• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.22 no.3
• /
• pp.149-155
• /
• 2010

The existing formula for estimating the wave overtopping are mainly about the perpendicularly incident wave to the structure and wave overtopping formula for the obliquely incident wave are rare. Moreover, these formula present only the overtopping reduction factor(${\gamma}_{\beta}$) with respect to the incident wave angle rather than the spatial distribution of overtopping along the structures because the length of model is relatively too short for the wave to propagate along the structure. In this study, the wave overtopping reduction factor considering the spatial variation of wave overtopping along the vertical wall is investigated using the hydraulic model tests and the results are compared with the those of EurOtop(2007). The wave overtopping reduction factor is modified for ${\beta}$ > $45^{\circ}$ condition.

• 한국방재학회:학술대회논문집
• /
• 2010.02a
• /
• pp.107.1-107.1
• /
• 2010

본 논문에서는 국내 및 국외에서 항만 구조물 설계시 적용되는 월파량 산정식을 고찰해 보고 각각의 식에 대한 특성을 비교하였다. 일반적으로 항만구조물 설계시 대부분 구조물에 직각으로 입사하는 조건을 대상으로 하여 각종 설계 인자를 계산한 후 설계에 적용하게 된다. 그렇지만 실제 항만구조물 설계시 경사입사파 조건에 대한 검토가 필요한 경우가 발생한다. 이는 일반적으로 경사입사파 내습시 직각입사파 조건에 비하여 월파량이 저감되므로 경제적인 설계를 위해서는 필요한 사항이다. 본 논문에서는 기존 직립제에 대한 월파량 산정식의 비교 및 분석을 하였다. 그리고 국내 월파량 산정식의 개선점을 고찰해 보고자 한다.

• 한국방재학회:학술대회논문집
• /
• 2010.02a
• /
• pp.64.1-64.1
• /
• 2010

국내 지진해일에 관한 연구 중, 구조물에 직접적인 영향을 미치는 파력에 대한 연구가 현재 미미한 실정이다. 본 연구에서는 파고와 입사각, 그리고 유의주기를 기지값으로 하여 파압을 계산하는 Goda(1974)가 제안한 파압공식을 이용하여 파압을 산정하였다. 파고는 Cho(1995) 모델로 산정하였으며 이를 임원항구의 방파제에 적용하였다.

• Journal of Navigation and Port Research
• /
• v.45 no.6
• /
• pp.325-332
• /
• 2021

As commercial and residential areas are actively developed around the coastal area with excellent scenery, installing coastal structures such as seawalls and breakwaters is continuously increasing to secure safe coastal regions. Additionally, the increase in the intensity of natural disasters due to climate change may cause higher incident waves than in the past, which may further aggravate the damage caused by wave overtopping. In this study, compared to the existing vertical seawall, we investigated the effect of wave overtopping reduction of a recurved seawall, which actively reflects the incoming waves, through the hydraulic model test. As a result of the hydraulic model experiment, it was confirmed that there was an effect of up to 92.4% of wave overtopping reduction in average compared to the vertical seawall and structures covered with armor blocks.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.19 no.6
• /
• pp.606-613
• /
• 2007

This study investigates the behavior of a plunging wave and its associated runup and overtopping through velocity measurements and suggests an empirical formula for overtopping velocities on a structure. The plunging wave breaking in front of the structure generates very bubbly flow fields. For measurements of the two phase flow field of the breaking wave, particle image velocimetry and a modified optical method were employed. The obtained velocity fields were discussed in respect of the process of wave impinging, runup and overtopping. The overtopping velocity distribution is found to have a nonlinear profile showing a maximum magnitude at its front part. The relationship of self-similarity among dimensionless parameters is observed and used to obtain the regression formula to depict the overtopping velocity.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2020.06a
• /
• pp.304-304
• /
• 2020

