• Clean Technology
• /
• v.2 no.1
• /
• pp.60-68
• /
• 1996

The oxidation of carbon monoxide of low concentration on the natural manganese dioxide (NMD) has been investigated in a fixed bed reactor. The experimental variables were concentration of oxygen (500ppm~99.8%) and carbon monoxide (500ppm~10000ppm) and catalyst temperature ($50{\sim}750^{\circ}C$). The NMD(Natural Manganese Dioxide) has been characterized by temperature - program reduction(TPR) using 2.4% $CO/H_2$ as a reducing agent, thermogravimetric analysis (TGA), and reduction of NMD by 2.4% $CO/H_2$. It was found that the NMD catalyst activity on the unit area was greater than the $MnO_2$ catalyst for oxidation of CO at the same temperature. The thermal stability of oxidation activity was considered to be maintained when the NMD was heated to $750^{\circ}C$. The TGA, reduction by CO, and TPR of the NMD showed that the NMD had active lattice oxygen which was easily liberated on heating in the absence and low concentration of oxygen. The reaction order in CO is 0.701 between 500~3500ppm and almost zero between 3500~10000ppm of CO.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2011.10a
• /
• pp.396-397
• /
• 2011

This paper has proposed a multi-channel low pass filter (LPF) for LTE-Advanced systems. The proposed LPF is an active-RC 5th chebyshev topology with three cut-off frequencies of 5 MHz, 10 MHz, and 40 MHz. A 3-bit tuning circuit has been adopted to prevent variations of each cut-off frequency from process, voltage, and temperature (PVT). To achieve a high cut-off frequency of 40 MHz, an operational amplifier used in the proposed filter has employed a PMOS cross-connection load with a negative impedance. A proposed filter has been implemented in a $0.13-{\mu}m$ CMOS technology and consumes 20.2 mW with a 1.2V supply voltage.

• Journal of the Korean Society for Railway
• /
• v.17 no.5
• /
• pp.365-372
• /
• 2014

Technologies for rapid concrete curing using elevated temperature are important for saving cost and time when constricting concrete structures. Recently, a microwave heating form was developed. In this study the early strength of concrete cured by the developed form was experimentally investigated. Large scale mock up tests were conducted six times, and the results were analyzed based on the maturity theory. Logarithmic correlation curves were generated based on the measured strength and estimated maturity. It was confirmed that the strength development of the concrete cured by microwave heating form can be estimated by the equivalent age theory usually applied to steam-curing technology. By using the microwave heating form, one day at most is enough to get the required strength for the safe removal of forms, even in cold weather.

• Korean journal of food and cookery science
• /
• v.16 no.6
• /
• pp.652-662
• /
• 2000

This study was performed to measure the mutagenicity of fish by cooking and storage. Mutagenicity of the fish extract was measured by Ames test(Salmonella typhimurium reversion assay with TA 100) in vitro and by micro-nucleus test in vivo. The fish samples screened in this study were white fish(Trichiurus, Croaker, Salted Croaker) and red fish(Saury pike, Mackerel, Yellowtail, Salmon). The number of revertants of red fish were significantly higher than that of white fish. And the mutagenicity of mackerel was higher than other red fish, so followed experiment was made by using the extract of mackerel. Mutagenicity of the samples cooked on microwave oven was the lowest, whereas there was no significant difference between the samples cooked on gas grill and the ones on electric grill. In the presence of S9 mixture, the methanol extract of mackerel showed 2∼4 times high values of mutagenicity in comparison with the extract without S9. The extract of mackerel cooked with various vegetable juices showed inhibitory effects on the mutagenicity in the order of green tea, ginger, and radish. Also, the number of revertants was increased in the stored samples. Mutagenicity of the samples stored in the refrigerator was higher than that of the freezer. In micronucleus test, the methanol extract treated with vegetable juice inhibited micro-nucleus formation in bone marrow by cyclophosphamide in the order of ginger, green tea, and radish. In TBA test, there was a tendency that TBA values were increased as the storage time increased. Also, the rancidity of sample were stored in the refrigerator was higher value than sample stored in the freezer. Samples cooked on microwave oven showed the highest value in rancidity. When the antioxidant effect of vegetable juice was measured by electron donating ability(EDA) of mackerel cooked with vegetable juice to DPPH, the samples treated with onion showed the highest value of EDA(%), and the samples treated with green tea, ginger and cabbage also showed the antioxidant effect.

