• The Journal of the Acoustical Society of Korea
• /
• v.35 no.3
• /
• pp.167-174
• /
• 2016

Underwater communication is difficult to increase the communication capacity because the carrier frequency is lower than that of radio communications on land. This is limited to the bandwidth of the signal under the influence of the characteristics of an ocean medium. As the high transmission speed and large transmission capacity have become necessary in the limited frequency range, the studies on MIMO (Multiple Input Multiple Output) communication have been actively carried out. The performance of the MIMO communication is lower than that of the SIMO (Single Input Multiple Output) communication because cross-talk occurs due to multiusers along with inter symbol interference resulting from the channel characteristics such as delay spread and doppler spread. Although the adaptive equalizer considering multi-channels is used to mitigate the influence of the cross-talk, the algorithm is normally complicated. In this paper, time reversal mirror technique with the characteristic of a self-equalization will be applied to simplify the compensation algorithm and relieve the cross-talk in order to improve the communication performance when the signal transmitted from two channels is received over interference on one channel in the same time. In addition, the performance of the MIMO communication based on the time reversal mirror is verified using data from the SAVEX15(Shallow-water Acoustic Variability Experiment 2015) conducted at the northern area of East China Sea in May 2015.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.25 no.5
• /
• pp.515-525
• /
• 2014

In this paper, we present a design and implementation of a Voltage-tuned Planar Composite Resonator Oscillator(Vt-PCRO) with a low phase noise. The designed Vt-PCRO is composed of a resonator, two phase shifters, and an amplifier. The resonator is designed using a dual mode SIW(Substrate Integrated Waveguide) resonator and has a group delay of about 40 nsec. Of the two phase shifters (PS1 and PS2), PS1 with a phase shift of $360^{\circ}$ is used for the open loop gain to satisfy oscillation condition without regard to the electrical lengths of the employed microstrip lines in the loop. PS2 with a phase shift of about $70^{\circ}$ is used to tune oscillation frequency. The amplifier is constructed using two stages to compensate for the loss of the open loop. Through the measurement of the open loop gain, the tune voltage of the PS1 can be set to satisfy the oscillation condition and the loop is then closed to form the oscillator. The oscillator with a oscillation frequency of 5.345 GHz shows a phase noise of -130.5 dBc/Hz at 100 kHz frequency offset. The oscillation power and the electrical frequency tuning range is about 3.5 dBm and about 4.2 MHz for a tuning voltage of 0~10 V, respectively.

• Journal of Internet Computing and Services
• /
• v.13 no.2
• /
• pp.21-32
• /
• 2012

We develop architecture of a virtual aggregation gateway (VAG) which enables composite application streaming based on N-Screen-as-a-Service (NaaS) using cloud computing in thin-client environment. We also discuss the problem of server computing burden in large scale multi-client case for screens sharing with composite application streaming over the internet. In particular, we propose an efficient Framework of N-Screen Session Manager which manages all media signaling that are necessary to deliver demanded contents. Furthermore, it will provides user with playback multimedia contents method (TV Drama, Ads, and Dialog etc) which is not considered in other research papers. The objectives of proposing N-Screen Session Manager are to (1) manage session status of all communication sessions (2) manage handling of received request and replies (3) allow users to playback multimedia contents anytime with variety of devices for screen sharing and (4) allow users to transfer an ongoing communication session from one device to another. Furthermore, we discuss the major security issues that occur in Session Initiation Protocol as well as minimizing delay resulted from session initiations (playback or transfer session).

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38C no.12
• /
• pp.1134-1149
• /
• 2013

Pub/sub system enables data users to access any necessary data without knowledge of the data producer and synchronization with the data producer. It is widely used as the middleware technology for the data-centric services. DDS (Data Distribution Service) is a standard middleware supported by the OMG (Object Management Group), one of global standardization organizations. It is considered quite useful as a standard middleware for US military services. However, it is well-known that it takes considerably long time in searching the Participants and Endpoints in the system, especially when the system is booting up. In this paper, we propose a discovery scheme to reduce the latency when the participants and Endpoints are densely distributed in a small area. We propose to modify the standard DDS discovery process in three folds. First, we integrate the Endpoint discovery process with the Participant discovery process. Second, we reduce the number of connections per participant during the discovery process by adopting the concept of successors in Distributed Hashing scheme. Third, instead of UDP, the participants are connected through TCP to exploit the reliable delivery feature of TCP. We evaluated the performance of our scheme by comparing with the standard DDS discovery process. The evaluation results show that our scheme achieves quite lower discovery latency in case that the Participants and the Endpoints are densely distributed in a local network.

• Journal of the Institute of Electronics Engineers of Korea SP
• /
• v.48 no.6
• /
• pp.18-26
• /
• 2011

Debates concerning the competitive edge of leading 3DTV technology of the shutter glasses (SG) 3D and the film-type patterned retarder (FPR) are flaring up. Although SG technology enables Full-HD 3D vision, it requires complex systems including the sync transmitter (emitter), the sync processor chip, and the LCD lens in the active shutter glasses. In addition, the transferred sync-signal is easily affected by the external noise and a 3DTV viewer may feel flicker-effect caused by cross-talk of the left and right image. The operating current of the sync processor in the 3DTV active shutter glasses is gradually increasing to compensate the sync reconstruction error. The proposed chip is a low-power hardware sync processor based discrete-event SoC(system on a chip) designed specifically for the 3DTV active shutter glasses. This processor implements the newly designed power-saving techniques targeted for low-power operation in a noisy environment between 3DTV and the active shutter glasses. This design includes a hardware pre-processor based on a universal edge tracer and provides a perfect sync reconstruction based on a floating-point timer to advance the prior commercial 3DTV shutter glasses in terms of their power consumption. These two techniques enable an accurate sync reconstruction in the slow clock frequency of the synchronization timer and reduce the power consumption to less than about a maximum of 20% compared with other major commercial processors. This article describes the system's architecture and the details of the proposed techniques, also identifying the key concepts and functions.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.44 no.11
• /
• pp.1-10
• /
• 2007

