• Proceedings of the Korea Institute of Fire Science and Engineering Conference
• /
• 2010.04a
• /
• pp.433-437
• /
• 2010

가을철 산불조심기간 중 영동지방(동해, 삼척) 침엽수림에 대하여 임분밀도별(소임분 800본/ha, 중임분 800-2000본/ha, 밀임분 2000본/ha 이상) 직경별 지표연료를 0.6cm 이하, 0.6~3.0cm, 3.0~6.0cm, 6.0cm 이상에 대하여 연료습도 변화를 실측한 결과 0.6cm 이하의 경우소임분은 3일차 되는 날 중, 밀입분은 4,5일차에 산불 초기 발화위험성이 나타났으며, 0.6~3.0cm의 경우 강우 익일 후 62-75%의 높은 연료습도를 보이고 있었으며, 소임분은 강우 후 5일차에 산불 초기발화 위험성이 시작되었다. 0.6~3.0cm의 경우 강우 익일에는 75-98%의 연료습도를 나타냈고, 소임분의 경우 6일차에 산불 초기발화 위험성이 시작되었다. 6.0cm 이상의 경우는 6일이 경과하여도 임분별 35-50%의 연료습도를 유지하고 있어서 산불 초기발화 위험성이 적은 것으로 조사 되었다.

• Membrane Journal
• /
• v.22 no.5
• /
• pp.301-308
• /
• 2012

Phosphazene diagnostic membranes were prepared to measure blood glucose level of diabetics. Final absorbances at 680nm through activated phosphazene membranes were measured at various temperature and humidity by varing concentration of glucose in blood. Measuring temperature and humidity did not seriously affected the end-point results of varing absorbance values as time (K/S). The effects of storage temperatures on the measurements of glucose concentration were studied after activated phosphazene diagnostic membranes were stored at various temperatures for 3 days, 1 week, 3 weeks, and 5 weeks. The stabilities of phosphazene dianostic membranes were confirmed even at RH 80%.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.12 no.9
• /
• pp.1564-1568
• /
• 2008

The anti-collision system is one of units for effectual operation and safety in crane operation. Most of the system have used ultrasonic to measure position and to prevent collision of crane. But, the anti-collision system using ultrasonic is fallen the reliability of performance by the change of temperature and humidity. Hence, this study proposes neural network applied to anti-collision system to improve accuracy and stability of the measured distance data, and we evaluate performance of the system. In results of experiments, the proposed method was seen that stability and accuracy of data are improved than that of the temperature compensation method.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.29 no.4A
• /
• pp.385-393
• /
• 2009

This study grasped the relationship between relative humidity in concrete and concrete shrinkage followed by pre-absorbed water of porous lightweight aggregates through measurements of concrete shrinkage and humidity and comparisons with established research results. It was showed that shrinkage reduction effect of lightweight concrete is 36% at 7 days early ages and 25% at 180 days long-term ages when water-binder ratio is 0.3. It also showed that shrinkage reduction effect is 19% at 7 days and 16% at 180 days when water-binder ratio is 0.4 and 37%, 32% when water-binder ratio is 0.5. The moisture supply effect of lightweight aggregates was remarkable at early age within 7~10 days irrespective of water-binder ratio. In case of waterbinder ratio is 0.3, the relationship between shrinkage and internal humidity of concrete has been underestimated regardless of applied existing model type and in case of water-binder ratio is 0.4, 0.5, measurement values are relatively similar with existing model equations. Finally this study did regression analyses about the relation among the humidity change and the shrinkage strain as a high-degree polynomial and derived parameters that can connect moisture movement analysis with differential shrinkage analysis in case of considering relative humidity at the time by moisture movement analysis of concrete.

• Journal of the Microelectronics and Packaging Society
• /
• v.27 no.1
• /
• pp.31-35
• /
• 2020

This study demonstrates metal-oxide based memtransistor device and the gate tunable memristive characteristic using atomic layer deposition (ALD) and ZnO n-type oxide semiconductor. We fabricated a memtransistor device having channel width 70 ㎛, channel length 5 ㎛, back gate, using 40 nm thick ZnO thin film, and measured gate-tunable memristive characteristics at each gate voltage (50V, 30V, 10V, 0V, -10V, -30V, -50V) under humidity of 40%, 50%, 60%, and 70% respectively, in order to investigate the relation between a memristive characteristic and hydrogen doping effect on the ZnO memtransistor device. The electron mobility and gate controllability of memtransistor device decreased with an increase of humidity due to increased electron carrier concentration by hydrogen doping effect. The gate-tunable memristive characteristic was observed under humidity of 60% 70%. Resistive switching ratio increased with an increase of humidity while it loses gate controllability. Consequently, we could obtain both gate controllability and the large resistive switching ratio under humidity of 60%.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.38 no.2
• /
• pp.119-128
• /
• 2010

The hygrothermal effect on the strength of composite single-lap bonded joints were investigated. The specimens were manufactured in four different manufacturing methods and tested in three different environmental conditions. An interesting result is that the strengths of the joints in the elevated temperature and wet (ETW) conditions were found to be 11 ~ 23% higher than those in the room temperature and dry (RTD) environment. In contrast, the strengths of the joints in the cold temperature and dry (CTD) condition decrease by 8 ~ 21% compared to those in the RTD environment except for cobonded joint. The difference in the strength by testing environments is mainly attributed to the change of the material properties of adhesive by temperature and moisture.

