• Journal of Energy Engineering
• /
• v.24 no.1
• /
• pp.97-103
• /
• 2015

Natural convection heat transfer rates in vertical pipes were measured varying the diameter, length, and roughness of vertical cylinder. To achieve high Rayleigh number with relatively small test rig, mass transfer experiments instead of heat transfer were performed based on the analogy. Prandtl number was 2,014. The length of vertical cylinder was 0.1m, 0.3m, and 0.5m, which correspond to GrL $4.2{\times}10^7$, $1.1{\times}10^9$, and $5.5{\times}10^9$. To each length of vertical cylinder, the heat transfer rates were measured varying the iameter 0.005m, 0.01m, and 0.03m. The heat transfer rate for a short length pipe(0.1m) agreed with the prediction from Le Fevre correlation developed for a vertical plate for all diameter. The heat transfer rate decreases as the diameter and the length of the pipe increases. The heat transfer rate inside of vertical cylinder is affected by roughness only for a laminar flow regime.

• Journal of Energy Engineering
• /
• v.20 no.3
• /
• pp.242-251
• /
• 2011

The effects of top and bottom lids on the natural convection heat transfer phenomena inside vertical cylinders were investigated experimentally for $Ra_{Lw}$ from $9.26{\times}10^9$ to $7.74{\times}10^{12}$. Using the concept of analogy between heat and mass transfer, a cupric acid-copper sulfate electroplating system was employed as mass transfer experiments replacing heat transfer experiments. The natural convection heat transfer of both-open cylinders in laminar and turbulent flows was in good agreement with the existing heat transfer correlations developed for vertical plates. The effects of top and bottom lids on the heat transfer rates were very similar to the studies of Krysa et al. and Sedahmed et al. and Chung et al. With the copper lids, the bottom-closed cavity showed the highest heat transfer rates and then followed both-closed, top-closed, both-open ones in both laminar and turbulent flows. However with the acryl lids, the similar trends were observed except that the heat transfer rates for both-open were higher than top-closed one. The use of the copper lids increased the heat transfer rates compared to the acryl lids due to the hydrodynamic interaction of the flows developed for the different heated faces. This study extended the ranges of flow conditions of the existing literatures and proposed the empirical correlations.

• Journal of Energy Engineering
• /
• v.21 no.1
• /
• pp.18-25
• /
• 2012

This work investigated the influence of the chimney dimensions(exit and entrance length, and diameter) on the heat transfer of a vertical cylinder in a duct. The measured mass transfer rates for the natural convection of vertical cylinder in a duct were presented for Prandlt number 2,094, Rayleigh number in the range of $4.55{\times}10^9$, $5.79{\times}10^{10}$, and $1.69{\times}10^{11}$. Experiments were performed using a copper sulfate electroplating system to simulate heat transfer based upon the analogy concept. The diameter of the duct was varied from 0.06 m to 0.14 m, and the heights from 0.30 m to 1.10 m. Nusselt numbers measured at open channel condition agreed well with the existing laminar heat transfer correlations for vertical plate developed by Le Fevre. The increase of the exit length enhanced the heat transfer up to a certain duct height but further increase does not affects the heat transfer. The heat transfer decreased with increasing the entrance length up to a certain duct height and was constant at further increase. The Nusselt number decreased with increasing the diameter of duct, until Nusselt number becomes similar to that at open channel beyond a certain diameter.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.35 no.1
• /
• pp.33-42
• /
• 2011

In this study, we investigated the natural convection on the outer surface of a vertical pipe by performing mass transfer experiments using fluids with high Pr number using the concept of analogy between heat and mass transfer. A cupric acid-copper sulfate electroplating system was adopted as the mass transfer system. Tests were performed for $Ra_H$ numbers from $1.4{\times}10^9$ to $4{\times}10^{13}$, Pr numbers from 2,094 to 4,173, and diameters from 0.005 m to 0.035 m. The test results for laminar flow conditions were in good agreement with the correlations reported by King, Jakob and Linke, McAdam, and Bottemanne, and those for turbulent conditions with the correlations presented by Fouad for a vertical plate and also proved the dependence on Pr numbers. The obtained correlations were $Nu_H=0.55Ra^{0.25}_H$ for laminar and $Nu_H=0.12Ra^{0.28}_HPr^{0.1}$ for turbulent. The transition between laminar and turbulent occurs at $Ra_H$ of about $10^{12}$.

