• Journal of the Geological Society of Korea
• /
• v.54 no.6
• /
• pp.631-640
• /
• 2018

To understand the formation and evolution of a sedimentary basin in basin analysis and modelling studies, it is important to analyze the thickness and age range of sedimentary layers infilling a basin. Because the compaction effect reduces the thickness of sedimentary layers during burial, basin modelling studies typically restore the reduced thickness using the relation of porosity and depth (compaction trend). Based on the compilation plots of published compaction trends of representative sedimentary rocks (sandstone, shale and carbonate), this study estimates the compaction trend ranges with exponential curves and equations. Numerical analysis of sedimentary compaction is performed to evaluate the variation of porosity and layer thickness with depth at key curves within the compaction trend ranges. In sandstone, initial porosity lies in a narrow range and decreases steadily with increasing depth, which results in relatively constant thickness variations. For shale, the porosity variation shows two phases which are fast reduction until ~2,000 m in depth and slow reduction at deeper burial, which corresponds to the thickness variation pattern of shale layers. Carbonate compaction is characterized by widely distributed porosity values, which results in highly varying layer thickness with depth. This numerical compaction analysis presents quantitatively the characteristics of porosity and layer thickness variation of each lithology, which influence on layer thickness reconstruction, subsidence and thermal effect analyses to understand the basin formation and evolution. This work demonstrates that the compaction trend is an important factor in basin modelling and underlines the need for appropriate application of porosity data to produce accurate analysis outcomes.

• The Journal of Engineering Geology
• /
• v.2 no.1
• /
• pp.36-46
• /
• 1992

Granite core samples and bulk samples were first subjected to petrographic examination to determine weathering degrees. Secondly, their physical or mechanical properties including specific gravity, porosity, sonic wave velocity and uniaxial compressive strength were measured. The results were correlated to investigate the influences between properties including physical and mechanical properties, weathering degrees, and rock textures. Porosity and P wave velocity were found the most useful indices in determining the weathering degrees of granites.

• Mineral and Industry
• /
• v.16 no.1
• /
• pp.1-16
• /
• 2003

수천 년 전부터 인간생활에 이용되어온 일라이트-운모는 다른 광물자원에 비하여 사용량은 많지 않지만, 요업, 도료, 종이, 건축용 재료, 화장품 소재 및 전자부품과 전기 재료 등 여러 산업 분야에 널리 사용되고 있다. 일라이트-운모는 광물학적으로 같은 계열의 광물군임에도 불구하고 산출상태, 입도 및 용도의 차이에 따라 다른 광물자원으로 취급되고 있다. 특히 국내에서 일라이트는 용어상의 혼란과 불명확한 법정 등록광종 때문에 효율적인 자원관리와 연구개발이 곤란한 실정이다. 그러므로 일라이트를 비롯한 점토광물 자원에 대한 광업법규상의 개선과 제도적 정비가 시급히 요구된다. 국내에서 개발되고 있는 일라이트-운모의 광석 유형은 그 광물상과 산출상태에 따라 페그마타이트상 백운모, 운모편암상 백운모, 납석상 일라이트 및 점토상 일라이트로 구분된다. 일라이트와 운모는 서로 다른 용도로 사용되고, 그 용도에 따라 그 품위 및 품질 개념이 다르다. 일라이트-운모 광석의 품위 및 품질 면에서 가장 기본적인평가방식은 (1) 육안 및 편광현미경 관찰, (2) X-선회질 분석 및 (3) 화학분석인 것으로 생각된다. 특히 리트벨트법을 응용한 X-선회질 정량분석법은 일라이트의 품위를 산정하는데 유력한 수단이 될 수 있을 것으로 여겨진다. 국내 일라이트-운모 자원의 자원잠재성과 부가가치를 향상시키기 위해서는 광석에 대한 정확한 품위 평가를 바탕으로 가장 적절한 이용 분야를 모색해야 할 것으로 판단된다.

