• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.42 no.2 s.332
• /
• pp.61-74
• /
• 2005

Digital Multimedia Broadcasting(DMB) is a reliable multi-service system for reception by mobile and portable receivers. DMB system allows interference-free reception under the conditions of multipath propagation and transmission errors using COFDM modulation scheme, simultaneously, needs powerful channel error's correction ability. Viterbi Decoder for DMB receiver uses punctured convolutional code and needs lots of computations for real-time operation. So, it is desired to design a high speed and low-power hardware scheme for Viterbi decoder. This paper proposes a combined add-compare-select(ACS) and path metric normalization(PMN) unit for computation power. The proposed PMN architecture reduces the problem of the critical path by applying fixed value for selection algorithm due to the comparison tree which has a weak point from structure with the high-speed operation. The proposed ACS uses the decomposition and the pre-computation technique for reducing the complicated degree of the adder, the comparator and multiplexer. According to a simulation result, reduction of area $3.78\%$, power consumption $12.22\%$, maximum gate delay $23.80\%$ occurred from punctured viterbi decoder for DMB system.

• Journal of the Korean Institute of Landscape Architecture
• /
• v.37 no.1
• /
• pp.43-49
• /
• 2009

The number of registered vehicles increased to one million in 1985 and ten million in 1997, and the parking lots in multi-family housing complex that had been mainly constructed on the ground level began to be constructed in underground levels. Therefore, planting design in such complex were greatly changed. This study classifies the parking lots in multi-family housing complexes located in Cheongju into three categories: above-ground, mixture of above-ground and underground, and underground. The characteristics of planting design in each were then analyzed. The rate of parking per family increased by two or more in the type of mixture when compared to in the type of above-ground. As underground parking lots became dominant, the rate of parking per family increased to one car or more. The green area ratio did not change considerably when above-ground parking was combined with underground parking, but the green area per total floor space was reduced, which indicates the quality of green area became lower. Most of the parking lots in multi-family housing complexes since 2000 have been constructed underground, and the green area became larger. As for the species of trees used in planting design, trees that are vulnerable to damage by blight and harmful insects and may be repugnant have been reduced and replaced by trees whose shapes are beautiful and whose flowers and fruits can be appreciated, such as Chionanthus retusa, Malus floribunda, Styrax japonicus, Prunus mume, Lagerstroemia indica. Pine trees are variously planted with diversified standards, and, in particular, tall pine trees are being utilized as focal points. Herbaceous flowers began to be planted in underground parking lots constructed since 2000, and they are expected to be planted even more due to the appreciation of their flowers and their splendid appearance.

• Proceedings of the Korean Institute Of Construction Engineering and Management
• /
• 2004.11a
• /
• pp.290-295
• /
• 2004

Along with social changes, school buildings are getting complex and diversified unlike the past. However, objective data analysis on construction costs fall short. In particular, ordering agencies are in a great need of objective and practical construction cost management for on-budget construction and procurement of quality goods. This paper analyzes the design diagram for a newly built school with an order from the Daejeon Metropolitan Office of Education, and compares the analysis with those of other kinds of buildings. The results are: the total construction cost of one school unit is 8,017,596,000 won on average; the cost is in the order of building, machinery and equipment, electricity, communications and civil engineering; as to activity, RC construction takes account of $30.3\%$ of the total construction cost. 1'he cost of school construction per M2 is 838,000 won, which is 6th highest of 11 kinds of constructions and slightly lower than 950,000 won, the average price of comparative constructions. When it comes to the percentage, school building takes mote percentage of the total cost than comparative building while machinery and equipment, electricity and communications takes slightly less percentage. Through simple regression analysis of gross coverage, this paper suggests a model formula with which the total construction cost, construction cost in accordance with activity, how much main construction materials are to be used are predictable.

