• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.13 no.3
• /
• pp.212-218
• /
• 2020

When Radiofrequency energy is applied to the human body, the vibration width is very short. Therefore, the electrolyte burn generated when using the direct current does not occur. Ion molecules, polarized molecules, etc., vibrate more than 40,000 times per second, converting them into frictional heat to generate deep heat. The blood flow of capillaries increases 4-5 times more than at rest, increasing the supply of oxygen, nutrients, antibodies, and white blood cells. In addition, the electrochemical reaction does not occur because the vibration width and the pulsation period are very short. It is a physical factor treatment method that does not stimulate the sensory nerves and motor nerves. In this study, an isotonic exercise is performed in a young normal adult using a Radiofrequency pain treatment device. The purpose of this study is to integrate rehabilitation therapy by measuring electromyography data during isotonic exercise and confirming the effect on changes in motor neuron response. The EMG data generated when isotonic exercise of the forearm biceps muscle and the EMG data measured after the use of a Radiofrequency pain treatment device after exercise were RMS, respectively, and verified through t-test. It was confirmed that there was a significant difference in both men and women because the t-value was smaller than the significance level p (<.05).

• Applied Chemistry for Engineering
• /
• v.32 no.6
• /
• pp.664-670
• /
• 2021

Stainless steel was applied as bipolar plate (BP) of polymer electrolyte membrane fuel cell (PEMFC) due to high mechanical strength, electrical conductivity, and good machinability. However, stainless steel was corroded and increased contact resistance resulting PEMFC performance decrease. Although the corrosion resistance could be improved by surface treatment such as noble metal coating, there is a disadvantage of cost increase. The stainless steel corrosion behavior and passive layer influence on PEMFC performance should be studied to improve durability and economics of metal bipolar plate. In this study, SUS316L bipolar plate of 25 cm² active area was manufactured, and experiments were conducted for corrosion behavior at an anode and cathode. The influence of SUS316L BP corrosion on fuel cell performance was measured using the polarization curve, impedance, and contact resistance. The metal ion concentration in drained water was analyzed during fuel cell operation with SUS316L BP. It was confirmed that the corrosion occurs more severely at the anode than at the cathode for SUS316L BP. The contact resistance was increased due to the passivation of SUS316L during fuel cell operation, and metal ions continuously dissolved even after the passive layer formation.

• The Korean Journal of Pesticide Science
• /
• v.2 no.3
• /
• pp.64-69
• /
• 1998

New thirty derivatives of 5,6-dihydro-2-trifluoromethyl-1,4-oxathiin carboxanilide as substrate(S) were synthesized and their fungicidal activities in vivo against rice sheath blight(Rhizoctonia solani) and wheat leaf rust(Puccinia recondita) were examined. The structure activity relationships(SAR) between the activities($pI_{50}$) and a physicochemical parameters of substituents(X) at the phenylcarbamoyl group were analyzed using the adaptive regression analysis method. The 3-methoxy, 11, 3-isopropyloxy, 13 and 3-isopropyl substituent, 25 as X on the phenylcarbamoyl group exhibited the most highest fungicidal activity against the two fungi. The fungicidal potency of the (S) against Puccinia recondita was higher than Rhizoctonia solani. In case of Rhizoctonia solani, the molecular hydrophobicity(${\pi}>0$) and resonance effect(R<0) by meta-alkyl substitutents with electron donating were important factors in determining fungicidal activity. And the HOMO energy(HOMO>0), ABSQ, sum of absolute values of the atomic charges on each atom and specific polarizability(Sp.Pol<0) of (S) were significantly influential towards fungicidal activity against Puccinia recondita.. The interaction between (S) and receptor agonist from the based on SAR studies proceeds through charge-control reaction, and conditions to show higher activity has been also discussed.

