• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.16 no.8
• /
• pp.785-792
• /
• 1991

We designed the hal wavelength dipole antennal which can be used for he determination of the suitability of an antenna test site and considered the characteristic of antenna factors by using the moment methods. Antennal factors remain almost constant with negligible variations for the variations of $\pm$1 mm antenna dimention-radius and length. comparisons are mae between measured values and calculated results for the input impedance.

• The Proceeding of the Korean Institute of Electromagnetic Engineering and Science
• /
• v.1 no.1
• /
• pp.28-34
• /
• 1990

In this paper we discussed the theoretical antenna factor of a cylinderical dipole antenna. The Current distribution on a dipole antenna was analyzed by the method of moment, and this solu- tion is used for calculating the effective length and antenna factor of the half-wave dipole in free space.

• The Proceeding of the Korean Institute of Electromagnetic Engineering and Science
• /
• v.2 no.4
• /
• pp.3-9
• /
• 1991

This paper presents the characteristics of antenna factors of half-wave resonance dipole antennas above a ground plane. The current distributions on a horizontal and vertical dipole antennas were analyzed by the Galerkin's method of moments, and these solutions are used for calculating the horizontal and vertical antenna factors above the ground plane. It is shown that accurate antenna factors of the horizontal and vertical dipole above the ground plane are required of the radiated emission test.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.5 no.4
• /
• pp.9-19
• /
• 1968

In this paper, I introduced the theoretical formulas for calcuating the input impedance of a folded dipole antenna which is held in parallel with the conductive supporter. Through the comparision of the above impedance formulas with the imput impedance formulas of a half wave dipole antenna which is parallel to the conductive supporter, it was found that the former can be made in identically same form as the latter, if some conditions are satisfied. The equivalent conditions mentioned above are derived also and the manufacturing of a vertically polarized omni-drectional antenna is apossible by the use of above equivalent conditions, because a half wave dipole antenna in parallel with a conductive supporter is already illustrated to become an omni-directional vertical polarization antenna. Some experimental data are shown together.

• Journal of Advanced Marine Engineering and Technology
• /
• v.40 no.7
• /
• pp.642-646
• /
• 2016

A wearable antenna made using conductive tape on paper is presented in this paper. The proposed antenna is composed of a half-wavelength conducting dipole strip and a parasitic conducting strip on the A4 copy paper. The antenna is fed at the center of the dipole strip by an SMA connector. The configuration of the proposed antenna changes according to the origami method. Therefore the radiation patterns of the antenna vary according to whether or not the paper is folded. This approach solves the problem that the reception ratio of the signal decreases because of null points in the antenna radiation pattern. The reflection coefficient and the radiation pattern of the proposed antenna at 900 MHz are evaluated using an EM simulation and measurements. It was shown that the proposed paper antenna has reconfigurable characteristics at 900 MHz when utilizing the origami method.

• The Proceeding of the Korean Institute of Electromagnetic Engineering and Science
• /
• v.15 no.1
• /
• pp.40-49
• /
• 2004

최근에 새로운 전파이용기술이 상용화됨에 따라, 주파수 혼신 및 상호간섭에 의한 무선설비의 보호 및 전파이용 통신서비스의 질적 수준의 유지를 위하여 무선장비들에서 나오는 출력 전력을 제한하고 있다. 현재, 국내에서는 출력전력을 공중선전력(전도성전력)으로만 측정을 하는데, 이것은 실제로 복사되는 출력전력이 아니므로 좀더 정확한 출력전력의 측정방법을 알아보기 위해 국내.외의 복사성 전력의 기술기준 및 측정방법을 비교 분석하였다. 분석 결과 미국과 유럽은 실제로 복사되는 출력전력을 안테나에서 나오는 출력전력뿐만 아니라 안테나의 이득까지 고려한 복사성 전력인 EIRP(등가등방성복사 전력 : Equivalent Isotropic Radiated Power)와 ERP(유효복사전력: Effective Radiated Power)를 사용하여 측정하고 있었다. 또한 복사성 전력 측정시 주파수대 별로 1GHz이하인 경우에는 기준 안테나를 반파장 다이폴 안테나를 사용하여 ERP로 측정을 하며, 1GHz 이상인 경우에는 기준 안테나를 혼 안테나를 사용하고 ERP로 측정을 하고 있었다. 따라서,우리나라도 보다 정확한 출력 전력의 측정 및 규제를 위하여 실제로 복사되어지는 EIRP와 ERP를 고려 할 필요가 있다.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.10 no.8
• /
• pp.1352-1358
• /
• 2006

In this paper, we have fabricated and tested a broad band bow-tie slot antenna with dual reflector. If we put 1/2 length thin and long slot on a wide metal plate, the slot antenna radiates efficient and strong radio wave as same as 1/2 dipole antenna does. we made with bow-tie form slot which has wider broad band than normal rectangular slot. At first, we made and test a single reflector slot antenna. To enlarge the broad band, we inserted another reflection plate between the slot antenna and reflection plate. After the test, we could have known that the low band(VSWR<2.0) has about $22%(793MHz\sim992MHz)$, high band(VSWR<2.0) has about 61% (1626MHz\sim3064MHz).

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.9
• /
• pp.971-978
• /
• 2010

In this paper, we propose a compact multiple meander RFID tag antenna with broadband characteristic. The proposed tag antenna has been designed using the multiple meander form to effectively minimize the U-shaped half wavelength dipole antenna as the radiator part. The commercial tag chip is attached to the upper center of the rectangular shaped feed for impedance matching. The size of the antenna is $20{\times}19.7\;mm^2$ and VSWR<5.8 bandwidth is 855~964 MHz which covers the world UHF RFID bandwidth.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.14 no.1
• /
• pp.176-182
• /
• 2006

In this paper, we have measured the power of the electro-magnetic waves in the cabin of automobiles with automatic transmission or manual transmission. Measured frequency ranges are $815\~865MHz\;and\;900\~950MHz$. Experimental studies are conducted by measuring the radiated power of the frequency spectrum for above frequency bands. The $\lambda/2$ dipoles used for measurement are fabricated to comply with the COMMISSION DIRECTIVE 95/54/EC. Experimental results confirm that the level of radiated power in the cabin of automobile with automatic transmission is higher than that with manual transmission. The measured values are less than -85dBm for the manual transmission vehicles, but more than -79dBm for the automatic transmission vehicles.

• Journal of Korea Society of Industrial Information Systems
• /
• v.14 no.1
• /
• pp.9-16
• /
• 2009

In this paper, a method is proposed for the analysis of radiowave receiving characteristics of an ammunition with electric detonator. In this method, an ammunition with electric detonator is modelled as a receiving antenna with its gain obtained by computer simulation or measurement. The induced radiowave power is obtained by inserting the gain of the electric detonator in the antenna coupling formula. Radiowave receiving characteristics at very close distances are obtained by Treasuring the transmission coefficient between a half-wave dipole and the electric detonator model. Radiowave receiving characteristics of the electric detonator in a 105mm tank ammunition are obtained using the proposed method and the safety of the 900 MHz RFID reader on the detonator is assessed.