• Proceedings of the Korean Institute of Surface Engineering Conference
• /
• 2014.11a
• /
• pp.193-194
• /
• 2014

원전은 고온기능시험 이후 2차계통 내부를 상대습도 40%이하로 관리하여 계통 재질 부식을 최소화하고 있다. 일반적으로 발전소에서는 운전 정지 후 상대습도 40%이하로 낮추는데 15일정도 소요되지만, 발전소 계통 중 일부 곡관부위는 약 60일정도 소요된다. 본 연구는 일부 계통 재료가 상대습도 제한치(<40%) 이상의 환경에서 장기간(최대 60일) 노출시 재료 건전성에 미치는 영향 평가이다. 평가를 위해 시편의 실험 전, 후 무게변화를 이용한 부식률 측정과 표면분석을 위해 광학현미경을 이용하였다. 사용 시편의 재료는 SA516 Gr.70이며 표면상태를 인위적으로 산화피막을 생성 시킨 것(2개)과 산화피막이 없는 것(6개)으로 2종류로 제작하였다. 총 시험기간은 60일이고 시험기간 중 산화피막이 없는 시편은 7일, 21일, 60일에 시편을 2개씩 꺼내어 무게를 측정하여 부식률을 계산하였다. 실험결과, 산화피막이 없는 시편은 노출되는 시간에 따라 부식률이 각각 0.35(7일), 0.21(21일), 0.67(60일) mpy이었고 산화피막이 있는 시편은 0.06(60일) mpy였다. 산화표면 분석결과, 산화피막이 없는 시편은 노출되는 시간에 관계없이 물방울이 맺힌 부분에 pitting을 확인하였다. 하지만, 산화피막이 있는 시편은 pitting의 흔적은 없었다. 산화피막이 없는 시편의 경우 시간에 따라 부식률은 높아지지만 학계에서 통용되는 뛰어난 내부식성 재료의 부식률 기준인 < 1 mpy이하기 때문에 재료 건전성에 미치는 영향은 거의 없을 것으로 판단된다. 또한, 대부분 원전의 경우 고온기능시험 또는 운전기간 동안에 2차계통 구성 재료 표면에 산화막이 생성되었기 때문에 산화피막이 있는 시편의 결과로 판단하면 상대습도 40%이상에 60일 이상 노출되어도 부식은 거의 일어나지 않았을 것으로 사료된다. 실증실험결과를 가지고 종합적으로 평가하면 상대습도 40%이상 환경에서 곡관부위가 60일이상 노출되어도 재료 건전성에 미치는 영향은 거의 없을 것으로 판단된다.

• Proceedings of the KIEE Conference
• /
• 2001.07c
• /
• pp.1352-1354
• /
• 2001

후막 EL소자는 연속동작 중에 발광특성이 저하되는 특징을 가진다. 본 연구는 상온과 $70^{\circ}C$, 상대 습도 100% 환경에서 후막 EL소자를 100V, 400Hz의 전원을 인가한 후 휘도 변화를 측정 및 비교하였다. 또한 열화된 시료의 표면 및 측면 주사 전자 현미경 사진을 통해 열화 부분을 관찰하였다. 측정된 휘도와 열화 메카니즘을 통해 sulfur vacancy와 deep traps 농도 시뮬레이션을 활용하였다. 후막 EL소자의 발광 특성은 주변의 온도 및 습도에 의해 크게 저하됨을 확인하였다.

• Journal of Advanced Marine Engineering and Technology
• /
• v.24 no.4
• /
• pp.421-426
• /
• 2000

A study on the combustion and exhaust emissions characteristics of diesel engine with various suction air humidity is performed experimentally. In this paper, suction air humidity is changed from RH 50% to RH 90%, the experiments are performed at engine speed 1800rpm, and main measured parameters are cylinder pressure, fuel consumption rate, CO, HC, NOx and Soot emissions etc. Increase of suction air humidity from RH 50% to RH 90% does not effect specific fuel consumption, decreases maximum pressure in cylinder, ratio of maximum pressure rise and net heat release, and delays ignition timing. Also, that increases CO and HC emissions, decreases NOx emissions, but does not constant in changing tendency on emission.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.10 no.5
• /
• pp.1-6
• /
• 1973

The paper deals with a study on an electronic watering device. The system is designed to scan 10 probes so that they detect moisture of soil. Input potentials are compared with reference level before the system is watering. rt provides a main clock oscillator and a control oscillator for the system control, and a programmable unijunction transistor is used for the control circuit. The reference levels are adjustable so as to water various soils. The device is tested for two different sails of moisture content ranging from 6 to 51%. It works at any input level higher than 0.6 V compared to the reference level.