• Journal of Advanced Navigation Technology
• /
• v.10 no.3
• /
• pp.213-218
• /
• 2006

In this paper, we analyzed the performance of orthogonal frequency division multiplexing/ frequency hopping multiple access(OFDM/FHMA) hybrid system that in impulsive interference and broadband wireless communication channel then we applied the turbo code scheme to make satisfied in data and voice transmission service. Also, we compared the bit error rate(BER) performance of turbo coded diversity scheme in the OFDM/FHMA hybrid system. As a result of simulation, proposed OFDM/FHMA hybrid system shows the enhancement of 10 times compared to the general OFDM/FHMA system.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.15 no.7
• /
• pp.4489-4493
• /
• 2014

LED light driving device has problems in efficiency and heating at higher than 150W. In addition, there is inconvenience in replacing the lighting device to another when W is not the same as the previous one. In this paper, a multi-channel LED light driver, driver embedded driver circuit in a multi-channel structure with a power system in the driver-interlocking structure was designed. With the auto control converter structure with a power efficiency above 93% and power factor above 0.98, the weight of the high efficiency LED lighting-actuating device in driver-interlocking structure, a driver in self-calibrating self-optimization structure. In this paper, at below 10% THD, the existing converter contrast weight was reduced by 40% or more.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.13 no.3
• /
• pp.1-7
• /
• 2013

We perform simulation. It is that LED panels is fixed and moving the terminal with PD in order to analyze the performance of visible-light wireless communication system based on MIMO under variety of the interference environment. And, based on the technology MIMO, we analyzed whether the interference caused by external light to give what effect changes in the quality of the communication channel. The distortion due to time delay in channel transmission must be compensated by using the equalizer. Especially, use of equalizer is need absolutely as data rate becomes high speed. Therefore, in this paper, the system VLC, were analyzed BER performance using channel equalization.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.3A
• /
• pp.160-167
• /
• 2005

The gain-clamped EDFA has been developed to eliminate the output power change of WDM surviving channels to occur with added or dropped channels, which degrades the performance of WDM optical network. It maintains the constant gain of surviving channels when WDM channels are added or dropped in a network amplifying node. In this paper, the hi-directionally pumped gain-clamped EDFA is implemented to compensate the change of the input power by a lasing. The results show that the lasing of a short wavelength and backward propagation is the optimal condition to minimize the transient response of surviving channels in terms of the overshoot and gain saturation due to the inhomogeneous broadening effect.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.11C
• /
• pp.1107-1119
• /
• 2006

Data transmission experiences multiplicative distortion in frequency nonselective fading channel. This distortion occurs in OFDM communication channel and can be compensated using an equalizer. Usually, in the case of LMS equalizer, eigenvalue distribution of training signal is enlarged. Large eigenvalue distribution causes principally the performance of a communication system to be deteriorated. This paper proposes a new algorithm that shows the same performance as the existing fast wavelet transform algorithm with less computational complexity. The proposed algorithm was applied to an adaptive equalizer of OFDM communication system. Matlab simulation results show a better performance than the existing one. The proposed algorithm was implemented in VHDL and simulated.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.43 no.11 s.353
• /
• pp.77-82
• /
• 2006

Analog channel selection filter is described which is designed for a direct-conversion receiver of a IEEE 802.11a wireless LAN. The channel selection filter is an active-RC fifth-order Chebyshev filter with 10MHz cut-off frequency. Two-stage operational amplifier of the filter employs a current re-using feedforward frequency compensation scheme to minimize the power consumption. The filter has been implemented in a 0.18mm CMOS technology and the experimental results show 20mW power consumption with 1.8V supply voltage and 19dB out-of-band iIP3.

