• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.7A
• /
• pp.794-806
• /
• 2004

This paper deals with correction of frequency offset and analysis of quantization angle noise in the IEEE 802.1la OFDM system. The rotation phase per symbol due to the carrier frequency offset is estimated from auto-correlation of the short Preambles, which are over-sampled for the reduction of noise in OFDM signals. The pilot signals are introduced to estimate the rotation phase per OFDM symbol due to estimation error of the carrier frequency offset and the sampling frequency onset. During the estimation and correction of the frequency onsets, a CORDIC processor and a look-up table are used for the conversion between a rotation phase and its complex number. Being calculated by a limited number of bits in the CORDIC processor and the look-up table, the rotation phase and its complex number have quantization angle errors. The quantization errors are analyzed as SNR (signal to noise ratio) due to the quantization bit numbers. The minimum bit number is suggested to meet the specification of IEEE 802.1la properly. Finally, the quantization errors are evaluated through simulations on number of quantization bits and SNR of received signals.

• The KIPS Transactions:PartC
• /
• v.12C no.1 s.97
• /
• pp.53-62
• /
• 2005

The NG-SDH system requires signal synchronization to synchronize incoming ethernet signal with GFP frame. The foreign nation research completes a chipset development until now and it secures a relation technique, but it does not secure a relation technique from domestic. Therefore, in this paper, we presented with signal synchronization method of Ethernet signal through GFP frame. We knew that the synchronized method of Ethernet signal through GFP-F must apply ingress & egress buffer and GFP Idle. We understood that the synchronized method of Ethernet signal through GFP-T must apply GFP Idle and $65B{\_}PAD$, and require maximum 3-bit addition & deletion of idle. Also we showed signal synchronization realization through simulation and obtained MTIE/TDEV characteristics and peak to peak jitter in egress output.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.14 no.5
• /
• pp.55-59
• /
• 2014

Multi-band and multi-mode transmitters are needed for SDR and CR. Recently many types of polar transmitters have been studied in order to implement a multi-band and multi-mode transmitter. Polar transmitters have many advantages, such as a simple structure, high efficiency and etc. In this paper we consider the number of D/A bit and the effects of a delay mismatch as design parameters for implementing polar transmitters. From the simulation we know that a 10 bit D/A is sufficient and a delay mismatch must be maintained small than 1/64 chip for satisfying the spectrum mask characteristics. We implement a polar transmitter based on the design parameters and the measured output signal meet the spectrum mask of 800MHz CDMA.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.38 no.11
• /
• pp.41-48
• /
• 2001

The exact general bit error rate (TIER) expression of M-ary square quadrature amplitude modulation (QAM) for arbitrary M has not been derived so far. In this paper, a generalized closed-form expression for the BER performance of M-ary square QAM with Gray code bit mapping is derived and analyzed in the presence of additive white Gaussian noise (AWGN) channel. The derivation is based on the consistency of the format in signal constellation o[ Gray coding and it has been derived from the results for M-16, 64, and 256.

• Journal of Biomedical Engineering Research
• /
• v.20 no.3
• /
• pp.299-305
• /
• 1999

In thls paper, the representative beal textraction algorIthms for the diagnostic parameter extraction in noisy signal were compared. We used the avernge, median, mode, and trmmed mean to calculale the central tendency. In our experimenl, we have restricted to four kinds of noises -EMG noise, 60Hz powerline inlerference, ahrupl baseline shift, and baselme drift due to respimtion-which were commonly occurred in ECG mgnal, then we have calculated signal-to-noise ratios(SNRs) for the ECG corrupted with each noise and all noises together. As the result of this paper, we have proved that the average method has super lor performance than the others in the ECG corrupted wilh EMG noise. When the signal mcludes extreme value such as abrupt baseline shIft, the median, mode, trimmed mean methods have supenor performance in the SNR ratios. Especially when the ECG corrupted with baseline drift due to respirallon, the trimmed mean method was most efficient because ST level change was 0 V.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.13 no.12
• /
• pp.2511-2517
• /
• 2009

Recently, a FMCW radar is used for the various purposes in the short range detection and tracking of targets. The main advantages of a FMCWradar are the comparative simplicity of implementation and the low peak power transmission characterizing the very low probability of signal interception. Since it uses the frequency modulated continuous wave for transmission and demodulation, the received beat frequency represents the range and Doppler information of targets. Detection and extraction of useful information from targets are performed in this beat frequency domain. Therefore, the resolution and accuracy in the estimation of a beat spectrum are very important. However, using the conventional FFT estimation method, the high resolution spectrum estimation with a low sidelobe level is not possible if the acquisition time is very short in receiving target echoes. This kind of problems deteriorates the detection performance of adjacent targets having the large magnitude differences in return echoes and also degrades the reliability of the extracted information. Therefore, in this paper, the model parameter estimation methods such as autoregressive and eigenvector spectrum estimation are applied to mitigate these problems. Also, simulation results are compared and analyzed for further improvement.

