• Journal of Animal Environmental Science
• /
• v.6 no.3
• /
• pp.175-184
• /
• 2000

A lab-scale MF membrane reactor was installed to investigate the membrane permeability, characteristics of membrane fouling at each conditions, and quality of permeate (liquid livestock manure) in the separation of solid-matters using membrane. Experiment was divided three filtration type such as follows; continuous filtration, gravity filtration, and intermittent filtration. As a result of experiment, flux 1 LMH was maintained for 7days, and trans-membrane pressure(TMP) was increased gradually under 10cmHg, but it was increased immediately after 10cmHg, respectively. However, the flux was increased, the Tmax was decreased exponential more and more. During the pure-flux test, most of the fouling of membrane was reversible. At the gravity filtration, permeate could be obtained as 1.75 LMH for 3.5days without any other electronic pressure. As an investigation of membrane surface, this study could be decided that the reason of fouling at the lower flux (Run 1 and 2) was attached matters in membrane surface, but at the higher flux (Run 4-6) was concentration polarization.

• The Korean Journal of Food And Nutrition
• /
• v.14 no.1
• /
• pp.34-39
• /
• 2001

The purpose of this study was to examine physical properties of the addition of green tea powder on bread flour and dough rheology of white pan bread. Three levels(0.1, 0.5 and 1.0% ) of each green tea powder with bread flour were tested for their effects in dough mixing using rapid disco analyzer, alveogram and farinogram. Addition of green tea powder tended to reduce initial pasting temperature and increase peak viscosity, break down and set back. L(extensibility) and G(swelling index) value in alveogram showed decrement with increasing green tea powder. These meant that the volume of white pan bread would show same tendency. The use of green tea powder increased consistency and water absorption of the bread flour but decreased development time, salability and degree of softening on farinogram. White pan bread with green tea powder had higher value of hardness and springness than without it. Sensory evaluation determined that the white pan bread with 0.5% green tea powder had the highest score.

• Journal of Bio-Environment Control
• /
• v.31 no.3
• /
• pp.194-203
• /
• 2022

Cultivation of tomatoes in Korea grown in soil covers 89% of the total area for tomato cultivation. Tomatoes grown in soil often encounter various environment stresses including not only salt stress and soil-borne diseases but also cold stress in the winter season. This study was conducted to comparatively analyze the performance of rootstocks with cold stress by measuring the growth, yield, and photosynthetic efficiency in tomatoes grown in soil. The rootstocks were used 'Powerguard', 'IT173773', and '20LM' for the domestic rootstock cultivars and 'B-blocking' for a control cultivar. The tomato cultivar 'Red250' was used as the scion and the non-grafted tomatoes. Stem diameter, flowering position, leaf length, and leaf width were investigated for the growth parameters. The stem diameter of the non-grafted tomatoes decreased by 15% compared to the grafted tomatoes at 80 days after transplanting when exposed to low temperatures of 9-14℃ for 14 days. The leaf length and width of the non-grafted tomatoes were the lowest with 42.4 cm and 41.8 cm at 80 days after transplanting. The total yield per plant was the highest in tomato plants grafted on 'Powerguard' with 1,615 g and lowest in non-grafted tomatoes with 1,299 g. As the result of measuring the chlorophyll fluorescence parameters, PI_ABS and DI₀/RC, which mean the performance index and dissipated energy flux, 'Powerguard' was the highest with 3.73 in PI_ABS and the lowest with 0.34 in DI₀/RC, whereas non-grafted tomatoes was the lowest with 2.62 in PI_ABS and the highest with 0.41 in DI₀/RC at 80 days after transplanting. The stem diameter has positive correlation with PI_ABS, while it has negative correlation with DI₀/RC. The results indicate that can be analyzed by chlorophyll fluorescence parameters can be used for analyzing the differences in the growth of tomato plants grafted on different rootstocks when exposed to cold stress.

