• 대한지질공학회:학술대회논문집
• /
• 대한지질공학회 2002년도 정기총회 및 학술발표회
• /
• pp.163-171
• /
• 2002

지금까지 양산단층에 대한 운동학적 해석은 단지 지질분포 특성의 차이를 근거로 단순 우수주향이동으로 해석해왔다. 그러나 일반적으로 대규모 단층들은 단계적으로 서로 다른 운동체계에서 복합적인 발달과정을 거치면서 현재의 모습으로 보인다. 따라서 양산단층의 주변 지질구조와 운동학적 관계를 알아보기 위하여 양산단층 주변의 지질분포, 지질구조, 단층주변의 소단층들에 대한 특성을 분석하였다. 양산단층 주변 퇴적암의 층리면 자세는 양산단 층이 동일한 사건의 주향이동으로 형성된 단층예인의 특성이 아니라 서로 다른 응력축의 지배를 받았거나 서로 다른 크기의 운동을 받았음을 암시하고 있다. 또한 단층의 주향을 따라 단층대 폭의 변화를 살펴본 결과 크게 5개의 주기를 가지면서 변화되고 각각의 주기는 약 25-30 km 로 규칙적으로 나타난다. 또한 단층조선이 발달된 소단층의 분석결과들은 양산단층이 한번의 운동으로 발달한 것이 아니라 매우 복잡하고 다양한 사건들을 겪은 다중 변형의 산물임을 지시하고 있다.

• 대한지질공학회:학술대회논문집
• /
• 대한지질공학회 2002년도 정기총회 및 학술발표회
• /
• pp.173-182
• /
• 2002

단층이동자료를 이용하여 지구조 사건을 분별하고 단층의 운동시기 및 한반도 주변지구조체계와 비교하여 양산단층의 진화과정을 해석하였다. 양산단층은 팔레오세 때 단층형성이 시작되었고 그 후 NW-SE 신장 사건에 의해 우수주향이동을 했다. 우수주향이동은 장구한 시간동안 진행되어 마이오세 초에 확장축이 바뀜에 따라 약간의 변화가 있지만 우수운동은 지속되었다. 마이오세 말에 양산단층은 좌수이동으로 변하여 운동하게 되며, 마이오세 말 혹은 플라이스토세 초에 와서 양산단층은 N-S 방향의 최대 수평압축응력을 받게 된다. 이후 플라이스토세를 전후해서 E-W 방향의 최대수평압축응력에 의해 양산단층은 다시 우수이동을 한다. 이와 같이 양산단층은 한번의 운동으로 발달된 단층이 아니라 서로 다른 응력체계 하에서 다중변형을 받아 현재의 모습으로 진화되었다고 판단된다.

• 한국지진공학회:학술대회논문집
• /
• 한국지진공학회 1997년도 추계 학술발표회 논문집 Proceedings of EESK Conference-Fall 1997
• /
• pp.49-56
• /
• 1997

Most large strike-slip faults do not rupture their entire length during single faulting but generally break in segments which are different in location and time of faulting. Studies related to the development of the Yangsan fault have been reported based on partial results from characteristics of geolgocial distribution, geophysical prospecting and paleostress analyses. This paper shows, based on preliminary results, that the Yangsan fault could be divided into four structural areas along entire length. These areas are different in geological distribution, bedding attitude measured from sedimentary rocks, strike of main fault, geometry of small faults, termination types of fault tips, cyclic variation of fault zone width, and arrangement of paleostress. Therefore, the Yangsan fault could be divided into at least four segments.

• 한국지진공학회:학술대회논문집
• /
• 한국지진공학회 1998년도 추계 학술발표회 논문집 Proceedings of EESK Conference-Spring 1998
• /
• pp.228-234
• /
• 1998

To interpret the relationship between movement of the Yangsan fault and tectonics around the Korean peninsula, the six sequential paleostresses were reconstructed from 1, 033 striated small faults which were measured at 37 outcrops along the strike of the Yangsan fault. And, the relationship between these paleostresses of the Yangsan fault and the tectonic events around the Korean peninsula were compared. As compared with the tectonic history around the Korean peninsula, the movement of the Yangsan fault is interpreted as follows; The initial feature of the Yangsan fault was formed with the development of extension fractures by the NW-SE extension. The fault experienced a right-lateral strike-slip movement continuously. The movements had been continued until the Late Miocene age, which was the most active period in faulting. The left-lateral strike-slip movement was followed by subsequent tectonic events. In the last stage, the fault acted with a slight extension or right-lateral movement.

