• Korean Chemical Engineering Research
• /
• v.50 no.6
• /
• pp.960-968
• /
• 2012

In this study, the measurement of physical properties of 3 different ethylene oxide adducted zwitterionic surfactants were measured such as critical micelle concentration, surface tension, interfacial tension, contact angle, viscosity and foam stability. Also, the dual function characteristics of the zwitterionic surfactants were investigated by determining an isoelectric point, which were obtained using zeta potential measurement and QCM (quartz crystal microbalance) experiments. The isoelectric point of the synthesized zwitterionic surfactant determined by zeta potential measurement was close to that obtained by QCM experiment and both results have shown almost the same trend as that determined by the frictional property measured using an automated mildness tester. In particular, it has been observed that all three surfactants used during this study provide better softening effect at a pH of neutral condition than at an acidic or an alkaline condition. This result indicates that the synthesized surfactants act as a cationic surfactant at a pH of neutral condition and thus provide good softening effect during a rinsing cycle in the detergency process.

• Journal of Korean Society of Forest Science
• /
• v.99 no.1
• /
• pp.136-143
• /
• 2010

This study was conducted to provide basic information on the management of natural deciduous forests by presenting suitable stand density over time for natural deciduous forests in Pyungchang Area. The stand density index(SDI) for the sampling point was also computed. The cutting scenarios were adopted by considering the SDI estimated in the sampling point. And then, simulation cutting was enforced to the stand. Cutting scenarios consisted of three cutting levels, with the period of 5 years where each suitable cutting level of selection system will not have the SDI over the maximum SDI throughout 30 years and consider harvest after 30 years. As a result of the simulation cutting, it was found that removing 12% and 14% of basal area per each time kept proper stand density while removing 10% exceed to the adequate basis. From an economic point of view, it was concluded that removal 12% of basal area would be the most suit cutting level in selection system.

• Applied Chemistry for Engineering
• /
• v.10 no.4
• /
• pp.523-530
• /
• 1999

Acrylic pressure-sensitive adhesive has been made utilizing organic solvents, but nowadays it is made by solvent-free system due to environmental problems. In this study, emulsion polymerization were carried out at $40^{\circ}C$ with methacrylic acid(MAA), n-butyl acrylate(n-BA) and 2-ethylhexyl acrylate(2-EHA) as monomers in the presence of anionic(sodium dodecyl sulfate, SDS) and nonionic(ethylene oxide types) surfactant mixtures. The overall conversion of the polymerization reaction in a mixed surfactant system was found to be higher than that in a single surfactant system. Emulsion stability in mixed or anionic surfactant systems was found to be over 12 week, which was better than that in nonionic surfactant system. Emulsion particle size decreased as surfactant content increased. The Tg and molecular weight of emulsion polymer were inependent of the type, the amount and the mixing ratio of surfactant. Based on the results of stability and peel strength, the optimum nonionic surfactant ratio in total 4 g of surfactant mixture systems is found to be 40~60% by weight where the nonionic surfactant has 50 ethylene oxide groups and 16~18 carbon atoms in hydrophobic alkyl chain.

• Korean Journal of Organic Agriculture
• /
• v.23 no.4
• /
• pp.867-873
• /
• 2015

The potential of nitrogen mineralization was studied by applying organic fertilizer to soil and incubating at $25^{\circ}C$ for 28 weeks. The organic fertilizers used in this experiment were oil-cake (CF-I, CF-II) and amino acid fertilizer (AAF-I, AAF-II). Accumulated mineralized nitrogen (N) fits the frist-order kinetics during incubation. The N mineralization potential ($N_0$) for organic fertilizers treated soil was highest at AAF-II treatment with a value of 27.71 N mg/100g, then followed by CF-II, AAF-I, CF-I. The pure N mineralization potential ($N_0$ treatment - $N_0$ control) for CF-I, CF-II, AAF-I, AAF-II were 2.55, 5.83, 3.66, 8.57 N mg/100g, respectively. The amount of N mineralized from organic fertilizers applied soil ranged from 46% to 61% of the total N content in organic fertilizer. The half-life ($t_{1/2}$) of organic nitrogen in soil treated with oil-cake and amino acid fertilizer was 17-21 days. Therefore, half of nitrogen contained in oil-cake and amino acid fertilizer was mineralized after 3 weeks application.

