• Transactions of the Korean Society of Automotive Engineers
• /
• v.14 no.1
• /
• pp.109-114
• /
• 2006

The reformed bio-diesel fuel irradiated by the ultrasonic wave is applied to the diesel engine of common rail in common use recently. This study has the object to examine the properties of engine performance and discharged materials. The bio-diesel fuel is mixed and used with the diesel fuel in common use at the ratio of $20\%\;or\; 100\%$. The ultrasonic energy is irradiated to the individually mixed fuel in order to reform the fuel. This fuel is applied to the engine in this experiment. And It is compared and analyzed from the experimental results with two cases irradiating the ultrasonic wave and no irradiating.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.38 no.2
• /
• pp.129-137
• /
• 2014

In this study, the characteristics of exhaust gas as a function of the biodiesel mixing ratio were investigated. Diesel and waste oil were used for preparing mixed fuel, and the ratios of the mixed fuel were varied in the BD3~BD100 range. The injection pressures(${\Delta}p_{inj}$) was considered as an experimental variable and was set to 400 bar, 600 bar, 800 bar, 1000 bar, and 1200 bar. Furthermore, for quantitatively analyzing the characteristics of exhaust gas(NOx and Soot), the concepts of Pearson correlation coefficient and Spearman rank-order correlation coefficient based on statistics were introduced. Consequently, it was found that the correlation of the emission of NOx and Soot is linear, and the Pearson and Spearman coefficients are -0.732 and -0.724, respectively, under all analysis conditions. Especially, for the injection pressure of 800 bar, a simultaneous reduction in NOx and Soot emission is possible by controlling the biodiesel mixing ratio. This is because the correlation coefficients of NOx and Soot emissions were nearly 0, as the Pearson correlation coefficient was -0.089.

• Journal of Energy Engineering
• /
• v.18 no.2
• /
• pp.101-107
• /
• 2009

The combustion characteristics of a single droplet of diesel and bio-diesel have been investigated experimentally with varying droplet size, ambient temperature and compound ratio in a high temperature chamber. The fuels used were diesel with bio-diesel contents varied from 0% to 100%. Each experiment has been performed from 970K to 1070K by 50K intervals. Imaging with a high-speed digital camera was adopted to measure the ignition delay and flame life-time, as well as to observe micro-explosion behavior. The increase of droplet size and decrease of furnace temperature cause an increase of the ignition delay time. As the bio-diesel content decreases, the ignition delay increases and the micro-explosion behavior is strengthened. It is also confirmed that the full combustion time decreases as the micro-explosion occurred.

• Journal of Power System Engineering
• /
• v.8 no.2
• /
• pp.18-23
• /
• 2004

Recently many researchers have been studying the development of alternative energy due to serious environmental pollution and drying up fossil energy. Among various alternative fuels, authors investigated the physical and combustion characteristics of the bio diesel fuel(BDF) which was made from the wasted vegetable oil. In this study, PXI and LabVIEW, which is a novel measuring instrument and online analysis, was used to investigate the combustion characteristics of BDF in a DI diesel engine.

• Journal of the KSME
• /
• v.55 no.7
• /
• pp.32-36
• /
• 2015

최근 화석 연료의 과다 사용에 따른 에너지 자원 고갈 및 환경오염에 대한 우려가 증가함에 따라 비화석연료 기반의 재생가능하고 지속가능하며, 환경친화성이 높은 에너지에 대한 관심이 급증하고 있다. 농산폐기물, 폐목재, 에너지작물, 도시고형폐기물, 미세조류, 거대조류 등 육상 및 해상에서 발생하는 바이오매스는 재생가능한 에너지원으로서 화석원료와는 달리 사용 후 발생하는 이산화탄소를 다시 흡수하는 탄소중립(carbon-nutral)의 특성을 갖고 있어 전세계적으로 많은 주목을 받고 있다. 바이오연료 중 당질계원료를 이용하는 바이오에탄올 및 식물성유지를 이용하는 바이오디젤은 현재 상업적인 생산이 이루어지고 있으나, 이들 1세대 바이오연료는 식량자원과의 경쟁이라는 원천적인 한계를 가지고 있고, 분자구조식에 산소를 포함하고 있기 때문에 기존 화석원료에서 출발하는 가솔린, 항공유 및 디젤과 비교하였을 때 에너지 함량이 낮은 단점이 있다. 따라서 기존 1세대 바이오연료에서 탈피하여, 식량자원과 경쟁이 없으며, 또한 분자구조식에 산소를 적게 포함하거나 아예 포함하지 않는 바이오연료("drop-in" 바이오연료) 생산에 많은 관심이 집중되고 있다. 이 글에서는 최근 그린공정으로 대표되는 초임계 유체를 이용한 "drop-in" 바이오연료를 제조하기 위한 바이오매스 액화의 기술동향을 소개하고자 한다.

