• Journal of Energy Engineering
• /
• v.25 no.4
• /
• pp.74-84
• /
• 2016

After Sep. 2017, the LEV3 emission standard will be applied to gasoline and gas vehicles in Korea. This standard has HWFET and SFTP standard as well as FTP-75. Most of LPG vehicles were certificated as SULEV in Korea. Until now, only FTP-75 standard is applying for the certification but it is expected that HWFET and SFTP are used after beginning LEV3. In this paper, 8 LPG and 4 gasoline vehicles were tested on FTP-75 and SFTP to check whether the LPG vehicles can meet LEV3 SFTP standard or not and to suggest direction of development. Most of test vehicles did not meet the SFTP standard. To make up for the fault, fuel injection control improvement is needed.

• Proceedings of the Korea Air Pollution Research Association Conference
• /
• 2001.11a
• /
• pp.211-212
• /
• 2001

자동차 생산공정은 일반적으로 프레스, 차체, 도장, 의장으로 구분되어 진다. 특히 차량의 조립 완성 후 엔진과 하부 샤시를 검사하는 Test 라인 공정에서는 차량운전 상태에서만 검사를 실시하는 작업특성 때문에 자동차 배기가스가 실내환경 오염을 유발하고 있다. 그래서 대부분 자동차 공장의 경우 배출가스에 대한 제어방식 및 배기 유량 부족으로 자동차 생산을 위하여 실내에서 작업하는 근로자들에게 두통 및 호흡기질환이 유발되고 있다. (중략)

• Journal of the korean Society of Automotive Engineers
• /
• v.10 no.4
• /
• pp.19-28
• /
• 1988

1. 인증후 차량의 추가변경. 2. 양산검사. 3. 성능보증. 4. 결함시정. 5. 시험검사 방법. 6. 한국 배출가스 규제의 예외 규정.

• Journal of the Korean Institute of Gas
• /
• v.19 no.6
• /
• pp.34-39
• /
• 2015

Recently, most of the energy consumed in vehicle is derived from fossil fuels. For this reason, the demand for clean, renewable and affordable alternative energy is forcing the automotive industry to look beyond the conventional fossil fuels. Natural gas represents today a promising alternative to conventional fuels for vehicles propulsion, because it is characterized by a relatively low cost, better geopolitical distribution than oil, lower environmental impact, higher octane number and a higher self ignition temperature. Above all, CNG is an environmentally clean alternative to the existing spark ignition engines with the advantages of minimum change. In this study was installed bi-fuel system that a conventional 2 liters gasoline engine was modified to run on natural gas by a gas injection system. Experiments were mainly carried on the optimization of an ECU control strategy affecting the emission characteristics of CNG/Gasoline bi-fule vehicle. The test results shown that CO2 emission in bi-fuel mode was reduced 16% compared to gasoline fuel in the NEDC mode. Also the amount of CO and HC emissions in bi-fuel and gasoline modes were found to equality. But Compared to gasoline, the bi-fuel mode resulted in higher NOx emissions.

• Journal of Korean Society of Transportation
• /
• v.29 no.4
• /
• pp.85-93
• /
• 2011

Many policies, such as transit-oriented development, encouraged use of bicycle and pedestrian, reduction of green house gas (GHG) and etc., have been deployed to support transport sustainability. Although various studies regarding GHG were presented, no one has yet adequately explained the behavior of travelers. This paper proposes a GHG emission model by highlighting its sensitivity, elasticity with regard to such travel cost as travel time, travel fare, and GHG pricing, introduced to reduce the amount of GHG in transportation system. For better estimation of GHG, the proposed model adopts (1) a production-constrained gravity model and (2) the travel distance from the origin and the destination (OD). The gravity model has a merit that it considers travel pattern between OD pairs. The model was tested with an example, and the promising results confirmed its validation and applications.