• Fire Science and Engineering
• /
• v.16 no.3
• /
• pp.26-31
• /
• 2002

Bromotrifluoromethane(halon-1301) and bromochlorodifluoromethane(halon-1211) have been widely used as a clean fire extinguishing agents due to their outstanding properties. However, production and use of halon are currently being phased out under an international agreements Montreal Protocol because of global environmental concerns and HFCs have been considered as promising alter-natives for the replacement of halon since their ozone depletion potentials are low. The vapor-liquid equilibrium data are required as important basic information in evaluating the solubility of clean fire extinguishing agents and determining their optimal compositions. In this work, we chose HFCs such as HFC-22 HFC-125, and HFC-l34a for gaseous fire extinguishing agents and nitrogen as a pressurization gas for a proper jet velocity of these agents. Phase equilibria for binary mixtures of nitrogen/HFC-22, nitrogen/HFC-125, and nitrogen/HFC-l34a were measured in the temperature range from 283.15K to 303.15K. For equilibrium measurement, we used a circulation type apparatus in which both vapor and liquid phases were continuously recirculated. The experimental data were relatively well correlated with the Peng-Robinson equation of state with Wong-Sandier mixing rules.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.8
• /
• pp.844-853
• /
• 2008

This paper describes the design of a FEM(Front End Module) having power detection function for mobile handset application. The designed FEM consists of a MMIC(Monolithic Microwave Integrated Circuits) power amplifier chip, SAW Tx filter and duplexer, diode power detector and stripline matching circuit. An LTCC(Low Temperature Co-fired Ceramics) technology is adopted for miniaturized FEM. The frequency band is $824{\sim}869$ MHz which is the uplink Tx band of the CDMA mobile system. The size of designed FEM is $7.0{\times}5.5{\times}1.5\;mm^3$, which is an ultra-small size even though the power detector circuit is included. All sub-components of FEM have been developed and measured in advance before being integrated into FEM. The measured output power and gain are 27 dBm and 27 dB, respectively. In addition, the measured ACPR characteristics are 46.59 dBc and 55.5 dBc at 885 kHz and 1.98 MHz offset, respectively.

• Journal of the Korean Chemical Society
• /
• v.33 no.4
• /
• pp.371-378
• /
• 1989

Kinetics of the substitution reaction of [pt[dien]X]$^+$(X = $Cl^-$, $Br^-$, $I^-$) with NO2- in aqueous solution were investigated by a spectrophotometric method at $20-35^{\circ}C$ and 1-1500 bars. The rates of these reactions were increased with raising temperature and pressure. The relative reactivities of replaceable ligands in [pt[dien]X]$^+$ follow the order ($Cl^-$ > $Br^-$ > $I^-$). Activation volumes (${\mid}{\Delta}V^{\neq}{\mid}$) were large negative values and decreased with raising temperature. First ($k_1$) and second($k_2$) order rate constants of these reactions were determined at $25^{\circ}C$ and both $k_1$ and $k_2$ were increased with raising pressure and activation volumes (${\Delta}{V_1}^{\neq}$, ${\Delta}{V_2}^{\neq}$) for the $k_1$ and $k_2$ path were large negative values respectively. The $k_1$ and $k_2$ of these reactions were determined at 1 bar and these values were increased with raising temperature. Activation parameters of $k_1$ and $k_2$ path were determined, therefore it can be inferred frp, these results that the substitution reactions of [pt[dien]X]$^+$ with ${NO_2}^-$ proceed through on associative (A) mechanism independent of a leaving groups and reaction paths.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.18 no.1
• /
• pp.38-42
• /
• 2005

