• The Journal of the Korea institute of electronic communication sciences
• /
• v.6 no.1
• /
• pp.129-134
• /
• 2011

The construction method in electrical room with hydro power generation is well informed in drawings and according to this method, to master the actual working conditions. It's necessary to consult location of KEPCO liability threshold with the KEPCO side, therefore make a decision to install the underground cable in hydro power station in each state, including outdoor pipes and manholes. Undulating rigid polyethylene conduit (125C) and CNCV-W extra high cable are laid and installed, to make a closely analysis to the construction by reviewing its process. In this work, the key part of the KEPCO power system for House of Commons is actually based on liability threshold, even including outdoors pipeline construction, high voltage underground electrical wiring and switchgear installation. It directly reveals the contents of the proposed construction methods about Housing Corporation and the High Voltage Switchgear Installation Inlet.

• Journal of Korean Society of Water and Wastewater
• /
• v.25 no.3
• /
• pp.383-390
• /
• 2011

In this study, a process combined biofiltration with sulfur-utilizing autotrophic denitrification and membrane separation was proposed to examine the efficiency of nitrogen removal. As an experimental device, hollow-fiber module was installed in the center of reactor to generate the flux forward sulfur layer in the cylinder packed with granular sulfur. In addition, a simple module was installed in activated sludge aeration tank which inside and outside of sulfur-using denitrification module was covered with microfilter and the module was considered as an alternative of clarifier. The experiment for developing new MBR process was carried out for three years totally. As the results of first two-year experiment, successful nitrogen removal performance was revealed with lab-scale test and pliot scale plant using artificial wastewater and actual plating wastewater. In this year, pilot scale test using actual domestic wastewater was performed to prove field applicability. As the results, high-rate nitrogen removal performance was confirmed with about 0.19 kg ${NO_3}^--N/m^3$ day of rate. Also significant fouling and pressure increase were not found during the experiment. And, the production ratio of sulfate and the consumption ratio of alkalinity showed a slightly higher value about 311 mg ${SO_4}^{2-}/L$ and 369 mg $CaCO_3$/L, respectively. In conclusion, the developed MBR process can be utilized as an alternative for retrofiting existing wastewater plants as well as new construction of advanced sewage wastewater treatment plants, with cost-effective merit.

• Korean Journal of Head & Neck Oncology
• /
• v.2 no.1
• /
• pp.61-66
• /
• 1986

Three cases of hyperparathyroidism are presented from our experience at Presbyterian Medical Center in Chonju in the hope that this will alert us all to the variegated patterns of clinical presentation. In the first case the principal symptom was muscular weakness. In the second a bone cyst (which was part of the syndrome of osteitis fibrosa cystica); and in the third case rib cage tenderness, backache, and persistent epigastric pain. All three had adenomas, but in Case 2 the adenomas were multiple. All three responded to surgical resection and remain well.

• Weed & Turfgrass Science
• /
• v.5 no.1
• /
• pp.35-41
• /
• 2016

Earthworm cast is a harmful factor which reduces the uniformity of management of turfgrass and play quality in golf courses and playground. This research was conducted to carry out the efficacy of some pesticide (bifenthrin GR + clothianidin GR, ethoprophos GR, imidacloprid SC, picoxystrobin WG, thiophanate-methyl WP) and tee tree (Camellia oliefera) extracts against reducing earthworm cast in golf courses. All tested materials were acted reducing earthworm cast, thiophanate-methyl among them showed the highest effect reducing earthworm casts in golf courses. Tea tree extracts was occurred similar efficacy among tested chemical pesticides. However, pellet type byproduct of tea seed extract and liquid formulation of tea tree extract were better than granule formulation of them. Byproduct of tea seed and tea tree extract can be used for alternative biological management material for reducing earthworm cast in heavily casting occurrence area.

• Korean Chemical Engineering Research
• /
• v.45 no.3
• /
• pp.277-285
• /
• 2007

The adsorption characteristics of multi-component solvent vapors including poorly-adsorbable chemicals such as toluene-xylene-MEK and toluene-MEK-IPA on the activated carbonaceous adsorbents were investigated in a stainless steel fixed bed of 10.2 cm ID and 50 cm in height in order to identify those carbons for eliminating and recovering solvent vapors from industrial emission sources. The used activated carbonaceous adsorbents were pelletized commercial activated carbons and activated carbon fiber. Breakthrough curves and adsorption capacity at atmospheric pressures were obtained. It has been found that non-polar and larger molecules have been adsorbed better than polar and smaller molecules. In special, alcohols and ketones were poorly adsorbed caused by competitive adsorbability in multi-component mixture system. However, it could be overcome by profitable employment of organization of cooperative system which was composed of different porosity activated carbonaceous adsorbents appropriately.