• Membrane Journal
• /
• v.22 no.4
• /
• pp.235-242
• /
• 2012

Ammonium perchlorate (AP) is primarily derived from the process of liquid incineration treatment when dismantling a solid rocket propellant. A series of batch dead-end nanofiltration (NF) and reverse osmosis (RO) membrane experiments were conducted to explore the retention mechanisms of AP under various hydrodynamic and solution conditions. Low levels of silicate type of siloxane had been detected through the GC/MS and FTIR analysis of liquid solutions extracted from solid ammonium perchlorate composite propellant (APCP). It is indicated that NF/RO membranes fouling in the presence of APCP was mainly attributed to the AP interactions because the concentration of silicate type of siloxane was negligible compared to that of AP. The osmotic pressure of AP was presumably resulted in the flux declines ranging from 13 to 17% in the case of the application of low-pressure (551 and 896 kPa for NF and RO) compared to those in application of high-pressure. The retention of AP by NF/RO membranes significantly varied from approximately 10 to 70% for NF and 26 to 87% for RO, depending on the operating and solution water chemistry conditions. The results suggested that retention efficiency of AP was fairly increased by reducing concentration polarization (i.e. application of low-pressure and stirring speed of 600 rpm) and increasing the pH of a solution. The result of this study was also consistent with the previous modeling of 'solute mass transfer of NF/RO membranes' and demonstrated that hydrodynamic and solution water chemistry conditions are to be a key factor in the retention of AP by NF/RO membranes.

• Journal of the Korean Chemical Society
• /
• v.53 no.1
• /
• pp.42-50
• /
• 2009

The dielectric-spectroscopic and ac conductivity studies firstly carried out on layered manganese doped Sodium Lithium Trititanates ($Na_{1.9}Li_{0.1}Ti_3O_7$). The dependence of loss tangent (Tan$\delta$), relative permittivity ($\varepsilon_r$) and ac conductivity ($\sigma_{ac}$) in temperature range 373-723K and frequency range 100Hz-1MHz studied on doped derivatives. Various conduction mechanisms are involved during temperature range of study like electronic hopping conduction in lowest temperature region, for MSLT-1 and MSLT-2. The hindered interlayer ionic conduction exists with electronic hopping conduction for MSLT-3. The associated interlayer ionic conduction exists in mid temperature region for all doped derivatives. In highest temperature region modified interlayer ionic conduction along with the polaronic conduction, exist for MSLT-1, MSLT-2, and only modified interlayer ionic conduction for MSLT-3. The loss tangent (Tan$\delta$) in manganese-doped derivatives of layered $Na_{1.9}Li_{0.1}Ti_3O_7$ ceramic may be due to contribution of electric conduction, dipole orientation, and space charge polarization. The corresponding increase in the values of relative permittivity may be due to increase in number of dipoles in the interlayer space while the corresponding decrease in the values of relative permittivity may be due to the increase in the leakage current due to the higher doping.

• Applied Chemistry for Engineering
• /
• v.10 no.1
• /
• pp.6-11
• /
• 1999

Dialkylamine (di-)nitrobenzoates as vapor corrosion inhibitor were synthesized with dialkylamines and (di-)nitrobenzoic acids. The compounds were analyzed by elemental analyzer, FT-IR and $^1H$-NMR spectrophotometer. Corrosion inhibition of synthetic compounds and additives [$(NH_4)_2CO_3$, $NaHCO_3$] against ferrous and non-ferrous metal was investigated by potentiostatic method [1% (w/v) corrosion inhibitor in 1M $Na_2SO_4$ aqueous solution] respectively. For corrosion inhibition of ferrous metal, dialkylamine 4-nitrobenzoates were better inhibitor than dialkylamine 3, 5-dinitrobenzoates, the passivating current density ($i_p$) of dialkylamine 4-nitrobenzoate was shown $4.78mA/cm^2$. While, for non-ferrous metal, dialkylamine 3, 5-dinitrobenzoates were better, those of dipropylamine 3, 5-dinitrobenzoate and hexamethyleneimine 3, 5-dinitrobenzoate were shown 36 and $37mA/cm^2$. Additive effect of $(NH_4)_2CO_3$ and $NaHCO_3$ for corrosion inhibition of ferrous metal was excellent but that of non-ferrous metal was not. Optimum ratios of diethylamine 4-nitrobenzoate with $(NH_4)_2CO_3$ and $NaHCO_3$ were 4 : 6 and 5 : 5 (V/V), and passivating current densities ($i_p$) of the mixtures were shown 0.26 and $0.85mA/cm^2$, respectively.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.17 no.2
• /
• pp.69-74
• /
• 2007