항만구조물의 방파제 또는 방파호안의 마루높이는 배후지역의 활용도에 따라 내습파의 월파로 인한 전달파 또는 월파량에 의해 결정되기 때문에 월파량산정은 항만구조물을 설계함에 있어서 주요한 설계인자이다. 그동안 국내에서는 항만구조물 설계시 주로 외국의 기준이나 기법을 활용하고 있는 실정이다. 국내 항만설계기준에서는 Goda도표를 이용하여 직립제 및 방파호안에 대한 월파량 산정방법을 제시하고 있으나, 도표축이 log로 되어 있어 내삽 또는 외삽시 사용자에 따라 월파량 차이가 발생할 수 있다. 국내의 해역특성 및 최근 설계동향을 반영한 월파량 산정식의 개발이 필요하고, 동일조건에 대한 동일한 월파량 산정결과가 도출될 수 있어야 한다. 최근의 대표 연구성과인 EurOtop(2007)과 같이 지수함수의 형태로 월파량 산정식을 제시하고자 한다. 경사식구조물의 평균월파량 산정식 도출을 위해 적용한 구조물 위치에서의 수심(d_t)은 0.40m, 0.55m, 0.70m 이다. 적용수심을 서로 다르게 한 것은 기존의 대부분의 연구에서 적용하지 않았던 구조물 위치에서의 쇄파조건을 고려하기 위한 것이다. 실험파는 Bretschneider-Mitsuyasu 주파수 스펙트럼을 사용한 불규칙파를 적용하였다. 본 연구에서는 주 피복재로 TTP를 대상으로 하였고, 주기 및 파고를 다양한 조건에서 수리실험을 수행하였다. 본 연구의 실험결과는 월파량 계측을 통해 분석된 평균 월파량을 적절한 산정식으로 나타내기 위해 EurOtop(2007)의 기존 월파량 산정식 형태에 대입하여 비교하여 분석하였다. 따라서, 본 논문은 월파량 산정식 제시를 통해 보다 합리적인 항만구조물의 마루높이 산정이 가능하게 하고, 또한 월파량 산정과 관련된 실험자료 구축을 통해 신뢰성해석 자료 및 수치모형의 검증 자료로 활용될 수 있을 것으로 판단된다.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.20 no.2
• /
• pp.157-167
• /
• 2008

The aeration of an overtopping wave on a vertical structure generated by a plunging wave was investigated through laboratory measurements of void fraction. The overtopping wave occurring after wave breaking becomes multi-phased and turbulent with significant aeration, so that the void fraction of the flow is of importance. In this study, fiber optic reflectometer and bubble image velocimetry were employed to measure the void fraction, velocity, and layer thickness of the overtopping flow. Mean properties were obtained by ensembleand time-averaging the repeated instantaneous void fractions and velocities. The mean void fractions show that the overtopping wave is very high-aerated near the overtopping wave front and relatively low-aerated near the deck surface and rear free surface of the wave. The flow rate and momentum of the overtopping flow estimated using the measured data show that the void ratio is an important parameter to consider in the multiphase flow. From the similarity profiles of the depth-averaged void fraction, velocity, and layer thickness, one-dimensional empirical equations were obtained and used to estimate the flow rate and momentum of the overtopping flow.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.29 no.6
• /
• pp.363-368
• /
• 2017

The tsunami flood the coastal cities and damage the land structures. The study on wave pressure and force on land structures is one of the important factors in designing the stability of inland structures. In this study, two - dimensional wave flume tests on the horizontal wave force and pressure of tsunamis on a simplified box-type structure was conducted. Vertical distribution and wave power of horizontal wave pressure over time were measured by pressure sensors and force transducer. Also, those were measured from the different wave breaking types. The vertical distribution of horizontal wave pressure was uniform at the moment when the horizontal wave force to the structure was maximum under the breaking wave condition. A surf similarity parameter was employed in order to figure out the relationship between the maximum horizontal wave force on the structure as a function of various incident wave conditions. As a result, the non - dimensionalized horizontal wave force tends to decrease exponentially as the surf similarity parameter increases.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.34 no.3
• /
• pp.82-92
• /
• 2022

In recent years, coastal and port structures have attempted to prevent wave-overtopping or provide waterfront areas by installing superstructures on the structural crowns. In general, in the design stage, the Goda formula acting on the front the structure is applied to calculate the wave pressure acting on the superstructure in consideration of the wave-runup of the design wave. However, the wave pressure exceeding the Goda wave pressure could generate depending on the installation location of the superstructure where the wave-overtopping occurs. This study analyzed the applicability of the Goda formula to the wave pressure calculation for the superstructure of the vertical structures through hydraulic model experiments and numerical simulations. Furthermore, this study investigated the magnitude of the wave pressure acting on the superstructure based on detailed numerical results. As a result, the wave pressure acting on the superstructure was up to 120% higher than the maximum wave pressure on the still water surface. In addition, the wave pressure increases exponentially with the Froude number computed by the overtopping water depth at the crown of the structure, and we proposed an empirical formula for predicting the wave pressure based on the Froude number.

• Journal of Ocean Engineering and Technology
• /
• v.18 no.4 s.59
• /
• pp.1-7
• /
• 2004

A simultaneous measurement system that can analyze the flow-structure interaction has been developed. This system consists of four CCD cameras, two for capturing instantaneous flow fields and two for tracking a solid body. The three-dimensional vector fields around a cylinder are measured, while the motion of the cylinder forced by the flow field is measured, simultaneously, with the constructed system. The cylinder is suspended in the working fluid of a water channel, and the surface of the working fluid is forced sinusoidally to make the cylinder bounced. Reynolds number for the mean main stream is about 3500. The interaction between the flow fields and the cylinder motion is examined quantitatively.