• Korean Journal of Optics and Photonics
• /
• v.14 no.2
• /
• pp.184-188
• /
• 2003

We fabricated a P-I-i-I-N $GaAs/Al_{0.35}Ga_{0.65}As$waveguide phase modulator with significant phase shift for the TE mode but negligible for the TM mode. We selected the P-I-i-I-N structure to cause a phase shift about the TM mode. The wavelength of $\lambda=1.55$\mu\textrm{m}$ was measured for both the TE and TM modes, respectively. As a result, the measured phase shift efficiency ($\Delta\phi$) by using the Fabry-Perot resonance method was $7.9^{\circ}/V.mm$ for TE-polarized light. Also, no modulation was observed for TM-polarized light.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.13 no.1
• /
• pp.67-76
• /
• 1989

Although the standard 2-CR network filter, one of the filters used for measuring surface roughness, is being used widely in the field of industry it possesses a weak point of causing Phase-distortion when the wavelength is passing through. Phase-corrected filter is used for eliminating these phase-distortion and the difference of phase characteristics between these two filters is thought to have considerable amount of effect on the surface roughness value. Moveover, the definition on this is as yet unclear. Therefore, the Rt and Rz value, obtained when the wavelength are passed through the standard and phase-corrected filters from the same random machine-processed surface, and its standard deviation are compared and experimented in this paper. Also, the ratio of relative bearing curve complying to the phase characteristics of these two filters are acquired. As a result, the use of phese-corrected filter is appropriate in experiments where the form of wavelength is important, and the standard deviation on the same experimented values appeared greater with when using the standard filter. The rate of relative bearing curve became greater as .lambda.$_{c}$, the cut-off value of filter, became smaller.r.

• Proceedings of the KAIS Fall Conference
• /
• 2009.12a
• /
• pp.217-219
• /
• 2009

본 논문에서는 NE6510179A 트랜지스터를 사용하고, 나선형 공진기를 이용하여 단일 고출력 발진기를 설계 측정하였다. 발진기의 출력과 주파수 선택을 공진기가 결정하므로, 공진기중에 Q값이 높은 나선형 공진기를 선택하였다. 이를 ADS Momentum을 이용하여 설계하여 제작 및 측정을 하였다. 이 때 측정된 단일 고출력 발진기의 성능은 22.61dBm @ 1.74GHz로 측정되었고, 위상잡음은 -146.76dBc/Hz @ 1MHz offset으로 측정 되었다.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.4
• /
• pp.442-450
• /
• 2008

In this paper, the phase diverisity in a direct-conversion receiver for a UHF RFID reader is analyzed and the optimal I/Q signal combining methods is presented with respect to tag modulation. At first, fading characteristics of a single channel receiver is shown to prove the importance of phase diversity due to the phase relationship between the backscattered signal and the local oscillator. And the optimal signal combining methods are presented in order to overcome the signal power reduction due to phase diversity. In case of ASK, the power combining method is presented for the optimal I/Q combining. And the arctangent and principal component combining methods using covariance matrix of I and Q channels are presented for the optimal I/Q combining in case of PSK. In order to analyze the performance of suggested methods, the selection diversity and the optimal combining methods are compared. According to analysis and simulation results, the optimal combining methods have a maximum 3 dB SNR enhancement than selection diversity.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.16 no.6
• /
• pp.1242-1249
• /
• 2012

This paper proposes a metastability-free synchronization method and a mesochronous synchronizer for NoC. It uses the clock transmitted from TX as a strobe and solves the metastability problem by selecting one of rising or falling clock edge depending on the sampling value in RX when the phase difference between clocks is under a metastability window. The logic simulation results show that it works without metastability under $0^{\circ}{\sim}360^{\circ}$ phase difference in the synchronizer that a fault is inserted. The mesochronous synchronizer has a simple control logic and is suitable for NoC.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.27 no.11
• /
• pp.978-986
• /
• 2016