• Journal of Korean Society of Water and Wastewater
• /
• v.19 no.2
• /
• pp.200-208
• /
• 2005

In this study, a new submerged membrane bioreactor process packed with granular sulfur (MBR-GS) was operated to identify the biological nitrogen removal behaviors with plating wastewater containing high-strength $NO_3{^-}$ concentration. The continuous denitrification was carried out at $20^{\circ}C$ with various nitrogen loading rates using synthetic wastewater, which composed of $NO_3{^-}$ and $HCO_3{^-}$, but also actual plating wastewater, which was collected from the effluent of the H metal plating company. As a result, high-rate denitrification in the range of $0.8kg\;NO_3{^-}-N/m^3\;day$ was accomplished at nitrogen loading rate of $0.9kg\;NO_3{^-}-N/m^3\;day$ using synthetic wastewater. Also, higher-rate denitrification with actual plating wastewater was achieved up to $0.91kg\;NO_3{^-}-N/m^3\;day$ at the loading rate of $1.11kg\;NO_3{^-}-N/m^3\;day$. Additionally, continuous filtration was possible during up to 30 days without chemical cleaning in the range of 20 cmHg of transmembrane pressure. On the basis of the proposed stoichiometry, ${SO_4}^{2-}$ production could be estimated efficiently, while observed alkalinity consumption was somewhat lower than theoretical value. Consequently, a new process, MBR-GS is capable of high-rate autotrophic denitrification by compulsive flux and expected to be utilized as an alternative of renovation techniques for nitrogen removal from not only plating wastewater but also municipal wastewater with low C/N ratio.

• The Korean Journal of Pesticide Science
• /
• v.2 no.3
• /
• pp.36-44
• /
• 1998

To develope cost-effective new granular formulation of mixture with 7.0% chlomethoxyfen and 3.5% butachlor, this study was conducted by investigation of floatability, dispersibility or collapsability and released concentration of active ingredients in water and bio-efficacies of the granules formulated by different formulation methods compared to commercial pellet-extruded granules. They were formulated by coating on or impregnation into extruded pellets, sands and zeolites with two active ingredients, binders, friction reducer, dispersing agents and bentonite. Pellet-coated method showed similar floatability, collapsability and bio-efficacy to the commercial pellet-extruded one or better than that but unstable patterns of released concentration of chlomethoxyfen because of easy isolation of coated technical particles from the surface of granules. Sand-coated methods showed similar physical properties, released pattern of two active ingredients, and bio-efficacy to the commercial one. Liquid binders and/or dispersing agents are more important than powdered ones to control released concentration of active ingredients from the granule mixtures, to improve the floatability and dispersibility, and to show good bio-efficacy. Sand-coated one might be a suitable method if types and amount of liquid binders and dispersing agents are selected.

• Journal of Korean Society of Forest Science
• /
• v.55 no.1
• /
• pp.1-21
• /
• 1982

The pollen morphology of 2 forms, 6 varieties, 50 species, 15 genera, 11 families of Korean Sapindales was studied. The keys were provided for general and families of Korean Sapindales. General pollen morphology was diversed and taxonomically significant differences were obtained in shape, aperture, type and size, sculpture pattern and exine thickness of pollen grains. Pollen grains of Korean Sapindales could be grouped into four types and five subtypes. One of five sub-types pollen grains of Acer could be ground into four under subtypes: ginnala type, barbinerve type, psseudo-sieboldianum type and negundo type. Pollen morphology of Empetraceae, Buxaceae and Balsaminaceae appeared to have very special features in the equatorial view and aperature type compare with pollen grain of the other families of Korean Sapindales.

• Korean Journal of Plant Resources
• /
• v.18 no.2
• /
• pp.260-269
• /
• 2005

Taxonomic studies on morphological, principal component analysis (PCA), palynological, RAPD and PCR-RELP analysis were conducted to intraspecific relationships of Rubus oldhami. Three types of Rubus oldhami based on the flower characters such as petal length and number were used in this study. Among the 14 morphological characters, perianth length, calyx lobe length, apical leaflet shape and leaflet length were used to distinguish for each type. The pollen characters such as shape, aperture number, surface sculpture were showed very similar among three types. Eight primers out of 20 arbitrary primers were screened for three types, and were revealed 33 ($60\%$) polymorphic bands. The phonogram by RAPD data showed incongruent with morphological analysis. Even though ten restriction endonucleases produced 20 restriction sites, polymorphic bands were not observed. Based on the results, three types of Rubus oldhami divided well by morphological characters, but pollen and DNA data were not supported. Therefore, type 1 and 2 which different from type 3 by flower characters considered as a temporary hybrid or ecotype because of their similar habitats.

• Journal of the Korean Society of Radiology
• /
• v.11 no.5
• /
• pp.297-302
• /
• 2017

Recently, building materials and air purification filters with eco-friendly charcoal are actively studying to reduce the concentration of radon gas in indoor air. In this study, radon reduction performance was assessed by designing and producing new panel-type activated carbon filter that can be handled more efficiently than conventional charcoal filters, which can reduce radon gas. For the fabrication of our panel-type activated carbon filter, first the pressed molding product after mixing activated carbon powder and polyurethane. Then, through diamond cutting, the activated carbon filter of 2 mm, 4 mm and 6 mm thickness were fabricated. To investigate the physical characteristics of the fabricated activated carbon filter, a surface area and flexural strength measurement was performed. In addition, to evaluate the reduction performance of radon gas in indoor, the radon concentration of before and after the filter passes from a constant amount of air flow using three acrylic chambers was measured, respectively. As a result, the surface area of the fabricated activated carbon was approximately $1,008m^2/g$ showing similar value to conventional products. Also, the flexural load was found to have three times higher value than the gypsum board with 435 N. Finally, the radon reduction efficiency from indoor gas improved as the thickness of the activated carbon increases, resulting in an excellent radon removal rate of more than 90 % in the 6 mm thick filter. From the experimental results, the panel-type activated carbon is considered to be available as an eco-friendly building material to reduce radon gas in an enclosed indoor environment.