• Journal of the Korean Society for Nondestructive Testing
• /
• v.32 no.4
• /
• pp.431-438
• /
• 2012

• Proceedings of the Optical Society of Korea Conference
• /
• 2005.07a
• /
• pp.250-251
• /
• 2005

• The Journal of the Acoustical Society of Korea
• /
• v.13 no.5
• /
• pp.40-50
• /
• 1994

In this paper, the sensitivity compensation method for three-dimensional acoustic intensity probe in the higher frequency range has been studied. The measurement error in the higher frequency range is generated from the phase mismatch between microphone's signals of the probe. If the wavelength of sound signal measured is less than those of the distance between microphones of the probe, that is, the higher frequency of the sound signal, the bigger measurement error is generated. In this study, we proposed the compensation methods for one-dimensional acoustic intensity probe with two-microphones, and the efficiency of those methods were investigated by numerical calculation of computer. It was most effective method to compensate the phase mismatch between microphone for the acoustic intensity probe was investigated for the sound estimated. and the efficiency of this method in a three-dimensional probe was investigated for the sound wave travelling in the arbitrary direction by numerical calculation of computer. In this result, the efficiency was proved that, for the measurement error of 1dB or less with the three-dimensional probe of 60mm space, the frequency should be less than 1.2kHz without the error compensation method, but the frequency increased up to 2.8kHz with the error compensation method.

• Journal of Advanced Navigation Technology
• /
• v.13 no.2
• /
• pp.178-186
• /
• 2009

SBAS(Satellite Based Augmentation System) provides GNSS satellite orbit and clock corrections for positioning accuracy improvement of GNSS users. In this paper, the accuracy of SBAS satellite orbit and clock corrections were analyzed by comparing with the IGS(International GNSS Service) precise ephemeris. The GPS antenna phase center offsets and the P1-C1 bias are considered for the analysis. The correction data of the US WAAS and the Japanese MSAS were analyzed. The analysis results showed that the SBAS satellite orbit and clock corrections are highly correlated. The correction data accuracy depends on the SBAS ground network size and orbit trajectories.

• Journal of Korean Society for Geospatial Information Science
• /
• v.22 no.3
• /
• pp.113-119
• /
• 2014

The positioning accuracy of GNSS surveys deteriorates due to various error factor, and many users sometimes ignore Phase Center Variation (PCV) of antennas. IGS provides an ANTEX file which contains PCV correction information to correct for PCVs. But it is not directly applicable because PCV correction information is provided at 5-degree intervals in the azimuth and elevation directions for the case of receiver antennas, and at 1-degree intervals in the nadir angle for the case of satellite antennas. So, we devised new and optimal ways of interpolating PCV in any desired line of sight to the GNSS satellite. We used spherical harmonics fitting methods in terms of the azimuth and elevation angle for interpolation, and found an optimal degree and order. It is shown that the best accuracy was obtained from the 8 by 8 spherical harmonics. If one requires lower burden on computing resources, the order and degree less than 8 could produce resonable accuracy except for 1st and 5th order.

• Korean Journal of Optics and Photonics
• /
• v.25 no.1
• /
• pp.29-37
• /
• 2014

We have studied and demonstrated general, systematic error-correction methods for a dual rotating quarter-wave plate ellipsometer. To estimate and correct 5 systematic error sources (three offset angles and two unexpected retarder phase delays), we used 11 of the 25 Fourier components of the ellipsometry signal obtained in the absence of an optical sample. Using these 11 Fourier components, we can determine the errors from the 5 sources with nonlinear optimization methods. We found systematic errors ${\epsilon}_3$, ${\epsilon}_4$, ${\epsilon}_5$) are more sensitive to the inverted Mueller matrix than retarder phase delay errors (${\epsilon}_1$, ${\epsilon}_2$) because of their small condition numbers. To correct these systematic errors we have found that error of any variety must be less than 0.05 rad. Finally, we can use the magnitudes of these errors to correct the Mueller matrix of optical components. From our experimental ellipsometry signals, we can measure phase delay and the rotational angular position of its fast axis for a half-wave plate.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.25 no.6
• /
• pp.637-645
• /
• 2014

This paper presents a new $4{\times}4$ multi-port amplifier(MPA) structure using reconfigurable switching matrices as input and output hybrid matrices(IHM, OHM), and phase/amplitude error calibration circuits. According to the mode selection of the switches, output power can be flexibly and effectively managed since the number of PA's to be used and the number of output port to distribute/combine amplified signals can be controlled. In addition, the proposed structure contains the phase and amplitude error calibration block that helps produce identical amplitudes and desired phase differences to the $4{\times}4$ OHM, resulting in optimizing the port-to-port isolation of the MPA system.

• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.45 no.6
• /
• pp.141-148
• /
• 2008

An utility voltage information, including the frequency, phase angle and amplitude is very important in many industrial systems. The grid-connected photovoltaic system in the limelight as alternative energy needs utility voltage information such as frequency, phase angle and magnitude to connect the grid-line. In this paper, it proposes the instantaneous phase-tracking in PLL that uses the frequency from the utility voltage as a sync signal and locks the phase with compensation for phase difference from DPT algorithm. It also proposes not only DFT algorithm execution by every sample not by one period, but also phase-tracking method in a wide range of frequency not a fixed one. This paper shows the feasibility and the usefulness of the proposed methods through the computer simulation and the experiment.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.11 no.8
• /
• pp.1376-1385
• /
• 2000

The phase characteristic of delay line in feedfarward linearizer has been changed due to variation of operating temperature. In this paper, design method of fixed phase control circuit of group delay line using adaptive vector control is derived. To maintain transfer characteristics of nominal operating temperature, the error correlated signals, which are changed adaptively due to changing of temperature, are added to main signals. The proposed method maintains transfer characteristics under 0.06dB of insertion loss and 0.36$^{\circ}$ of phase variation in case of 1-tone(880 MHz) and under 0.07 dB of insertion loss and 0.35$^{\circ}$ of phase variation in case of 2-tones(877 MHz, 882 MHz) for 10dB input power dynamic range and +/-10$^{\circ}$ phase variation respectively.

• Korean Journal of Optics and Photonics
• /
• v.3 no.3
• /
• pp.143-147
• /
• 1992

1)iscussed in this paper are the effects of phase modulation on the line spread functions (LSF) and MTFs of ;I binocular objective system. The binocular objective lens is made in Korea. It has rotationally symmetric aberrations. The LSFs and MTFs are measured experimentally. The phase modulation is carried out by applying phase retardation $\pi$ on the aperture. The area where the phase is not retarded presents a double annular type. The OTF curves of phase modulated aperture are compared with that of unmodulated aperture. The comparison shows that there is the aberration compensation effect in aberration loaded system. Therefore the performance of many optical system can be improved without any loss of light energy by properly modulating the phase on the aperture.