• Proceedings of the Korean Magnestics Society Conference
• /
• 2002.12a
• /
• pp.212-213
• /
• 2002

전자기기의 소형화에 동반하여 동작주파수가 높아짐에 따라 여기에 이용되는 소자의 크기도 밀리 사이즈에서 마이크로 사이즈까지 작아지고 있다. 이에 따라 여기에 이용되는 각종 소자의 전기적인 값도 작아지고 있으며 허용 오차 값이 적은 정밀한 소자가 이용되고 있다. 그러나 소자의 크기와 소자값의 감소에 따라 정확하고 간편하게 그리고 많은 소자를 효율적으로 측정할 수 있는 방법이 필요하다. 특성 임피던스 50 $\Omega$을 가지는 동축선로형 프루브 제작에 대해 이미 검토하였다[1]. (중략)

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.34 no.4
• /
• pp.457-465
• /
• 1998

• Journal of the Korean Magnetics Society
• /
• v.8 no.1
• /
• pp.21-26
• /
• 1998

The temperature dependence of the magnetoimpedance (MI) effect is important both for scientific study and for thermal stability of MI sensor. We have performed the measurement of MI effect in amorphous $Co_{66}Fe_1Ni_1B_{14}Si_{15}$ (Metglas 2714 A) ribbon from a cryogenic chamber where the temperature of the sample can vary from 10 K to 300 K. The ac current was fixed at 10 mA for all measured frequencies ranging from 100 KHz to 10 MHz. The magnetoimpedance ratio (MIR) was revealed the drastic increment as a function of MIR (T) = MIR (0) exp(cT$^2$) where c is a constant. The measured MIR values at room temperature are usually 2-3 times larger than the data measured at 10 K for all measured frequencies. However, the shapes of the MIR curves are remained. This result shows the potential application of the MI effect for a temperature sensor. The frequency dependence of MIR has shown the typical tendency where the maximum values of MIR are increasing ans also the shapes of MIR curves are getting broader as the measured frequency increases.

• Journal of the Korean Magnetics Society
• /
• v.26 no.6
• /
• pp.201-205
• /
• 2016

In this report, we measured the impedance spectrum in TMR device, and the relaxation behavior of the real and imaginary impedance spectrum was analyzed by using the equilibrant circuit of tunneling capacitance ($C_T$) and tunneling resistance ($R_T$). The relaxation frequency was increased with AC voltage in both the parallel and antiparallel alignment of two magnetic layers. The $R_T$ with AC voltage showed the typical bias voltage dependence. However, the $C_T$ showed large value than the expected geometrical capacitance. The huge increase of $C_T$ was affecting as a limiting factor for the high speed operation of TMR devices. Thus, the supercapacitance of $C_T$ should be considered to design the high speed TMR devices.

• Korean Journal of Materials Research
• /
• v.8 no.3
• /
• pp.252-255
• /
• 1998

In this paper, we investigate the magneto-impedance(M1) effect of the FeCoSiB amorphous magnktic films. The amorphous magnetic film having near zero magnetostriction is fabricated by using the sputtering method, and then annealed in magnetic field. When the external magnetic field is directly applied to the fabricated film, the voltage amplitude between both side of the magnetic film varies about 76.2% at 120[MHzl and the impedance varies about 2.1%/0e. Thus, we find that the fabricated magnetic film has the characteristics of good sensor element.

• Journal of the Korean Magnetics Society
• /
• v.17 no.2
• /
• pp.55-59
• /
• 2007

Co-based amorphous magnetic wire with a diameter of $125{\mu}m$ and a length of 40 mm was used as an inner conductor of a coaxial cable to construct a magnetic sensor. Sensor characteristics was measured up to 3 GHz with applied up to 60 Oe by using network analyzer. Frequency dependence of impedance for this sensor was very close to the impedance resonant pattern of transmission line and 250 MHz was obtained as a 1/4 wavelength without external magnetic field. Large impedance change was measured in the magnetic field range between 0 Oe and 1 Oe, which was influenced by permeability change of magnetic amorphous wire. Because ${\Delta}Z/{\Delta}H$ value of $300{\Omega}/Oe$ was obtained at 0.1 Oe, this coaxial cable with amorphous wire can be useful as a magnetic sensor.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.52 no.6
• /
• pp.43-49
• /
• 2015

