• Journal of Radiation Protection and Research
• /
• v.24 no.4
• /
• pp.187-193
• /
• 1999

The specific radioactivity concentrations in the coal fly ash obtained from heat producing stations in Korea were analyzed and its radiological hazard for reuse in construction purpose was evaluated. The concentrations of uranium isotopes in the real fly ash measured by TBP solvent extraction method and $\alpha$-spectrometer were found to be about 116.1 Bq $kg^{-1}$ for $^{238}U$, 5.01 Bq $kg^{-1}$ for $^{235}U$, and 121.2 Bq $kg^{-1}$ for $^{234}U$, respectively. The activity ratio of $^{234}U/^{238}U$, in the coal fly ash was in $1.04\;{\pm}\;0.03$, which is similar to that of uncontaminated Korean soil in natural conditions (1.14). The specific radioactivities of $^{226}Ra,\;^{232}Th,\;and\;^{40}K$ in the coal fly ash were also determined using $\gamma$-spectrometer with a HPGe detector The results showed that $^{226}Ra,\;^{232}Th,\;and\;^{40}K$ in the coal fly ash were in concentrations of $101.7{\sim}113.9$, $39.5{\sim}54.2\;and\;315.0{\sim}990.6$ Bq $kg^{-1}$, respectively. With the specific radioactivities obtained from $\gamma$-spectrometric measurements of the coal fly ash, its radiological hazard for reuse was evaluated. The result showed that the radioactivity of the coal fly ash was in permissible level.

• Journal of the Mineralogical Society of Korea
• /
• v.28 no.2
• /
• pp.147-163
• /
• 2015

Chemical and mineralogical properties of coal ash samples from the nine thermal power plants of Korea were investigated to acquire basic data for estimating the potential of rare metal recovery. Chemical compositions of coal ash were consistent with those of average shale and foreign coal ashes. However, there were small differences between the metal contents of domestic anthracitic and imported bituminous coal ashes. Unburned coal particles were much abundant in the ash of domestic anthracitic coal. Chalcophile elements were relatively enriched in the fly ash compared to bottom ash. Silicate glass was the major component of coal ash with minor minerals such as quartz, illite (muscovite), mullite, magnetite, lime, and anhydrite. Al and Si were the major components of the glass with varying contents of Ca, Fe, K, and Mg. Glass occurred in a form of porous sphere and irregular pumace-like grain often fused with iron oxide spheres or other glass grains. Iron oxide spheres were fine intergrowth of fast-grown iron oxide crystals in the matrix of silicate glass. Chemical, microstructural, and mineralogical properties would guide successful rare metal recovery from coal ash.

• Resources Recycling
• /
• v.24 no.4
• /
• pp.67-75
• /
• 2015

The content distributions of some rare metals and rare earthe metals in coal ash (fly ash, bottom ash and pond ash) and leachate from coal-fired power plants were investigated. In case of Yttrium (Y) and Neodymium (Nd) which were strategic critical elements, their contents were ranged from about 23 ~ 75 mg/kg and it is shown they are worth to be developed for the recovery and separation method. Considering the annual amount of fly ash and bottom ash and pond ash, coal-fired power plants have great value of about 1,670 billion KRW and it is regards they are worthy as urban mines.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.36 no.6
• /
• pp.663-668
• /
• 2012

Fly ash erosion is a leading cause of boiler tube failure in PC boilers. Therefore, shields or baffle plates are installed in specific areas to mitigate fly ash erosion and prevent boiler tube failure. However, the tube failure problems caused by fly ash erosion cannot be eliminated with this solution alone, because each PC boiler has a different flue-gas flow pattern and erosion can become severe in unexpected zones. This problem is caused by an asymmetric internal flow velocity and local growth of the flue gas velocity. For these reasons, clearly defining the flow pattern in PC boilers is important for solving the problem of tube failure caused by fly ash erosion. For this purpose, the cold air velocity technique (CAVT) can be applied to the fly ash erosion problem. In this study, CAVT was carried out on the Hadong #2 PC boiler and the feasibility of application of CAVT to conventional PC boilers was validated.

• Analytical Science and Technology
• /
• v.11 no.5
• /
• pp.394-399
• /
• 1998

This study was carried out to characterize the chemical composition and leaching properties of heavy metals in coal fly ash, which was generated from Korean electrical power utilities in several million tons per year. Comparion with respect to the leachability of heavy metals between the Korea standard leaching test (KSLT) and the American Environment Protection Agency (EPA) method 1311 (TCLP: Toxicity Chracteristic Leaching Procedure) was performed. The concentration of Ag, As, Ba, Cd, Cr, Cu, Pb, Se, Hg in the leacheate was determined by ICP-MS. The analytical result showed a significant difference of the leachability according to the characteristics of the leaching solution except Se, suggesting the necessity of improvement in the leaching test method that is currently implemented in Korea.

