• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.5A
• /
• pp.634-640
• /
• 2000

This paper proposes a new extended decision directed-decision estimated phase recovery algorithm based on maximum likelihood parameter estimation for OQPSK. In this scheme, comparing conventional one, the data dependent noise of phase recovery loop is reduced by inserting filter with 2 taps to in-phase and quadrature-phase channel respectively before phase detector. The proposed scheme is compared to conventionalscheme and OQPSK in aspect to BER(Bit Error Rate) and phase error according to the roll-off factor of baseband filter, the output back-offs of nonlinear satellite channel, and loop bandwidth.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.13 no.9
• /
• pp.907-915
• /
• 2002

In this paper, a compact digital phase shifter to be used an active phased array antenna system for satellite communications was proposed. The even and odd mode analysis for a given reflection-type phase shifter, which uses a folded hybrid coupler as a base element, was performed and the design parameters were derived. Also, to verify experimentally the electrical performances of the proposed structure, X-band 4-bit digital phase shifter was designed and fabricated using Teflon soft substrate $({\varepsilon}_r; =\;2.17)$. Its circuit size was less than 3.5 cm $\times$ 3.0 cm, and it exhibited at least 50 % size reduction as compared with the conventional unfolded configuration. The experimental results of the fabricated phase shifter showed that the average insertion loss and insertion loss variation were less than 3.5 dB, $\pm$ 0.6 dB within the operating band, 7.9 ~ 8.4 GHz, respectively. And, input and output return loss were more than 10 dB, respectively. Also, the phase response of the phase shifter showed 4-bit operation with $\pm$3$^{\circ}$ rms phase error.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.23 no.10
• /
• pp.1145-1150
• /
• 2012

In this paper, an improved Schiffman phase shifter is proposed using slot-coupled lines. It consists of the typical coupled lines and a simple rectangular slot which is placed in the ground plane underneath the coupled lines. Phase responses of the slot-coupled Schiffman phase shifter are analyzed in consideration of the phase velocity of two independent transmission modes and the characteristic impedance of slot-coupled line. The $905^{\circ}$ Schiffman phase shifters with high impedance ratio is realized at 2.4 GHz, which cannot be implemented with the conventional coupled lines. The measured results show that the bandwidth is around 74.2 % within the phase errors ${\pm}5^{\circ}$. The measured return loss is found to be better than 15.0 dB and insertion loss is less than 1.5 dB over the operating frequency band.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.22 no.8
• /
• pp.1076-1082
• /
• 2018

This paper describes interferometer direction finder which measures the angle of arrival based on calculation of the phase difference of received radio signal from different antennas. Modern Electronic Warfare direction finder uses digital phase difference measuring techniques which have less effect on temperature variation and better performance under low Signal to Noise Ratio environment. In this paper, we analyze acceptable phase difference error for requirement of system's direction finding accuracy and introduce digital phase difference calculation techniques. We have investigated quantitative analysis on phase difference calculation according to sample number, SNR, interference injection. Through the simulation, frequency domain measurement technique is better performance than the time domain one at the environment of low SNR and interference injection. Proposed method can be used to determine the performance of interferometer direction finder.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.1A
• /
• pp.83-90
• /
• 2007

In this paper, we propose an implementation and an algorithm of 'Jitter and Glitch Removing Circuit' for UHF RFID reader system based on ISO/IEC 18000-6C standard. We analyze the response of TI(Texas Instrument) Gen2 tag with a reader using the proposed algorithm. In ISO/IEC 18000-6C standard, a bit rate accuracy(tolerance) is up to +/-22% during tag-to-interrogator communication and +/-1% during interrogator-to-tag communication. In order to solve tolerance problems, we implement the Jitter and Glitch Removing Circuit using the concept of tolerance and tolerance-accumulation instead of PLL(DPLL, ADPLL). The main clock is 19.2MHz and the LF(Link Frequency) is determined as 40kHz to meet the local radio regulation in korea. As a result of simulations, the error-rate is zero within 15% tolerance of tag responses. And in the case of using the adaptive LF generation circuit, the error-rate varies from 0.000589 to zero between 15% and 22% tolerance of tag responses. In conclusion, the error-rate is zero between 0%-22% tolerance of tag response specified in ISO/IEC 18000-6C standard.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.22 no.1
• /
• pp.16-23
• /
• 2011