• The Journal of the Acoustical Society of Korea
• /
• v.15 no.2
• /
• pp.55-60
• /
• 1996

This paper describes the subjective assessment of the multi-channel audio quality according to the bitrate changing and evaluates the predistortion effect to avoid the unmasked noise after matrixing/dematrxing process in transmission and regeneration of the multi-channel audio. The simulation is processed by the perceptual coding that is MPEG-2 Audio layer II algorithm. We evaluate the quality improvement about predistortion using or not by 384, 320, 256, 128kbps. As the result of the double blind subjective assessment, 5 Grade-Impairment Scale is scored under minus one to 320kbps and so audio quality is evaluated to be perceptible, but not annoying in 3/2 channel. The effect of the predistortion is improved one level in 128kbps and especially speech test material I better improved than music test materials.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2008.10a
• /
• pp.689-692
• /
• 2008

WAVE based on OFDM is made for vehicle to vehicle wireless communication. Its performance is decreased by continual timing delay in multipath fading channels after starting initial timing synchronization. In this paper, the tracking algorithm that synchronizes symbol timing is proposed to continually compensate additional timing delay. Computer simulation of the proposed algorithm is performed in the worst communication environment that applies to maximum timing delay. Computer simulation shows that the proposed algorithm can improve the system performance in various channel conditions.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.11 no.2
• /
• pp.158-165
• /
• 2000

In this paper, the transmission channels of L-band and Ka-band multi-media satellite communication systems for the land mobile satellite(LMS) communication service are modeled. Trellis coded(TC) 8PSK is proposed as a power and bandwidth efficient digital transmission scheme for the LMS system, and its error probability performance is analyzed. Block interleaving and deinterleaving are applied to the transmitter and receiver of LMS system respectively in order to compensate for the BER performance degradation of TC-8PSK caused by multipath fading. Viterbi equalizer is also employed in the receiver for channel equalization, and the corresponding BER performance improvement is analyzed.

• Proceedings of the Korean Nuclear Society Conference
• /
• 1998.05a
• /
• pp.526-531
• /
• 1998

본 논문은 농축도 0.9%의 순환우라늄 핵연료(CANFLEX-RU)에 대한 축방향 출력분포(AFD) 및 반경방향 출력분포(RFD) 특성을 조사하고 CANFLEX-RU 다발이 장전된 CANDU줄 채널의 예비 열수력 해석을 수행하였다. CANFLEX-RU 다발의 4 bundle shift 핵연료 교체 방법에 따라 AFD 분포 특성은 정점(Peak) 열속이 채널 상류쪽으로 이동하였고 채널 중심 부근에서 평탄하거나 다소 오목한 형상을 보여주었다. RFD 분포를 표현하는 적절한 변수로서 국부 다발열유속비를 정의하고, 이 비와 국부 표면열유속비의 상호 관계식을 도출하였다. 연소도에 따른 최외환봉의 국부 다발열유속비 변화를 조사한 결과로서, CANFLEX-RU 다발의 최대 국부 다발열유속비는 초기 연소도에서 발생되었고 이 값 CANFLEX-NU 다발 보다는 크고 37-핵연료봉다발 보다는 작았다. CCP 계산시에 RFD 분포 효과를 고려하는 방안으로서 최외환봉 열유속을 다발의 국부 열유속으로 가정하였다 이는 임계열유속이 -10.2% 감소한 조건을 사용하여 CCP를 계산하는 결과가 되었다. 다발-블균형 계수를 이용한 CCP 민감도 결과와 본 계산에서 얻은 CCP 결과에 의하면, CANFLEX-RU의 CCP 는 CANFLEX-NU에 비교해서 土1.0% 이내로 근사한 분포가 예상되었으며 이는 AFD 분포 효과가 RFD 분포에 의한 CCP 감소를 보상하기 때문이다. 결론적으로, CANFLEX-RU는 열수력적 설계 관점에서 CANFLEX-NU에 비교해서 열적 성능이 저하되지 않았고 따라서 기존 37-핵연료봉다발에 대한 CANFLEX-NU의 열여유도 증가와 같은 장점을 유지할 것으로 예상되었다.