• Journal of Korean Society of Environmental Engineers
• /
• v.36 no.3
• /
• pp.198-205
• /
• 2014

The present paper investigates the leaching property of coal fly ash (FA) using distilled water as solvent and its performance of mineral carbonation. The highest leaching efficiency is obtained at 100 min after leaching begins and the overall leaching efficiencies of Ca and Na via five consecutive leachings were calculated to be 25.37% and 7.40%, respectively. In addition, because $Ca(OH)_2$ produced during the leaching reacts with $SiO_2$ which is the major component of FA, the Pozzolanic reaction may occur and thus reduces leaching efficiency. Total carbonation capacity of FA by absorbing $CO_2$ into FA leachates is 6.08 mg $CO_2/g$ FA and the contribution of alkali substances such as Ca, Na, Mg and K to this value is calculated to be 5.19 mg $CO_2/g$ FA. Carbonation efficiencies of Ca and Na based on leachates are 85.62% and 77.70%, respectively. On the other hand, the ratios of Ca and Na in raw FA to participate in carbonation are calculated to be 9.04% and 5.26%, respectively.

• Analytical Science and Technology
• /
• v.15 no.6
• /
• pp.567-573
• /
• 2002

The most important and largest commercial outlet of fly ash in Korea is a replacement material of Portland cement in concrete industry. The high level of unburned carbon in ash brings about some malfunctions in concrete. Therefore, fly ash is refined to improve the quality as a concrete additive. In this process, a lot of the residual carbon is produced, and discarded now. In the present study, to find out a valuable outlet of the enriched carbon samples, the basic morphology of residual carbon in fly ash from Boryung power plant was investigated. The unburned carbon characterization included shape, size measurement, and chemical analysis was examined using scanning electron microscope (SEM) and energy dispersive X-ray spectrometer (EDX).

• Proceedings of the Korea Society for Energy Engineering kosee Conference
• /
• 2000.11a
• /
• pp.101-104
• /
• 2000

1980년대 중반이후 화력발전소용으로 순환유동층 연소로(Circulating fluidized bed combustor : CFBC)가 많이 건설되고 있다. 이는 기존의 고정층 연소로보다 효율면에서 좋고, 차지하는 부피는 훨씬 적기 때문이다. 순환유동층의 층물질로 사용되는 모래, 석탄회, 석회석 등은 순환하는 입도, 비산유출되는 회재(fly ash)와 하부로 배출되는 회재(bottom ash)로 나누어진다. 주입되는 석탄 및 석회석의 입도는 입자-입자, 입자-연소로의 마모(attrition), 입자의 깨짐(fragmentation), 입자의 축소(shrinking) 등에 의해서 변화하게 된다.(중략)

• Resources Recycling
• /
• v.5 no.3
• /
• pp.44-49
• /
• 1996

One of the most serious problems in utilizing the fly-ash produced from damcstic coal-firing power plants is lhc unburned-carbon mntained m the fly-ash In this shldy, the effects of fruther and collector an the yield,recuvery,unburnedcarbon rejectiou peiccntage,and process efficiency of product (cleaned fly-ash) wcrc examined when convzntional froth flotation was applied to rejcct the unburned-carbon included in the fly-ash of bituminous coal Alsa,the ash analysis for both thc raw and the clcaned fly-ash was conducted to review the change in thc major elements of fly-ash. Experimental results shawcd lhat tlle rcjectlon oI the unburned-cubon of thc raw fly-ash sample is available upto 92.4% using fiath flotalian and that the putity ol the pmdud(c1eancd fly-ash) attains up to 99.4%.

• Korean Journal of Soil Science and Fertilizer
• /
• v.45 no.2
• /
• pp.253-259
• /
• 2012

Disposal of high amount of coal combustion by-products, such as fly ash and bottom ash, is of a great concern to the country, due to the huge treatment cost and land requirement. On the other hand, those coal-ash wastes are considered to have desirable characteristics that may improve physical, chemical, and biological properties of soils. Especially, compared with fly ash, bottom ash has a larger particle size, porous surface area, and usable amount of micronutrients. In the present study, we examined bottom as a soil amendment for mitigating $CO_2$ emission and enhancing carbon sequestration in soils fertilized with organic matter (hairy vetch, green barely, and oil cake fertilizer). Through laboratory incubation, $CO_2$ released from the soil was quantitatively and periodically monitored with an enforced-aeration and high-temperature respirometer. We observed that amendment of bottom ash led to a marked reduction in $CO_2$ emission rate and cumulative amount of $CO_2$ released, which was generally proportional to the amount of bottom ash applied. We also found that the temporal patterns of $CO_2$ emission and C sequestration effects were partially dependent on the relative of proportion labile carbon and C/N ratio of the organic matter. Our results strongly suggest that amendment of bottom ash has potential benefits for fixing labile carbon as more stable soil organic matter, unless the bottom ash contains toxic levels of heavy metals or other contaminants.