• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.10 no.3
• /
• pp.74-78
• /
• 2011

In this paper, the bandpass filter for ITS system of 5.8 GHz is proposed by using the dual-mode resonator with the radial stub. As alternating the open stub with the radial stub, the size of the dual mode resonator can be reduced about 39.6% and the out-of-band characteristics of the bandpass filter using dual mode resonator can be enhanced from 19.4 dB to 29.1 dB by using the stub of $6.9{\Omega}$ i.e. realized by parallel two radial stubs with $60^{\circ}$ angle. The fabricated bnadpass filter using the dual mode resonator has the center frequency of 5.72 GHz with the fractional bandwidth of 4.1%. Also, the filter has the insertion loss and return loss of 1.79 dB and 19.4 dB, respectively.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.15 no.3
• /
• pp.301-310
• /
• 2004

In this paper, a compact dual-mode filter structure without coupling gaps is proposed. The novel design is achieved by embedding a pair of equal crossed slots and spur-lines. Without coupling gaps between feed lines and patch resonator, the new filter can provide low insertion loss. It is found that this design has wide coupling range for dual-mode operation. It means that these characteristics of the proposed filter can reduce uncertainty in fabrication. By using two PIN diodes mounted inside a pair of spur-lines, the proposed structure works as a switchable filter. Also, it has a size reduction of about 34.7 %, compared with conventional dual-mode filters.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.12
• /
• pp.1432-1437
• /
• 2010

This paper proposes a new design method of bandpass filter with single dual-mode resonator. In the proposed method, a coupling coefficient between two resonators was obtained by considering a dual-mode resonator as two single resonators. Based on the obtained coupling coefficient, two resonant frequencies of dual-mode resonator were calculated and then arranged according to a transmission zero's location of required filter. To verify the proposed theory, two WLAN bandpass filters which have a transmission zero to a lower and an upper stopband repectively were designed and implemented.

• Electronics and Telecommunications Trends
• /
• v.13 no.5 s.53
• /
• pp.53-64
• /
• 1998

본 고에서는 한파장 폐루프 공진기의 기본특성과 이를 활용한 이중모드 필터 구조 및 필터의 주요특징을 기술하였다. 또한 독립적인 직교공진모드를 이용한 폐루프 공진기의 특성과 공진기의 크기를 소형화 하는 기법 및 소형화 된 공진기의 공진조건 등을 기술하였고, 소형화 된 공진기를 이용한 듀플렉서의 응용 예 등에 대해 기술하였다. 폐루프 공진기를 이용한 이중모드필터 등은 마이크로 스트립 형태로 구현이 가능하기 때문에 MIC 또는 MMIC 등에 적합한 구조이며, 능동소자 등의 삽입이 가능하기 때문에 능동필터, VCO, 튜닝필터 등의 구현이 가능하고 소형의 듀플렉서 설계가 가능하기 때문에 향후 마이크로파 부품분야에서 기대되는 부품이라 할 수 있다.

• Korean Journal of Optics and Photonics
• /
• v.20 no.1
• /
• pp.41-47
• /
• 2009

We report the spectral characteristics of Multimode Interferometer (MMI)-coupled semicondoctor square ring resonators. The epitaxial layers of the proposed semiconductor ring resonator consists of $1.55{\mu}m$ GaInAsP-InP multiple quantum wells. The lasing characteristics were observed by varying the structure parameters of the MMI-coupled square ring resonators. It is concluded that the MMI-coupled scheme selects a single spectral lasing mode in the double square ring cavities.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2013.05a
• /
• pp.497-499
• /
• 2013

In this paper, electrical lengths and impedances of a dual-mode resonator are calculated by using the transfer function of a dual-mode resonator by realizing the short-stub. The electrical length of transmission-line for a resonator is function of the frequency and the electrical length of stub is defined by the frequency and impedances of line and stub. Also, the inverter value of a bandpass filter using the dual-mode resonator is calculated. The effect of stub's impedance for inverter is very small. And, as the impedance of line is decreasing, the inverter value is increasing and as the bandwidth is increasing, the inverter value is increasing.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.26 no.9
• /
• pp.814-820
• /
• 2015

In this paper, A high selective dual-band bandpass filter was proposed using a dual-mode ring resonator with two short-circuited stubs. For dual-mode resonance, the ring resonator is directly connected with non-orthogonal feed-lines via coupling capacitors. Two short-circuited stubs which are unequal lengths are simultaneously placed at two corners along the two symmetry plane of the ring resonator in order to obtain dual-band responses. Because the feeding angle perturbated ring resonator of the proposed dual-band bandpass filter has the symmetrical structure, Even/Odd mode analysis can be well applied to extract the scattering parameters and transmission zero frequencies. The proposed dual-band bandpass filter was designed and fabricated for WLAN(Wireless Local Area Network) application of IEEE 802.11n standard. The measured results showed a good agreement with the simulation results, and it should be well applied not only for WLAN applications but also for any other communication systems.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.13 no.2
• /
• pp.327-332
• /
• 2018

In this paper, the value of inverter and the characteristics of the dual-mode resonator with the shunt-stub are analyzed and calculated. The value of inverter is function of the impedances and electrical lengths of the resonator and shunt-stub. According to suggested equation, the value of inverter is increased for the square root function. And the value of inverter is decreased as higher impedance of resonator and higher ripple. The bandwidth of the filter is increased as the ripple and the impedance ratio. Also, the center frequency of the filter is shifted as designed impedance. In order to show the designed method, the filter with the resonator's and stub's impedances of $70.7{\Omega}$, and $56.56{\Omega}$, respectively, is suggested by example.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.12
• /
• pp.1447-1453
• /
• 2010

In this paper, the design and the fabrication of dual-band bandpass filter using two dual-mode resonators is presented. Dual-mode resonator using a short stub is miniaturized by inter-digital capacitor and stepped impedance. Two dual mode resonators are designed to have different resonant frequencies, one for the lower passband and the other for the upper passband. Transmission zero is positioned at low or high rejection bands with a sharp skirt characteristic. Dual-band operation can be achieved using dual feeding structure. For WLAN, the proposed filter at 2.45/5.25 GHz is designed and fabricated. The size of the filter is as compact as 1$10.83\;mm{\times}5.3\;mm$.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.22 no.2
• /
• pp.252-257
• /
• 2011

A compact microstrip dual-band bandpass filter with controllable bandwidth for each passband is proposed. Each passband is independently designed using two different dual-mode resonators. The proposed dual-band bandpass filter has three transmission zeros. Two transmission zeros are generated by each dual-mode resonator. An additional transmission zero is generated by input/output port coupling. The dual-band bandpass filter application is designed for 2.4/5.7 GHz WLAN. Experimental results are presented to validate theory.