• Geophysics and Geophysical Exploration
• /
• v.6 no.1
• /
• pp.28-34
• /
• 2003

A problem of ground subsidence has been a focus of our research over the past 3 years. The purpose of this study is to investigate the disturbed stratigraphic structure by mining and to separate the possible ground subsidence area using shallow seismic reflection survey and processing. To overcome the problems such as the distortion and attenuation of seismic signal caused by ground disturbance and to acquire the high frequency data, an array with short spacing (0.3m) for both the shot and receivers, yielding near-offset (<30m) and CMP spacing of 0.15m was implemented. Data were acquired along the survey line with length of about 43m by fixed receiver array. By considering statics caused by the ground disturbance and offset distribution of data, careful processing steps such as muting and residual statics correction were applied for successful shallow reflection imaging. By correlating the ground subsidence data and stack section, possible subsidence zone could be interpreted quantitatively.

• Journal of the Korean Geotechnical Society
• /
• v.19 no.6
• /
• pp.49-59
• /
• 2003

The factors affecting the vertical loads acting on embankment piles can be classified into two factors on pile and soil. Factor on pile is the space between pile cap and factors on soil are embankment height and soil parameters(c, $\phi$). Therefore, a series of model tests were performed both to investigate the extent of influence of these factors and to verify the reliability of the proposed theoretical analysis. In the model tests, the piles were installed in the 6 columns $\times$ 6 rows(or 5 columns $\times$ 5 rows) below the embankment and the isolated pile caps with the area of 2.5cm $\times$ 2.5cm were installed on each pile head. The portion of the embankment load carried by model pile caps decreases with increment of the space between pile caps and increases with increment of the embankment height and the relative density(or internal friction angle) of fill. Also, the experimental results showed good agreement with theoretical predictions.

• Journal of the Korean Geotechnical Society
• /
• v.16 no.3
• /
• pp.29-37
• /
• 2000

많은 경우 액성한계 이상의 함수비 상태를 각즌 지반을 액체상태로 표현한다. 액체상태의 공학적 의미는 유효응력이 존재하지 않은 상태로 볼 수 있으며, 전단강도가 0임을 의미한다. 그러나 실제로는 액성한계 이상의 함수비를 갖는 지반에서도 유효응력이 존재하며, 따라서 전단강도가 존재한다. 연약한 해성점토의 경우는 이러한 경우가 비교적 흔하다. 일반적으로 액체상태란 용어에서 연상되는 지반상태는 물과 같은 상태로서 기술자로 하여금 지반의 상태에 대한 올바른 감을 가지는 것을 어렵게 한다. 본 고는 Bolt 의 electrical double layer 이론을 이용한 이론적 해석 및 실험적 자료들을 이용하여 액성한계란 용어의 올바른 제조명에 초점을 맞추었다.

• Journal of the Korean Geotechnical Society
• /
• v.17 no.4
• /
• pp.71-86
• /
• 2001

본 고에서는 도심지 터널의 과학적인 설계/시공을 위한 요소기술 확보의 일환으로 기존의 연구자들이 제시한 손상평가 기법을 토대로 터널굴착에 따른 지중매설관 손상여부의 예비평가를 위한 평가기법을 제시하였다. 제시된 기법을 토대로 다양한 경우에 대한 매개변수 연구를 수행한 결과 지반침하곡선의 경사 및 곡률 등 침하곡선의 제반특성에 기반을 둔 본 연구에서 개발된 손상평가기법의 평가결과는 변곡점의 위치에 많은 영향을 받는 것으로 나타났으며, 따라서 현장 특유의 지반특성 및 시공조건이 반영된 변곡점 산정식의 개발을 위한 지속적인 연구가 필요한 것으로 판단된다. 아울러서 터널심도가 터널직경의 2.5배 이하인 경우 손상도가 현저히 증가하며, 전반적으로 관의 재질이나 조인트의 형식에 관계없이 관체의 인장변형률이 손상여부를 결정짓는 인자인 것으로 나타났다. 본 연구에서 얻어진 결과를 종합하여 터널과 매설관의 상대적 위치 및 지반손실량에 따라 매설관의 손상정도를 정량적으로 평가할 수 있는 설계도표를 제시하였다.

