• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.13 no.1
• /
• pp.94-105
• /
• 1988

In this paper, we deal with to survey a narrow band ISDN transmission capability through the local subscriber line in Korea. First, we disscuss international activity trends of technical references required for a narrow band ISDN services using existing pair cables. Second, we have measured transmission characteristics to send digital signals at 144kbps ratio through the local subscriber line With this result, we have found that 3.6% of measured lines are not availlable for a narow band ISDN channel, obtained a conclusion that the input level of U-transceiver should be more than -31dBm so as to assure the sufficient digital transmission quality. We also know that majority noise cased by transmission error are due to impulsive noise and near end crosstalk. Fianlly. as a result of the BER measruement, it is observed that, within 2.5km, more than 70% of measured cables are satisfied with the reference quality.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.26 no.11A
• /
• pp.1820-1826
• /
• 2001

In this paper, we present a modeling scheme for the already-installed two-wire home phone lines with arbitrary topologies and show that the inter-symbol interference due to the topology can be removed using an adaptive equalizer. The transmission characteristics of the arbitrary-configured two-wire home phone lines can be analyzed through the ABCD matrices. The simulation result shows that the impedance mismatch due to the branch lines renders nulls in the frequency response or delayed pulses in the impulse response. These nulls or delayed pulses cause inter-symbol interference that inhibits correct signal detection. An adaptive equalizer is shown to be effective in eliminating the interference. Also, the simulation result shows that the equalizer converges in 1.5 ms at a data rate of 1 Msps at signal-to-noise ratios greater than 15 dB. In addition, from the result of relation between E$\_$b//N$\_$and BER(Bit Error Rate), we can see that E$\_$b//N$\_$o/ more than 19 dB is required for the data communication with a BER less than 10$\^$-5/.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.28 no.8A
• /
• pp.633-643
• /
• 2003

UWB impulse radio signals have an very short duration, extremely wide bandwidth and share the same frequency spectrum with other existing systems. It was determined by the Federal Communications Commission (FCC) that UWB systems could cause interference with other systems, such as Global Positioning System (GPS) for example. Therefore, at present. the FCC has restricted the use of UWB systems to frequencies above 3.1㎓. In this paper, We evaluated performance of UWB system using proposed pulses in ［1］［2］ that are strictly limited in time to remove interference while, at the same time, contain their power distribution to a frequency band from 3.1㎓ to 10.6㎓. In particular, We evaluated the BER Performance in relation to system parameters such as pulse duration. $\delta$, the number of users. Nu. and the number of symbols, M. We found the optimal pulse duration $\delta$ through computer simulation using developed UWB pulses in ［1］［2］. It is shown that performance evaluation between the UWB communication system using these UWB pulses ［1］［2］and the Gaussian monocycle pulse in M-ary PPM and BPSK schemes. These results can be contributed to construct M-ary PPM UWB communication system in terms of multiuser parameters and pulse duration.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.3C
• /
• pp.295-301
• /
• 2010

In this paper, we propose a new mouthpiece model for the electronic wind instrument using a propeller and linear analysis for fast tracking wind velocity blown. This method is a modification of the velocity anemometer for fast tracking wind velocity by the propeller's angular velocity (speed of revolution). In the case of velocity anemometer, wind velocity is calculated using the property that wind velocity is in proportion to the propeller's angular velocity. However, wind velocity and angular velocity of the propeller are not in one-one correspondence because wind velocity takes some transitional time for the expected wind velocity to be calculated from angular velocity. To resolve this problem, we propose a method for finding the impulse response of the system which can be considered as a linear system, and for estimating the wind velocity by deconvolving the propeller's angular velocity with the impulse response. To experiment and to prove the validity of the proposed system, we designed a mouthpiece model which consists of a motor, a propeller and an encoder. The result of estimated wind velocity in this method showed that this system is about eightfold faster than the method by the conventional velocity anemometer.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.1C
• /
• pp.81-89
• /
• 2009

We propose a D-ATR UWB (Differential-Average Transmitted Reference Ultra Wide Band) system based on impulse radio. The TR-UWB systems including traditional TR (Transmitted Reference) and ATR (Average TR), exhibit a problem of reduced data rate, since reference signals are additionally transmitted. To tackle this issue, the transmitter of the proposed D-ATR system employs a differential coding like the conventional D-TR system. In addition, the receiver of the proposed system has the structure that can improve signal-to-noise ratio of the reference template used in the correlation process, by recursively averaging the received reference signals like the conventional ATR system. The simulation results in the IEEE 802.15.4a UWB multipath channel models reveal that the proposed D-ATR system achieves much better bit error rate performance as compared to the conventional D- TR system.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.66 no.7
• /
• pp.1066-1071
• /
• 2017