This paper suggests a motion compensation technique using GPS/IMU data in order to compensate for phase error caused by undesired motion of radar platform. An actual flight trajectory would be deviate from an ideal straight-constant trajectory with a constant velocity for SAR imaging, due to pitch, roll and yaw motion of aircraft caused by turbulence. This leads to blurred SAR images due to inter-pulse phase errors as well as along-track velocity errors. If the motion compensation is carried out to reduce those errors, SAR image quality can be significantly improved. Simulation results show that the motion compensation technique introduced in this paper is an effective tool to improve SAR image quality against severe motion of radar platform.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.46 no.2
• /
• pp.46-52
• /
• 2009

In this paper, the timing estimator based on the principle of the best linear unbiased estimator (BLUE) is proposed in OFDMA uplink systems. The proposed timing estimator exploits the phase information of the differential correlation between adjacent subcarriers. The differential correlation can extract the information about timing offset and mitigate the distortion of the signal caused by the frequency selectivity of channel. Compared with conventional methods, the proposed estimator shows more accurate capability in estimation. In addition, the estimator is hardly affected by the distortion caused by the frequency selectivity of channel. Simulation results confirm that the proposed estimator shows a small error mean and a relatively small error variance. In addition, the performance of the estimator is evaluated by means of SNR loss. It is shown by simulations that the SNR loss of the proposed estimator by estimation errors is less than 0.4 dB for the SNR values between 0 and 20 dB. This might indicate that the proposed estimator is suitable for the timing synchronization of multiple users in OFDMA uplink systems.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.22 no.3
• /
• pp.299-311
• /
• 2011

In this paper, we have identified the system instability factors in a bistatic radar system using pulse chasing and considered their effects on the bistatic receiver's MTI(Moving Target Indication) improvement performance. The pulse chasing is a scan method that searchs a restricted area on the transmit pulse-to-pulse basis and the MTI filter is a signal processing that separates a target from some kinds of interferences such as clutter using small number of transmit pulses. Ideal MTI processing performance, e.g., clutter attenuation and improvement, has been limited by the property of the clutter itself, however, the MTI performance in a proposed bistatic receiver configuration could be affected by the receiving beam pointing error during pulse chasing scanning. Also, for the bistatic receiver, we have defined other system instability factors, which result from the time synchronization error, COHO's phase error, the frequency/phase synchronization error, and have analyzed their effects on the system performance improvement.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.32 no.5
• /
• pp.74-83
• /
• 2004

The carrier phase measurements from GPS and GLONASS have different characteristics and therefore, have to be processed with different methods to provide precise positions or attitudes. In this contribution, at first, a measurement model is derived which can be used to not only GLONASS only applications but also both GPS and GLONASS applications. And then an error analysis of the proposed method performed using the derived model to derive analytic relationships between GDOP, PDOP and RGDOP. Finally, an integer ambiguity resolution method which was used in GPS is expanded to GPS and GLONASS. The proposed results can be directly applied to the design and analysis of GLONASS receiver and application programs. Furthermore, it is expected that the suggested method can also be effectively applied to combine the characteristically different measurements from the future satellite navigation systems such as GPS modernization, Galileo and QZSS.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.18 no.6
• /
• pp.567-575
• /
• 2017

The direction finder is an important device for an electronic support(ES) system because it is responsible for finding the direction of an emitter. The higher the accuracy of the direction finding, the higher the vitality of the weapon system with the ES system. Recently, the direction error occurred in the operating shipboard ES system when direction finding was performed for the signal with a pulse width of 200 ns. Therefore, this paper proposes, an improved method to reduce the direction error for shipboard ES systems. The proposed method was applied to the operating shipboard ES system and a field test was performed. The results of the field test showed that the direction error was reduced significantly for the signal with a pulse width of 200 ns.