• Journal of Advanced Navigation Technology
• /
• v.6 no.3
• /
• pp.223-230
• /
• 2002

In this paper, we induced that the noise powers and bit error rate of direct detection receiver taking account of ISI (intersymbol interference) in the 2,000 km optical transmission system. And we evaluated the sensitivity in the vrious bit rate system. We verified that the proposed calculation method is applicable to the exact optical system. And we confirmed that the signal distortion due to both chromatic dispersion and nonlinear effects compensated by using of MSSI (Mid-Span Spectral Inversion) method, and yet the sensitivity of a higher bit rate system is reduced, because of the increase of ISI and then the decrease of the average receiving power, compared with a the lower bit rate system.

• Proceedings of the Acoustical Society of Korea Conference
• /
• spring
• /
• pp.335-338
• /
• 2002

본 연구에서는 주파수 영역에서의 확산 스펙트럼 방식을 이용한 오디오 워터마킹 기법을 사용하고 있다. 워터마크 삽입은 오디오 신호를 MCLT(Modulated Complex Lapped Transform)로 분석한 후, 특정 주파수 영역의 진폭에 삽입되며 추출은 상관도를 이용하여 추출하게 된다. 워터마크 삽입은 44.1 kHz의 음악에 80 bits의 정보가 4초 단위로 반복적으로 삽입되며, 추출에서는 무작위로 추출된 8초 분량의 오디오 신호로부터 80 bits 비트 열과의 상관도를 계산하여 선정된 문턱 값을 초과하게 되면 워터마크가 존재하는 것으로 판단하게 된다 피치 스케일에 대응하기 위하여 120개 정도의 탐색을 수행하며, 시간 스케일에 대응하기 위하여 상관도의 지역 최대 점을 추출하고, 이러한 지역 최대 점들로부터 추출된 비트 열과 실제 비트 열과의 상관도를 계산하게 된다. 그러나 추출된 비트 열은 삽입 에러와 삭제 에러를 가질 수 있기 때문에 이러한 비트 열과의 최대 상관도를 구하기 위하여 본 연구에서는 동적계획법에 의한 최대 상관도 추출 알고리즘을 제시한다. 제안된 방법은 피치 및 시간 스케일링 변환 뿐만 아니라, 오디오 압축에도 견고함을 보인다.

• Journal of IKEEE
• /
• v.15 no.3
• /
• pp.205-210
• /
• 2011

A novel hysteresis tunable monolithic comparator circuit based on a 0.35 ${\mu}m$ CMOS process is suggested in this paper. To tune the threshold voltage of the hysteresis in the comparator circuit, two external digital bits are used with supply voltage of 3.3V. The threshold voltage of the suggested comparator circuit is controlled by 234mV by change of 4 digital control bits in the simulation, which is a close agreement to the analytic calculation.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.23 no.5
• /
• pp.1349-1359
• /
• 1998

In this paper, presented is the result of a digital implementation of a FM stereo composite signal generator. The chip utilizing DDFS(Direct Digital Frequency Synthesizer architecture is implemented using $1.0\mu\textrm{m}$ CMOS gate-array technology thereby replacing analog componentry. To verify the process of generating composite signals a conventional logic simulation method was used. The processed chip was mounted on an evaluation PCB to test and analyze to signals. According to the measurement result obtained by using a 12-bit DAC, the digital FM composite signal generator produces a 74DB spectrally pure signal over its entire tuning range, which is superior to that of analog counterpart by 14dB in it spectral reponse. And further enhancements of the spectral response is expected to be achieved by using a high resolution digital to analog converter, such as a 16-bit DAC. The resulting signals is superior to the signal of the analoy circuitry typically used, in major characteristics such as S/N ratios, accuracy, tuning stability, and signal seperation.