In this paper, we propose enhanced wireless power transfer system based on magnetic resonance for portable electronic device charging. Resonators were designed and fabricated for efficiency improvement and miniaturization through electromagnetism simulation using HFSS(High Frequency Structure Simulator). Impedance matching network is employed to minimize reflections that is caused by difference between input impedance and output impedance. Receiver IC that consist of rectifier and Low Drop Out(LDO) regulator were designed and fabricated to reduce power loss. This chip is implemented in $0.35{\mu}m$ BCD technology. A maximum overall efficiency of 73.8% is determined for the system through experimental verification.

• Journal of Sensor Science and Technology
• /
• v.12 no.5
• /
• pp.205-210
• /
• 2003

To develop the highly sensitive Magneto-Impedance sensor, the amorphous ribbon was micro-processed to meander type sensor pattern, and its external magnetic field dependence of impedance was investigated. The impedance of the pattern had peak value at the magnetic field of 13 Oe and its changing ratio was about 170%. The impedance change per unit magnetic field was about 36% at bias field of 6 Oe, in which the output with high sensitivity and linearity could be obtained. The magnetic field resolution of the sensor module, which consist of the amorphous pattern and driving circuit, was about $10^{-3}$ Oe.

• Journal of the Korean Magnetics Society
• /
• v.17 no.3
• /
• pp.141-146
• /
• 2007

A new class of LC-resonator for micro magnetic sensor device was invented and fabricated by means of MEMS technique. The micro LC-resonator consists of a solenoidal micro-inductor with a bundle of soft magnetic microwire cores and a capacitor connected in parallel to the micro-inductor. The core magnetic material is a tiny glass coated $Co_{83.2}B_{3.3}Si_{5.9}Mn_{7.6}$ microwire fabricated by a glasscoated melt spinning technique. The core materials were annealed at various temperatures $150^{\circ}C,\;200^{\circ}C\;,250^{\circ}C\;,$ and $300^{\circ}C$ for 1 hour in a vacuum to improve soft magnetic properties. The solenoidal micro-inductors fabricated by MEMS technique were $500{\sim}1,000{\mu}m$ in length with $10{\sim}20$ turns. The changes of inductance as a function of external magnetic field in micro-inductors with properly annealed microwire cores were varied as much as 370%. Since the permeability of ultra soft magnetic microwire is changing rapidly as a function of external magnetic field. The inductance ratio as well as magnetoimpedance ratio (MIR) in a LC-resonator was varied drastically as a function of external magnetic field. The MIR curves can be tuned very precisely to obtain maximum sensitivity. A prototype magnetic sensor device consisting of the developed microinductors with a multivibrator circuit was test successfully.

• Proceedings of the KIPE Conference
• /
• 2015.07a
• /
• pp.237-238
• /
• 2015

본 논문은 스위치 동작 듀티에 따른 등가임피던스가 광범위하게 변화 하는 벅부스트 컨버터를 이용하여 전자식, 자기식 안정기 모두 호환 가능한 LED(Light Emitting Diode) 구동회로를 제안한다. 현재 사용되는 안정기는 상용 주파수를 출력으로 가지는 자기식 안정기와 LCC 인버터를 거쳐 수십kHz 주파수 출력을 가지는 전자식 안정기가 있다. 제안 회로는 안정기출력 주파수 특성 차이를 이용하여 High Pass Filter(HPF)를 통해 전자식 또는 자기식 안정기가 연결되었음을 감지하여 서로 다른 제어방식으로 동작시킴으로써 전자식 및 자기식 안정기 모두 호환이 가능하다. 본 논문에서 제안된 회로의 우수성을 검증하기 위하여 이론적 분석 및 16.8W급 LED 구동회로에 적용한 실험결과를 제시한다.