• Journal of Conservation Science
• /
• v.7 no.1
• /
• pp.9-18
• /
• 1998

There are about 1470 stone-cultural properties in Korea which have been registered and protected by the government. Representative of them are pagoda, stupa, stone-buddha, stele support of banner pole and stone-lanterns. Most of them have been exposed to and weathered by natural environments. Stone-cultural properties are destroyed and/or destructed mostly by weathering and its related features of rocks. Therefore, it is necessary to conduct geological studies on the weathering phenomena and related features as well as characteristics of the rock itself must be done for the conservation. Thus geological investigation should include detail measurements, rock varieties and phases, structural lineaments of the rock, cause and degree of weathering, degree and patterns of crack development structural stability, identification of reusable parts for restoration, geomorphological characteristics of the site, and etc. The interaction among these factors must be investigated and analyzed, which must be used as basic data to establish the guideline of conservation and to plan for repair and/or restoration. The conservation plan should involve parts to be repaired, method of repair, type of cementing material, the characteristics of rock phases to be supplemented, method for maintaining structural stability, and method to delay or to prevent the rock weathering.

• Geophysics and Geophysical Exploration
• /
• v.27 no.1
• /
• pp.23-36
• /
• 2024

In this study, we analyze the structure of the Korea-Japan Joint Development Zone (JDZ) using gravity, magnetic, and seismic data. Gravity and magnetic data analysis confirmed that the Jeju Basin exhibits low anomalies compared to adjacent areas. We applied the total gradient to the Bouguer anomaly to identify basin boundaries, and computed the analytic signal from the total magnetic anomaly data to enhance the edges of the magnetic anomalies. The Taiwan-Sinzi Belt, exhibits high magnetic anomalies and crosses the center of the JDZ in the northeast-southwest direction; we presume that intrusive rocks are sporadic in the JDZ. The 3D inversion results of the gravity and magnetic data show a strong correlation between magnetic susceptibility and density (i.e. a low-density zone in the Jeju Basin and the Ho Basin, and a high magnetic susceptibility distribution in the Taiwan-Sinzi Belt). Comparison of the density and seismic profiles of the Jeju Basin shows that high densities are associated with sill, horst, and basement highs, whereas low densities are associated with basement low and grabens. These results suggest that interpretations based on seismic, gravity and magnetic data can effectively reveal the subsurface structure of the JDZ.

• Economic and Environmental Geology
• /
• v.46 no.4
• /
• pp.313-327
• /
• 2013

In the study, three-dimensional geostatistical simulations on McMurray Formation which is the largest oil sand reservoir in Athabasca area, Canada were performed, and the optimal site for steam assisted gravity drainage (SAGD) was selected based on the predictions. In the selection, the factors related to the vertical extendibility of steam chamber were considered as the criteria for an optimal site. For the predictions, 110 borehole data acquired from the study area were analyzed in the Markovian transition probability (TP) framework and three-dimensional distributions of the composing media were predicted stochastically through an existing TP based geostatistical model. The potential of a specific medium at a position within the prediction domain was estimated from the ensemble probability based on the multiple realizations. From the ensemble map, the cumulative thickness of the permeable media (i.e. Breccia and Sand) was analyzed and the locations with the highest potential for SAGD applications were delineated. As a supportive criterion for an optimal SAGD site, mean vertical extension of a unit permeable media was also delineated through transition rate based computations. The mean vertical extension of a permeable media show rough agreement with the cumulative thickness in their general distribution. However, the distributions show distinctive disagreement at a few locations where the cumulative thickness was higher due to highly alternating juxtaposition of the permeable and the less permeable media. This observation implies that the cumulative thickness alone may not be a sufficient criterion for an optimal SAGD site and the mean vertical extension of the permeable media needs to be jointly considered for the sound selections.

• The Journal of Engineering Geology
• /
• v.27 no.4
• /
• pp.429-438
• /
• 2017

Monte Carlo N-Particle (MCNP) modeling algorithm based on the Monte Carlo method was used to perform the simulation of neutron logging in order to increase the reliability and utilization of neutron logs applied in geological and resource engineering fields. To perform the simulation using MCNP, we used a realistic three-dimensional configuration of neutron sonde and formation. Validation of the modeling was confirmed by comparing the calibration curves of sonde manufacture with those calculated by MCNP modeling. After the validation, lithology effects, pore fluid effects, borehole diameter change, casing effect, and effects of borehole water level were investigated through modeling experiments. Numerical tests indicate that changes in neutron count ratio according to the lithology were quantitatively understood. In case of a borehole with a diameter of 3 inches, ratio of counting rates was higher than expected to be interpreted as borehole fluid has small effects on neutron logging. Effect of casing was also small in general, particular when porosity increases. Since modeling results above the groundwater level showed a tendency opposite to those below the groundwater level, neutron logs can be used to detect groundwater level. The modeling results simulated in this study for various borehole environments are expected to be used for data processing and interpretation of neutron log.

