• The Journal of the Acoustical Society of Korea
• /
• v.20 no.4
• /
• pp.94-100
• /
• 2001

In October 1997, low-frequency reverberation was measured at an experimental site off the west coast of the Jeju island using the explosive charge, Signals Underwater Sound (SUS). Received signals were separated into the noise, the reflection, and the scattering region, and then were analyzed for the spectral and statistical characteristics of each region. In the analysis of the spectrum we verified that each region had a unique frequency band and statistical characteristics as well. The results of this analysis showed that the real and imaginary portions were shown to be both normal distributions in each frequency bin. The reverberation envelope had a Rayleigh distribution and the phase had a uniform distribution.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.10 no.2
• /
• pp.187-195
• /
• 1999

A series feedback DRO operating at 3.2 GHz applicable to the spectrum analyzer as the second local oscillator, is designed and fabricated. We can obtain a low noise by utilizing the small signal S-parameter of the transistor and adjusting the reflection coefficient from the coupling coefficient between dielectric resonator and microstrip line. The results show that output power is 10.50 dBm, a stable low phase noise is -116 dBc/Hz at a 10 kHz offset frequency and a harmonic characteristic is 19.33 dBc.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.13 no.5
• /
• pp.854-859
• /
• 2009

Many pilot projects are developed using USN(Ubiquitous Sensor network). Recently USN has more attention to be used for the applications of circumstance monitoring. In order to acquire information from sensor nodes, sensor nodes need a RF transceiver. In this paper we describe the design of a RF transceiver, based on IEEE 802.15.4, for sensor nodes operating in 2.4GHz frequency band. The architecture to be implemented and the electrical performance specifications satisfied IEEE 802.15.4 are presented. The noise figure of a receiver, selectivity, phase noise of a frequency synthesizer, transmitter's linearity and spectrum mask are derived as a design parameters from the specifications of IEEE 802.15.4.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.51 no.12
• /
• pp.83-89
• /
• 2014

A ku-band complementary cross-coupled differential voltage controlled oscillator is designed, measured and fabricated using $0.18-{\mu}m$ CMOS technology. A 2.4GHz of very wide frequency tuning at oscillating frequency of 14.5GHz is achieved with presented circuit topology and MOS varactors. Measurement results show -1.66dBm output power with 18mA DC current drive from 3.3V power supply. When 5V is applied, the output power is increased to 0.84dBm with 47mA DC current. -74.5dBc/Hz phase noise at 100kHz offset is measured. The die area is $1.02mm{\times}0.66mm$.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.14 no.1
• /
• pp.11-21
• /
• 1989

In this paper, a GMSK modulator was implemented with a gaussian lowpass filter using digital signal processing, a phase integration, D/A convers and auxiliary circuits. The relatively narrow bandwidth of power spectrum of the GMSK modulator is observed when the cut off frequency (B T) of the gaussian baseband filter is varied. In a demodulator, a discriminator type circuit is used. Using the above degital radio GMSK modem, BER is theoretically derived and experimentally measured when 16Kbps PRBS data is transmitted under Rayleigh fading and additive white gaussian noise conditions.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2014.10a
• /
• pp.956-957
• /
• 2014

In a fluid velocity measurement radar, the velocity information can be extracted from Doppler spectrum estimates of the return signal. However, the Doppler frequency ranges are too low for the case of low velocity profile measurements resulting in the serious effects in the velocity measurement. Therefore, the improved method is analyzed to overcome this problem.

• Journal of Dental Rehabilitation and Applied Science
• /
• v.32 no.1
• /
• pp.38-46
• /
• 2016

Purpose: study for discriminating method of origin side vibration from non-symptomatic clicking group. Materials and Methods: 60 joints vibrations of 30 subjects in non-symptomatic clicking group was recorded via subject's awareness, examiner's palpation and JVA analysis. Origin side vibration was discriminated with consideration for frequency spectrum, time delay and phase shift of waveforms, analysis of numeric values. Results: There were all unilateral vibrations with JVA analysis and number of origin vibrations were 42. 11 pairs of vibrations showed time delay and phase shift and transferred side vibrations showed smaller values of total integral and bigger values of > 300 / < 300 ratio than origin side vibrations except one pair of vibrations. Also as the ipsi-lateral joint vibrations with smaller values of total integral showed bigger values of > 300 / < 300 ratio than the contra-lateral joint vibrations and there all ipsi-lateral vibrations were showed small values of total integral below 10 and hard to detect time delay and phase shift. So the features were used in discrimination of origin side vibrations. Conclusion: There should be all-around considerations for discrimination of origin side vibrations that is frequency spectrum, phase shift and time delay and analysis of numeric values.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.39 no.5
• /
• pp.8-15
• /
• 2002

We optimally designed the VCO(voltage-controlled oscillator) with spiral inductor using the MOSIS HP 0.5${\mu}{\textrm}{m}$ CMOS process. With the developed SPICE model of spiral inductor, the quality factor of spiral inductor was maximized at the operating frequency by varying the layout parameters, e.g., metal width, number of turns, radius, space of the metal lines. For the operation frequency of 2㎓, the inductance of about 3nH, and the MOSIS HP 0.5 CMOS process with the metal thickness of 0.8${\mu}{\textrm}{m}$, oxide thickness of 3${\mu}{\textrm}{m}$, the optimal width of metal lines is about 20${\mu}{\textrm}{m}$ for the maximum Quality factor. With the optimized spiral inductor, the VCO with LC tuning tank was designed, fabricated and measured. The measurements were peformed on-wafer using the HP8593E spectrum analyzer. The oscillation frequency was about 1.610Hz, the frequency variation of 250MHz(15%) with control voltage of 0V - 2V, and the phase noise of -108.4㏈c(@600KHz) from output spectrum.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.10 no.5
• /
• pp.565-570
• /
• 2015

Spread spectrum communications have increased interest due to their immunity to channel fading and low probability of intercept. One of the limitations of the traditional digital spread spectrum systems is the need for spreading code synchronization. Chaotic communication is the analogue alternative of digital spread spectrum systems beside some extra features like simple transceiver structures. In this paper, This paper was used instead of the digital modulation and demodulation carriers for use in the chaotic signal in a digital communication system among the chaotic modulation schemes, the Differential Chaos Shift Keying(DCSK) is the most efficient one because its demodulator detects the data without the need to chaotic signal phase recovery. Also Implementation of Differential Chaos Shift Keying Communication System Using Matlab/Simulink and the receiver con decode the binary information sent by the transmitter, performance curves of DCSK are given in terms of bit-error probability versus signal to noise ratio with spreading factor as a parameter and we compare it to BPSK modulation.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.21 no.4
• /
• pp.317-322
• /
• 2003

This paper have calculated a relative heights of an each station using the data which were observed by GPS permanent stations(Chejudo, Homigoj, Jumunjin, Marado, Palmido, Ulengdo, Youndo) established in Korea. We performed spectrum analysis with a calculated relative heights by CLEAN algorithm. Through these process, we estimated vertical displacement of earth surface by semi-dinural ocean tidal loading components, and compared them with the results which were calculated by improving ocean tide model(NA099jb) for adjacent seas around Japan and Korea. As the result of this study, we determined the ocean tidal loading components with loading effects of $M_2$ and $N_2$, and we noted that the amplitude and the phase lags of ocean tidal loading components from observed GPS data were almost equal to values calculated from ocean tide models. However, the loading components about semi-diurnal tide $S_2$, $K_2$ couldn't estimate because of periods. Also, the diurnal ocean tide loading components were not considered, because the noise level have increased during the diurnal frequency.