• 한국지진공학회:학술대회논문집
• /
• 한국지진공학회 2003년도 춘계 학술발표회논문집
• /
• pp.30-37
• /
• 2003

Lineaments along the Yangsan and Ulsan fault systems were extracted through aerial photograph interpretation in the southeastern part of Korean Peninsula. Lineaments can be classified into five ranks on the basis of certainty and divided by curvatures. Mean strikes of all lineament by aerial photograph interpretation is dominant in NS ~N05$^{\circ}$E direction along the Ulsan fault system and Nl5-20$^{\circ}$E direction along the Yangsan fault system respectively. The curvature of lineament around Yangsan Fault is different from around the Ulsan Fault system, the former shows that straight lineament is dominant but the latter curved lineaments are dominant. It indicates that the Quaternary faults around Ulsan Fault would be appeared as reverse fault.

• 한국지진공학회:학술대회논문집
• /
• 한국지진공학회 2003년도 춘계 학술발표회논문집
• /
• pp.61-68
• /
• 2003

The H/V ratio (Horizontal to Vertical spectral ratio) has been used to infer site amplification without previous knowledge of near-surface geology and in fact may provide useful general site condition information. This method is used to classify the site characteristics of seismic stations in Korea by comparison with known H/V ratios representative of various sites all over the world. In addition, differences between horizontal and vertical kappa values were evaluated for each seismic stations by comparing WV ratio and Weak Motion amplification derived from inversion of stochastic ground motion parameters and were used as index to quantitatively classify the site characteristics.

• 한국지진공학회:학술대회논문집
• /
• 한국지진공학회 2003년도 추계 학술발표회논문집
• /
• pp.20-27
• /
• 2003

The nonparametric method was employed to obtain detailed broadband attenuation characteristics of horizontal Fourier spectra without generally assigned constraint that derived path terms be zeros at a reference distance. Instead, path terms fer a reference distance were obtained based on the physical phenomenon that the seismic phase is stable over the hypocentral distance range from 200km to 400km so that the Q-values evaluated at several distances inside that region should be the same. The inverted path terms show three distinct linear regions roughly divided by hypocentral distances at 65km and 115km. Also complex behavior at the near distance range below 100km was revealed which can not be properly fitted by combination of single $Q_{0}$ $f^{η}$ model and any geometrical spreading models.s.

• 한국지진공학회:학술대회논문집
• /
• 한국지진공학회 2003년도 추계 학술발표회논문집
• /
• pp.28-35
• /
• 2003

Quaternary faults found around the Ulsan Fault System can be divided into 4 types based on the fault outcrop features : Type I fault cuts basements and Quaternary deposits of which remain on both hangwall and footwall. Type II fault is developed only in Quaternary deposit. Type III fault has inclined unconformity after Quaternary faulting. Type IV fault is common type around the Ulsan fault system and has horizontal unconformity surface after cutting earlier Quaternary deposit. After erosion, later Quaternary deposit overlays on both old deposit and basement. The Ulsan Fault System consists of three segments at large scale from north to south based on the lineament rank and shape, Quaternary fault location, and slip rate. The segment boundaries are identified by the existence of the two intervals which show no lineaments and Quaternary faults. But, if detail fault parameters could be obtained and used in segmentation, it can be divided into more than three segments.

• 한국지진공학회:학술대회논문집
• /
• 한국지진공학회 2006년도 학술발표회 논문집
• /
• pp.33-40
• /
• 2006

Since early 1990's, several Quaternary faults have been found in the southeastern part of the Korean peninsula with reference to fault activity. Because some of these faults could be considered a capable fault, it is a very delicate matter, which need to be deal with carefully in assessing the seismic hazard. In determining whether or not a faults are capable, because of the low rate of seismicity and insufficient relationship between instrumental macro-seismicity and fault, there has been considerable debate among geologists and geophysicists in Korea. In this study, we discuss the criteria and probabilistic approaches that are used to assess whether or not a fault is seismogenic. And, we preliminarily also suggest the probability of fault activity from the spatial association between faults and earthquake epicenters, fault slip and tectonic stress, and geological evidence for multiple episodes of reactivation.

• 한국지진공학회:학술대회논문집
• /
• 한국지진공학회 2006년도 학술발표회 논문집
• /
• pp.78-85
• /
• 2006

The Ulsan Fault System continues from north of Gyeongju to Ulsan city, trending NNW-SSE and is about 50 km. Many Quaternary faults have been reported and investigated with outcrop observation. Lineaments have been extracted with aerial photograph interpretation and classified by their ranks. Trench excavations on the lineaments along Ulsan Fault System have been carried out to clarify the neotectonic movements and fault parameters such as the latest movement age, fault displacement, slip rate and recurrence interval. We have compiled data from previous studies on criteria of segment type such as lineament rank, seismicity, slip rate, and the latest fault movement. Based on these data, we tried to devide the Ulsan Fault System into several segments. The results of segmentation with each types of segment along the Ulsan Fault System did not show singular division point but overlapped or different length and location.