B$_2$O$_3$ added Ba(Mg$_{1}$3/Nb$_{2}$3/)O$_3$ (BBMN) ceramics were not sintered below 900 $^{\circ}C$. However, when CuO was added to the BBMN ceramic, it was sintered even at 850 $^{\circ}C$. The amount of the $Ba_2$B$_2$O$_{5}$ second phase decreased with the addition of CuO. Therefore, the CuO additive is considered to react with the B$_2$O$_3$ inhibiting the reaction between B$_2$O$_3$ and BaO. Moreover, it is suggested that the solid solution of CuO and B$_2$O$_3$ might be responsible for the decrease of the sintering temperature of the specimens. A dense microstructure without pores was developed with the addition of a small amount of CuO. However, a porous microstructure with large pores was formed when a large amount of CuO was added. The bulk density, the dielectric constant ($\varepsilon$$_{r}$) and the Q-value increased with the addition of CuO but they decreased when a large amount of CuO was added. The variations of those properties are closely related to the variation of the microstructure. The excellent microwave dielectric properties of Qxf = 21500 GHz, $\varepsilon$$_{r}$ = 31 and temperature coefficient of resonance frequency($\tau$$_{f}$) = 21.3 ppm/$^{\circ}C$ were obtained for the Ba(Mg$_{1}$3/Nb$_{2}$3/)O$_3$+2.0 mol%B$_2$O$_3$+10.0 mol%CuO ceramic sintered at 875 $^{\circ}C$ for 2 h.h.2 h.h.

• Korean Journal of Materials Research
• /
• v.4 no.3
• /
• pp.319-328
• /
• 1994

Aluminium and titanium precursors containing $\beta$-diketonate ligands were used for the synthesis of polymeric sols of alumina and titania by sol-gel methods. To prepare polymeric sols by solgel processing, we synthesized modified precursors having chelating organic ligands. With these precursors it was found to be possible to control both hydrolysis and polycondensation reaction rates which resulted in ultrafine particles few nms of average size. The optimum molar ratio of acid to alkoxide for alumina sol was 0.3-0.4 and that of water to alkoxide &as 1. On the other hand, the corresponding ratios for titania sol were found be 0.25-0.20 and 1 respectively. Dynamic light scattering measurements indicated that the average particle size in both sols was in the order of few nms. SEM photographs were taken to observe crack-free and smooth surfaces of coated membranes after sintering at $450^{\circ}C$. Alumina coated membrane on a slide glass had about 4-4.5$\mu \textrm{m}$, thickness and titania coated one had 2-2.5$\mu \textrm{m}$, thickness. And according to TEM photographs, the grain size of titania was smaller than 30nm and that of alumina was in the range of few $\AA$s to 2nms. An X-ray diffraction study revealed that alumina was $\gamma$ phase and titania was anatase crystal.

• Applied Chemistry for Engineering
• /
• v.23 no.1
• /
• pp.112-118
• /
• 2012

In this study, physical properties of synthesized DE7-OSA82-AO and DEP52-OSA82-AOQ82 zwitterionic surfactants were measured such as critical micelle concentration, surface tension, interfacial tension, contact angle and viscosity. Phase behavior study was also performed. The dual function characteristics of a zwitterionic surfactant were investigated by determining an isoelectric point, which was attained using zeta potential measurements and QCM (quartz crystal microbalance) experiments. The isoelectric point of DE7-OSA82-AO surfactant determined by the zeta potential measurement and QCM experiment was about 7.2 and 7.4, respectively. On the other hand, the isoelectric point of DEP52-OSA82-AOQ82 surfactant determined by the zeta potential measurement and QCM experiment was about 10.9 and 11.0, respectively. The frictional property measured using an automated mildness tester showed that DE7-OSA82-AO surfactant can provide a good softening effect at an acidic or neutral condition. On the other hand, DEP52-OSA82-AOQ82 was found to provide a good softening effect to a fabric surface at a pH below its isoelectric point of 11.