• 한국기계연구소 소보
• /
• s.18
• /
• pp.37-48
• /
• 1988

• Proceedings of the Korean Nuclear Society Conference
• /
• 1998.10a
• /
• pp.128-128
• /
• 1998

• 한국방재학회:학술대회논문집
• /
• 2011.02a
• /
• pp.197-197
• /
• 2011

최근 들어 전력 사용량의 증가로 인한 화력발전소의 부산물인 석탄회 중 바텀애시와 각종 공공사업과 관련하여 해마다 현장발생토의 발생량이 지속적으로 증가하고 있는 추세이다. 바텀애시와 현장발생토사를 효과적으로 재활용하는 방법 중 유동성 뒤채움재를 개발하여 활용하는 방안을 모색하기 위한 연구이다. SP로 분류된 흙 현장발생토와 서천 화력발전소에서 발생하는 석탄회 중 입경이 0.9~1.5mm의 바텀애시만을 선별하여 현장발생토와 바텀애시의 비율을 7 : 3으로 변환한 최적배합을 선정하여 강재로 제작된 가로 80cm, 세로 60cm, 높이 90cm의 모형토조를 이용하여 실험을 진행하였으며, 사용상 지하 매설이 되는 관의 거동 특성은 확인하기 위하여 내경 30cm, 두께 8mm의 연선관 중 하나인 PVC관을 원형지하매설관으로 선정하여 배합을 타설하는 과정과 타설 후 7일간의 양생기간을 거친 후 차량하중으로 가정할 수 있는 하중을 가하여 원형지하매설관의 관외부에서 수직방향과 수평방향의 토압과 관내부의 수직 수평방향 변위 그리고 관 자체의 횡 종단 변형을 측정하여 원형지하매설관의 거동특성을 파악하였다. 타설시 지하매설관은 유동성 뒤채움재의 특성으로 인하여 시간이 지남에 따라 안정화되는 것을 확인할 수 있었으며, 최대하중을 3300kgf로 하여 하중 재하 후 지하매설관의 거동특성은 대체적으로 일반 모래를 사용하여 실험한 값보다 적은 변형 특성을 보이고 있으나 수평토압의 경우 일반적인 흙의 변형과 전혀 상이한 결과값을 보이는 경우도 있어 추가적인 실험 및 고찰의 필요하다. 본 실험에서 사용한 최적배합비 이외의 배합으로 같은 실험을 수행하여 바텀애시 량의 가감 및 재활용 재료인 폐타이어 고무칩등을 첨가한 실험을 계획하고 있으며 추후 실내시험과 모형실험을 토대로 유한요소해석을 추가로 시행하여 실험값과 해석값의 비교를 할 예정이다.

• The Korean Journal of Zoology
• /
• v.36 no.2
• /
• pp.245-263
• /
• 1993

신경성장인자 수용체(nerve growth factor receptor, HGFr)의 소재를 휜쥐 전뇌 기저부 핵들의 신경세포와 그 세포내 소기 관에서 연역세포화학적 방법으로 관찰하였다. NGFr에 면역반응을 보이는 신경세포들은 내측중격, 수직 및 수평대각선 브로카대, 거대세포 시삭전핵 그리고 Meynert 기저핵에는 다수 미상핵-피각과 복부담창구에는 소수 관찰 되었다 NGFr에 면역반응을 보이는 신경세포들은 형태학적으로 3가지 형 즉, 1) 난형(또는 원형). 2) 방추형, 3) 삼각형(또는 다각형)으로 구분되었다 내측중격은 주로 난형의 세포로 구성되었으며(91.2%), 수직 및 수평대각선 브로카대, 거대세포 시삭전핵 및 Meynert 기저 핵에는 난형의 세포가 높은 율로 구성되었으나, 방추형과 삼각형 세포들도 내측중격에서보다는 많았다 특히 복부담창구에는 다른 핵들에 비하여 방추형세포(25%)들이 높은 출현율을 보였다 일반적으로 이들 세포의 크기는 삼각형세포가 제일 컸으며, 방추형세포가 그 다음, 그리고 난형 세포가 제일 작았다 전자현미경적 관찰에서 0.05% triton X-100을 처리한 조직중 Meynert 기저핵을 관찰한 결과. Golgi체, multivesicular body 및 소포체들이 N6Fr에 면역반응을 보였으며. trion X-100을 처리하지 않은 조직에서는 단지 수평대각선 브로카대의 신경세포 원형질 막에서만 약한 면역반응을 보였다 위의 결과로 미루어 NGFr은 조연소포체에서 합성되어. Golgi체에서 농축되고, multivesicular body를 통하여 원형질막에 위치하게 되며, 원형질막에서 NGFr은 외래성의 NGF와 복합체를 형성한후, 궁극적으로는 Iysosome의 형태로 세포체 안으로 들어 가는 것으로 추정된다.

• Journal of Energy Engineering
• /
• v.23 no.3
• /
• pp.27-35
• /
• 2014

The existing flow regime map on mixed convection in vertical cylinders was investigated through an analysis of original literatures and its re-formation. The original literatures related to the existing map were reviewed. Using the investigated data and heat transfer correlations, the map was redrawn independently, and compared with the existing map. The redrawn map showed that mixed convection regime was not curved lines but straight lines and the transition regime was unable to be reproduced. Unlike the existing map with a little data, there are lots of data in the redrawn map. The reviews revealed that the existing map used the data selectively among the experimental and theoretical results, and a detailed description for lines forming mixed convection and transition regime was not provided. While considerable studies on mixed convection have been performed since that of Metais and Eckert, the existing map has still been used as the best method to distinguish natural, forced and mixed convection regime.

• Proceedings of the SAREK Conference
• /
• 2005.06a
• /
• pp.85-85
• /
• 2005