• The Korean Journal of Mycology
• /
• v.29 no.1
• /
• pp.47-51
• /
• 2001

Obesity and lipid metabolism of SD rats were studied with an edible Nigerian mushroom, namely, Lentinus tuber-regium (Fries) Singer. Experimental diets prepared with Lentinus tuber-regium (LTR) instead of carbohydrates were fed to SD rats for 6 weeks. Body weights gain were decreased (3.2% and 29.3%, respectively) In LTR-50 and LTR-100 groups, whereas food intakes were significantly increased (24.5% and 40.7%, respectively) compared with control group. Feed efficiencies were significantly decreased (22.2% and 49.8%, respectively) in these two LTR groups, whereas gross efficiencies (GE) were increased (9.9% and 10.4%, respectively) compared with control group. The ratios of diet intake (DI)/metabolic body size (MBS) were remarkably increased (50.3% and 136.1%, respectively) in these groups. Triglyceride and LDL-cholesterol levels were significantly decreased (22.4% and 32.6%, 8.3% and 12.7%, respectively) in these two groups, but HDL-cholesterol levels were desirably increased by $3{\sim}10%$ in LTR-added groups. Atherogenic indices (Als) were significantly decreased about $8{\sim}13%$ in LTR-added groups compared with control group. These results suggest that an edible mushroom, Lentinus tuber-regium may inhibit obesity in above 50%-LTR by increasing a diet intake, GE and DI/MBS ratio, but may also effectively modulate a chronic degenerative diseases by improving a lipid metabolism.

• Journal of Korean Society of Forest Science
• /
• v.111 no.3
• /
• pp.405-417
• /
• 2022

The purpose of this study was to describe the photosynthetic features of Prunus maximowiczii and Prunus serrulate Lindl. var. pubescens (Makino) Nakai in response to drought stress. Specifically, we studied the effects of drought on photosynthetic ability and photosystem II activity. Drought stress (DS) was induced by cutting the water supply for 30 days. DS decreased the moisture contents in the soil, and between the 10th and 12th days of DS, both species had 10% or less of x., After the 15th day of DS, it was less than 5%, which is a condition for disease to start. We observed a remarkable decrease of maximum photosynthesis rate starting from 10th day of DS; the light compensation point was also remarkable. Dark respiration and net apparent quantum yield decreased significantly on the 15th day of DS, and then increased on the 20th day. In addition, the stomatal transpiration rate of P. maximowiczii decreased significantly on the15th day of DS, and then increased on the 20th day. Water use efficiency increased on the 15th day of DS, and then decreased on the 20th day. The stomatal transpiration rate of P. serrulate decreased significantly on the 20th day of DS, and then increased afterward, while its water use efficiency increased on the 20th day of DS, and then decreased afterward. These results indicate that the closure of stoma prevented water loss, resulting in a temporary increase of water use efficiency. Chlorophyll fluorescence analysis detected remarkable decreases in the functional index (PI_ABS) and energy transfer efficiency in P. maximowiczii after the 15th day of DS. Meanwhile, photosystem II activity decreased in P. serrulate after 20 days of DS. In addition, Ts-Ta, PI_ABS, DI_O/RC, ET_O/RC followed similar trends as those of the soil moisture content and photosynthetic properties, indicating that they can be used as useful variables in predicting DS in trees.

• Environmental and Resource Economics Review
• /
• v.14 no.4
• /
• pp.817-838
• /
• 2005

In this paper, the resource adequacy as well as the optimum fuel mix is obtained by the following procedures. First, the regulation body, the government agency, determine the reliability index as well as the optimum portfolio of the fuel mix during the planning horizon. Here, the resources with the characteristics of public goods such as demand-side management, renewable resources are assigned in advance. Also, the optimum portfolio is determined by reflecting the economics, environmental characteristics, public acceptance, regional supply and demand, etc. Second, the government announces the required amount of each fuel-type new resources during the planning horizon and the market participants bid to the government based on their own estimated fixed cost. Here, the government announces the winners of the each auction by plant type and the guaranteed fixed cost is determined by the marginal auction price by plant type. Third, the energy market is run and the surplus of each plant except their cost (guaranteed fixed cost and operating cost) is withdrew by the regulatory body. Here, to induce the generators to reduce their operating cost some incentives for each generator is given based on their performance. The performance is determined by the mechanism of the performance-based regulation (PBR). Here the free-riding performance should be subtracted to guarantee the transparent competition. Although the suggested mechanism looks like very regulated one, it provides two mechanism of the competition. That is, one is in the resource construction auction and the other is in the energy spot market. Also the advantages of the proposed method are it guarantee the proper resource adequacy as well as the desired fuel mix. However, this mechanism should be sustained during the transient period of the deregulation only. Therefore, generation resource planning procedure and market mechanisms are suggested to minimize possible stranded costs.