• Korean Journal of Agricultural and Forest Meteorology
• /
• v.14 no.1
• /
• pp.19-27
• /
• 2012

The open-top chamber (OTC) system is designed for long term studies on the climate change impact on the major tree species and their community in Korea. In Korea Forest Research Institute (KFRI), the modified OTC system has been operating since September 2009. The OTC facility consists of six decagon chambers (10 meters in diameter by 7 meters high) with controlled gas concentration. In each chamber, a series of vertical vent pipes are installed to disperse carbon dioxide or normal air into the center of the chamber. The OTC is equipped with remote controlled computer system in order to maintain a stable and elevated concentration of carbon dioxide in the chamber throughout the experimental period. The experiment consisted of 4 treatments: two elevated $CO_2$ levels ($1.4{\times}$ and $1.8{\times}$ ambient $CO_2$) and two controls (inside and outdoors of the OTC). Average operational rate was the lowest (94.2%) in June 2010 but increased to 98% in July 2010 and was 100% during January to December 2011. In 2010~2011, $CO_2$ concentrations inside the OTCs reached the target programmed values, and have been maintained stable in 2011. In 2011, $CO_2$ concentrations of 106%, 100% and 94% of target values has been recorded in control OTC, $1.4{\times}$ $CO_2$-enriched OTC and $1.8{\times}$ $CO_2$-enriched OTC, respectively. With all OTC chambers, the difference between outside and inside temperatures was the highest ($1.2{\sim}2.0^{\circ}C$) at 10 am to 2 pm. Temperature difference between six OTC chambers was not detected. The relative humidity inside and outside the chambers was the same, with minor variations (0~1%). The system required the highest amount of $CO_2$ for operation in June, and consumed 11.33 and 17.04 ton in June 2010 and 2011, respectively.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.39 no.10
• /
• pp.1528-1534
• /
• 2010

The antibacterial effects of seed decontamination during presoaking before sprouting as an intervention step for eliminating foodborne pathogens on red radish seeds were evaluated. The effect of seed decontamination on seed germination rate was also evaluated. Red radish seeds were inoculated (at a level of 3 to 4 log CFU/g) with Listeria monocytogenes ATCC 19111 and decontaminated with 20,000 ppm calcium hypochlorite, 50 and 100 ppm chlorinated water, acidic electrolyzed water, low-alkaline electrolyzed water, and ozonated water for 6 hours. The control seeds were immersed in distilled water. The germination rate was measured on each treatment for 48 hours. Treatments with 20,000 ppm calcium hypochlorite, acidic and low-alkaline electrolyzed water were more effective than treatments with chlorinated water and ozonated water. Immersion in 20,000 ppm calcium hypochlorite resulted in the largest microbial reduction (more than 3 logs). Treatments with acidic and low-alkaline electrolyzed water reduced APC by 3 logs and L. monocytogenes counts by 2 logs. After sprouting, APC and L. monocytogenes counts on seeds treated with 20,000 ppm calcium hypochlorite, acidic and low-alkaline electrolyzed water were significantly lower than the control. The germination rate ranged from 93.5% to 97.7% except for 20,000 ppm calcium hypochlorite (from 82.3% to 84.8%) after 48 hours. Although the treatments tested in this study will not eliminate L. monocytogenes on inoculated red radish seeds, the results show that rapid growth of surviving cells during sprouting could be prevented if red radish seeds are given a presoak treatment used in combination with a disinfectant treatment of irrigation water.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.30 no.5
• /
• pp.174-182
• /
• 2020

