• Applied Chemistry for Engineering
• /
• v.32 no.2
• /
• pp.149-156
• /
• 2021

A kraft recovery boiler produces steam for power generation by the combustion of black liquor from the kraft pulping process. Since saturated steam became superheated in a superheater above the furnace, it is important to increase the heat exchange efficiency for the superheated steam production and power generation. A nose arch at the bottom of the superheater is important for blocking radiation from the furnace which causes corrosion of the superheater. But the nose arch is the main reason for creating a recirculation region and then decreasing the heat exchange efficiency by holding cold flue gas after the heat transfer to saturated steam. In this study, the size of recirculation region and the temperature of flue gas at the outlet were analyzed by the nose arch structure using computational fluid dynamics (CFD). As a result, when the nose arch angle changed from 106.5° (case 1) to 150° (case4), the recirculation region of flue gas decreased and the heat exchange efficiency between the flue gas and the steam increased by 10.3%.

• Journal of Korean Tunnelling and Underground Space Association
• /
• v.10 no.1
• /
• pp.17-24
• /
• 2008

Many problems exist in the current cast in place concrete lining used in domestic tunnel construction. Especially, the crack of tunnel lining brings about a social and economic problem. It has a lot of influence on stability of structure and the fine finish of lining. So enormous repair-work and reinforcement of tunnel lining could occur an running out of government's budget. In our country, there are domestic production enterprises which produce a special pre-cast concrete product, but the technical level of them is still far behind compared to developed countries. Also, optimum steam coring method is important for the production of high quality product. But there is no regulation of steam curing method in our country. This study is to investigate the properties of PC panel according to the variation of steam curing conditions such as presteaming time and rate of temperature rise. The result shows that the optimum presteaming time of steam curing method in PC panel is more than 1 hour and the desirable rate of temperature in curing chamber is about $20^{\circ}C/hr$.

• Transactions of the Korean Society of Pressure Vessels and Piping
• /
• v.5 no.1
• /
• pp.1-8
• /
• 2009

Nuclear hydrogen production using high temperature heat of a very high temperature reactor(VHTR) is one of the most attractive ways of mass hydrogen production without greenhouse gas emission. In many countries, sulfur-iodine(S-I) thermochemical process and high temperature steam electrolysis(HTSE) process are being investigated. In such processes, corrosion behavior of Intermediate heat exchanger materials are the most critical issues. Especially in a HTSE system, several heat exchangers will be facing hot steam conditions. In this paper, the status of high temperature corrosion researches in hot steam and supercritical water conditions are reviewed in view of the implication to HTSE conditions. Based on the review, test condition and plan of the hot steam corrosion of the candidate materials are formulated and described in some details along with the schematics of the test set-up. The test results and subsequent evaluation will be used in development of a interface system between the HTSE hydrogen production system and the VHTR.

• Journal of Energy Engineering
• /
• v.28 no.2
• /
• pp.47-54
• /
• 2019

As absorption type heat pump for waste heat recovery is installed in combined cycle power plant for Energy Service Company, performance test is implemented to confirm the operation data on partial load. The operation data changes according to the heat pump operation on partial load are as follows. Total heat output increases, because waste heat of closed cooling water and a portion of LP steam from HRSG is supplied. But electric power output of steam turbine is reduced, because LP steam to steam turbine is reduced. And heat output from HP district heater and LP district heater is reduced, because HP turbine exhaust steam to HP district heater and LP district heater is reduced. On partial load operation, turbine output reduction is higher than the base load operation. Therefore, on partial load, heat pump should be operated in consideration of the heat output increase and electric power output reduction.

• Proceedings of the Korean Nuclear Society Conference
• /
• 2002.10a
• /
• pp.165.2-165
• /
• 2002

• Transactions of the Korean hydrogen and new energy society
• /
• v.33 no.5
• /
• pp.499-506
• /
• 2022

This study proposes kinetic parameters of Ru catalyst for steam methane reforming (SMR). First, extensive experiments are performed under different SMR conditions to evaluate performance of the catalyst in SMR. Second, a kinetic model is designed and developed for parameter estimation and validation using gPROMS. Finally, estimated parameters are fitted to the kinetic model and then, the model results are compared with the experimental data. The model results are in a good agreement with the experimental data.

• Proceedings of the Korea Air Pollution Research Association Conference
• /
• 2003.11a
• /
• pp.495-496
• /
• 2003

연소 배가스 중에 대표적인 가스상 중금속은 수은(Hg), 비소(As), 셀레늄(Se)을 들 수 있다. 이 중에서도 수은은 증기압이 높아서 가스상으로 배출될 가능성이 가장 높은 물질이다. 수은은 세계적으로 약 5000톤이 가스상으로 발생하고 있다. 이 중에서 1000톤은 자연적인 발생원 즉, 화산, 암반이나 해양에서의 증발로부터 발생하며, 나머지 4000톤은 인위적 시설들, 즉 소자로나 발전소, 천연가스, 형광등, 전기제품, 촉매 생산공정 등 일반산업체에서 발생하는 것으로 알려져 있다. (중략)

• Nuclear industry
• /
• v.19 no.12 s.202
• /
• pp.59-65
• /
• 1999

원자력발전소는 우라늄 핵연료를 태워서 물을 끓여 증기를 발생시키고 이 고압 증기로 터빈을 돌려 전기를 생산하는데, 이와 같은 일련의 과정은 고압 용기나 배관을 사용하여 가능하게 된다. 이와 같은 고압 용기 및 고압 배관은 그 기기 안에 핵반응 물질이 들어 있다는 점을 고려해 볼 때 그 기기의 건전성 확보는 매우 중요한 일 중 하나이다. 본고에서는 원자력발전소의 원자로 압력 용기를 비롯하여 압력 배관의 용접부에 대한 결함 탐지에 사용되는 자동 초음파 탐상 기기에 관하여 서술하고자 한다.

• Proceedings of the Korean Institute of Surface Engineering Conference
• /
• 2015.05a
• /
• pp.170-170
• /
• 2015

아크이온플레이팅(AIP)을 이용하여 SKD61강에 TiN 및 TiAlN을 증착함으로써 내산화성 및 아연증기와의 반응을 억제할 수 있었으며, 도금두께 제어를 위한 에어나이프의 수명개선 및 생산성향상에 매우 중요한 요인으로 판단되었다.

• KEPCO Journal on Electric Power and Energy
• /
• v.7 no.1
• /
• pp.53-58
• /
• 2021

한전에서 운영중인 사우디라빅발전소에서 저압터빈 블레이드가 파손되었다. 블레이드의 경우 터빈의 핵심부품으로서 증기를 활용하여 발전기를 회전시켜 전기를 생산하는데 필수 부품이다. 반복적인 사고발생을 예방하기 위해 조직분석, 운전신호 분석등을 활용하여 원인을 규명하였고, 대책을 제시하였다.