• Journal of Bio-Environment Control
• /
• v.19 no.4
• /
• pp.210-216
• /
• 2010

This study was carried out to investigate the plant growth of various foliage plants affected by the nutrient solution strength. Ficus benjamina, Hedera helix, Philodendron tatei, Rhapis excelsa, Spathiphyllum spp. were used in this experiment. The Sonneveld solution was diluted to 0, 1/4, 1/2, and 1 folds and applied through a subirrigation system. Plant height and width, leaf number, leaf area, fresh and dry weights of shoots were measured to compare the responses to the different treatments. The required amounts for nutrients were different among the various foliage plants. The growth of Ficus and Philodendron was improved as the nutrient solution strength got higher, but that of Hedera and Spathiphyllum showed the best growth in the lower nutrient solution strength of 1/4 and 1/2 folds. The growth of Rhapis was improved in the nutrient solution strength of 1 fold but the other treatments did not affect on plant growth. N, P, and K were the most important nutrients that had influence on the growth of the foliage plants in this study. There was not an accurate criterion for fertilization and irrigation to each foliage plant. Moreover, the foliage plants grew slowly during the early stage and this period must be shortened for commercial production. Therefore, the experiment was executed to make up these defects. The plants applied with proper strength of Sonneveld solution grew faster and had better quality.

• Journal of Korea Port Economic Association
• /
• v.33 no.4
• /
• pp.73-82
• /
• 2017

Korea is the fifth largest producer of automobiles in the world, and this industry accounts for the highest portion of the entire manufacturing industry. It is an especially important industry occupying second place in the top 10 export items in Korea. Korea exports about 3 million units of cars produced in the country and abroad, based on new cars and excluding second hand cars. Japan, along with Korea, represents a high portion of the global automobile industry, and it exports more than 4 million cars to the rest of the world. In particular, both Korea and Japan export automobile and used cars produced within the country, almost all of them by PCC(Pure Car Carrier) or PCTC(Pure Car Truck Carrier). Therefore, automobile export ports are located near automobile factories, and are being used in export to foreign countries. However, there are inefficient problems, such as poor port facilities, yard space shortage for loading and unloading operations and lack of proficiency of cargo handling companies. As a result, there are delays in cargo operations, or ships waiting have occurred. Therefore, the purpose of this study is to measure and compare the efficiency of automobile export ports in Korea and Japan. To measure the efficiency of automobile export port, we used CRS and VRS models from DEA. The input and output parameters were set as length of quay, yard area and throughput of cars, and DMUs are 25 ports for evaluating the efficiency. As a result of the efficiency measurements, two Korean ports (Gwangyang and Ulsan) and three Japanes ports (Kanda, Omaezaki, Kanmon-Shimonoseki) showed high efficiency in both models. These results can be used to establish strategies for enhancing efficiency and competitiveness of automobile export ports in Korea and Japan.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.21 no.10
• /
• pp.354-360
• /
• 2020

This study examined the factors for sorting miscellaneous cereal crops using a rice-sorting device by analyzing the physical characteristics according to the moisture content. The initial moisture contents of miscellaneous cereal were 16.3, 19.8, and 16.5%, respectively. The samples were used in the experiment after drying to five levels. The width, length, and area of the samples increased with increasing moisture content except for the roundness, and all the prediction models were developed with a first-order linear equation. The bulk density of Italian millet and sorghum increased with increasing moisture content, whereas the bulk density of common millet was unaffected by the change in moisture content. The terminal velocity of the samples increased with increasing moisture content, and a first-order linear equation was used to develop the prediction models. The measured physical properties of the miscellaneous cereal crops based on the changes in the moisture content could be expressed using a first-order experimental model equation. Therefore, the rice-sorting device could be applied to the terminal velocity, but the other device applying the geometrical characteristics and bulk density was required to change the design of the process depending on the type of grain.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.18 no.1
• /
• pp.91-102
• /
• 2020

According to the Korea Radioactive Waste Agency's (KORAD's) medium and low level radioactive waste management implementation plan, the Domestic 3rd Step Landfill Disposal Facility has planned to accept a total of 104,000 drums (2 trenches) of very low level radioactive waste (VLLW), from the decommissioning site from April 2019 - February 2026 (total budget: 224.6 billion Won). Subsequently, 260,000 drums (5 trenches) will be disposed in a 34,076 ㎡. Accordingly, KORAD is preparing a waste acceptance criteria (WAC) for this facility. Every disposal facility for VLLW in other countries such as France and Spain, operate their WAC for each VLLW facility with a reasonable application approach, This, paper focuses on analyzing the WAC conditions in VLLW sites in the USA and discusses whether these can be met in domestic VLLW WAC. It also helps in the preparation of WAC for the 3rd Step Landfill Disposal Site in Gyeongju, since the USA has prior experience on decommissioning nuclear waste.

