• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.41 no.12
• /
• pp.1765-1767
• /
• 2016

Non-coherent UWB receivers are promising due to the low hardware complexity while the coherent receiver such as the rake receiver requires the complex hardware to estimate channel characteristics and get the synchronization. In this letter, the block coded modulation scheme as one of the most promising method is enhanced in terms of the performance. The performance enhancement is carried out by the modification of the block structure with unequal frame length for each pulse. Simulation results show that the proposed method has the performance enhancement by the transmission rate or bit error rate.

• Korean Journal of Optics and Photonics
• /
• v.8 no.1
• /
• pp.63-67
• /
• 1997

We have experimentally investigated the fiber four-wave mixing effect on equal spaced multichannel optical transmission system with dispersion shifted fiber. To reduce the fiber four-wave mixing effect, we set the polarization states of the adjacent channels to be orthogonal each other by using polarization controller. In this case, we can reduce the transmission power penalty by 1.5 dB compared with that of equal polarization states.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.11 no.2
• /
• pp.273-279
• /
• 2007

I evaluate the BER performance of OFDM systems in frequency selective Doppler time variant fading channels, considering the pilot patterns for channel estimation. The performance of the systems is degraded due to channel estimation error. For the reduction of performance degradation in acceptable level, the optimum distance of pilot symbols in pilot pattern is 5 subcarriers in frequency domain and 6 OFDM block in time domain.

• Journal of Korean Society of Steel Construction
• /
• v.15 no.2
• /
• pp.109-116
• /
• 2003

An investigation on the structural behavior of cold-formed steel lipped C-section stud for interior walls or partitions was carried out. This experimental research was carried out to study the ultimate and service load capacity of stud assemblies that are subjected to lateral loads. Each test specimen consisted of three or four lipped C-section studs and two C-section tracks that restrained both ends. The major factors considered in this experiment were the perforation on the web, the connection of the bridge channel and the special clip. The effect of the plaster board and the ply wood, which were attached to the tension flange on the flexural strength, was also investigated. Thereafter, the test strength capacities were compared with the nominal strength, based on the AISI Specifications (1996).

• Journal of the Institute of Electronics and Information Engineers
• /
• v.53 no.11
• /
• pp.3-8
• /
• 2016

In this paper, we design to generate 12.5 GHz spaced 256 number of multi-carrier generation module using 32 laser diodes. We modulate the generated multi-carrier generation module by 12.4 Gbps, and confirm the performance of optical channels passing through recirculating loop up to 1000km distance. An experimental result shows that the carrier away from the laser diode is significantly influence by noise effect.

• Proceedings of the KIEE Conference
• /
• 2006.07d
• /
• pp.2043-2044
• /
• 2006

배전 계통을 대상으로 하는 통신 시스템에 전력통신(PLC : Power Line Communication)기술을 적용하고자 할 때, 고압 배전선의 통신 채널로서의 특성 분석이 근간이 되어야 한다. 일반적으로 지하 공동구의 배전 지중 케이블에는 케이블-케이블 간의 전기적, 물리적 접촉점인 접속 개소가 일정한 간격으로 존재하게 된다. 그러므로 통신 신호의 매개체가 되는 전력 케이블의 채널 특성 분석에는 케이블 접속 개소의 영향도 고려 대상이 되어야 한다. 본 논문에서는 서울시 광진구 일부의 부하를 담당하고 있는 22.9 kV 고압 배전 지중 선로를 시험 선로로 비접촉식 커플러를 통해 통신 신호를 전송하여 삽입 손실 측정 결과를 보았고 케이블 접속 개소의 영향을 주파수 영역에서 채널 특성을 통해 분석 하였다. 시험 결과 케이블 접속 개소를 통과할 때 채널 특성은 십여 dB의 신호 감쇄를 보였다.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.41 no.4
• /
• pp.49-55
• /
• 2004

This paper describes a 1550 nm multichannel source using Quatemary/quatemary multiple quantum well (MQW) InGaAsP/InGaAsP quantum confined Stark effect (QCSE) tuning for dense wavelength division multiplex (DWDM) systems with 140 ㎓ channel spacing and 32 nm channel selection bandwidth.

• Proceedings of the Korean Institute of Communication Sciences Conference
• /
• 1996.10a
• /
• pp.1016-1019
• /
• 1996

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.10A
• /
• pp.912-921
• /
• 2005

Optical burst switching(OBS) is a promising solution for building terabit optical routers and realizing If over WDM. Channel scheduling Algorithm for reduce contention is one of the major challenges in OBS. We address the issue of how to provide basic burst channel scheduling in optical burst switched WDM networks with fiber delay lines(FDLs). In OBS networks the control and payload components or a burst are sent separately with a time gap. If CHP arrives to burst switch node, because using scheduling algorithm for data burst, reservation resources such as wavelength and transmit data burst without O/E/O conversion, because contention and void between burst are happened at channel scheduling process for data burst that happened the link utilization and bust drop probability Existent proposed methods are become much research to solve these problems. Propose channel scheduling algorithm that use Release Time of bust to emphasize clearance between data and data dissipation that is happened in data assignment in this treatise and maximize bust drop probability and the resources use rate (RTUC : Release Time Unscheduled Channel). As simulation results, Confirmed that is more superior in terms of data drop and link utilization than scheduling algorithm that is proposed existing. As simulation results, confirmed improved performance than scheduling algorithm that is proposed existing in terms of survival of burst, efficiency resource and delay. However, In case load were less, degradation confirmed than existent scheduling algorithm relatively, and confirmed that is superior in data drop aspect in case of load increased.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.2A
• /
• pp.43-50
• /
• 2005

In this paper, we present an improved channel estimation method for orthogonal frequency division multipexing systems using pilot symbol assisted modulation(PSAM). Conventional linear minimum mean square error(LMMSE) channel estimation method uses only pilot symbols for channel estimation. So, as the fading channel varies rapidly, the system performance is degraded. The basic idea of the proposed scheme is that we firstly estimate channel coefficients at the middle point between two pilot symbols and then compute the channel attenuation by using LMMSE method. Superior performance achieved with the proposed method is illustrated by simulation experiments with the Doppler frequency of 36Hz and 185Hz in comparison with conventional LMMSE channel estimator.