• Proceedings of the Korea Air Pollution Research Association Conference
• /
• 2001.11a
• /
• pp.183-184
• /
• 2001

전 세계적으로 철도차량에 의한 대기오염물질은 도로 차량과 기타 산업부문과 비교할 때 비교적 낮은 비율을 차지하지만 점차 미세먼지나 질소산화물의 배출량이 증가하면서 주요 대기오염원으로 부각되고 있다. 최근 미국 등 선진국을 중심으로 배출가스 규제대상을 기존의 도로용 차량에서 비도로용 차량까지 확대적용하고 있으며, 우리나라에서도 이에 대한 대책마련을 서두르고 있다. (중략)

• Journal of Energy Engineering
• /
• v.24 no.4
• /
• pp.33-41
• /
• 2015

Dimethyl ether (DME) can be used as a clean diesel alternative fuel due to the high cetane number and low emission, it can also be applied to automotive fuel as a blended liquefied petroleum gas (LPG) because physical properties are similar to those of LPG. In this study, feasibility test of LPG vehicle using blended DME-LPG fuel was investigated. Three types of fuel supply such as LPLi (Liquid phase LPG injection), LPGi (Liquid phase gas injection) and mixer type were selected to consider the LPG fuel-injection system. The performance characteristics of LPG vehicle were examined by using LPG and blended DME-LPG fuel in order to compare the exhaust emissions (CO, THC, $NO_X$) and fuel economy. The emissions and fuel economy of DME-LPG blend fuel were comparable to those of LPG with increasing driving distance.

• Journal of the Society of Disaster Information
• /
• v.16 no.3
• /
• pp.550-557
• /
• 2020

Purpose: Greenhouse gases are one of the major causes of global warming, a global disaster. In this study, the priority that affects when calculating the GHG emissions in the road sector is accurately calculated based on the speed of individual vehicles from the existing section average speed. I have the purpose of finding a possible factor. Method: A comparative analysis is conducted between the conventional method of the general passage section, the rest area section, the entrance section, and the confluence section of the highway and the speed-based emission calculation method of individual vehicles. Result: As a result of analyzing a total of 6 sections of the Gyeongbu Expressway, it was found that the standard deviation of the speed and the congestion of the sections had a great influence. Conclusion: When comparing the existing GHG emission calculation method with the speed-based emission calculation method of individual vehicles, it is clear that the speed-based method of individual vehicles is more precise. However, since it is difficult to apply it all over the country, this study compares the existing method with the speed-based method of individual vehicles and presents factors that have a significant difference.

• Journal of the Korea Convergence Society
• /
• v.11 no.1
• /
• pp.181-186
• /
• 2020

Civil technologies and parts occupy big ratio in military vehicle as military supply goods were commercialized. In case of the military vehicle engine, the civil purposed engine has been militarized without developing engine for defense industry. Because of this, it happens that Euro-5 version is mounted in spite of Euro-6 at present because the civil laws on the civil purpose engine and required operational capability for militarization are applied by overlapping. Therefore, this study focused on current situation and issues on the military vehicle emission regulation and suggested how to improve through analyzing the theses, articles, Korean laws and systems. For improving methods, imposing the emission certification duty and exempting the certification for the vehicle of high strategical importance were suggested through aligning the related laws. Consequently, it is expected that this study will be used for basics of checking the civil laws and connection with military systems for commercialization of military supplied goods.

• Journal of Korean Society of Transportation
• /
• v.25 no.6
• /
• pp.7-18
• /
• 2007

There are few studies on air pollution due to vehicle emissions in spite of the importance of this field. Therefore, this study describes trends and suggests implications through analysis relating to existing emissions research. This study has been divided into three areas. The first part is about estimating vehicle emissions. In this part, the authors analyze limits in ways of calculating emissions in the existing macroscopic view and then suggest the development of a model for calculating emissions considering velocity and acceleration. These variables are a function of traffic and individual driving behavior in the microscopic view. The second part is about management techniques for reducing vehicle emissions. The traffic management techniques for reducing vehicle emissions should conform to regional characteristics. The final part is about traffic operation for reducing vehicle emissions. The authors suggest the development of a micro-simulator and then the development of strategies for traffic operation. It is necessary to design better models estimating emissions and then, using real time data, to make a monitoring system simulating emission rates. This study serves as a literature review to make a foundation for further research about emissions research for transportation engineering.