Recently high voltage impulse (HVI) technique has been extensively studied for desalting processes to control the $CaCO_3$ scale formation in industrial water practices such as power plant, boiler, and heat exchange operations. Investigation of the operational parameters for the HVI is important, however, those had not been reported yet. In this study, the effect of initial feed volume and contact time on reduction of calcium ion concentration by the HVI technique was investigated. Initial feed volumes of artificial hard water which contained 100 mg/L of $Ca^{2+}$, were set to 1, 2, and 3 L respectively. After 24hr of HVI contact with 12kV, $Ca^{2+}$ ion was reduced to 50, 29 and 19 % of their initial concentration, indicating that calcium removal increased as initial feed volume decreased. This implies the applied HVI pulse energy per unit mass of calcium is important parameter determining overall desalting efficiency. A series of extended operations of HVI up to 30 days verified the long term stability of the HVI system. The calcium ion declined to 40 mg/L after 2~3 days, and further reduction of calcium was not achieved, indicating that optimum operation time could be 2~3 days under these experimental conditions. Consequently, it was confirmed that the important operational parameter of HVI technique is initial feed volume and contact time as well as the applied voltage that was already proven in the previous study.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• v.9 no.1
• /
• pp.524-527
• /
• 2005

A society has progressed rapidly toward the highly advanced digital information age. However, noise is generated by several causes, when signal is processed. Therefore, methods for eliminating those noises have researched. There were the existing FFT(fast fourier transform) and STFT(short time fourier transform) for removing noise but it's impossible to know information about time and time-frequency localization capabilities have conflictive relationship. Therefore, for overcoming these limits, wavelet-based denoising methods that are capable of multiresolution analysis are applied to the signal processing field. However, existing threshold- and correlation-based denoising methods consider only statistical characteristics for noise, accordingly a lot of noise is acceptable as an edge and are impossible to remove AWGN and impulse noise, at the same time. Hence, in this paper we proposed wavelet-based new denoising algorithm and compared existing methods with it.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.17 no.7
• /
• pp.641-655
• /
• 1992

In this paper, the performance of the various multiple accesstechniques for the mobile computer network has been studied in the consideration of the characteristics. Of the mobile communication channel. In the case of the hidden node occurring, it could be seen that the performance of the code division multiple access(CDMA) technique. With simultaneous access function is better than that of the other packet access methods such as carrier sensed multiple access(CAMA). Busy tone mulitiple access(BTMA)and idle signal muitiple access(ISMA) in the view of the throuhtput and mean delay time. Also it has been shown that the performance of the CDMA method is superior to that of other packet access techniques such as multiple access(CSMA).etc when the fading effect or impulsive noise exists in the mobile channel. Especially in the case of the distributed mobile network. It has been shown that the receiver-transmitter based CDMA method using the characteristics of CDMA effectively has better throughput and less mean delay time than the commontransmitter based CDMA technique.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.11C
• /
• pp.1498-1509
• /
• 2004

In this paper, we evaluate the performance of a noncoherent OOK (On-Off Keying) UWB (Ultra Wide Band) system based on power detection with noise power calibration and noise power windowing for ubiquitous sensor network applications in typical indoor wireless channels. Utilizing noise power calibration and noise power windowing, the current noise information can be initially or adaptively provided to determine suitable detection threshold value for signal demodulation. Simulation results show that the noncoherent OOK UWB system using noise power calibration achieves good BER (Bit Error Rate) performance which is favorably comparable to that of the system using the ideal adaptive threshold, while maintaining simple receiver structure. However, despite the serious loss of the data transmission rate, the performance improvement by noise power windowing is not so remarkable. furthermore, these performance results are similarly maintained in BEE 802.15 Task Group 3a UWB indoor channel model, and it is also revealed that the BER performance can be significantly improved by increasing the pulse repetition rate.

• Journal of Sensor Science and Technology
• /
• v.5 no.3
• /
• pp.9-16
• /
• 1996

This paper deals with the capacitive voltage divider which can measure a transient voltages generated by operating a high voltage impulse generator. The transient voltage measuring system using the capacitive electric field sensor consists of the planar-type electric field sensor having a fast response characteristic and the wide-bandwidth voltage follower, and the input impedance of which is extremely high, about $10^{12}{\Omega}$. In order to analyze the response characteristics to a step input, the newly developed calibration method is proposed, and the error of voltage dividing ratio associated with set-up condition is investigated. Also the optimal set-up condition that is to be maintained within the range of 0.5 % is taken. From the calibration experiment, the frequency bandwidth of the transient voltage measuring system whose response time to a step input is about 15.8 ns, is from 6.37 Hz to 27.3 MHz. Therefore it is possible to measure the commercial frequency voltages as well as the transient over voltages without signal distortions.