• Journal of KIISE:Information Networking
• /
• v.35 no.4
• /
• pp.251-267
• /
• 2008

In this paper, we present a distributed topology control algorithm for constructing an optimized topology having a minimal search-time in unstructured peer-to-peer network. According to the proposed algorithm, each node selects the best nodes having higher hit-ratio than other nodes as many as the number being exponentially proportional to the hit-ratio of the node itself, and then it connects to them. The ensemble behavior of the proposed algorithm is very similar to the recrystrallizing phenomenon that is observed in nature. There is a partial order relationship among the hit-ratios of most nodes of constructed topology. Therefore once query message visits a node, it has a higher hit-ratio than the node that was visited last by the message. The query message even sent from freeloader can escape to the node having high hit-ratio by one hop forwarding, and it never revisits any freeloader again. Thus the search can be completed within a limited search time. We also propose the Chain-reactive search scheme using the constructed topology. Such a controlled multicasting reduces the query messages by 43 percent compared to that of the naive Gnutella using broadcasting, while it saves the search time by 94 percent. The search success rate of the proposed scheme is 99 percent.

• Clean Technology
• /
• v.23 no.2
• /
• pp.163-171
• /
• 2017

Currently, researches on recycling and reuse of waste energetic materials have recently gained a great attention from advanced countries due to ever tightening environmental regulations. In this study, as a part of a recycling technology, the experiments and dynamic simulation of simulated moving bed (SMB) process were performed to efficiently separate TNT and RDX from their mixture, which are main components of ammunition. In order to determine the operation zone of SMB process, the retention times of TNT and RDX were measured using HPLC at different flow rates and the adsorption equilibrium of each component was obtained by using a moment method. According to the adsorption equilibrium and the triangle theory of SMB process, four operation points were determined and separation experiments were carried out by the SMB process using the solvent consisting of acetonitrile and water. Two different mixing ratios (6:4 and 1:1) of acetonitrile and water were chosen for the experiment due to the great impact of mixing ratio of the solvent on separation. The performance of SMB process was evaluated by purity, recovery, productivity and solvent consumption. Pure TNT and RDX were successfully obtained from the SMB process and the dynamic simulation for the SMB process agreed well with the experimental results. Therefore, the dynamic model could be applied for predicting the dynamic behavior of the SMB process and designing a large scale SMB process.

• Clean Technology
• /
• v.28 no.1
• /
• pp.18-23
• /
• 2022

Using air as an insulator due to its low heat transfer coefficient has been studied and has been widely commercialized to save energy in the field of thermal insulation technology. In this study, we analyzed the heat insulating effect of hollow silica nanoparticles mixed in non-uniform size, and the maximum heat insulating efficiency of these particles given the limited number of particles that can be mixed with a medium such as paint. The hollow silica nanoparticles were synthesized via a sol-gel process using a polystyrene template in order to produce an air layer inside of the particles. After synthesis, the particles were analyzed for their insulation effect according to the size of the air layer by adding 5 wt % of the particles to paint and investigating the thermal insulation performance by a heat transfer experiment. When mixing the particles with white paint, the insulation efficiency was 15% or higher. Furthermore, the large particles, which had a large internal air layer, showed a 5% higher insulation performance than the small particles. By observing the difference in the insulation effect according to the internal air layer size of hollow silica nanoparticles, this research suggests that when using hollow particles as a paint additive, the particle size needs to be considered in order to maximize the air layer in the paint.

• The Journal of the Acoustical Society of Korea
• /
• v.41 no.3
• /
• pp.302-311
• /
• 2022

Sound barrier walls are one of the most effective alternatives for reducing environmental noise on roads and railways in the city center. The insertion loss of the sound barrier against road traffic noise is the sum of the sound transmission loss, sound absorption loss, and sound energy reduction due to the diffraction attenuation of the sound barrier. The sound transmission loss of the sound barrier is one of the important factors that determine the insertion loss of the sound barrier and is a basic indicator that determines the performance of the sound barrier. Nevertheless, there is not a separate standard in Korea for measuring the acoustic transmission loss of sound barrier panels. There are only a few conditions in KS F 4770 series that stipulates on the general material of sound barrier panels. This thesis examines the necessity of the acoustic transmission loss measurement and evaluation standards of sound barrier walls, and seeks a measurement method in a free sound field (anechoic chamber) sound receiving room considering the characteristics of sound barrier walls installed in external spaces, unlike indoor building materials. In addition, a single number evaluation method using a reference spectrum was proposed so that the sound insulation effect according to various installation places such as roadside or railroad side can be easily displayed.