• Spatial Information Research
• /
• v.22 no.3
• /
• pp.47-58
• /
• 2014

The credible measurement, reporting and verification (MRV) is among the most critical elements in UN-REDD (United Nations programme on Reducing Emissions from Deforestation and forest Degradation in Developing Countries). This study is intended to explore MRV potential in terms of UN-REDD opportunity cost estimation using satellite image for Mt. Geum-gang of North Korea. A visual interpretation were conducted to evaluate MRV conditions by sub-dividing or decomposing the images with different pixel size into a three types of hierarchical tree structure that helps dealing with spatial variability within each subarea. The permanent record of standard satellite remote sensing system demonstrated its capability of presenting area-wide visual evidences of MRV conditions in Mt. Geum-gang (such as the identification of forested area, degradation trends for forest space, three types of hierarchical land-cover and land use tree structure, carbon density in the landscape). Satellite data could be accepted as legally binding proof when it comes to REDD opportunity cost estimation since several cases exist where remote sensing has been used as legal evidence in ICJ (International Court of Justice) and UN resolution. It doesn't seem very difficult to comply with MRV requirements for UN-REDD opportunity cost calculation due to the probative value of satellite data. It is anticipated that this research output could be used as a valuable reference for Korea-based enterprises exploring REDD project sites and the carbon traders to ensure MRV potentials using satellite image in UN-REDD Opportunity Cost estimation.

• Journal of Korean Home Economics Education Association
• /
• v.20 no.4
• /
• pp.59-75
• /
• 2008

This study is designed to support the development and the teaching of revised curriculum of 2007 "Technology & Home Economics" by investigating the actual condition and the necessity of education for elderly housing education. Questionnaire survey was conducted with 488 high school students in Gyeongnam in 2008. The data analyzed by descriptive statistics, t-test, One-way ANOVA, Duncan's multiple range test by using SPSS 14 program. The results showed that most of the students were dissatisfied with their middle school education of elderly housing due to the lack of interesting and practical contents. Thus, various teaching-learning methods where student can experience and experiment is needed. Also, the students demanded more of factors of elderly housing, spacing plan, elderly welfare service and less of three-generation housing and senior housing in their elderly housing education. The needs of education contents differed among students depending on variables such as sex, graduated middle school, household income, dwelling space and length of residential years. Therefore, revised 2007 curriculum of "Technology & Home Economics" should include required contents in related chapters. Because there are significant differences among textbooks about elderly housing, further attention needs to be paid to the new textbooks in order to include education contents evenly. At the same time, teachers should organize their teaching contents considering the divergence of variables. The effect of elderly housing education will be maximized if the revised curriculum consists of more experimental activities such as elderly simulation in the local community.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.17 no.1
• /
• pp.9-14
• /
• 2016

This study evaluated a digital locking device design using detection distance of 13.4mm of a human body sensing type magnetic field coil. In contrast to digital locking devices that are used nowadays, the existing serial number entering buttons, lighting, number cover, corresponding pcb, exterior case, and data delivery cables have been deleted and are only composed of control ON/OFF power switches and emergency terminals. When the magnetic field coil substrates installed inside the inner case detects the electric resistance delivered from the opposite side of the 12mm interval exterior contacting the glass body part, the corresponding induced current flows. At this time, the magnetic field coil takes the role as a sensor when coil frequency of the circular coil is transformed. The magnetic coil as a sensor detects a change in the oscillation frequency output before and after the body is detected. This is then amplified to larger than 2,000%, transformed into digital signals, and delivered to exclusive software to compare and search for embedded data. The detection time followed by the touch area of the body standard to a $12.8{\emptyset}$ magnetic field coil was 30% contrast at 0.08sec and 80% contrast at 0.03sec, in which the detection distance was 13.4mm, showing the best level.