• Journal of the Korean earth science society
• /
• v.26 no.1
• /
• pp.41-57
• /
• 2005

The purpose of the study is to develop a educational data in order for students to perform geologic field survey effectively by themselves. A area around the Duta Mountain is selected. which is located at the southeastern part of Eumsung sedimentary basin because various rock types and geologic structures are well shown in this area and also it is convenient to reach there. Thirteen stops for observation are chosen m a route f3r exercising field geologic investigation. Data for field research are given and described in detail from each stop for observation. To do this, students make their own route map using general or digital geographic map and aerial photo is added to know relationship between large-scale structure and different rock types regionally. Moreover, it is designed to minimize conflict factors that may be experienced from the real field survey by showing outcrop photographs and polarizing photomicrographs of rut samples related to each stop and geologic structures. The attitude of students is investigated with the data of field geologic survey for students of an Earth Science class in the College of Education in Chungbuk National University. The results indicate that the educational data for geologic field survey brought positive changes that greatly help students perform field survey in definitive side, especially formation of absolute concepts on earth science.

• Journal of the Korean earth science society
• /
• v.25 no.4
• /
• pp.251-264
• /
• 2004

The Charnockite in Sancheong region is quarzofeldspathic rock containing orthopyroxene and garnet with a color dark than common granitic rocks. The Chamockite are mostly massive and medium to coarse-grained with K-feldspar phenocryst, but reveal weak foliation. The rock consist mainly of quartz, K-feldspar, plagioclase and orhopyroxene, with biotite, garnet, and anthophyllite. In petrochemistry, the Chamockite has 61-65% $SiO_2$ contents, varying gradually into the margin contacted with orthogneiss, which have compositions of felsic igneous rocks. Major element show almost systematical variation with those of the marginal orthogneisses, except the hornblende gneiss and anorthosite. The Charnockite and orthogneisses show the tholeiitic differentiational trend. Trace and rare earth element abundance patterns in the Charnockite show remarkable negative Sr and Eu anomalies similar to orthogneisses, but different from the hornblende gneiss and anorthosite. Eu contents of the Charnockite are richer than that of orthogneisses. The metamorphic condition of the Charnockite were tested by an orthopyroxene-garnet geotherrnorneter and a plagioclase-garnet geobarometer. Estimated P-T conditions are about $761^{\circ}C$ and 7 kbar at peak metamorphism, but $653^{\circ}C$ and 6.4 kbar at retrograde metamorphism. This suggests that the Charnockite have from an early stage of high-grade metamorphism to represent the granulite facies and then to a late stage medium-grade metamorphism belonging to the amphibolite facies.

• Economic and Environmental Geology
• /
• v.53 no.1
• /
• pp.87-98
• /
• 2020

The bird track fossil site in Haman Formation is divided into seven sedimental layers by the sedimentary structures, lithofacies and sequences. The bird tracks top on the highest layer, which includes ripple marks and suncracks. The layer has lithofacies with reddish grey siltstone and dark grey mudstone, alternately. As an analysis for the same rocks of the fossil site, physical properties show on mean values for 0.62% of absorption rate, 1.64% of porosity and 2.63 of specific gravity. Rock-forming minerals composed mainly of plagioclase, quartz, calcite, chlorite and mica. Meanwhile, we executed an experiments based on the petrography and weatherings to find a proper consolidants. In the experiments, the OH 100 reagent proved stable aspect and the lowest transition rate in terms of weight and chromaticity. Also, it showed the highest increase in ultrasonic velocity, improving the physical properties of the rocks. In the case of applying the OH 100 with antihygro, an swelling inhibitors on the sedimentary rocks, the chromaticity indicated an stable transition aspect. When it comes to the physical properties, the antihygro also decreases the porosity effectively. Thus, the most proper method for the fossil site of Haman Formation is to apply antihygro and OH 100 reagents since the rocks includes clay minerals that show swelling characteristics. However, this result is deduced from an indoor application experiments, leaving the necessity of verification how these reagents would affect the bird tracks site under the field condition.