In this paper, we proposed channel estimation scheme for LR-UWB system which has low data rate for WPAN in IEEE 802.15.4a. At the transmitter, we proposed dynamic power level allocation depends on channel condition in specific period when we modulate signal. We use two orthogonal code to estimate channel at once. It can estimate channel more accurately by using two code which shows good correlation characteristic then it can estimate more accurately by spreading gain. Using estimated channel condition, we synchronize symbol timing of transmitted signal. Then determined power allocation scheme and channel information is transmitted to transmiter side. Finally, using these information, transmiter side change the power level of repeated pulse to adopt to channel condition. Simulation is performed under S-V channel for LR-WPAN in IEEE 802.15.4a and we compare the performance with a different type of receiver type. We use coherent and non-coherent method at the receiver. Simulation result shows us at the NLOS channal performance evaluation is greater than that of LOS channel and the result is independent of receiver type. In the NLOS channel, as the signal delay spreading is big, performance evaluation is also increased.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.16 no.12
• /
• pp.8357-8362
• /
• 2015

The emergency call device has been installed and operated for the elevator passenger safety, but the call can not be connected or delay to the operator in an emergency. The application of the Internet of Things(IoT) technology is required for the systematic management and reliability of the emergency call device installed in the elevator. To meet these requirements it is necessary to apply the RMS(Remote Management System). Emergency call device periodically reports the operating status information and the emergency call history information of the emergency call device to the RMS in the PSTN(Public Switched Telephone Network) environment, and transmits the call request information in an emergency. RAS(Remote Access Server) plays a role of converting the PSTN signals to TCP / IP. RMS reports a significant outbreak call and abnormal operating conditions to administrators. In this study, we developed optimized protocol to PSTN environment that is required by RMS and implemented its differentiated process. And a RAS-RMS Protocol was added to the Application Layer. Development protocol consisting of simple structure as compared to CoAP, MQTT or HTTP can work properly in low-spec CPU and transmit elevator emergency key information easily.

• Journal of Korea Spatial Information System Society
• /
• v.1 no.2 s.2
• /
• pp.21-31
• /
• 1999

In accordance with the completion of the spatial database building works in the central and/or local government authorities as well as the rapid popularization of various information services through internet, it is heavily required to provide spatial information services through World Wide Web. To provide a qualified spatial information service, it is crucial to have a Web-based GIS (Geographic Information Service) service system equipped with the publicity, the convenient accessibility, and the easy-to-use user interface. In this paper, we introduce a new component system for Web-based spatial information services based on the OpenGIS Simple Feature specification for OLE/COM[3] and OLE DB specification[4]. The important functionality of a Web-based spatial information service system includes its accessibility of various existing GIS server system and huge databases in addition to the resolution of response-time delay problems caused by transmitting a large amount of digital maps via internet[6]. To cope with these problems, our component system has been designed to access heterogeneous databases in transparent manner and to support vector-based and/or image-based image production techniques for shortening transmission time.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.8
• /
• pp.701-713
• /
• 2009

This paper studies a method for reducing performance degradation due to losing sub-carrier orthogonality caused by power transient between physical channels in LTE uplink transmission. The pattern of inter-carrier interference(ICI) caused by power transient is different from what has been studied for doppler shift, in that its pattern occurs at front and rear sides of channels in each period of power transient. The reason of ICI's occurrence results from power difference between channels, power transient duration, multi-path channel delay spread, and numbers of sub-carrier. New criterion is proposed to find out number of taps of multi-tap equalizer enough to improve the ICI. The scheme is to determine the number of taps of multi-tap equalizer when a normalized interference or a normalized ICI is greater than a normalized noise. Simulation results show that the number of taps is flexibly adjusted according to SNR(Signal to Noise Ratio) of a received signal to improve Bit Error Rate(BER), while the complexity of the proposed scheme is reduced down to 88 percentage of the classical method.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.8 no.12
• /
• pp.1883-1890
• /
• 2013

Location detection technology (LDT) is one of the core techniques for location based service (LBS) in wireless communication for improving resource management and quality of services. The location of a mobile station (MS) is estimated using the time of arrival (TOA) technique based on three circles with centers corresponding to coordinates of three base stations (BSs) and radius corresponding to distances between MS and BSs. For accurately estimating the location of MS, three circles should meet at a point for the trilateration method, but they generally do not meet a point because the radius is increased depending on the number of time delay for estimating the distance between MS and BS and the carrier frequency. The increased three circles intersect at six points and the three intersection points among them should be generally placed close to coordinate of the location for the specific MS. In this paper, we propose the shortest distance algorithm for TOA trilateration method, to select three interior intersection points from entire six points. The proposed approach selects three intersection points with the shortest distances between coordinates of MS and intersection points and determines the averaged coordinate of the selected three points, as the location of the specific MS. We demonstrate the performance of the proposed algorithm using a typical computer simulation example.