• Journal of the Korean Institute of Gas
• /
• v.14 no.1
• /
• pp.8-14
• /
• 2010

In this study, we experimentally investigated a compression ignition engine operated with Bio-diesel blended LPG fuel. In particular, the performance, emissions characteristics (including total hydrocarbon, carbon monoxide, nitrogen oxides, and carbon dioxides emissions), and combustion stability of a CI engine fueled with Bio-diesel blended LPG fuel were examined at 1500 rpm. The percentage of Bio-diesel in the fuel blend ranged from 20-60%. The results showed that stable engine operation was possible for a wide range of engine loads up to 40% Bio-diesel by mass. When the Bio-diesel content was increased, leading to a decrease in the lower heating value of the blended fuel, the cetane value increased, resulting in a advanced start of heat release. Exhaust emission measurements showed that THC and CO emissions were increased when using the blended fuel at low engine speeds due to partial burn from over-mixing. NOx emission was emitted less at lower loads and more at higher loads.

• Journal of ILASS-Korea
• /
• v.13 no.4
• /
• pp.180-186
• /
• 2008

The aim of this work is to investigate the effect of ambient conditions on the spray behavior of biodiesel-ethanol blended fuels. In order to analyze the spray behavior, spray tip penetration and spray cone angle were obtained from the visualization system and the effects of ethanol blending are compared macroscopic characteristics with the numerical results. It was reveled that the ethanol contents in biodiesel-ethanol blended fuels affect the spray tip penetration a little and increased the spray cone angle. Increased ambient pressure induced the decrease of the spray tip penetration, and the increased ambient temperature lead to the increase of the spray tip penetration. In addition, the increased ambient temperature promoted the vaporization and atomization of spray with the effect of increasing ethanol fuel.

• Applied Chemistry for Engineering
• /
• v.23 no.2
• /
• pp.232-240
• /
• 2012

Bio-diesel (BD) is the mono alkyl esters of long chain fatty acids derived from renewable feed stocks like vegetable oils or animal fats. Bio-diesel shows poorer fuel properties than that of diesel fuel in a cold condition. For the diesel fuel, many cold flow improvers have been developed; however, since primary ingredients of bio-diesel are different from those of the diesel fuel, there is a limit to the cold flow improvement when the same cold flow improvers are added to bio diesel. In this study, to improve low temperature properties of bio-diesel, we developed a cold flow improver using an alkyl methacrylate monomer, prepared via ester reaction, and maleic anhydride and also conducted a ring opening reaction using amine. We characterized the products using $^1H-NMR$, FT-IR and GPC methods. In addition, the cold flow improvements of the products in Soybean BD and Palm BD in the concentration rage of 1000~10000 ppm were investigated. It was found that the addition of LMA2SMA6MA2-C8A in Soybean BD improved the pour point by $12.5\;^{\circ}C$.

• Applied Chemistry for Engineering
• /
• v.21 no.4
• /
• pp.385-390
• /
• 2010

Transesterifications of vegetable oils (soybean oil, grapeseed oil, corn oil, canola oil) by ultrasonic energy were examined on various catalysts for biodiesel production. Reaction activities of the transesterifications were evaluated to the ultrasonic energy and thermal energy. The physicochemical properties and product distribution were also investigated to the biodiesels produced from the oils in the reaction using ultrasonic energy. The yields of fatty acid methyl ester (FAME) on the alkali catalysts were higher than those on the acid catalysts. The highest FAME yield was obtained as 83% on potassium hydroxide catalyst in the transesterification. The effective reaction conditions by ultrasonic energy were 1 wt% catalyst loading and 6:1 molar ratio of methanol to vegetable oils. The reaction rate of the transesterification by ultrasonic energy was faster than that by thermal energy. The acid values of the biodiesel products were improved above 30% compared to those of the feedstocks.

• Journal of Advanced Marine Engineering and Technology
• /
• v.33 no.2
• /
• pp.252-258
• /
• 2009

Engine bench tests has been done on a common-rail diesel engine with bio-diesel fuel to study effects of B100 and B20 on output power, fuel consumption and emissions. Test results show that B100 and B20 could reduce PM, HC, CO emission and smoke, but power decrease, fuel consumption increase and NOx increase obviously, B100 reduce PM and DS with $50%{\sim}70%$ and $80%{\sim}85%$ compared with diesel fuel, while B20 reduce PM and DS with $25%{\sim}35%$ and $30%{\sim}40%$. NOx of B100 and B20 increase $5%{\sim}20%$ compare to diesel.