X-band phased array antenna module for the compensation of deformed beam direction by wing deformation is designed and fabricated. The phased array antenna module consists of array antenna, phase shifter, power divider and control circuit. To select out the best component, the variation of radiation pattern by wing bending and phase error of components is simulated. The fabricated phased array antenna module shows an antenna gain of 5.84 dBi, a return loss of 13.6 dB and a bandwidth of 10.6 % at 9.375 GHz. The test bed was set up to verify the performance of beam direction compensation. This test confirmed that the main beam direction of array antenna has been well restored under wing bending of 9 %.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.12 no.3
• /
• pp.462-469
• /
• 2001

In this paper, local oscillator in K band using low frequency noise upconversion gain anaylsis was designed and measured. We extended Two Signal Method(TSM) to estimate upconversion gain and resulting phase noise. To confirm the validity of the proposed method, a free-running oscillator which had low upconversion gain was designed. The measured oscillation frequency was 23.42 GHz and phase noise at 1 MHz of offset was -105.2 dBc/Hz. Also, this oscillator was operated for subharmonic injection locked osci1lator(SILO). In this case, SILO showed ideal frequency multiplier phase noise characteristics at low subharmonic injection power level.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.8 no.4
• /
• pp.906-911
• /
• 2004

In this paper, a VCDRO(Voltage Control Dielectric Resonator Oscillator) applied to FMCW(Frequency Modulated Continuous Wave)Radar as stable source is implemented and constructed with a MESFET(Metal-semiconductor Field-Effect Transistor) for low noise, a dielectric resonate. of high frequency selectivity, and high Q varator diode to obtain a good phase noise performance and stable sweep characteristics. The designed circuits is simulated thrash harmonic balance simulation technique to provide the optimum performance. The measured result of a fabricated VCDRO shows that output is 2.22㏈m at 12.05GHz, harmonic suppression -30㏈c, phase noise -130㏈c at 100KHz offset, and sweep range of varator diode $\pm$18.7MHz, respectively. This oscillator will be available to FMCW Radar.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.26 no.5A
• /
• pp.836-845
• /
• 2001

본 논문에서는 시간 선택성 다중경로 이동 무선 채널을 다양한 방법으로 모델링 하고 그에 따른 여러 가지 특성평가를 제시하였다. 모델링 방법에는 Jakes 방식과 시간 영역에서 독립적인 두 개의 가우시안 잡음 발생기와 정형필터(shaping filter)를 사용하는 방식 및 주파수 영역에서 필터링 하는 방식이 있다. 이 세 가지 모델링 방법의 성능을 진폭의 자기상관함수, 상호상관함수, 누적분포함수(Cumulative Distribution Function), 레벨 교차율(Level Crossing Rate), 평균 페이딩 지속 시간(Average Duration of Fades), 위상차의 확률 밀도, 위상차의 자기상관함수 등의 측면에서 시뮬레이션하고 그 결과치와 이론치 간의 특성 비교를 제시하였다. 특히, 확산 대역 시스템을 고려했을 때 이상적인 채널 추정을 가정한 레이크 수신기에서의 BER 성능을 다중경로 개수에 따라 보임으로써 여러 가지 채널 모델링 중에서 주파수 영역에서 필터링 하는 방식이 이동 무선 채널을 모델링 하는데 있어 가장 적합하다는 것을 보였다. 마지막으로 비대칭 도플러(Doppler) 스펙트럼을 모델링 하는 것도 주파수 영역에서 필터링 하는 방식이 편리하다.

• Journal of the Microelectronics and Packaging Society
• /
• v.3 no.2
• /
• pp.51-56
• /
• 1996

각종 통신기기의 주파수 합성기 등에 광범위하게 응용되고 있는 전압제어 발진기에 서 캐리어 대 잡음비(C/N비:Carrier noise Ratio)특성이 매우 중요하다. 특히 휴대용 단말기 에 쓰이는 소형 저소비전려의 VCO는 위상 잡음의 억제가 필수적이다. VCO의 C/N비 특성 은 공진회로의 선택도 Q와 능동소자의 각종 파라미터들 그리고 발전전력과 밀접한 관계가 있다. 본 논문에서는 CAD를 이용하여 우수한 C/N비를 갖는 900MHz대 VCO의 최적화 설 계방버을 제시하고 그 결과를 기초로 우수한 저잡은 VCO를 실현하였다.