[ $0.6Pb(Sc_{1/2}Ta_{1/2})O_3-0.4PbTiO_3$ ] (hereafter PSTT) ceramics were prepared by the molten salt synthesis (MSS) method using KCI as a flux. Formation of perovskite phase was investigated by a differential thermal analysis (DTA) and X-ray diffraction (XRD) analysis in the temperature range from $600^{\circ}C$ to $850^{\circ}C$. A 92% perovskite phase was synthesized at $750^{\circ}C$ for 2 hrs using the MSS method, while 82% perovskite phase was synthesized at $850^{\circ}C$ for 4ks using the calcining of mixed oxide (CMO) method. This result could be due to the improvement in reactivity of $Sc_2O_3$ by melting of KCI. The MSS specimen sintered at $1,100^{\circ}C$ for 4hrs showed a dielectric constant of 11,200, a remnant polarization of $13.5{\mu}C/cm^2$ and a coercive field of 10.198 kV/cm, which was discussed in view of the microstructure.

• Progress in Medical Physics
• /
• v.11 no.1
• /
• pp.29-38
• /
• 2000

The signal transduction pathway for most neurotransmitter induced inhibition of $Ca^{2+}$ channels in sympathetic neurons involves a G-protein mediated, membrane-delimited mechanism without the participation of any known protein kinase. However, activation of protein kinase C (PKC) has been proposed as one of the intracellular mechanisms mediating some neurotransmitter induced $Ca^{2+}$ channel inhibition. In the present study, we investigated the effects of phorbol-12, 13-dibutyrate (PDBu) on $Ca^{2+}$ channel currents of acutely dispersed neurons from adult rat superior cervical ganglion (SCG) neurons using whole cell variant of the patch clamp technique. PDBu (500 nM), the activator of PKC, increased $Ca^{2+}$ channel currents and retarded the deactivation of tail currents. The effects of PDBu were voltage dependent and the maximal increase in the current amplitudes was observed between -10 to 10 mV (n=4). PDBu attenuated $Ca^{2+}$ current inhibition induced by norepinephrine (NE), which modulates $Ca^{2+}$ channels via a pertussis toxin (PTX)-sensitive pathway. Inhibition of PDBu by staurosporine (1 $\mu$M) blocked the effects of PDBu on current amplitudes and NE-induced G-protein mediated inhibition of $Ca^{2+}$ currents. Further experiment should be done to know if G-protein or $Ca^{2+}$ channel itself is the target of PKC phosphorvlation.phosphorvlation.

• Journal of Energy Engineering
• /
• v.18 no.1
• /
• pp.49-55
• /
• 2009

Occurrence of hydrogen embrittlement could be one of the main obstacles for using structural equipment under hydrogen environment. It is required to develop assessment methods of hydrogen embrittlement for the metals used in production, storage, transmission and application utilities of hydrogen. The most probable method of hydrogen mass transmission is using existing natural gas pipeline. Base or weld part of the pipeline can be damaged by mixed gas of hydrogen in the pipeline. In this study small punch (SP) testing was employed to evaluate the hydrogen embrittlement behavior for a line pipe steel (API X65) with electrochemically hydrogen charged specimens. Results showed that the SP test can be a good candidate test method for hydrogen damage evaluation method. Strength of steel is known to be decreased with the level of hydrogen charging. However, for API X65 steel base metal need in this study, the effect of hydrogen to strength was not significant. It can be negligible regardless of the hydrogen contents in the steel. With this test different strength levels with various hydrogen charging conditions were observed. It can also be anticipated that more sensitive evaluation of material behavior be obtainable by the SP test method.

• Journal of Energy Engineering
• /
• v.18 no.1
• /
• pp.56-62
• /
• 2009

With weld metal of X65 steel, hydrogen was charged by electro-chemical method and mechanical behavior such as strength was measured by the small punch test. The weld metal was more sensitive to hydrogen charging than the case of base metal. The small punch (SP) strength was decreased as the hydrogen contents increased. Magnitude of strength decrease was dependent on current density, temperature, charging time. Current density and charging time have significant effect on the mechanical properties but temperature of electrolyte has limited effect. Fractured surfaces of the tested specimens were observed by SEM (scanning electron microscope). In the hydrogen charged specimens cleavage fracture were observed, which is consistent with the SP test results. Since the testing procedure for studying hydrogen embrittlement proposed in this study has shown good reproducibility of test results, the proposed method can be assumed to be a reliable test procedure. Using the electrochemical charging and the small punch test, the change of SP strength for X65 weld metal due to hydrogen embritlement could be evaluated sensitively.