The printed electronics field using ink-jet printing technology is in the spotlight as a next-generation technology, especially ink-jet 3D printing, which can simultaneously discharge and precisely control various ink materials, has been actively researched in recent years. In this study, complex structure of an insulating layer and a conductive layer was fabricated with photo-curable silica ink and PVP-added Cu nano ink using ink-jet 3D printing technology. A precise photocured silica insulating layer was designed by optimizing the printing conditions and the rheological properties of the ink, and the resistance of the insulating layer was 2.43 × 10¹³ Ω·cm. On the photo-cured silica insulating layer, a Cu conductive layer was printed by controlling droplet distance. The sintering of the PVP-added nano Cu ink was performed using an IPL flash sintering process, and electrical and mechanical properties were confirmed according to the annealing temperature and applied voltage. Finally, it was confirmed that the resistance of the PVP-added Cu conductive layer was very low as 29 μΩ·cm under 100℃ annealing temperature and 700 V of IPL applied voltage, and the adhesion to the photo-cured silica insulating layer was very good.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.34 no.1
• /
• pp.19-26
• /
• 2010

A PEMFC(proton exchange membrane fuel cell) is a good candidate for residential power generation to be coped with the shortage of fossil fuel and green house gas emission. The attractive benefit of the PEMFC is to produce electric power as well as hot water for home usage. The thermal management of PEMFC for RPG is to utilize the heat of PEMFC so that the PEMFC can be operated at its optimal efficiency. In this study, thermal management system of PEMFC stack is modeled to understand the dynamic response during load change. The thermal management system of PEMFC for RPGFC is composed of two cooling circuits, one for controling the fuel cell temperature and the other for heating up the water for home usage. The different operating strategy is applied for each cooling circuit considering the duty of those two circuits. Even though the capacity of PEMFC system (1kW) is enough to supply hot domestic water for residence, heat-up of reservior takes some hours. Therefore, in this study, time schedule of the simulation reflects the heat-up process. Dynamic responses and operating strategies of the PEMFC system are investigated during load changes.

• Fire Science and Engineering
• /
• v.25 no.6
• /
• pp.168-177
• /
• 2011

The combustion test for real box of AC outdoor unit has been performed in this study in order to estimate the fire hazard in multi-system type of AC outdoor unit which is currently used for commercial use. The result showed that in test, there was explosion inside of AC outdoor unit, and flame erupted and fire spread through upper side grill. And then this fire burnt the combustibles such as wires, electronic control board, heat exchange copper plate and plastics etc inside the unit, refrigerant gas pipe was burst due to fire, and accelerated the explosion and flame eruption to outside while the refrigerant was erupting. It is found in this test that the maximum heat release rate of AC outdoor unit is 5,830 kW, the maximum internal temperature measured with infrared camera and thermocouple is $1,201^{\circ}C$, maximum ambient temperature is $881^{\circ}C$, and flame rose higher than about 5 m. It is concluded that the fire in AC outdoor unit cause fire to combustibles around the unit, and may give big damage by generating the secondary fire. It is expected that the result obtained from the test on the real object may be applied to fire realization of AC outdoor unit and estimation of fire spreading to the combustibles around in the future computer simulation.

• Journal of the Korean Vacuum Society
• /
• v.12 no.4
• /
• pp.263-268
• /
• 2003

Precise thickness control and excellent properties of silicon nitride thin films are essential for the next-generation semiconductor and display devices. In this study, silicon nitride thin films were deposited by batch-type atomic layer deposition (ALD) method using $SiC1_4$ and $NH_3$ as the precursors at temperatures ranging from 500 to $600^{\circ}C$. Thin film deposition using a batch-type ALD reactor was a layer-by-layer atomic growth by self-limiting surface reactions, and the thickness of the deposited film can be controlled by the number of deposition cycles. The silicon nitride thin films deposited by ALD method exhibited composition, refractive index and wet etch rate similar with those of the thin films deposited by low-pressure chemical vapor deposition method at $760^{\circ}C$. The addition of pyridine mixed with precursors increased deposition rate by 50%, however, the films deposited with pyridine was readily oxidized owing to its unstable structure, which is unsuitable for the application to semiconductor or display devices.