and structure of the upper sedimentary layers. In this study, contaminated sediments were discriminated by the correlation of ultra high resolution profiles with geologic data. In addition, the burial depth of the submarine cable was measured by the interpretation of acoustic anomalies in the profiles.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.5 no.2
• /
• pp.143-150
• /
• 1993

Shallow sub-bottom reflection recorders are obtained using dual frequency (15/100 KHz). The main goal of this study is to enhance the resolving power and penetration for the sub-bottom reflection of the sub-marine seismic exploration. The Fresnel zones of spherical waves for the near-field are of great importance to reach the high resoluton. In case a target to detects than the Fresnel radius, a diffraction hyperbola on the recorder is observed. A larger attenuation of sand makes less penetration than the smaller attenuation of silt and clay. It is found that the selective frequency as well as the seismic energy generation is the most important factors for sub-marine exploration. This technique of using dual frequency sub-marine exploration may be applied to detect the sub-bottom sludge soil, ocean contamination and marine archaeological relics.

• Geophysics and Geophysical Exploration
• /
• v.8 no.1
• /
• pp.7-17
• /
• 2005

The determination of seismic velocities in refractors for near-surface seismic refraction investigations is an ill-posed problem. Small variations in the computed time parameters can result in quite large lateral variations in the derived velocities, which are often artefacts of the inversion algorithms. Such artefacts are usually not recognized or corrected with forward modelling. Therefore, if detailed refractor models are sought with model based inversion, then detailed starting models are required. The usual source of artefacts in seismic velocities is irregular refractors. Under most circumstances, the variable migration of the generalized reciprocal method (GRM) is able to accommodate irregular interfaces and generate detailed starting models of the refractor. However, where the very-near-surface environment of the Earth is also irregular, the efficacy of the GRM is reduced, and weathering corrections can be necessary. Standard methods for correcting for surface irregularities are usually not practical where the very-near-surface irregularities are of limited lateral extent. In such circumstances, the GRM smoothing statics method (SSM) is a simple and robust approach, which can facilitate more-accurate estimates of refractor velocities. The GRM SSM generates a smoothing 'statics' correction by subtracting an average of the time-depths computed with a range of XY values from the time-depths computed with a zero XY value (where the XY value is the separation between the receivers used to compute the time-depth). The time-depths to the deeper target refractors do not vary greatly with varying XY values, and therefore an average is much the same as the optimum value. However, the time-depths for the very-near-surface irregularities migrate laterally with increasing XY values and they are substantially reduced with the averaging process. As a result, the time-depth profile averaged over a range of XY values is effectively corrected for the near-surface irregularities. In addition, the time-depths computed with a Bero XY value are the sum of both the near-surface effects and the time-depths to the target refractor. Therefore, their subtraction generates an approximate 'statics' correction, which in turn, is subtracted from the traveltimes The GRM SSM is essentially a smoothing procedure, rather than a deterministic weathering correction approach, and it is most effective with near-surface irregularities of quite limited lateral extent. Model and case studies demonstrate that the GRM SSM substantially improves the reliability in determining detailed seismic velocities in irregular refractors.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2002.09a
• /
• pp.144-147
• /
• 2002

효과적인 국내 충적층 지하수의 이용을 위해서는, 충적 대수층의 내부 구조를 정밀하게 평가하여야 한다. 특히, 강변여과, 인공 침투지 등의 적극적인 충적 대수층의 활용을 위해서는 충적 대수층의 퇴적 환경에 대한 이해가 요구된다. 국내 충적층의 대부분은 하천 둔치 주변에서 하도의 수평 이동에 의해 형성된 경사 지층으로, 니질 박층이 협재하므로 내부의 분균일성에 의해 인접한 취수 공간에도 지하수체의 이동 특성 및 화학적 특성이 달라질 수 있다. 본 연구는 이러한 불균질성을 박히기 위해 지하투과레이다(GPR)를 이용하여 부여 군수리 지역의 천부 충적층에 대한 퇴적학적 분석을 시도하였다. 군수리 지역은 크게 상하 두 개의 충적층으로 구분되며, 상부 수평층은 범람에 의해 형성된 것으로 수직 불균질성이 크고 수평 불균질성은 낮다. 하부 경사층은 수평, 수직 불균질성이 모두 크다. 특히 하부 경사층내에 발달한 하도곡은 인접한 충적층과 분리되어 이 층내의 지하수체 이동은 제한적일 것이고 수질 특성 또한 크게 다를 것으로 판단된다. 본 연구는 충적 대수층에 대한 물리 화학적 특성의 정확한 해석을 위해서 퇴적학적 해석이 선행되어야 함을 시사한다.

• Economic and Environmental Geology
• /
• v.28 no.5
• /
• pp.481-485
• /
• 1995

This paper presents a new approaching method to determine the velocity and geometry of shallow subsurface from seismic refraction events. After picking the first breaks from seismic refraction data, we assume that field refraction seismogram can be replaced by the unit delta function having time shift of first break. Time curves are generated by shooting ray tracing. The partial derivatives seismogram for a damped least squares method is computed analytically at each step of the forward ray tracing. The technique is successfully tested on synthetic and real data. It has the advantage of real full waveform inversion, which is robust at low frequency band even if the initial guess is far from the true model.

• Geophysics and Geophysical Exploration
• /
• v.18 no.4
• /
• pp.181-196
• /
• 2015

A 3.5 kHz or chirp sub-bottom profiling survey is widely used in the marine geological and engineering purpose exploration. However, swells in the sea degrade the quality of the survey data. The horizontal continuity of profiler data can be enhanced and the quality can be improved by correcting the influence of the swell. Accurate detection of sea bottom location is important in correcting the swell effect. In this study, we tried to pick sea bottom locations by finding the position of crossing a threshold of the maximum value for the raw data and transformed data of envelope or energy ratio. However, in case of the low-quality data where the sea bottom signals are not clear due to sea wave noise, automatic sea bottom detection at the individual traces was not successful. We corrected the mispicks for the low quality data and obtained satisfactory results by picking a sea bottom within a range considering the previous average of sea bottom, and excluding unreliable big-difference picks. In case of trace by trace picking, fewest mispicks were found when using energy ratio data. In case of picking considering the previous average, the correction result was relatively satisfactory when using raw data.