• Magazine of the Korea Concrete Institute
• /
• v.13 no.2
• /
• pp.38-43
• /
• 2001

교량 하부구조 특히 교각 및 기초의 경우는 지반 또는 수중에 묻혀 있기 때문에 손상을 발견하기도 어렵고 또한 손상의 보수 및 보강이 곤란한 경우가 많다. 하부구조의 손상은 지반의 마모, 침하, 측방유동토압, 하상세굴, 홍수류, 선박 및 유하물에 의한 충격, 지진 등의 여러 원인에 의하여 발생된다. 이러한 손상은 지표수 및 지하수 배제공, 성토공, 지반개량공, 단면보수공, 세굴방지공, 내진보강공 등에 의하여 보수 및 보강이 행하여 진다. 본 고에서는 이러한 하부구조의 보수.보강공법 중 수중부에 실시되는 방법에 대하여 소개하고자 한다.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2003.06b
• /
• pp.13-33
• /
• 2003

시추조사는 설계 및 시공을 위한 기본적인 조사이며 조사자는 지층을 정확히 판단하고 시추주상도를 매개체로하여 이를 설계자와 시공자에게 전달하여야 한다. 많이 개선되었다고는 하지만 시추주상도의 내용이 작성자 또는 작성회사별로 양식과 기재방법이 다른 경우가 많아 시추주상도의 역할이 반감되는 경우가 많다. 본 고에서는 조사업계에 종사한 경험을 바탕으로 합리적인 시추주상도 작성을 위해 국내외의 시추주상도 양식을 비교하고 표준안을 제시하였으며 기재방법의 통일을 기하기 위한 개선 사항을 제시하였다.

• Journal of the Korean earth science society
• /
• v.37 no.1
• /
• pp.40-51
• /
• 2016

The problem has been pointed out that the domestic design response spectrum does not reflect site amplification, particularly in the high frequency bands, including the fact that site specific response spectrum from the observed ground motions appears relatively higher than design response spectrum. Among various methods, this study applied H/V spectral ratio of ground motion for estimating site amplification. This method, originated from S waves and Rayleigh waves, recently has been extended to Coda waves and background noise for estimating site amplification. For limited time of periods, 4 electric substation sites had operated seismic stations at two separate locations (bedrock and borehole) within each substation site. H/V spectral ratio of S wave, Coda wave, and background noise, was applied to 36 accelerations of 3 macro earthquakes (Odaesan, Jeju and Gongju earthquakes), larger than magnitude 3.4. observed simultaneously at each bedrock location within 4 electric substation sites. Site amplifications at the bedrock location of 4 sites were compared among S wave, Coda wave energy, and background noise, and then compared to the previous results from the borehole location data. The site classification was also tried using resonancy frequency information at each site and location. The results suggested that all the electric substation sites showed similar site amplification patterns among S wave, Coda wave, and background noise. Each station showed its own characteristics of site amplification property in low, high and specific resonance frequency ranges. Comparison of this study to other results using different method can give us much more information about dynamic amplification of domestic sites characteristics and site classification.

• Journal of the Society of Disaster Information
• /
• v.13 no.1
• /
• pp.35-42
• /
• 2017

In this study, to quantitatively evaluate the strength characteristics of the inflatable liquid used for the recovery of soft ground or partial settlement, the inflatable liquids were prepared by dividing the inflatable capacity and the strength characteristics were analyzed according to the conditions. The experimental group was divided into two groups: relatively high expansion group and low expansion group. The specimens were prepared by controlling the volume of 10 ~ 30% of the maximum expansion volume, and the strength of the specimens were evaluated. The compressive strength of the high expansion group and low expansion group was about 2.1 times.

• Tunnel and Underground Space
• /
• v.33 no.5
• /
• pp.312-338
• /
• 2023

The underground disposal facility for spent nuclear fuel demands a specialized design, distinct from conventional practices, to ensure long-term thermal, mechanical, and hydraulic integrity, preventing the release of radioactive isotopes from high-temperature spent nuclear fuel. SKB has established design criteria for such facilities and executed practical design implementations for Forsmark. Moreover, in response to subsurface uncertainty, SKB has proposed an empirical approach involving monitoring and adaptive design modifications, alongside stepwise development. SKB has further introduced a unique support system, categorizing ground types and behaviors and aligning them with corresponding support types to confirm safety through comparative analyses against existing systems. POSIVA has pursued a comparable approach, developing a support system for Onkalo while accounting for distinct geological characteristics compared to Forsmark. This demonstrates the potential for domestic implementation of spent nuclear fuel disposal facility designs and the establishment of a support system adapted to national attributes.

• Journal of the Korean GEO-environmental Society
• /
• v.23 no.1
• /
• pp.31-37
• /
• 2022

This study is focused on developing a technology to prevent high-strength wire net from expanding damage due to insufficient performance of the existing PVC coating net. For the test method, reference was made to ISO 17746, an international standard. In addition, as a result of referring to the test criteria, a wire net was fabricated with a width of 1,000 mm or more a size of 1 m² sample. load-displacement curve of the test results was compared to analyze how much performance was improved compared to the existing PVC coating net.